Sleep mode, power supply compaq presario cq5300y windows 7 32 & 64 bit

Similar Questions

• Upgrading power SUPPLY Compaq Presario SR1403WM block

  I know this is an old computer and everything, but I'm always wanting to do some updates for her because I'm not getting rid of it for a while.

  So I was wondering what would be a compatible power supply for this computer. I'm looking for at least a 350 watts so that I could run easily 3 hard drives, a dvd burner and a Radeon X 1300 XT.

  If you know if this card will work with the 250 that is in this computer with my other updates please tell so I don't have to worry about this.

  Since the computers original specifications I already changed to 3 320 WD HDD, 2 GB of RAM and an ATI Radeon 9550, while also removing the modem 56 k the 9 in 1 card reader and the original hard drive, CD burner and stick of RAM.

  The 9550 is just a little weak for me and the x 1300 will be able to hit the sweet spot. That is why I wonder about upgrading the PSU or the card will work with the current.

  Anyway thanks for the help in advance.

  Ok. Good ATX PSU brand will do. (Corsair / OCZ / Fortron / shut up!) Your motherboard uses an ATX PSU specification. With what you already have in your system, you should get a decent at least 450 Watts and ATX12V 2.2 EPS12V, modular, 80 more specs. Care like these will allow you to use it in a motherboard upgrade when you are ready

• Compaq Presario CQ5300Y desktop PC - memory upgrade

  Hello, everyone! I hope you are all well.
  
  I have a desktop PC Compaq Presario CQ5300Y, to which I would like to upgrade the memory.
  
  The product specifications indicate clearly that the motherboard, a M2N68-(Narra5), 2 x DDR2 memory media. (In addition, the amount of installed memory is 2 GB.)
  
  The product specifications, in the information section of upgrade memory also mention the following:

  -----------------------------------------------------------------------------

  Dual channel memory architecture
  Supports two DDR2 DIMM (240-pin)

  Supported DIMM types:

  PC2-5300 (667 MHz)
  PC2-6400 (800 MHz)

  Memory non - ECC, unbuffered
  Supports DIMM DDR2 2 GB modules
  Supports up to 4 GB * on 32-bit PCs
  * 32 - bit operating systems cannot resolve a full 4.0 GB memory.

  -----------------------------------------------------------------------------

  I'm clear (with what the article said) I have only available two DIMM DDR2 2 brackets.

  "What confuses me is the statement" ""supports 2 GB DDR2 DIMM '. This is the reason for my question.

  "Supports 2 GB DDR2 DIMM" means that I have to use 2 GB DDR DIMM only, which means I can only go to 4 GB? Or could I use 4GB DDR2 DIMM, which breaks the barrier of 4 GB?

  In a few words, I would like to - at least - 8GB (assuming that I find two modules DIMM DDR2 4 GB). Would it be possible to have the above configuration?
  
  It is important to mention that the PC is running a 64-bit operating system.

  I would appreciate the attention he can draw on this issue.

  Best regards.

  Hello:

  Each slot of memory on the motherboard of your PC cannot accept that a maximum of one module of memory of 2 GB.

  1 x 2 GB will work.

  2 x 2 GB will work.

  1 x 4 GB will not work.

  2 x 4 GB will not work.

• Compaq presario c700 windows vista 32 bit lost all drivers and bootmgr but I have no discs to help me please

  do you have a factory reset on compaq presario c700 windows vista 32-bit lost all drivers and bootmgr, but I don't have any disks help me please

  Hello

  Here is the information of HP (Compaq) for recovery options for Vista factory settings.

  http://h10025.www1.HP.com/ewfrf/wc/document?DocName=c00809678&LC=en&DLC=en&cc=us&product=18703

  See you soon.

• Please help me find... Compaq presario f762au driver sound for 32-bit Windows 7.

  Please help me find... Compaq presario f762au driver sound for 32-bit Windows 7...

