Icona one b-770 overheating when charging

Similar Questions

• The battery on my Toshiba NB500 has not been charged since one should use it when you are connected to the power. The battery in the tool bar icon indicates charge but is always 0% available.

  The battery on my Toshiba NB500 has not been charged since one should use it when you are connected to the power. The battery in the tool bar icon indicates charge but is always 0% available. What could be the problem and how can I solve it?

  A problem better put to the support of Tosh or their forums, with regard to their equipment, not MS or Win

• When the progressions referred to my Office I get two icons, one is a file folder, when I try to delete this two icons are removed

  When the progressions referred to my Office I get two icons, one is a file folder, when I try to delete this two icons are removed from the trash how to solve?

  When the progressions referred to my Office I get two icons, one is a file folder, when I try to delete this two icons are removed from the trash how to solve?

  So if you right-click on the desktop and choose New--> shortcut and then create a shortcut to something, what is happening?

• How can I disable the startup mode fast for my Iconia One B1-770-K651 7 inch 16 GB Tablet

  Hi, I recently bought the Iconia One B1-770-K651 7 inch Tablet 16 GB and when I turn it on and put it back in the box for some reason any continues to go in quick start mode. I want to know how can I disable quick start permanently mode I can't find something in the settings to turn off the quick start mode.  the version I have is android 5.0 lollipop. Is it possible to disable it in settings. Thank you

  Honestly, I would contact the seller or the Acer support service for warranty check.

• Aspire Switch SW5-012 10 stops when charging

  When I go out my Tablet SW5-012 charging for a long time (a few hours or overnight), I find always off.

  As a result, I lose all open programs and documents... And Chrome told me that it was not turned off properly.

  There is no other problems with it - it turns its back on the property and the battery shows full charge.

  This problem occurs if I leave the Tablet from one day to the next without connecting the charger, he sleeps just.

  I can't capture the moment where she stops, as happens only when I leave it loads unattended. I'm guessing that he stops when the battery charges to 100%.

  I checked all the settings in the power management, could not find anything that could cause this problem...

  I think I found what was causing this problem. It's Acer Power Management application. When I close it in Task Manager (all processes beginning by ePower *), the Tablet does not close when charging.

  Not sure what this software is designed, the Tablet seems to work fine without him, so I'm just going to uninstall it.

• Adding icon in the background transparent when Michael

  Hi, I am observing interesting phenomenon (?)

  I've added an icon to my request that I developed using the guide provided by the kb article:

  http://docs.BlackBerry.com/en/developers/deliverables/21877/Add_icon_to_configuration_file_1374808_1...

  The icon has been added successfully on the Simulator and everything is normal but I notice that the background becomes now when I disable the soft (drag up to zoom out of the window of the application).

  It's weird because in the zoomed view on, all components are present (such as areas of labels, buttons, etc.), but the background (which is black) becomes transparent. When I again focus the application, the background color become serious.

  (Although I recognize that this method of adding icon is suspicious because he tells me to create another .xml file when there is a present already - one that was created when I first implemented the project - it's perhaps is the source of error...?)

  I'm afraid that RIM will reject the app for this reason, so I'm holding presentation until this issue is resolved.

  Anyone have any idea what can cause this? !!

  Any help is appreciated!

  Nevermind, I solved my case. The answer was hidden

  http://supportforums.BlackBerry.com/T5/Tablet-OS-SDK-for-Adobe-air/problems-while-publishing/TD-p/69...

  Transparent tag in the .xml file must be set to false.

• 3.6.3, cannot drag and drop tabs (the iconic chart moves but disappears when released), also can not 'tab.

  3.6.3, I can not drag and drop tabs (the iconic chart moves but disappears when released), also I can not "select" tab to change the status of parent/child etc.

  This has happened

  Each time Firefox opened

  == installation

  Hello

  I had the same problem (impossible to drag-and - drop) and it was restored when I disabled the addon "tab mix more.

• Satellite P750 - overheating when using the graphics card

  I have a Satellite P750. I have a few games that I love to play, but I am unable to because that laptop overheating during the execution of these games.

  The specifications of the P750 with GeFORCE 540 m graphics card and 8 GB of ram easily meet the requirements of the games (Counter strike source, cod mw3).

  While playing the games for about 10 minutes, all right.
  After this step, things start to warm up, and small defects appear on the screen.

  Small rectangles of messed up graphics.
  If I don't leave the game immediately, I get a BSOD with errors such as "IRQL _less_than_or_Equal.

  The vent on the left side of the laptop runs very hot when this happens.
  I cleaned dust vacuum on and uses a fan/cooling pad to try to cool it.
  Makes no difference.

  I updated to BIOS and graphics card drivers

  WHAT CAN I DO TO PREVENT OVERHEATING WHEN YOU USE THE GFX CARD

  Hmm using the page of the Toshiba driver graphics driver?
  Such driver is a bit different from the other nVidia drivers because it s modified for mobile use. It contains some kind of overheating protection.
  In case of higher temperatures of GPU, such driver would clock down GPU performance in order to increase the temperature of the GPU.

• HP pavilion dv-6 hang up & overheating when working on the battery (only when playing games)

  Hang up my hp dv-6 & overheating when working on the battery, especially when playing games, even online games.

  but when I use the AC everything works fine

  I did all the updates to day and scan for virus, & error also I bought the new battery, but the problem still exists

  Information on my laptop:

  OS: win 7 pro 32 bit

  VGA: Intel (r) Graphics Media Accelerator HD

  RAM: 4 gaeremynck

  I need advice please.

  Clean the vents of your laptop using compressed air.

