3524P

Hi my client wants to use stacking on this old model: 3524P, the question is whether it is possible to stack them in another unit of this model? I saw in the data sheet and technical documents that the answer is positive, if yes what is the necessary cable for this? Thanks lotan

The 3524 cannot be stacked with any other switch 3500. Page 12 of the user guide details the process of stacking.

http://FTP.Dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_powerconnect/PowerConnect-3524_User%27s%20Guide_en-us.PDF

PowerConnect 3548 switches use the RJ-45 Gigabit Ethernet (g3 and g4) ports for stacking. CAT5e or Cat6 RJ45 cables must be used for the ports of stacking due to the necessary flow for traffic between the battery units. Standard CAT5 can lead to communication errors.

Thank you

Tags: Dell Switches

Similar Questions

  • How do reset you the time-out of the user for the connection of MISTLETOE on a 3524P?

    By default, apparently of 5 min, is too short for me.  I tried several CLI commands, I found online, but apparently not the right one.  This in particular seems like it should work, but I get a response from the unrecognized command.

    Console (config) # ip http timeout policy 1200

    Okay, I think I'm going to itt.  My mistake was misinterpreted your instructions.  I thought "console line" took care of telnet also.  I see now that I need to use "telnet line" separately.  Learn about 'Show the line' helped me understand.

    Thanks again.  If the behavior of Exchange today timeout I mark as resolved.

  • Adding N2048P YES

    Hello

    I stacked the two switches to N2048P and created and added a VLAN 10 to all ports. I posted the VoiceVLAN to VLAN 10.

    I try to add the Polycom YES so Polycom phones are automatically transferred and assigned to VLAN 10.

    I've done this before on my devices 3524P easily via the web console such that there is an option specially for this. There is no option in the web interface for the N2048P well so I'm looking to add via CLI, but get an error.

    Yes vlan voice SW-STACK1 (config) #-table add 0004f2 PolycomTIPT

    He puts the error marker to 'o' to 'yes '.

    If someone could point me in the right direction I would really appreciate it.

    Thank you

    David.

    To get the phone automatically placed on VLAN 10 traffic, you will need to configure the VLAN 10 as the voice VLAN.

    Allow on a global scale.

    Console (config) #voice vlan

    Activate the voice VLAN on the specific interface.

    Console (config) # interface ethernet 1/g1

    Console (Config-if-Gi1/0/1) # vlan 10 voice

    Defines the General/Trunk interface. I would try the general mode first.

    Console (Config-if-Gi1/0/1) # switchport mode general

    Console # switchport general allowed vlan remove 10

    With this configuration, once the port detects a voice traffic it will place this traffic to VLAN 10. All no voice traffic from the client connected to the phone will be placed on the PVID.

Maybe you are looking for