XE satellite 3000 - display replacement catch cover.
I wonder if someone can help me.
I have a laptop Toshiba Satellite XE3000 that needs a new TFT "clip." Its the one that holds the screen as well as the bottom of the laptop.
Its only which is held in the body of the screen by two clips small peg plastic type and it has a spring on the item itself. Its one of the tweezers plastic that broke on my. The complete press in the clip part must be replaced.
The color of the laptop is pale grey in case someone found where I can get a part for it. I have been looking around but can't find anywhere who would do it.
I just need not cover the entire screen clamp.
Thank you
Hello, Neil
I put t believe that there are many options:
-Google all over the place. Maybe you will find some portable part offering
-Also check eBay. You will find laptops very often defective
-Contact the Service partner and try to order it if possible
-wait and maybe you will be lucky that some users of the Forum has this part for you.
Good luck!
Tags: Toshiba
Similar Questions
-
How to replace CMOS on Satellite 3000 514?
My laptop don't boot (even if power light turns on) and I suspect the CMOS needs to be replaced.
How can I open and replace in my Satellite 3000 514?
I tried to disassemble the back, but it got stuck.Any help?
Thank you.>... My laptop don't boot
This means you there is absolutely no reaction when you press the power button / stop? -
Module replacement satellite 3000 X 4 dvd
I can't find the list for the satellite 3000 X 4.
I'm looking to replace the module interchangeable dvd for a new or a combination if available. Can someone post a link to the right for one page please.Hello
as far as I know the Satellite 3000 - X 4 series was a series of country (maybe UK, but no responsibility)
If I remembered that it has the same chassy as other Satellite 3000 s, so it could be that it is modular Bay built in!
When you go on https://eu.computers.toshiba-europe.com - products - Options & accessories and to drive the unit you can find different Modular Bay offers. On the right site on the upper part is a rose with a compatibility status field.
There are also links to dealers!
I would advice to call the country based hotline where you bought the laptop and ask your safty!
Pete Bye
-
Satellite 3000-514: display dims
Hallo,
I got a Satellite 3000 514.
A couple of months ago, it falls on the floor and the broken screen.
However, I had another screen from ebay.
Unfortunately it wasn't a 3000-514, but a 3000-2xx.
It was no problem to install it.
When you use Notepad it always works for at least ten minutes about but she especially Gets a black screen.
I was wondering if it's because of the slitely different types or if there is something else broken.
Thanks for any help.Sven
Hello
If the screen does not show clearly the image therefore mainly the Fl inverter is responsible for this issue. But this is only a suggestion and it is necessary to check before replacing anything.
PS: FL inverter is not very expensive.
-
Replacement of the rubber feet on Satellite 3000 - X 11
Hello
Anyone know where I can get 2 rubber feet of replacement for the underside of a Satellite 3000 - X 11? I spent ages by browsing the Toshiba site, but nothing useful coming.
Thanks in advance
JonHello
I believe you can also order it through eBay.
-
Line problem vertical screen satellite 3000
my laptop is Satellite 3000, it had vertical line problem now, I want to use an outdoor screen tube to replace the current damaged LED screen.
I tried to use the swap FN + F5 key, but it's still doesn't work, I tried to log into the system to check, ((windows xp) system is normal), but I don't see anything because the screen is black, it will not be in the system even if I have in connected to the local network, because the configuration of mobile network function is forbidden to communicate with the internet , (I ghost before it has completely damaged), the question is:
1, I have to configure something so she may use it outside the screen in windows XP? or just use the FN + F5 swap button?
2, how am I going to do next step if I want to use the external screen?
thx a lot
Hello
the first question you should ask is, if the machine works really well. This means that all THE drivers are installed and so on.
The other thing is:
When you connect the external monitor to your computer, you see something while turning on the machine? (Logo of Toshiba, Windows XP start screen, etc.).
Usually, you should be able to work on an external display, and if all drivers and tools (such as FN + F5-> change device display tool) are installed, then the "display" button should be possible.Please answer and describe if you see something that we can do some better troubleshooting.
Welcome them
-
Satellite 3000 x 4 connector broken, is it easy to fix and how?
