Lumia 520 bluetooth disconect after 5 seconds

Similar Questions

• cFP-PWM-520 drops out after 30 seconds. Power would be bad or controller?

  PSC 2110 with PWM - 520 5 s and 3 modules of CFP HAVE completely stopped working.  If I disconnect all the output channels and manually put them in MAX.  However, now I can't even by car out of a PWM, that after providing the voltage for about 30 seconds, all of the channels on this PWM switched off.  Cannot determine if this is the problem with the controller, or perhaps electric power is a failure.  Power supply shows a constant 24 volt.  I can reset the controller and then all 8 channels are specified voltage output for about 30 seconds, then remove from pan.  This system is used for lighting low voltage on a display of aircraft cockpit.  Any help appreciated.

  Hello Patricia:

  Updated the current drivers, and question still remained.  I have reformatted the memory on the controller of the CFP, reloaded the drivers and then started with the dip switch 6 on so no vi charge and everything behaves as it should now.  I believe that we can have a power failure or the power peak which occurred near this show, not sure.  But we are on the right track now.  Thanks for your help and your advice.

  Brad

• IPod touch sound stops after 10 seconds to watch the video of youtube

  IPod Touch 9.3.2 volume stops after 10 seconds while watching a YOUTUBE video. Continue to play video.

  This happen using the YouTube app?

  Or by using the YouTube site?

  Try it otherwise.

• C50-A-1HF satellite will turn off by itself after 2 seconds

  Hello

  the laptop turns off by itself after 2 seconds when I turn it on. This happens if I shutted down or choosed hibernate before (Win8.1).

  This means hibernation is not at all useable.

  The next time I turn it on it works quite normal! Sleep mode works as well. Standby mode it is ready for use after open them both as a repetitive. Fascinating!

  I looked on all the settings of the BIOS, but I found nothing what could be the reason for this behavior.

  Perhaps there is a correlation with another strange behavior. The battery will not be charged over 80%. I do not use the green mode. I have to turn off the laptop and remove the battery completely for a minute. After inserting and booting Win8.1 what it charges again at 100%.

  The discharge time is approximately 3.5 hours. Otherwise, the battery is ok.

  But after the next discharge up to 10% charge that up to 80% more.

  These two effects are not normal. But I don't think (or better, I hope) that there is a material defect.

  Is there a chance does not post the laptop to a repair service?

  Best regards

  Onurbi

  Hey man it are so strange problems and it's not easy to say what to do. All you can do is to install the original recovery image and test with the settings once more, of course without changing anything or install updates or additional applications.

  If possible to do this and test it for a while.
  > Is there a chance does not post the laptop to a repair service?
  As you probably know your possibilities to do something about this are very limited and if there is permanent problem I think you should contact the closest service Toshiba and clarify all of this.
  You have the new laptop model and it should work properly. If you are not happy and there are service problems Toshiba should take are about it and help you.

• Skype Audio / video call disconnect after 14 seconds in mac

  Skype Audio / video call disconnect after 14 seconds in mac

  1. call interrupted after 13-14 seconds

  2. cannot hear the caller's voice but may receive on my side

  3. I have reinstall the Skype delete old does not work

  4. even I have remove the whole mac and reinstall is the same question

  5 normal voices of Skype can hear I can do auduio / video on the face time

  so its means something wrong after that I tried everything I decided to inform Skype because I didn't even have no solution or anyone else have problem with that

  Finally I found the solution that my firewall was turned off, I just turn on and work and then I turn off again and its working fine but this solution that I found after post

• Skype on Sierra - after 12 seconds of appeal stands - I can't hear your voice.

  Hello

  I have a big problem with my Skype.

  After that 12 seconds of appeal stands - I do not hear voices, but my client hear me.

  I run echotest, but even call echotest of break after 12 seconds.