  Resources:

  Reduce heat and the fan noise by cleaning the air vents

• Droid Ultra restart loop when charging

  Hello! Yesterday, my phone started acting very unusual. I had plugged in the charger while I was about to leave and was SMS market while it load. I looked at more than a minute and noticed that it was reset. He reset continuously in a loop until I took it from the charger. I tried another charger because one I used was not charging my tablet, and while the new charger charge my tablet, my problems with my phone reset still persist. In addition to this, my phone will also to sleep in just a few seconds of inactivity, which started yesterday. Is this a battery problem caused by my defective charger? What, if anything, can I do to fix this? I'm not the primary account holder, so it is difficult for me to communicate with Verizon and I don't know if I have a warranty. Thanks for the replies.

  EDIT: It seems now only be reset if I use it for more than a few minutes at a time during loading, but its good if his sleep and load. Last night I left it on the alarm this morning and the alarm has not extinguished because my phone turns off during the night.

  Can you tell me what percentage of your battery is that it is set to zero? If it is full, I would try either safe mode to see if that solves your problem, because if is there is an application that is the question.

• Chromebook 14-q015sa mouse pointer jitters when charging

  Hello

  CAN ANYONE HELP?

  I HAVE A NEW HP CHROMEBOOK BOUGHT 14 AT HP SIX WEEKS AGO.

  I ONLY GOT TO LOAD SEVERAL TIMES BUT EVERY TIME I PLUG IN THE CHARGER AND PUT THE FINGER ON THE TOUCH PAD THE ARROW/POINTER JITTERS AROUND THE SCREEN RANDOMLY.

  I RESORTED TO THE USE OF A WIRELESS USB MOUSE WHILE LOADING AND IT DOES NOT SUFFER THE SAME PROBLEM.

  ANY IDEAS? OR SHOULD I CONTACT HP I HAVE A THREE YEAR WARRANTY.

  Thank you very much.

  Hello Brioche-e-rabbit,

  Welcome to the HP Forums!

  I understand that your Chromebook is problems with the touchpad when charging. To be honest, you are more likely to have a hardware problem. Chromebook does not have a list of hardware drivers for me to direct you, so your best bet, as you already said, would be to contact support phone for service options. You can contact HP Technical Support at 1-800-474-6836 in North America. For all other regions click here.

  Hope this helps!

• I can change the settings on my netbook so that it is not "off automatically" I need a constant power when charging my flip camcorder

  Original title: changing the settings!

  I can change the settings on my netbook so that it is not "off automatically" I need a constant power when charging my flip camcorder

  Hello Christina MacInnes,

  Please visit the links below with respect to the power settings.  It's for Windows 7, so please let us know if you are using a different version.

  Power Managemnet

  http://Windows.Microsoft.com/en-us/Windows7/products/features/power-management

  Change, create, or delete a power plan (scheme)

  http://Windows.Microsoft.com/en-us/Windows7/change-create-or-delete-a-power-plan-scheme

• I'm Zenith one 733F error Code when I try to install Windows Vista update to SQL Server 2005 (Service Pack 2 KB970895).

  I'm Zenith one 733F error Code when I try to install the latest Windows Vista Update, which is an update to SQL Server 2005 (Service Pack 2 KB970895).  This update has failed several times now.

  I followed the advice given in a separate post in this forum at Ramer49 to perform a selective startup with msconfig to try to run the update with all Microsoft Services disabled.  This does not solve the problem.

  I spent reviewing the logfile under C:\Program Files\Microsoft SQL Server\90\Setup Bootstrap\LOG\Hotfix\SQL9_Hotfix_KB970895_sqlrun_sql.msp.log.  The problem highlighted is that the Services of Services SQL2005 database program did not start.  Here is an excerpt from the log file...

  Product Installation status
  Product: SQL Server Database Services 2005 (MSSMLBIZ)
  (Previous) product version: 3077
  Version of the product (Final):
  Status: failed
  Log file: C:\Program Files\Microsoft SQL Server\90\Setup Bootstrap\LOG\Hotfix\SQL9_Hotfix_KB970895_sqlrun_sql.msp.log
  SQL Express features:
  Error number: 29503
  Error description: error MSP: 29503 The SQL Server service could not start. For more information, see the

  I tried to run the problem file (SQL Server MSSMLBIZ) directly by using the Windows administrative tool, but the file does not seem to start successfully.  Event Viewer log contains an error with event ID = 823.

  I don't know what to do next.

  Can someone help me?

  Thank you.

  Take a look at this link as it covers a way to fix this problem. Mike - Engineer Support Microsoft Answers
  Visit our Microsoft answers feedback Forum and let us know what you think.

• all my desktop icons are windows mail, so when I want to open any mail arrives

  all my desktop icons are windows mail, so when I want to open any mail arrives

  Use this tutorial:

  Restore the file type associations
  http://www.Vistax64.com/tutorials/233243-default-file-type-associations-restore.html

  Scroll down to exe - executable application files.
  Click on the exe

  Follow the instructions in #1 à #7 at the top.

  Scroll to lnk - shortcut link (LNK) files.
  Click on lnk

  Follow the instructions in #1 à #7 at the top.

• HP Dm4 1201tx grounded body when charging

  I have a problem recently my computer hp dm4 1201tx laptop is connected to the earth when charging. You can feel its aluminum body is everything is connected to the earth when you touch it.

  Please help I can't understand why this is happening and im using this laptop for my work, so it's very important.

  Note:

  my hp warranty has expired.

  using windows 7 64 bit.

  Thank you more hp of power.

  Hello mrnotepad,

  Take a look at this document, and please let me know if the troubleshooting steps help solve or identify the problem.  Please let me know what you find.

  Good luck!