Card for the FTP port number
I try to open port 21 on the router 831 for access to the FTP server. I added the two lines of fllowing.
access-list 10 permit 171.16.5.2
list of port 21 ftp port-map IP 10
But can telnet it. When the double configuration controls, I don't have 'list ip port-map ftp port 21 10' line. I added it again without error, but the line is not displayed. Here is the configuration. Any suggestions?
version 12.3
no service button
tcp KeepAlive-component snap-in service
a tcp-KeepAlive-quick service
horodateurs service debug datetime localtime show-timezone msec
Log service timestamps datetime localtime show-timezone msec
encryption password service
sequence numbers service
!
hostname ciscodmz
!
Security of authentication failure rate 3 log
Passwords security min-length 6
logging buffered debugging 51200
recording console critical
enable secret 5 $1$ o0ko$ hXk18FTwq076pCcnKY0LY1
!
username privilege 15 password 7 ciscodmz 00071A1507545A545C
America/Regina-6 timezone clock
No aaa new-model
IP subnet zero
no ip source route
synwait-time of tcp IP 10
IP domain name cisco.com
IP-server names 4.2.2.1
DHCP excluded-address IP 172.16.5.1 172.16.5.5
!
IP dhcp pool sdm-pool1
network 172.16.5.0 255.255.255.0
router by default - 172.16.5.1
!
!
no ip bootp Server
IP cef
audit of IP notify Journal
Max-events of po verification IP 100
property intellectual ssh time 60
property intellectual ssh authentication-2 retries
No ftp server enable write
!
!
!
!
!
!
!
interface Ethernet0
Description FW_INSIDE, ETH - LAN$ $$
172.16.5.1 IP address 255.255.255.0
no ip redirection
no ip unreachable
no ip proxy-arp
IP nat inside
route IP cache flow
No cdp enable
!
interface Ethernet1
Description $FW_OUTSIDE$ $$ of ETH - WAN
IP 68.17.43.208 255.255.255.224
no ip redirection
no ip unreachable
no ip proxy-arp
NAT outside IP
route IP cache flow
automatic duplex
No cdp enable
!
interface FastEthernet1
no ip address
automatic duplex
automatic speed
!
interface FastEthernet2
no ip address
automatic duplex
automatic speed
!
interface FastEthernet3
no ip address
automatic duplex
automatic speed
!
interface FastEthernet4
no ip address
automatic duplex
automatic speed
!
the IP nat inside source 1 interface Ethernet1 overload list
IP classless
IP route 0.0.0.0 0.0.0.0 68.17.43.193 permanent
IP http server
local IP http authentication
IP http secure server
!
recording of debug trap
record 172.16.5.1
access-list 1 permit 172.16.5.0 0.0.0.255
access-list 10 permit 172.16.5.2
not run cdp
allowed SDM_RMAP_1 1 route map
corresponds to the IP 120
!
connection of the banner ^ CCCAuthorized access only!
Unplug IMMEDIATELY if you are not an authorized user. ^ C
!
Line con 0
local connection
no activation of the modem
telnet output transport
line to 0
local connection
telnet output transport
line vty 0 4
privilege level 15
local connection
!
max-task-time 5000 Planner
Scheduler interval 500
!
end
ciscodmz #.
Yes if this is what you want to do and then the term you used and the command you used (ip port-card) are not correct.
If you want that the FTP entering the router to a public IP address to pass to a private IP address of the router, so I think that a static NAT translation would be the solution you need.
HTH
Rick
Tags: Cisco Security
Similar Questions
-
Who are the real or compatible cards for the Portege M750-109?
Hello
Anyone know who is the number of the actual card for the Toshiba Portégé M750-109?
I wonder if the PA3283U-1ACA iscompatible.
(15V) voltage and amperage (5V) are the same, but what about the decision-making that plugs into the laptop?Can someone explain the significance of the various characters in the nummer adapter?
For example, the difference between a (-1ACA) and a (-3ACA), a.s.o..For 200V cord, country differences are not a problem, I can get the power supply one another.
But I need the adapter and its taken low voltage to be compatible with the M750-109.
So, how do I identify what Toshiba cards are compatible?Thank you very much.
Supports the adapter used for Portege M750 * 15 Volt ampere 5 *.
You must use a power adapter that supports 15V too!
This is very important!The value of intensity can be a little different but too low because in this case the laptop would not get enough power!
