How can I put a device in recovery mode

How can I go in on iPad recovery mode

To put your device in recovery mode follow these instructions: If you cannot update or restore your iPhone, iPad, or iPod touch - Apple Support

Tags: iPad

Similar Questions

  • How can I put my system in Standby Mode?

    Hello

    I'm not able to put my system in stanby mode.
    How can I do?

    Hi Vikas

    You can try to do it on two tracks:
    Using the FN + F3 key combination
    Click Start > stop > and choose the Standby option

    Good bye

  • I can not fire first aid in Recovery Mode

    I upgraded to Sierra this afternoon. Because I'm disorder obsessive-compulsive, I ran first aid on Macintosh HD, despite the quite well running system. Said disk utility it found corruption, and should I run first aid in Recovery Mode. I restart, press command + R and go into Recovery Mode. I open disk utility, but I can't select "Macintosh HD" to perform first aid. It is grayed out.

    How can I select Macintosh HD in Recovery Mode to run first aid?

    When mode of recovery, that on the mac? (Apple menu, about this mac)

    have you tried r instead of command + R?

    You have a time machine backup drive? If so, can you boot option for that?

  • I often get frequent blue screens on internet sites. Blue screen too fast for me to record specific error message. How can I put an end to the blue screen to get the error message?

    frequent blue screens often to internet sites.  Blue screen too fast for me to record specific error message.  How can I put an end to the blue screen to get the error message?

    en blue screen too fast for me to record specific error message.  How can I put an end to the blue screen to get the error message?

    If your computer is restarted when the BSOD appears, then you must change the by default for what to do in case of system error. It is easy to do, but takes a lot of mouse clicks to get there:

    Start | Control Panel | System | Advanced system settings (need for credentials for the administrator to spend here |) Advanced | Startup and recovery / settings.

    On this screen, uncheck the box under system failure that says automatically restart. The next time the BSOD appears, your computer will not do anything else until you press the reset button, so you'll have all the time you need to read and copy the error codes. Paste here, verbatim, and someone should be able to point in the right direction.

    ``````~~~~`````

    In the control panel choose reports on problems and Solutions (problem of type in the START search box), go to historical problem, right-click your error and choose check for the Solution. You can also examine the details.

    In administrative tools, choose the reliability and performance monitor and click on MonitoringTools then the reliability monitor (type reliability in research on Start). This list is a chart of the software installs, uninstalls, updated Windows and crashes by date. See if your plant has started to happen after you installed or uninstalled something.

    It may be useful to eliminate equipment defects

    Type of memory in the search box of start and choose Memory diagnosis

    In a command prompt (type command in the start search box then right click and choose Run as administrator) type

    CHKDSK c: /r

    If you have more than one drive replace C: with the other drive letters.

    Search for corrupted files by typing at the command prompt

    sfc/scannow

    You can clean boot troubleshooting http://support.microsoft.com/kb/331796

  • How can I put text in front of a form

    Hello I have header and one line below. For the character as j, p, etc. the background is cut by the line; How can I put the text to be in the front of the line? I tried to bring the line.

    Thank you!

    Select your line segment and then organize menu: Section Masters: move Section Master object. This will put this line in the background on all pages, and your text will appear on the line.

    Alternatively, you can consider giving your line transparency more or less color darker, so that it does not interfere with the readability of your character chutes.

  • How can I put an icon on your laptop MAC Book Air - i.e. Facebook (for faster access)?

    How can I put an icon on your laptop MAC Book Air - i.e. Facebook (for faster access)?

    Drag it to your desktop.

  • How can I put a my signature on a text?

    How can I put a signature on a text?

    Hello. Do you mean the type of signature used by PDF files, or just a picture of a signature that is added to a document? Is the software you use to create the document?

  • How can I put someone other iCloud for my computer account? I'm on my mothers iPhone account and I don't have physical access to its features, nor can I explain to heehaw to do itself.

    How can I put someone elses iCloud account from my computer? I'm on my mothers iPhone account and I do not have physical access to its features nor can I explain how do it herself.

    No, but you can use a remote control program and do it yourself. Try Teamviewer, or similar.