Hi, I'm looking for Info for my sister. She has a Satellite 3000 x 4 but the connection is broken and must be replaced.
Initially, I was going to buy him a motherboard to work of second hand to replace the broken Jack but it's still very expensive. However, I have recently purchased a jack for his model similar to that as this http://texas-shopper.com/pcitems/tjack5.jpg because I read that the connector can be solved this way.
The person who will fix my laptop computer sisters has never used something like this before and is not familiar with it. If everyone is familiar or fixing these type of catch up then do it me know how you do it. If you know any good sites with instructions for this task then I will also appreciate if you have linked to them. I also intend to pass this info on the technician who will do the repair work.
Thank youHello
Unfortunately, I n t found any documents on the change of the framework. But I think that to replace this part you must remove all the covers and the keyboard of the device.
Also I don't know if the part about the photo is compatible with the motherboard and as far as I know it's not easy to replace the electric parts of m.In my opinion, you should ask the service Toshiba for the right part and education partner exactly. But the best way is to give the unit for service partner. They have more experience.
Good bye
-
Satellite 3000 - x 4 - battery flat
I took my old Satellite 3000 - x 4 out when she came back the battery was flat and would not charge.
I bought a new one on e - bay, adapt, and yet it's still flat.
It works on a/c very well.Is it possible that someone can stop charging the battery,
Do you think that the new battery is not good, or is it my s3000-Hi mate
First of all; are you sure that the battery you bought on ebay is ok?
There are a lot of strange people who sell a product that is not completely ok
So first of all, you must be sure that the new battery is 100% ok.If the battery is ok so I guess that part of the motherboard works bad maybe something wrong with electronic power supply
In this case the mobo has need to be replaced, but look, man. This isn't worth a try because a new motherboard is more expensive than good old classic, so I wouldn't recommend replacing the mobo
-
Satellite 3000-214 - Ctrl key keyboard does not
Hello
I started my old Satellite 3000-214 Notebook and suddenly my Ctrl key not working not.
I tried to clean the keyboard disassemble all the keys to it and clean the grates, without success.Can someone tell me where I can get a suitable keyboard: i in Germany.
It must be an original Toshiba keyboard or is it possible from another manufacturer?
How can I remove the keyboard of the laptop? What I have to open the case, or is it possible to get it out with a screwdriver or something?Thx for any suspicion!
Best regards.
TingHello
You must use the original Toshiba keyboard that is cared for and compatible with this laptop.
All parts and devices, you can buy the Toshiba authorized partner in your country. The database complete with ASP in the world, you can find on the page of European support of Toshiba.Usually, if you want to remove the keyboard to remove first the thin cover above the keyboard.
There are two screws holding the keyboard. After the withdrawal of these two screws, you will be able to set the keyboard.
But be careful; the keyboard is connected with the flat cable to the motherboard. -
Where can I buy a motherboard for Satellite 3000 514?
I need to replace the card mother (?), mother (?) on my Toshiba Satellite S3000-514.
Question: Where can I go to buy the motherboard?
Question 2: How much in pounds sterling can I expect to pay?
Thank you.
Hello
I found this site with the motherboard for a Satellite 3000 series but it seems that the Satellite 3000 514 is not listed.
http://www.sparepartswarehouse.com/Toshiba, Laptop, K000816560.aspx,I m not 100% sure, but I think that the 3000 series was delivered with the same motherboard.
But before you buy anything, you should ask Toshiba authorized service partner for a more details. Guys should be able to also order a compatible Board directly from Toshiba.I think you're on the good side, if you ask the opinion of the service provider.
But as you can see the motherboard is expensive and eventually you might find a second-hand surfboard.
-
Satellite 3000-514 and put to hard disk
Hello
I recently bought a new hard drive (Toshiba MK6026GAX, 60 GB) for my Satellite 3000 514. When I replace the old with the new hard drive is not recognized. The version of the BIOS is later (2,30 trad) from the side support Toshiba. Someone now how this could be fixed?
Thank you
ChristianHello
As Quad says no each HARD disk will be recognized because of the size.