> Voltage (15V) and amperage (5V) are the same, but what about the decision-making that plugs into the laptop?
The 15V AC adapter should be the same -
Select <; of the Listener Port number >; in which_table?
I am writing a SQL script which, among other things, disconnects from Oracle and then reconnects to the same instance under a different name. I'm able to query v$ database and v$ instance to get most of the information I need (host, name of service, etc.) for the part of reconnect. The only part that miss me is the listener port number. I could hardcode it 1521, but it's not very flexible. Currently, I am asking the user (who is usually me) for the listening port number in the SQL script, but that just seems a little lame. So my question is this: is there a view or a table somewhere in the schema sys that I could use to display the configuration of the earpiece? I work mainly with the gr 10, 2 + databases.No, I don't think that that is maintained in one of the views and is not soemthing that you should believe would keep have changed (if the implementation of the network people are good). In order to check once and you should be fine.
Aman...
-
Part number for the serial port in option HP Z420
I am looking for the serial port in option for the HP Workstation Z420, but in a datasheet, it is only mentioned as an optional serial port kit.
What is the number on the right side of the product? The same for the workstation Z400 was PA716A, but it was not compatible with the new workstation model...
I used the same part number, I used to model Z400 and it seems to work well.
HP code is PA716A. -
I need to replace my number of credit card for the monthly payment. What they suggest to do the update your credit card number does not take me anywhere. You is any phone number to call to speed this up?
Francosp
Ensure that EACH DETAIL is the same in all places, you enter your information
-in how to spell and punctuate the parts of your name and address
Change/Verify account https://forums.adobe.com/thread/1465499 can help
- Https://helpx.adobe.com/utilities/credit-card.html credit card
-or by phone http://helpx.adobe.com/x-productkb/global/phone-support-orders.html
-
Can anyone recommend a compatible 3G card for the Satellite P10
Can anyone recommend a compatible 3G card for the Satellite P10?
I tried to use a vodafone gprs card that the machine would not work with.Thank you
Hello
You want to buy a PC WiFi 3 G/GPRS card?
These cards use the PCMCIA port and should work on most laptops that provide this PCMCIA location.
I think you'll find many cards if you googel in the internet.Check it out and
-
Impossible communication with an electronic card via the USB port of the United Nations
Hello
I must communicate with a normal electronic card a mini-USB port / USB (serial, COM4). This card transmits on the airwaves on a frequency range that I must address.
When I plug, the PC detects it and accept it (I installed the driver). Plug-in the HyperTerminal in Windows XP to send instructions in hexadecimal this carte pour what change the range of frequency on which it issues.
Furthermore, neither MAX nor Agilent Connection Wizard not the detected and none are able to communicate with it, everytime the same message error "no device detected".
I tried under LabView to send instructions with assistant IIOA, no results. I also tried the instructions 'Config VISA' and 'Entry VISA', trying to write in hexadecimal and normal mode, nothing works. Under labView I have yet no error message, nothing. Nothing.
I don't understand. I know that it is still possible to drive it under LabWindows, but under LabView (8.5) nothing, not a clue.
I have the latest version OR-488. 2
Y ' have a procedure to follow pour such communication of?
Thanks for any help that would be welcome.
Kind regards
Zoe.
Hello
The NOR-488 driver. 2 is the driver for the hardware from National Instruments GPIB; If you communicate to the port of of a USB through, this will not impact your code or on the resources used. The only element in common with your VISA application EST enhancement. It provides a unified API pour different types interface with instruments (series, Ethernet, GPIB, VXI, etc...).
Under MAX, on cannot hole your communication card, only the serial port. The first chose to do is therefore to ensure that the serial port 4 is clearly visible under MAX. You can then the uti Test Pannel VISA pour send and/or receive orders to/from your card.
If these elements do not allow you to properly configure your hardware, n 'hesitate to send a capture d' screen of the configuration under MAX. If you have a CVI code that allows you to interact with the map, it might be interesting to join, so you can see how interactions with the material are made.
Kind regards
-
Can I use an I tunes card for the mini game on my I pad?
Can I use an I tunes card for the mini game on my I pad?