  The steps:

  Uninstalled SKYPE cleaner and installed the latest version - did not help.
  I uninstalled Skype cleaner installed an older version - it did not help.
  I changed the method / extra internet connection (cable and my LTE network)-did not help.
  I changed the settings, turn off and turned on the macbook, nothing--has not helped.

  Sorry for my bad English.
  Help, please.

  Best regards

  Simon

  I've solved a problem!
  Problem was in the firewall settings!
  Turn it off completely for a while. It helped!
  
  Topic that you closed.
  
  * For those who have problems:
  Please check your firewall settings after the update of the Sierra.

• After a second, a number of categories disappear from the website and I can't read more?

  1. Question

  After a second, a number of categories disappear from the website and I can't read more?
  For instantance that I am looking for a telefoonnumber, I became the address and number once a second number disappears

  If you have installed Skype extension disable it.

• opening app e-mail but in white, then closes after 20 seconds

  opening app e-mail but in white, then closes after 20 seconds

  Have you tried to force quit the mail app? Tap the home button twice. Browse the overview of messaging out of the screen to close, then single tap the home button to exit this mode.
  Try again.

  Alternatively, you can try to force your iPad to restart. Press the sleep and home for 20-30 seconds. When you see the silver Apple, release taken and let reboot then try again your mail.

• Tecra A3 battery stops the charge after a second or two

  Hello

  I used the computer without the battery for a long time. Now, when I try to use the battery it is completely empty (it shows 0% º capacity).

  It starts to load when it is plugged in, but after a second or two, he stops, so it keeps the ability to 0%.

  The problem of any ideas of what can be?
  Thank you

  Hello

  Are you sure the battery stops charging to 100%?
  How have you checked it? What is the status of the battery LED?

  If you plug the battery of the laptop must be turned off.
  In addition, the charge process takes several hours if the battery is empty.
  I think you should connect the AC to the laptop and several waiting time.

  But if the battery will not charge, either the battery is dead or the portable electronic malfunctions.

• Satellite A100 - turns off the power after 60 seconds

  After pressing the power button, the laptop starts but 60 seconds from the moment it is activated, the it turns off suddenly?

  The fan turns, I tried cutting dvd, wireless, modem, ram, hard drive, it opens and clean all the dust. It turns off after 60 seconds exactly every time

  Any ideas?

  Thank you
  Ben

  Hello

  > and clean any dust
  How did you do that?
  Usually, you can use jet of compressed air to clean the laptop and remove the dust that blocks the fan. That is why it s not necessary to disassemble the laptop as you can read here:
  [How to clean a Toshiba laptop cooling system? | http://forums.computers.toshiba-europe.com/forums/ann.jspa?annID=40]

  And the same thing happens if you access the BIOS instead of starting in Windows?

• Satellite C660 shuts down after 3 seconds

  Received my new laptop yesterday and during the installation of windows 7 (not exactly sure to what extent the installation process has been) the screen turned a clear gray color and has started flashing, I tried to turn it off by pressing power button for 7 seconds, but he wouldn't answer, I had to unplug the charger and remove the battery to the laptop.

  Now, when I press the power button, the indicator light turn on, the cpu fan turns on and after 3 seconds it stops. I tried to put on about 100 times now, same result. Remove the RAM and HD makes no difference.

  Pending support Toshiba to communicate with me, so I thought I'd try here and see if there was an easy solution.

  Hello

  I guess that the Toshiba start screen does not appear at the beginning and you are not able to access the BIOS too. Right?
  Looks like you had a bad luck from my point of view its something wrong with the motherboard.
  But don t worry should guarantee all so either you could visit your retailer for laptop and ask for replacement (if possible) or you could get in touch with a Toshiba ASP in your country that could solve this problem.

  Good luck

• Play, stop after 15 seconds on iPod Shuffle

  My wife I recently purchased an iPod Shuffle and headphones Skullcandy method for Christmas. The plan was to use for the race (Skullcandy are more comfortable than most of the Earbud Headphones, Apple included).

