Try a laptop through a desktop computer wireless network. Office uses a USB plug for internet access.

Similar Questions

• Impossible to activate the laptop on Windows 7 computer wireless network connection

  I'm not able to activate my wireless network on Windows 7 laptop connection. I have Atheros AR928X Wireless Network Adapter and I am unable to connect wireless. I was able to connect a few weeks previously, but now my Wireless Network Connection is still "NOT CONNECTED", I called my local router support and they said that everything is good on both sides and that my settings of the adapter or the driver must be on off somehwere. Help!

  * original title - impossible to activate the wireless network connections to connect to the internet with Windows 7 and Atheros AR928X Wireless Network Adapter on laptop.*

  Hi djmoore20,

  See the following article with information and troubleshooting on your question:

  http://Windows.Microsoft.com/en-us/Windows7/setting-up-a-wireless-network

  I hope this helps!

  Debra
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• Pavillionp 6601f: can I put on my windows desktop computer wireless network card 7 HP p6601f

  Can I put the network card wireless on my HP model of office p6610f on windows 7 64 bit to get the best wireless connection?

  VJP2002, welcome to the forum.

  According to the Product Specifications for the computer, it came not with a wireless card installed.  However, you can add a.  Here is a card that should work for you.  It uses the technology of KT (Gigabit).  This means that your router must support AC.  However, it supports 802.11 a/b/g/n.  There are 3 PCI Express x 1 slots on the motherboard.

  There are other options, for example, wireless USB adapters.  You don't have to open the case and install them.

  Please click on the button + Thumbs up if I helped you and click on accept as Solution If your problem is resolved.

• Issues with Dell desktop computer wireless and D-Link wireless network card. Only able to get wireless access by checking "Use Windows to configure my wireless network". This kind of file sharing impossible.

  original title: can't see the computer on wireless internet!

  I hope that's not too much detail, but I would like that the sequence of events to be clear...

  I have a Dell desktop computer that's probably six or seven years now.  It did not come with a wireless card, so I bought a DLink router and combo card wireless, install both with the DLink software.  It works beautifully.

  Later, we through my rep AT & T DSL, I got a Motorola modem/router with wireless capabilities.  I had plugged directly on my computer Dell desktop and moved to a Dell laptop DLink wireless receiver.  No problems.

  The Dell laptop is dead and the DLink receiver has not been used for a long time.  Family of my daughter moved to our place, and I have connected his desktop computers and laptop to wireless internet, using the Windows Connection Wizard.  Still no problem.

  I got a new ASUS laptop, I also linked using the Windows Wizard.  STILL no problem.

  Now, here's the problem comes.  I moved the Dell desktop computer, connected the DLink wireless receiver to it and I am able to get wireless access ONLY when I go into the properties of PC, click the wireless networks tab and check the "use Windows to configure my wireless network" box.  Then I can connect correctly, but I don't see this computer on my wireless network.  Bad luck... because I want to be able to access share files.  When I try to connect using different assistants of Windows, I get a message to the effect that, if I used another software to connect to the program, I can't use the Windows Wizard.

  So, what can I do to remove the original configuration of DLink completely and to connect to my wireless network using the wizards in Windows?  I uninstalled the software of DLink, but it seems to have no effect at all.

  BTW, Dell desktop computer is running XP, office computer of my daughter is running VISTA, and two laptops are equipped with Windows 7.  I can see all the computers on the network with the exception of the original Dell desktop computer wireless.

  Any help would be appreciated!

  Hi Joe and DonnaLoth,

  The network will have to be changed to allow the computer Windows XP join a workgroup.

  How to change a computer name, join a domain, and add a computer description in Windows XP or Windows Server 2003

  You can also read the following article.

  Networking of computers running different versions of Windows

• Hello, a license can be used on my two computers: my laptop and my desktop computer?  Send Message

  Send Message

  Hello, a license can be used on my two computers: my laptop and my desktop computer?

  Send Message

  Send Message

  Send Message

  Send Message

  Yes, you can install it on as many machines as you want.  Of these machines, you can have two of them signed use.  Of these two, you can only use the subscription on one at a time

• Hello, I have a question, if I already paid for Adobe Creative Cloud (including all Adobe Applications) and I installed it in a desktop computer in my office, I might as well install in my laptop at home? Or should I uninstall it in the transfer Office

  Hello, I have a question, if I already paid for Adobe Creative Cloud (including all Adobe Applications) and I installed it in a desktop computer in my office, I might as well install in my laptop at home? Or should I uninstall it in the desktop to transfer it to my laptop? Thank you

  Cloud license allows 2 activations http://www.adobe.com/legal/licenses-terms.html

  -Install on a 2nd computer http://forums.adobe.com/thread/1452292?tstart=0

  -Windows or Mac has no importance... 2 on the same operating system or 1 on each

  -Two activations on one account CAN NOT be used at the same time (to be noted in the link above of the license)

  -An individual account is for one person and may not be shared with anyone else

• I need Exchange a license from a laptop to a desktop computer, how can I do?

  I need Exchange a license from a laptop to a desktop computer, how can I do?

  Hello

  Can I know what is the name of the application that you continue.

  If you gave the creative cloud subscription you can simply disconnect the laptop, download the creative application of cloud on the desktop and log in with your Adobe ID

  Thank you

• If I put pro on a laptop and a desktop computer?

  If I put pro on a laptop and a desktop computer?

  Hi B 26 c truck sales,

  Absolutely! The end user license agreement allows you to install/activate Acrobat on both computers.

  Best,

  Sara

• I use my MacBook Air as a desktop computer. Should I leave the charger plugged all the time or should I drain the battery and then recharge? What is the best for the battery?

  I use my MacBook Air as a desktop computer. Should I leave the charger plugged all the time or should I drain the battery and then recharge? What is the best for the battery?

