do not record voices
I can record voice via the built-in microphone, but not through my Scarlette 2i4 with a condenser MXL 3000 mic. I use this configuration on a regular basis for a few years and recorded several songs recently and everything was fine. Then the other day it didn't work anymore.
I have preferences inside the Gargeband on Scarlett for entry and exit
I have a lead of real instruments with active record
Phantom power of Scarlett's gain is in place and I can see this mic signal to the Scarlett
I hear the MXL 3000 in my headphones are plugged the Scarlett.
I tried a different microphone, no change.
I tried to stop everything, re-corner connections, don't reboot, no change.
I tried the channels 1 and 2 on the Scarlett, no change.
I tried several song files and new empty files.
Note: There is no drivers for the Scarlett - it runs in compatible mode on Mac
I'm puzzled. Any ideas? Thank you very much, really frustrated and can not save!
Have you checked the settings of the Audio configuration utility and Midi? Sometimes, the format is set to a frequency cap is not taken care of in GarageBand - there should be 44100 Hz. And check the volume sliders.
Tags: iLife
Similar Questions
-
iPhone'S will not record voice memos
Hello! My new iPhone IS will not record voice memos. I can open the app very well, but when I press the record button it shakes just for a moment and then stops.
The software is up-to-date (iOS 9.3.1), storage seems adequate (6.0 GB used, 5.6 GB available), MIC works fine in other applications (voice control, camera), so I'm not sure what the issue could be.
Thank you!
Try a forced reboot - after open applications using the app Chooser - invoked by fast double pressing the home button and drag upwards on each app until it disappears from the screen.
Meet the sleep/wake and home buttons down until you see the logo - then release and allow normal start upward
If this does not work
Please take a genius appointment at an Apple Store, or select another authorized service provider.
-
I need a little help with my dictaphone, I use an iPhone 5. Whenever I try to save my phone detects just to the touch when the record button is hit & unregisters immediately. It was restored from the back upwards to another iPhone that saves notes of worry-free service.
Greetings SLiKKSTaRR,
Welcome to Apple Support communities.
I see that, when you try to record a voice memo, your iPhone detects the touch when you press the record button, but unregisters it immediately. It's certainly something that I wouldn't have to happen. I want to assure you that you can record your voice memos with no problems. There are a few things I would like you to try.
First of all, let us ensure that applications running in standby mode are not causing problems when you try to save. Please use the resource in the following article to close all applications on your iPhone:
Force a nearby application on your iPhone, iPad or iPod touch
Then, use the following article to give your iPhone a fresh reboot:
Restart your iPhone, iPad or iPod touch
And finally, once that you have restarted, please test by recording a voice memo and see if it unregisters immediately as before.
Have an amazing day!
-
I can't sync my iPhone with iTunes 5. OK video ist in photos und - but the recorded voice (Sprachmemos) does not work
Hello
Click on these links, they should help you!
https://support.Apple.com/en-GB/HT201253
iPhone, iPad, or iPod not recognized in iTunes for Windows - Apple Support
Jack
-
HP Slate 7 How do I record voice with the microphone
I want to voice recording, live by using the microphone, but I don't know how to do it. Can someone help me please.
Thank you
Download one of the many free recorder voice applications available in the game store!
I just tried to 'Smart Voice Recorder' and it worked very well. (I am not affiliated with the author). Just type "Start Recording" and go! There's even a feature to silence 'Skip' to record the size of the record.
WyreNut
-
Microphone/driver issue; Quiet Recorded voices, loud noisy Boost
Without boost that my voice is very quiet (not understandable) despite the recording level being the max value, but the boost has really annoying white noise which increases disproportionately there worth more high. 10 + boost is doable but not practical (voice is always so calm, boost is still too loud), defining the upper thrust dominates my voice.
Sound card: onboard 6 Channel Audio of High Def (on motherboard: ASUS® Z87M-PLUS: m - ATX, USB3.0, SATA 6.0, XFIRE)
Driver: Realtek HD Audio, version 6.0.1.7071
Current microphone: Logitech Stereo Headset H150 (have had the same problem with other microphones)
I tried going to the Device Manager and try to update the drivers for audio devices, no updates where found.
Also try to help out "Audio playback" and "sound recording", both times he had no problems found.
I installed the new driver tetraethyle3 posted (these exact links seem directly to faulty .exe files, but I downloaded somewhere else), took a bit of faffing around trying to bypass plug-and-play (still not sure how I did it) but it works.
-
BlackBerry smartphones does not allow voice notes Delete?
Hello
I have the Storm 9530
For some reason he isn't back note me to delte my voice, I tried through the media/voice note / delete option and past the other route to go to applications/voice note recorder/view voice notes / remove option down... both seem to do nothing for me...
Anyone with ideas... little help would be greatly appreciated.
Thank you guys!
Try this: when the unit is on, remove the battery, wait a minute and return the battery.
After this attempt to remove voicenotes.
-
I wan to save my history Web sites, but my computer does not record. I go to tools > options > privacy and try to "save history", but it goes back to "use the custom settings for history"... I'm all down on those checked so it should save, but it doesn't.
Thank you for taking the time to help me!