  Unfortunately, when I try to play music after about 15 seconds of reading the track abruptly fades, and then stops. If I press play again, the track will start again then wither and stop after 15 seconds... and so on! The battery is fully charged. The period of time until the music stops seems very accurate, so I don't think it's a bad connection.

  I've not had much luck trying to find the question - this request doesn't seem to be that common. States of FAQ of SKULLCANDY headphones are compatible with my iPod model: http://www.skullcandy.eu/customer-service/faq/faq.html

  I tried without success to the following:

  • Restore the iPod
  • Using disk utility to analyze and repair the iPod
  • Let it take over completely (just in case where iTunes has been somehow misreading of the amount of charge on the iPod)

  I tried with another too - Apple and some AKG - helmet which seems to fix the problem. BUT the Apple headphones are useless for the race and my AKGs are reserved for the studio. I want to use the Skullcandy headphones! It is a 3.5 mm jack, it should work!

  So, my questions are:

  1. All the world had or heard about this problem (with Skullcandy or any other headphones)?
  2. There is a known compatibility issue? (I don't like about the features of the control of the headphone button works with the iPod - I want just works fine).
  3. Anyone have any suggestions to solve this problem or a work-around, before buying a new helmet?

  Thank you

  J

  iPod Shuffle (2 GB) 4th Gen 1.0.3

  iMac (27 inch, end 2013) race El Capitan 10.11.2

  SKULLCANDY method (S2CDGY-405)

  If it works correctly with other headphones, the cause must be the Skullcandy headphones.  It is defective, or design is not compatible in some way.  It seems that these headphones have controls on the cord.  There may be a short circuit that is causing a faulty signal playback.

  "15 seconds" is maybe the shuffle 'expire' because it does not recognize the headset is connected.  The adjustment can be different between helmet, in order to ensure that the plug is fully inserted into shuffle headphones Jack.  It is tighter than expected when shuffle is brand new.

  You have another device, like an iPhone, try with the Skullcandy?  Or you can also try with your iMac.  Your iMac can use the power cord remote control signals, as well to launch iTunes and play a song to see if anything unusual occurs.

• y510p go to sleep after 60 seconds

  After 60 seconds of inactivity, a video showing the new features of the lenovo series appears. the only time where it doesn't is when I'm in a youtube video or a game. I changed the setting to sleep for 15 minutes, but nothing has changed yet... I am on windows 8.1, have the 755M SLI and the i7 4700-MQ. Thanks for any help in advance!

  federalrebel11 wrote:

  After 60 seconds of inactivity, a video showing the new features of the lenovo series appears. the only time where it doesn't is when I'm in a youtube video or a game. I changed the setting to sleep for 15 minutes, but nothing has changed yet... I am on windows 8.1, have the 755M SLI and the i7 4700-MQ. Thanks for any help in advance!

  You can try to set the screen saver to zero and check if it solves your problem. You can also try to disable this program that displays the video by looking at msconfig under Startup.

• Youtube video of yoga stuck 8 after 27 seconds

  I have yoga 8 4.4.2 android running and the youtube app update. All tube videos you stuck exactly after 27 seconds to play. Audio to work well. Everyone face similar problem?

  I am doing this side only if playback of video in youtube app. If the video is embedded in the Web site (even if the source is still youtube)... The hanging of video stream is not the case.

  Update:

  There is a system update, I've seen today with the build number. 140811... applied the update and after reboot it seems that the problem has disappeared.

• HP officejet pro 8610: Error message print Officejet Pro 8610 after 30 seconds

  Whenever I print on the officejet pro 8610, after 30 seconds fo print an error message appears that says that you cannot print the job. If the print job is short, the message appears when the job is finished. If the print job is not finished, the printer stops mid page. I have a wireless connection. The HP install say Assistant and the doctor print and scan all right. My operating system is windows 8.1

  After trying the patch a second time, it worked fine.

  Thank you