  Keep the computer plugged in whenever possible.

  If you keep the computer always connected, make sure that at least twice a month

  Run it on battery until battery charge level falls to about 40-50%.

  Please don't completely discharge the battery. Discharge the battery completely will reduce wear and tear on the battery.

  For more information:

  Section: To optimize the battery life

  http://support.Apple.com/en-us/HT204054

  Citing at the bottom of the linked article.

  "The question is often asked:" should I disconnect my laptop from the mains when not in service? Under normal circumstances it should not be necessary because as soon as the lithium-ion battery is full, a properly functioning charger will stop the load and load the pad will only engage when the battery voltage drops to a low level. Most of the users do not remove AC power, and this practice is safe. »

  http://BatteryUniversity.com/learn/article/bu_808c_what_the_user_can_do

• I can't connect to the Internet via the wireless network. It shows that I have local access only. I can't connect even in SafeMode with network.

  I can't connect to the Internet via the wireless network. It shows that I have local access only. I can't connect even in SafeMode with network.  I have Ping www.microsoft.com and the answer is "ping request could not find host www.microsoft.com.  I am connected to the network wireless through my iPad and can connect via my smartphone. This leads me to believe there is only something configured properly on my laptop. Can anyone provide assistance?

  Hello

  You can try a system restore...

  http://Windows.Microsoft.com/en-us/Windows-Vista/system-restore-frequently-asked-questions

  .. .choose time, until this problem (you may tick to show more older restore points).

  Tricky

• When I connect my computer to the Netgear router, they do not seem to recognize the signal from the modem. I have to run each device directly to the modem (one at a time) for internet access.

  I have both a laptop and a desktop computer and use a modem wired high-speed internet.  I bought a router "Netgear" 5 port so that I could have both online at the same time, but when I connect my computer to the router, they do not seem to recognize the signal from the modem. I have to run each device directly to the modem (one at a time) for internet access. It gets very tedious, please help...

  Original title: router does not work...

  Hello

  Welcome to the Microsoft community.

  I see that when you connect multiple computers using the Netgear router, it does not recognize the signal from the modem.

  You must contact the ISP to verify if they can help you with this question.

  In addition you can keep these items handy, it might help you.

  Set up a wireless router

  http://Windows.Microsoft.com/en-in/Windows7/set-up-a-wireless-router

  Install or remove a modem

  http://Windows.Microsoft.com/en-in/Windows7/install-or-remove-a-modem

  Change modem settings

  http://Windows.Microsoft.com/en-in/Windows7/change-modem-settings

  It will be useful.

  If you need help with Windows, let know us and we will be happy to help you.

• How can I add/install a new application Adobe Creative cloud on my computer? My Department uses VIP device licenses for education.

  How can I add/install a new application Adobe Creative cloud on my computer? My Department uses VIP device licenses for education.

  I have a set of applications Adobe CC that comes from a package installer. A new plan should be created just to install the additional application?

  What update of applications (for example, the transition to the latest version of Adobe first Pro 2014)?

  I'm sorry.

  Applications must be made through Packager only.

  You can create packages for them, if you wish.

• How to navigate through the file to the blackberry playbook using Tablet blackberry OS for Adobe Air SDK

  Hi all

  How to navigate through the file to the blackberry playbook using Tablet blackberry OS for Adobe Air SDK.

  And also I want to download this file on the server.

  Help me by providing examples of coding.

  Thanks in advance.

  With respect,

  Sébille C

  Here are some tips to help you get started.  It all depends on the terms that you use for your search.  For the first, I would use "adobe air browse file."  For the second, I start with only a variation as "adobe air download file" and then adjust according to the first results.

• my laptop will not find my wireless network when I'm trying to relog. I then reboot the computer to make it work

  I can be on my laptop and the internet works fine, but if I close my laptop and come back, sometimes it will not open a session. When I try to connect to a wireless network, it will appear not all networks at all and I live in a condo and I usually pick mine as well as a dozen other choices. The laptop won't restart when I try to shut down or restart, it just goes in the part of the judgment of the process, but goes no further. I have to manually hold the power button to shut down the computer.

  Hello

  Maybe this can help.

  Assuming that the signal is strong, and that there is no noise in the electrical environment (http://www.ezlan.net/wbars.html ).

  Uncheck the box to the NIC of energy economy (I.e., do not leave the card save energy).

  There may be some variations on where is the energy saving setting.

  Here are a few examples, YMMV, look around your systems.

  Example, http://www.ezlan.net/example/powersave.jpg

  Example, http://www.ezlan.net/Win7/power_sav_wireless..jpg

  Example, http://www.ezlan.net/Win7/power_save_win7.jpg

  Example, http://www.ezlan.net/Win7/adv_power-sav.jpg

  ----------------------------

  Still a problem?

  Check support for the router and make sure that your using the latest firmware for the router.

  Check the support site for the manufacturer of the computer and make sure that you use the latest drivers.

  If the support site has a newer version of the drivers and installed current ask drivers the most up-to-date drivers use this method.

  Download the drivers and extract them to a folder of your choice.

  In Device Manager, right-click on the adapter.

  Click Update drivers and choose her browse my computer for drivers.

  Choose let me a list of choices, click on disk and point to the folder with the drivers.

• Hi, I Picture IT 2000 on an old computer laptop and I want to load it on my counter top. How can I load it from my laptop to my desktop computer?

  My laptop is a Dell Latitude CPX.  I want to transfer the program to my desktop computer.  I have to connect to get there?

  Hello

  If you have the Setup file to install the program, you can copy it to a USB stick and install it on another computer. You can also install the program by using an installation disc. If you do not have the configuration file, you will not be able to install the program.

  Thank you.