How to test ASA 5510 hardware before you buy?

Im looking to buy a refurbished warranty on ASA 5510 with security license. What tests should all I leads with one independent and the device network to ensure that the material is good?

Hi, I usually ask a full boot and see the output of the version every time I buy referb or eBay. Sometimes you do not get these output unless the vendor is notified.

Tags: Cisco Security

Similar Questions

  • How can I block my number before you make a call

    How can I block my number before you make a call? Thank you!

    Settings > phone > display my number: OFF

  • How will I know that the Windows Xp pro product key is already registered or not before you buy

    In fact, I'm going to buy Windows XP Professional and I see the product key is spent outside of the RAP and it is visible to everyone so here is the possibility that someone already uses this key and register online. I just want to know that how I know that the key is not yet register online before you buy.

    Hello


    Where will you buy Windows XP computer?

    You can contact Microsoft customer service to improve the assistance.
    http://support.Microsoft.com/kb/295539

    Hope this information helps.
  • Before you buy Windows 7 it will modernize my Windows XP?

    Before you buy Windows 7 it will modernize my Windows XP?

    First, see if your computer meets the Windows 7 system requirements:

    o 1 gigahertz (GHz) or faster 32-bit (x 86) or 64-bit (x 64) processor
    o 1 gigabyte (GB) of RAM (32-bit) or 2 GB RAM (64-bit)
    o 16 GB available space disk (32-bit) or 20 GB (64-bit)
    graphics device o DirectX 9 with WDDM 1.0 or higher driver

    If so, run the Windows 7 Upgrade Advisor to check for possible problems.  If it passes this test, you can buy a Windows 7 upgrade version and use it to perform a custom (clean) installation.   For more information, see upgrade from Windows XP to Windows 7 and Windows 7 Upgrade Considerations .

  • where can I find the chassis for the import file in MAX to draw the circuit diagram before you buy

    where can I find the chassis for the import file in MAX to draw the circuit diagram before you buy

    chassis: NI SMU-1078

    ini file to import into MAX

    See attachment

    THX

    Hi again Koen,

    Unfortunately, you can't simulate a complete PXI system, so we do not have the ability to simulate a PXI controller unit. The simulation, you can do is to set up the cards you want to use in you.

    concerning
    Lars

  • Is it necessary to have windows 7 is installed before you buy the upgrade of Windows 8

    Hello
    Is it necessary to have windows 7 installed before you buy windows 8. Or only the product key is sufficient.

    Lets assume that it is necessary to have windows 7 installed. Then, suppose if I want to reinstall windows 8, I have to follow the procedure:

    1. install windows 7
    2. run the upgrade of windows 8

    Or we can directly run windows 8 upgrade.

    Please help in solving my doubt.

    Andre said it is "recommended", it is always best to clean install original DVDs.

    Maybe you can google that question, you can get answers, we cannot give you here.

  • I can gather images in a gallery or a lightbox to share with my client before you buy?

    With other sources of stock images, I can gather images I am choosing in a lightbox or Gallery and share it with my client before you buy. Is it possible to do something similar to Adobe Stock? I only see the option to download a version of watermark or buy the version high resolution.

    Thank you! Leslie

    Go to www.adobe.com and connect. Select the asset library in the menu:

    This will take you to your creative heritage of cloud. Click libraries in the menu on the left:

    Click on the arrow down and choose to send a link or work:

  • Is there a UK sales / support phone number that I can call you please. I would like to talk to someone before you buy a product, but your website retains just direct me to this forum

    Is there a UK sales / support phone number that I can call you please. I would like to talk to someone before you buy a product, but your website retains just direct me to this forum

    Hi Joanne,

    Please see the link:

    http://www.Adobe.com/UK/company/contact.html

    I hope this helps.

    Concerning

    Megha Rawat

  • Before you buy Adobe software from a private party, is there a way I can check that the serial number is valid?

    Before you buy Adobe software from a private party, is there a way I can check that the serial number is valid?

    N °

    Another that calling Adobe Customer Service.

    Unfortunately, that's the risk you run with the purchase of used software 3 third-party. Not sure if it is hacked.

  • I bought the PDF monthly Pack and I can't open my files on my software of the company. I click on a document and a screen comes up asking me to buy something. I already have. Also before you buy the PDF package I got was able to open my documents of the c

    I bought the PDF monthly Pack and I can't open my files on my software of the company. I click on a document and a screen comes up asking me to buy something. I already have. Also before you buy the PDF package, I was able to open my documents of the company. WTF thank you

    Have you by any chance also tried Acrobat Pro, have a trial version for 30 days, and it is now out of print? If so, you must uninstall it.