-
A year ago, the camera suddenly started flashing and beeps a yellow icon in the middle of the screen. C:31:23 flashes in the upper right corner above the minutes from the end. The camcorder will not record or play.
If I remove and reseat or change the battery, and if I remove and reinsert or pass the minidisk, sometimes it'll save or play for a while before the beeps happen again.
Sunny in Sun Valley
Try to check the pin of pinch. Open the container of band and you can see the PIN pinch, is a small black roll about 1/4 in. wide and about 1 inch in height, see if she's down on the stem
-
Tecra M5 does not record the date and time - battery RTC or CMOS checksum is inconsistent
My Tecra M5 PTM50E reverend new does not record the date and time. I loaded RTC battery for 8 hours when electricity is on in the said user's manual. I don't know where is the problem. The BIOS settings are respect after power is on.
When I change any value in the BIOS, the changes are saved properly but date & time system restored to their value 01/01/2000, 00:00 every time when I get out of turning off more of 2-3 min. Message "RTC battery is low or CMOS checksum is inconsistent.
Press [F1] to set Date/time"does not appear when I power on the computer. Any suggestions?
Hi guys
Usually this problem appears only if the CMOS (real time clock) battery is empty or corrupted.
The real time clock battery powers the internal clock in real time and calendar. It also maintains the system configuration. If the RTC battery is completely discharged, the system loses these data and the real-time clock. In this case, the message RTC battery is low or CMOS checksum is inconsistent appears.So I see only two possibilities:
Either you will charge the battery for real-time clock, or you ask the technician for replacement.Generally, the battery must be completely charged after 8-9 hoers but try to connect the laptop to the power adapter for a long time.
If it will not help solve the problem if you contact the ASP for the RTC battery replacement. -
Paired Remote App not recording not peel after restart of Apple TV 4
Paired Remote App not recording not peel after that Apple TV 4 is restarted.
I have paired a remote with Apple TV 4, but that pairing is not saved after I power cycle the Apple TV 4. I checked with an Apple TV 2 and it stores the remote pairing when it is the power to bike.
Y at - it a setting or something I missed? Or is this a problem with the current software on the Apple TV 4?
Thank you
-Jeremy
Oh, it's working now. It was a problem with the device I have matching and not the Apple TV 4. Disregard this message.
-
my Apple Watch does not record the data of my activity on my iPhone. The application of the activity is implemented on my watch and twinned with phone and not yet to record data.
HI - try the following steps:
On your iPhone close application of activity and also, if it runs in the background, the health app (you can close open apps, including the app shows):
-Double-click the Home button, and then drag upward on each of the app previews to close.
It can help to restart your iPhone and your watch. Turn on both devices off the power together first, and then restart your iPhone before restarting your watch:
-To switch off your watch: press and hold the button side until you see the cursor off the power; slide it to turn off;
-To switch on: press and hold the side button until you see the Apple logo.
If this does not resolve the problem, try next disconnect and rematching of your watch:
-L'app shows on your iPhone shows backups automatically, including a new when the unpairing via the application.
-Choose to restore the watch (backup restore) when provided the opportunity during the whole.
-Most of the data and settings will be restored, with a few exceptions (for example cards Pay Apple, access code).
-
the R channel does not record on ION U RECORD.
the R channel does not record on ION U RECORD.
original title: ION U RECORD.Hi Patrice,
Please select your language from the drop-down menu above to post your question in the language of your choice. The forum in which you've posted is for English only. If you can't find your language above, support for additional international sites options are by following the link below:
http://support.Microsoft.com/common/international.aspx
Thank you
-
I checked the save my email address box, but it does not record
original title: can not enter hotmail sign to save my e-mail addressHello
As the issue is specifically related to Windows Live Hotmail, I suggest that you post the question on the link provided below for assistance.
Hotmail Portal
-
Built-in microphone does not record
I have a Toshiba laptop with a built-in webcam and microphone. For some reason, the microphone has stopped working - I can not record sound or having people hear me on Skype - if it says that it works correctly when I open Control Panel is. What should I do?
Hi Eryx,
You have made any changes to your computer recently?
I suggest you to follow the steps and check if she dreams.
Run Microsoft Fix - it for the link and if it helps.
Diagnose and automatically fix problems audio and sound recording
Maybe you are looking for
-
AT200 crashes playing music and the screen switch off
Hello first of all, I want to apologize for my bad English.I ve got an AT-200 and I have this problem: when I listen to music and turn off the screen, the music begins to shake (like when you have a blue screen error in windows) and she don't brokes
-
How can I access messages that came to my iPad but not my iPhone?
My friend, who also uses an iPhone, sent several messages this evening. I picked up my iPad and saw that there was a lot of posts on the lock screen, but I spent just the lock screen here as usual to use the iPad for the reason that I picked up. Th
-
How to make a backup on Qosmio G20?
Having owned this notebook since January, I thought I'd better make a return to the top. However once that data have been collected it ask me for a floppy drive store information on which I don't have. What I have to buy an external floppy drive that
-
How to retrieve text messages deleted from the Iphone 5
How to retrieve deleted messages of I Phone 5?
-
How to create a hidden in a network share
How to create a shared hidden so that it does not appear in network, but I can access only within the network.