Satellite U400-150 - always needed, even to start supervisor password

Similar Questions

• Re: Satellite U400-20V PSU44E - need for Win XP drivers WLan and sound

  Hi all.

  I have download the drivers for windows XP for this laptop Satellite U400-20V PSU44E-05300GAR, but the problem is the wireless don't work and his driver.

  I have download several times because I think to choose the correct driver, but the problem even if I need help

  Thank you all

  Hello

  As far as I know the laptop uses Intel WLan 5100AGN map and audio chip Conexant CX20561.

  The WLan driver can be downloaded here:
  http://APS2.toshiba-tro.de/WLAN/

  Audio driver can be downloaded from the page of European driver of Toshiba.

  It is important that you install all service packs of Microsoft and patches before install you the audio driver.
  SP3 must be installed before you try to install the audio driver.
  SP3 contains necessary fixes that are important.

• Satellite U400 - 150 (PSU45E) - ALPS touchpad problem

  Hello

  I am trying to solve some problems with the touchpad. My PSU45E Toshiba U400-150 was fitted in ALPS touchpad (synaptics, which is much better from day instead).

  Previously I worked on another laptop to factory with Synaptics and software that he had advanced options, better than the ALPS.

  1. when I use ALPS driver that the coursor movement seems to be "nervous", do not help the traffic regulations. So I uninstalled the driver ALPS, Synaptisc and the movement has been widely. However, the Synaptics software had any advanced options (such as the areas of contact, scroll, etc.). So I restored the ALPS driver, once again, and returned "jumpy" movement. I assume that the driver is not as good as synaptics.

  2 I need in fact for the middle button emulation. In synaptisc, there was this option in the "contact areas". I was using the upper right corner for the emulation of the middle button of the mouse. I was looking for such an option in the ALPS driver, but there is none.

  I woud be gratefull for any sollutions, suggestions about the issue 1 and 2. Is it possible to emulate the middle button of the mouse in the ALPS?

  TIA.

  I have a touchpad Alps on my Tecra and its very good, so maybe you just need to update the driver Alps?

  Using XP or Vista?

• Satellite U400-10W (PSU40E): need of BIOS to fix the battery problem

  Hello

  I already have a Satellite U400-10W (PSU40E) with the issue reported in the technical knowledge base (the battery is not recognized and does not load after a long period without power).

  To solve this problem I need a bios or above 3.0 but the latest available bios (4.00 - bios - 20090430082154.zip) in the download page refers to an invalid link.

  Please is - someone has a bios (version 3.0 or higher) for Win32 poster systems?

  Thanks in advance.

  OK, thanks for this entry.
  I think there could be something wrong with the Server driver Toshiba European page
  I think it will be corrected in the next time lets hope ;)

• Satellite L850-150 will stop even if the battery is charged

  Good evening

  Since I've upgraded to Windows 10, the following occur:

  The laptop battery stops unexpectedly without warning the minimum level, even if the battery is charged
  I bought a new battery and it is exactly the same as the previous battery

  What can happen?

  Best regards and thank you

  More details
  The first OS is Windows 7
  I created two partitions
  In the second partition, I installed Windows 8
  After awhile, I installed Windows 10 on Windows 7 and also installed 10 Windows on the partition of Windows 8
  In the two bulkheads made
  The computer turns off when you do not have the power cord plugged
  Earlier in Windows 7 and Windows 8, it did not
  Help, please

• Satellite M100-150 blank screen sometimes on start/alarm clock

  My friend and I both have the same model of notebook M100-150. Windows XP is installed on two laptops. And it's very stange, but it is true that we have the same problem. Sometimes, when the os specifications, it no longer responds and white - black screen.

  If I power down/up for laptop, it loads normally. The BIOS on my laptop version is last 2.80 (updated 3 days without help). I think that there is something common in both cases.
  And one thing I can Imaging is the BIOS.

  Something wrong with it.

  Hi mate,

  almost the same discussion is here:

  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=23834&MessageID=87563

  If after reading this, I suggest the following before contacting an authorized partner
  (which can be found through this link: http://eu.computers.toshiba-europe.com/cgi-bin/ToshibaCSG/generic_content.jsp?service=EU&ID=ASP_SUPPORT)

  do a check of the system with "SuperPi" to check if the RAM and the processor are well and try to do a restore complete. Check for a new bios, regardless if you've ever watched.

  And then if after recovery and update all your drivers/tools/bios that did not really help, click on the link above and contact and ASP for more proceedment. (Maybe for a checkup of material and/or repair).

  Friends of good luck and good weekend

• Satellite U400 - light always at the lowest level

  I have a U400 - 15G (PSU44E). I bought with Vista but I installed XP.

  My problem is that everytime I restart the computer, the brightness is set at the highest level and I have to reset it each time because I prefer the lowest level. Can't I fix this somewhere?

  Hello!

  > Can't I fix this somewhere
  Yes, you should only install the Toshiba Power Saver for Windows XP.
  Here, you can set the level of brightness at full power (AC adapter) and battery modus. It s a very useful tool and I like it.

  Consult the Toshiba site to download:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  Good bye

• Satellite A660-10 x - need more information about the password in the BIOS mode

  Hello

  When I go to the bios there are Security tab when I have things like user password, password mode password hdd/ssd and supervisor + user password hdd/ssd.

  I have not found no documentation mode "password hdd/ssd" is for and what is the difference between 'User only' and 'user + Master' and how it works.

  Could you please give me some info, how does it work?