You must contact the ASP for the drives supported. It has detailed information about the supported HARD drive sizes. But without a professional help s not possible to recognize the HARD drive.Good bye
-
Satellite 3000-514 does not start - 1-1-1-1 beep code appears
Hello
http://forums.computers.Toshiba-Europe.com/forums/images/bn_preview.gif
OverviewMy Toshiba Satellite 3000 514 starts each others time and gives me the following beep code: 1-1-1-1 (4 short beeps) and a black screen.
Does anyone know what this means?
This happens roughly every second time I try to start the PC. After l ' works again, it especially works again.Any ideas?
Thank you!
Hello
The beep code appears especially if the POSITION cannot be passed correctly.
If the problem is detected until the BIOS initialize the video card and the code cannot be displayed on the screen of the BIOS will play several beeps.
Each BIOS supports the meanings of the own beep codes. For example BIOS Toshiba beep code is not the same thing as "beep code" Phoenix BIOS.To my knowledge the Sat 3000 using Phoenix BIOS. In this case, you can try to search in the internet for a description of the code.
I found this site:
BIOS beep codesBut generally cannot solve this anomaly just average and I would recommend contact a technician with huge experience computer laptop.
-
Satellite 3000 - X 4: update BIOS
Attempt to upgrade the BIOS on Satellite 3000 - X 4 to help update BIOS downloaded 160 today. Using the method recommended (Windows).
Extract the files in the desktop folder and run the exe file. This runs request a diskette and continues when inserted. At the end of the writing process on diskette, a statement disc error error message and try a different disk. I tried 10 different lots disc every time the same mistake.
Use the method traditional, but cannot find my machine listed.
Can anyone help.
Hello
Satellite 3000 - X 4 is a UK machine, so I think that you can find the BIOS update TRANS on-site of the United Kingdom!
As far as I know the 3000 hs - X 4 a special BIOs that also needs a display updated driver at the same time!
I mean the BIOs upgrade was also to implement an update of displaydriver which must be run before a upodate BIOS can be done!Good bye
-
Satellite 3000-514: need FL inverter part number
Hello
I'm looking for a frequency for my toshiba satellite 3000 514 control, because my screen is almost black. Does anyone know where I can buy/order the it or what is the product number?
THX
ArneHello
Well, one of my friends ordered some parts of the Toshiba service partner.
I guess you can also order the EPA FL dimmer in your country.Remember that the FL inverter is not very expensive. But do you know how to change it? You have enough experience to replace?
I think that it s a very risky procedure because the entire screen needs to be removed. And you know; the screen is one of the most expensive parts on the laptop.
I think that if you n t be any technician if you ask someone who has more experience in these repair procedures. The best way is to ask the guy to service.
-
Satellite 3000-514: broke the backslash
Hello
I have a problem with my satellite 3000 514, the backslash key does not register in windows, back or any testing program. I've updated the BIOS, replaced the keyboard and it got me nowhere. I came to the conclusion that there must be something to do with the firmware of the keyboard as all other keys work and I can get a backslash to an external keyboard. It's almost as if he missed us firmware of the keyboard.
You used to be able to get the firmware of the keyboard in the bios, but apparently this is not the case now. Popular utilities or ideas.
See you soon,.
Steve
Hello Samuel
I think that James detachment is clearer when he wrote that it may be that this firmware has just ASP call them and pick up the news.
Result, you can post here. It may be useful for other users information.
Good luck!
Maybe you are looking for
-
OfficeJet pro 8600: streaks black copy cover page
When I make a black copy, the page is covered with many black streaks. I clean the printer heads. Color copies are ok.
-
The legacy program does not work in Windows 7
MD simple burner will not work on windows 7
-
I am running win7. Trying to get built in webcam to work. Help.
-
Media Encoder CC 2015.3 missing files during the export
Hi guys,.After the upgrade to 2015.3, I've noticed on several PP exports to ME that sometimes a video clip will not export. It will happen every time, lack the same clip or two with a certain sequence, and when I export directly from PP, the clip wi
-
1 convert to PDF and then restart the computer
I used Adobe Acrobat Pro 11.0 Win since January 2014 with no problems until recently. Now I am able to convert a file to PDF, but the next time I try, I get the error message "Adobe PDF creation cannot continue because Acrobat is not activated."After