  Hello

  It makes no sense at all. Based on its support page, it uses "Driver Conexant HD-Audio SmartAudio 221" for Vista

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?OS=2093&LC=en&cc=us&DLC=en&sw_lang=&product=3689060#N189

  and now, he can not see for Windows 7:

  https://h10025.www1.HP.com/ewfrf/wc/softwareDownloadIndex?cc=us&LC=en&DLC=en&softwareitem=ob-75899-1

  Please, try the following methods:

  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows

  http://support.HP.com/us-en/document/c01912228
  

  Kind regards.

• Compaq Presario c300 - Windows XP Recovery disk is not hard drive

  Compaq Presario c300 - S/No: CND6441F50 Prod No.: #ABU - Windows XP Media Center RT150EA

  When you try to restore a new copy of Windows XP and after booting with a Windows startup disk, download to the point where you can select "recovery or install new ones.

  When I press F3, it gives a message that the hard disk is not installed and I should check the connections of power supply, etc..  However, I can run XP from hard disk. And I checked through 'System' that the h/d driver works fine?

  The laptop is 2006 and the disc does a lot of 'Beating' when even simple are requested - where the need to re - install Windows.  (Tried to frag!).

  Can anyone suggest something outside the upgrade? Thank you

  Did you run a self test on the hard drive? You said that you can run XP from the drive, but it runs well? Looks like to me this drive is defect and the cause of these issues. Here's how you can run a self-test: http://goo.gl/pVHxW

  Let me know if there going to fail the test.

  Thank you!
  Sean

• Compaq Presario 5140: Compaq Presario 5140 windows Installation

  Okay so im trying to install ANY OS I have windows 2000, windows xp and linux. which none will him past the installation phase. It copies everything on the hard drive, but it can not find the disk hard once it restarts to complete the installation. I tested all three memory banks and the ram installed in them it has lots of power and the 2 400 MHz pentium running a little hot, but is a very good. I can do it in the bios but it's no help at all as I can NOT configure the list of devices first start-up, it is simply not available. As indicated in the title is an older compaq presario 5140; around 1998. Please send me an Email with some pointers or help. and my God not spammed not me saying to empty all the thing in a trash can! I like the older computers.
  E-mail: [email protected]

  I found the answer myself. This applies to the Windows XP operating system to not initiate systems with blinking cursor error.

  as with any startup in the bios section.
  
  1 Startup Repair windows running with installation or repair disk and guest disk open command
  2 run the fixboot command
  3. run the fixmbr command
  4. run chkdsk /r /p command
  5. disconnect all IDE connections, then restart. This will update your bios.
  6. make sure that the HARD drive is plugged into the motherboard of the PRIMARY IDE connection.  to find out what he just plug in each IDE plug and restart it until it starts.
  7 replugin other ide connections you disconnected earlier.
  8. check the HARD drive and set jumpers as "cable select".
   
  and BAM enjoy the operating system start now.
  
  Thanks the guy who gave me the generic answer without doing a
  background on the system of the computer in question.

  ID give you a negative vote if I could.

• Power Supply problem when installing Windows 7

  So I'll keep this short and to the point. I was upgraded yesterday from Vista to 7. Has made all the necessary updates and restart before installing 7. While it was installing, I weppe out of the room, came back and my monitor was empty... Silly me, I thought it was a reboot during installation. Futher glance, the monitor is in standby mode and the PC itself has been disabled. I waited about 10 minutes and it was always off. So I hit the power button, and it will not turn back. Tried the flipping of switches, different cables. Even called tech support, to get your warranty has expired and its $ 99 for me you tell the problem... Then he became the Lady on the line, telling me something I already knew... I got a power supply problem and I had to mapy 340.00 to repair... My question is this... It was just the stars lining up properly and my diet is to bite the dust while I have been upgraded or is there more behind it?

  http://social.answers.Microsoft.com/forums/en-us/w7install/threads

  "Download Windows 7 installed and activated on your PC."

  They will help you in the Windows 7 Forum at the above address.

  See you soon. Mick Murphy - Microsoft partner

• Compaq Presario SR5605UK: WINDOWS 10

  Hi, actually I bought a downloadable version for windows 10, and I was wondering how can I do to set this up? I have a Compaq Presario SR5605UK sound very old desktop PC, and when I put my disk in my computer, I press the name of the file, it says that it cannot install it? Like what I'm doing! Im stuck and I tried all night! His dribing me crazy! Help, please.