  • How can I put Inbox emails in date order

    emails are obsolete order, how can I put them in order

    Click on the column heading titled Date. Click on Date again to reverse the sort order, if necessary.

  • How can I put ONLY 9 tabs, NO 15, on the new tab Page?

    How can I put ONLY 9 tabs, NO 15, on the new tab Page?
    (First OFF... Please do not read this as being written by an angry person.) I'm just frustrated with the browser that I liked for years. I hope someone can help me)
    For a long time, I had my Firefox (version 33.0.2 - even if I don't remember getting mentions "update") defined so that every time I clicked on the tab new symbol '+' to create a new tab (which has the "new tab Page" on that), the NINE inch nails would be shown for my SELECTION and PIN sites. I LOVED!
    Yesterday, I opened Firefox and NOW when I click on the '+' to open the new tab Page... FIFTEEN thumbnails appear, 5wide x 3down, (and to be honest I probably would have the habit of 15! ha).
    Here's the PROBLEM: NONE of the thumbnails are "compressed". They ALL have "liberated" up yellow icon to the left and clicking on does nothing to remedy this of course. Other that THAT, everything else behaves normally. (that is to say moving the thumbnails, deleting, swap... I just can't pin THEM!)
    FINALLY, I prefer my 9-repositionable decals on the new tab Page.
    I went through ALL the options on the side, upside down and backwards, and I just get more frustrated.
    Can someone help me?

    Hello

    If you can see all your tiles, you can change your settings in settings page:

    1. In the address bar, type Subject: config and press enter. The subject: config "this might void your warranty!" warning page may appear.
    2. Click on I'll be careful, I promise! to keep the comments: config page.
    3. Search for browser.newtabpage.columns and change it to 3, or however many columns you like
      • Note: browser.newtabpage.rows allows you to change the number of desired lines as well

    You can also set a fixed number of tiles with the following extensions:

  • How can I put it to delete messages on my server after download?

    How can I put it to delete messages on my server after download?

    To make a new folder that you go to the folder you want the new folder created under, in this case, the local folders. Click with the right button on local folders and select new folder.

    When moving messages in IMAP, you want to be offline, syncing Thunderbird/server is out of the picture, and then drag the messages from the existing to the new folder new folder and drop them there.

    If you hold down the CTRL key while that drag / drop, you will see a + signs seem to indicate that it will be a copy and not a gesture.
    You can also use the menu system and the Move To Copy To commands or if you feel better about that than the drag and drop method. It's under the Message in the menu structure.

    You must use standard selection methods to work with more message at a time.

    control a = select all

    Select item1, up or down several elements and hold the SHIFT key while selecting the point 2 = selects items 1 and 2 and all the items between the two

    Hold down the CTRL key while clicking random objects = select any element that is clicked on

    Hold down the CTRL key while clicking on a selected item = deselect this item

    I don't know what to tell you on the filters. I do not use IMAP or filters myself if I don't want to tell you bad.

  • How can I put files on my ipad?

    How can I put a folder on my desktop icons of file ipad in

    Do drag an application or the icon document on top of the other and take a break for a while. A new folder will be created containing the two elements. You can then name the folder as you please.

  • How can I put the tab on bottom bar in Firefox 29?

    Why did the subject: config browser.tabs.onTop. set to false no longer work. Is not acceptibale, unless I'm doing something wrong and it worked in the last version. Please answer

    You can also move the lower position with code tab toolbar in userChrome.css that basically, you just give a higher value to the tab bar of -moz-box-ordinal-group (more toolbars have a default value for - moz-box-ordinal-group: 1 to show them in the order of DOM).

  • How can I add a device of the anther

    How can I add a device of the anther

    Hello

    "If you paired with your Apple Watch but who want to use it with another iPhone, you can transfer your Apple Watch and its contents to your new iPhone.

    Instructions here > set up your Apple Watch

  • How can I add a device

    How can I add a device

    As it says in the article:

    iOS 9 or OS X El Capitan

    Devices with iOS 9 or OS X El Capitan appears in the list of devices, if you are connected to iCloud, iMessage, FaceTime, iTunes and App Store or Game Center on the device. You can also see your Apple Watch matched.

Maybe you are looking for