  Best regards

  Hello

  This is a password disk HARD useful summary:
  http://APS2.toshiba-tro.de/KB0/TSB6B01MC000CR01.htm

  _HDD password user and HDD Master Password: __________
  There are two levels of password of HDD, HDD user password and the HARD drive password. If two levels of HARD drive password have been registered, you can access the HARD disk by entering one of them. Password of TOSHIBA (TPU) utility supports only the HARD drive password. If you want to register both, open the CONFIGURATION of the BIOS. If the HARD drive password has been saved, the drive HARD master password cannot be saved

  I hope this helps a little

• Need help with the supervisor password

  Dear support,

  I would ask you for help. I have a Toshiba Tecra M5 laptop and 4 years when I install it for the first time, I wonder "supervisor password". I entered my private password and everything was fine. Now, I want to change my internal HARD drive. After upgrading the HARD drive I wonder the supervisor password in a black screen directly after pressing the power button. The problem is that the suppervisor password was entered in windows mode using some Czech special characters "?" (the password is containing these characters). The portable wonder for the supervisor password using a 'back' as intrface - black screen and the blinking cursor and I'm not able to enter these characters Czechs. Can you help me how to do? I'm not able to work with my laptop.

  Best regards, Jan

  Hello

  you have the old hdd to replace to remove the password and replaced by a new one, at this time there?

• Satellite U400 - how to remove the HARD drive password?

  Hello

  I have Toshiba Satellite U400-PSU40E. I put the HARD drive password to test this optoins in BIOS. It woks fine. After that, I remove the HDD password, but when BONES start to start the fist show me black sreen with password and when push enter Os start at startup.

  How to remove this black screen (password disk HARD is clear) before you set a password it is not this black screen?

  Hi iliyan_84,

  You only set the HARD drive password or another password too?
  Normally the HARD drive password can be removed in the BIOS. Therefore, to set a new password and don't enter all the keys. Just press the Enter key to leave the new password disk HARD vacuum box.

  Try to also load default settings in the BIOS and if it doesn't work, you must update the BIOS. You can find the latest version on the official website of Toshiba.

• Satellite U400 - reset BIOS password

  Hello

  Is it possible to reset the BIOS password on my Toshiba Satellite U400 laptop?

  My friend changed my password in the BIOS. And unfortunately he forgot.

  Any ideas?

  P.S.: I don't want my laptop disassembly and clear the CMOS settings by removing the CMOS battery...

  Hello!

  The BIOS password can be reset to the ASP.
  Sorry, but this is the only way.

  On the Toshiba site, you can search an ASP:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported downloads & => find an authorized service provider

  Good bye

• Satellite U400 - 12 p: multimedia button is always on

  Feather touch keys lights of my Satellite U400 - 12 p are always on even though I shut down and the battery is drained.

  Please give a solution to swithc fires from the pen of touchpad.

  Hello

  You must disable it in the BIOS!
  Access the BIOS by pressing F2 when starting the laptop.

  You will find the option called Illumination.
  Disable it and save changes.

  Here ;) this should help

• Satellite U400 will not usually start upward

  Hi all

  I have a Toshiba Satellite U400-217 (PSU44E) running Windows 8.

  Worked fine until a week ago. Now, when I turn it on, the lights are, there is a memory hard drive spin (1 second) - and then nothing. Above the keyboard lights stay on, but the screen remains black.

  I read a use Reset where you take the battery and the power cable on and press and hold power for 30 seconds, then plug the power cable in, starting at the top, stop, reinsert the battery and start again.

  However, the machine still primer not after 30 seconds the hold button. I always get just the lights and nothing else.

  However, the machine will start usually fine on an attempt to out all 30 or more.

  It's boring - ideas or suggestions very welcome.

  Thank you very much

  KaiBosh

  > However, the machine will start usually fine on an attempt to out every 30 or more.

  In my opinion, you should first check the HARD drive
  A friend of mine installed Win 8 on the new computer laptop from another manufacturer
  After a while that the laptop will not start I thought its something wrong with the card mother, but in the end it was just a HARD drive failure

  To be honest I n don't know if his only problem disk HARD but in my opinion, the HARD drive is one of the first pieces that need to be checked
  OK, in the worst case, it could be possible that dysfunction of this mobo.

• TrueSuite Access manager needs fingerprints - Satellite U400 driver

  Hello

  Whenever I start my new Satellite U400, TrueSuite Access manager says that the drivers are not installed for the fingerprint reader and try to install them again. Even after I install TrueSuite Access Manager, he asks me to reinstall the driver. I'm currently ignoring this but it bothers me.

  "TrueSuite Access Manager on Portege M700 - 13P"asked the same question and answer. But I did not understand what means TPM.
  > Okay - it just stopped.
  > I installed the TPM secure and the problem disappeared...

  Can someone help me?
  Shinya

  Hello

  On the European driver Toshiba page, you will find a new v-Fingerprint Software 7.10.1.2
  Remove your old software from the system. Then clean the operating system using the CCleaner (it of free). Reboot several times, and then install the new fingerprint software downloaded.

  Work

• Unable to start my laptop Satellite U400

  Hi all

  After the installation of windows Vista Home Premium in my laptop Satellite U400 series and new partion Recovery created in what, I restarted my laptop and found no screen after the SCREEN TOSHIBA "LOGO". not even access the CD Rom drive, I tried all bootable drives.

  One! Kindly help me.
  The BIOS update will solve this problem?

  Thanks in advance.

  Hello

  You are able to access the BIOS?

  > The BIOS update will solve this problem?
  How you want to update the BIOS if you n t nothing appears on the screen?
  You'll have to start in windows to update the BIOS on this U400!

  Please connect an external monitor to the laptop and check if something wouldn't be visible on the external display!