You should be able, unless you're an Organizer from family to family sharing (an organizer can not use gift cards). Buy the card on your account (this is the account that has downloaded the games on your iPad?): Redeem iTunes and Apple music gifts and codes - Apple Support
Purchases should automatically use the balance of your account
-
Simply cancel the payment I made on my Visa for registration and download. It's all about confusion. I'm in no condition to continue playing with this situation. Just cancel the payment or my credit card for the amount paid. $35 + I'll just just another browser.
Marie Heckel
Looks like you've been scammed. Firefox is a free browser that does not require nor payment or registration. Never download from anywhere but the official site:
Please report the offending on the following site:
You will have to regularize the situation with the one who took your money, or failing that, with your bank or credit card company.
-
I want to have my credit card business for my purchases and subscriptions and have our personal card for the rest of the family purchases. Is it possible within a group sharing family? If so, how it is configured?
I think it's only 1 card credit payment to the folder. However, family members may have gift or store credit which can be used for purchases. If you credit cards/store gift for their accounts, then they may use their purchases, Yes?
-
I have 6 which weighed charges on my debit card for the same Netflix subscription.
I tried to update my information to cc without success, I might add, and now I have 6 which weighed charges on my debit card for the same Netflix subscription. He has actually decreased my debit card that has sufficient funds, and I hope that I have that I extract only, the only time. Can anyone confirm if this has happened to them before?
Thanks in advance!
Whenever you add or change your payment information, you are likely to receive a temporary store operating load, your card issuer should remove in a few days or more: on the payment card's authorization in the iTunes Store - Apple Support
If the card is still declined, then the subscription will be not have been paid for. You can check with the card issuer to see if they are declining, or try another card (a card have a chance to be accepted it must be registered with the same name and address (including the format and spacing etc) that you have on your iTunes account and have been issued by a bank in the country where you are and which is therefore the country on your iTunes account).
-
Would like to know where I could buy packs of cards for the PC for the game Call of Duty.
Hi all
I would like to know where I could buy packs of cards for PC. It would be for Call of Duty: World at war, Black Ops, Black Ops II, war in advance and maybe even Black Ops III. Please leave a few links below if you have an answer. I thank very you much for your time.
Hi Alex,
You may need to use your favorite search engine to know the best site to buy packs of cards for the mentioned games.
Kind regards
-
Photoshop has been giving me the warning:
Photoshop has encountered a problem with the display driver and has temporarily disabled GPU enhancements. Visit the Web site of the manufacturer of the video card for the latest version of the software.
Also other programs are affected. I suspect a recent download of Adobe. Can anyone HELP.
No, it has nothing to do with updates of Adobe. There is a problem with your video card driver.
Go directly to the Web site of the manufacturer of the GPU for updates (not Microsoft, not a System Builder).
-
I payd with my credit card for the CC costumes... why can I only download trial versions?
Hi APS investment.
I checked your account and I see that you have subscribed for the creative cloud for teams in which you have a license that you have assigned to the same Adobe ID, but the invitation is still not accepted.
In order to activate the license, please accept the invitation of your receipt for the same email, then sign on the CC from Adobe and reconnect.
Sign in, sign out | Creative office cloud app
Kind regards
Sheena
-
Hi, just sign for cloud of plan monthly photoshop, has received a message from the Bank that I already paid with my credit card for the first month, but I received no email / can not see the plan when I open a session.
There is no serial numbers for products Creative cloud,
Sign out of Creative Cloud App and sign in the back once
http://helpx.Adobe.com/creative-cloud/KB/sign-in-out-creative-cloud-desktop-app.html
If the trial warning still appears, then make sure your hosts file once entries
Log, activation, or connection errors. CS5.5 and later versions
Maybe you are looking for
-
Full sync Ipod with your music library
How can I get my new iPod to sync with ALL the songs in my library. It is only synchronization with 96 about 1,000 songs.
-
Help me please! My Player CD does not write CD, but it can always clean CD - RW. What should I do?
-
Where can I find the clip board?
I want to free up memory. Where can I find the clip Panel to delete messages?
-
Hello I am trying to simulate a binary counter with the help of JK - FF 2 but is does not work. I tried another way, as the test 2 JK - FF with individual clock (clock 1 and clock 2) and LED (LED 1 and LED 2). When the clock 1 is enabled, clock 2 is
-
How to disable Windows Live updates
I recently switched from a mac to an Asus laptop. I use a prepaid wireless modem and had barely put credit on it to discover a set of 1 GB used within 2 hours of my PC doing the updates of Windows Live without my knowledge and my credit was gone, so