  Hello:

  You may need to transfer the ISO file downloaded to a flash, DVD, or USB drive, but you can not just copy and paste it here.

  Most people use this tool to do.

  https://www.Microsoft.com/en-us/download/Windows-USB-DVD-download-tool

• missing Ethernet controller driver - compaq presario running windows 7 32 bit - HELP

  Hello. I have a Compaq Presario CQ5700Y desktop PC and recently installed a new version of Windows 7.  Now, I don't have a driver for the ethernet adapter. Looking for everywhere. HP website offers only one for windows 7 64 bit and mine is 32-bit. According to my device manager, my hardware to ethernet controller id is the following:

  PCI\VEN_10EC & DEV_8136 & SUBSYS_2AB7103C & REV_05

  PCI\VEN_10EC & DEV_8136 & SUBSYS_2AB1703C

  PCI\VEN_10EC & DEV_8136 & CC_020000

  PCI\VEN_10EC & DEV_8136 & CC_0200

  Any information would be appreciated, as I am going nuts with this thing. Thank you.

  Hello

  Unzip and install:

  FTP://WebUser:[email protected]/CN/NIC/Install_Win7_7089_09222014.zip

• Drivers Compaq Presario v3250au windows xp

  Hello

  I need Windows XP drivers for my Compaq Presario V3250AU laptop. The serial number is [thank you for visiting the Forums from HP Support. I'm sorry to inform you that your message needs some changes to remove personal information].
  .

  Thanks in advance

  Gordy

  Published on page V3000Z CTO XP drivers work on your laptop:

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?OS=228&LC=en&cc=us&DLC=en&sw_lang=&product=3180330#N898

• Compaq Presario 2700 windows 7 CD/DVD/RW problems

  Hello, I have a laptop Compaq Presario 2700 and it won't play all the discs in the cd rom. It WILL eject it and try to load it because it I can hear and see turn but then my computer tells me to insert a disc. Windows Media player and Nero all say the same thing. Ive updated all drivers and my computer says there is NO problem. However my smart, family of Mobile Intel 965 express chip card is having issues ive uninstalled and reinstalled and nothing works. I seatched my computer and before I upgtaded for Windows 7, the smart card has a chipset 945 express. Help! I love my rock ' n roll and burning cd and its been almost a year without my cd/dvd. Thank you very much Karen

  When you insert a disc, you are able to view the data on the drive in Windows Explorer?  Since you have attempted to load the non - RW disks and still nothing happens that looks like it could be the drive itself.  Did you go to the Web of Compaq site to check for the latest drivers, firmware and any type of updates?

• An on-screen volume indicator has disappeared from the Compaq Presario running Windows 7

  I have a Compaq Presario CG56 with Windows 7 64 bit.  All of a sudden the volume display on the screen (NOT the taskbar icon) does not appear when I adjust the volume.  I don't change anything on the computer.  Any ideas?

  Hi again,

  If you do not want to install / uninstall anything, then you can restore your system to the point where you remember that visuals work ok.

  Resources:

  How to do a system restore in Windows 7

  When it will not work then you will need to use the solution to my previous answer.

• The fan on a Compaq Presario CQ57 Windows laptop settings

  Hello, I have a Compaq Presario CQ57 and the fan runs all the time at full speed. I opened the laptop and did a fan and cleaning of the motherboard, I applied thermal paste, I changed in the bios the option #Fan always on # Enable to disable, I updated the Bios but still nothing... it sounds like a jet of fighter.should I change my fan? someone who has a Council?

  I already ordered the fan and I will keep you posted as soon as I get it and install it.
  Thank you very much

• Power supply Compaq SR5010NX

  Currently I still have the original power of 250W and I was wondering what I could spend it with. I want at LEAST 300W PSU. I just need to know what might work. And if possible suggestions. Money is a bit weak at the moment.

  Thanks in advance.

  All that matters is the size of the power supply. Most of the HP desktop PC contain power supplies ATX 6 inches (15.25 cm) x 5 inches (12.7 cm) x 3.25 inches (8.25 cm).

  If possible go to 350W, I'm sure that the price difference won't be much.