  • EqualLogic - how to level a new table before you add to the Group

    I have a new table which is v7 and I try to add a group of v8.  It won't join the group due to version incompatibility.  How to pass it to v8 so I can join the Group?  Thank you.

    Hello

    Create a new group with one member.  I wouldn't use the Remote Setup Wizard to do this.  Who sets policy RAID that requires you to wait that ends before you can upgrade the firmware.

    I would rather the serial port.  Then, you need to only configure port network and the new IP group.

    Once you answer the basic questions are the GrpName > cli prompt you can then transfer the kit to upgrade and update the firmware.

    Once you run the "update" process and restarted the table, reconnect and make sure it is in the new revision.  GrpName > show Member which will show.

    The CLI run "reset" to return unit to factory reset, and you can now add in your other group.

    Kind regards

    Don

  • How can I open an attachment before you save it?

    I'm used to be able to open an attachment before you choose to save it. Now I can just save it. Then I have to locate where it is save and open. PDF is not always open in Adobe. I have the most recent Adobe. It is a new problem for me to use gmail and firefox.

    Hello

    Please open settings and applications (optionally) see if the types of files (format pdf, jpeg, png) have a correct action. If they always ask they will be asked where to save the file or you want to open with application. If they are save, then they will be saved without asking.

    For more information, you can read the following:
    http:// http://kb.mozillazine.org/File_types_and_download_actions

    also read the following:

    More info

    It will be useful.

    You can return to your problem and we will try to help you.

  • How to configure ASA 5510 - my first time HA! Help!

    I need to connect 2 ASA 5510 in an HA configuration. I don't know about the types of cable (x - ovr or straight) for the connection of the State, heartbeat connection and where they must be connected. Also, I was told that the connection of the State must be on a switch or VLAN separate... Is it true...?

    We use a x-over for the failover of an int on the SAA primary to secondary ASA and it works very well.

  • How long does siri suggestions take before you start to work?

    I implemented a 6 s iPhone with an apple ID (that I have not touched within 2 years or more) and did a new restore before installing all services with this ID. Everything works well except Siri suggestions. My spotlight page is empty. As shown in the screenshot. Suggestions of siri takes some time to learn? If Yes, approximately how long? I really liked the suggestions of siri. I don't put my phone with the ID, June 4 and starting from June 8, theres no suggestion of siri

    With my previous ID apple (used on the iphone even) I used to get siri suggestions such as contacts and recent/favorite applications as not to change based on the location and time of day.

    My settings are the same with the two apple ID are the same except for the fact that the time that it worked, I was using a USA store identifier apple with the region settings defined in Singapore and now it's an Apple in Singapore id with the region defined in Singapore.

    I live in Singapore and for sure I know that some features may not work in all regions, but the recent contacts and apps work on law of Singapore?

    I tried the normal stuff as restart the phone hard reset and soft reset. I have toggled the power on and off settings and then rebooted the phone but nothing has worked... any help would be appreciated and sorry if my you do not understand my question

    How to turn the Suggestions of Siri on / off in iOS 9 on iPhone and iPad
    1. Step #1. Go to settings → general tap.
    2. Step #2. Press Spotlight search.
    3. Step #3. The first option is Siri Suggestions; You can toggle ON or OFF Siri Suggestions.
  • How do I know if the license key is valid before you buy?

    I'm suspicious that the Win 7 Pro sold license keys are stolen. How can I check before buying if it is the case or not? How will I know that it is authentic? And what happens if they are genuine now but later considered stolen?

    Leo,

    You have never seen an OEM license for the sale of an honest seller, unless this license was part of the sale of a PC with Windows 7 pre-installed by the OEM.  See the Microsoft OEM System Builder License

    You might be interested with the details provided in the forum thread is it legal to use a disc to install windows 7 OEM on my custom pc? this thread contains references to both OEMand System builder .

    - - - - - - - - -

    Edited an hour or later - I tried to find a link to a quote that I got the OEM System Builder License - this is

    Use of the OEM System Builder software is subject to the terms of the Microsoft OEM System Builder License:-the software is intended for pre-installation on a new personal computer for resale.

Maybe you are looking for