My C850D Satellite used to power on

Similar Questions

• Satellite A85-s107 - white screen at startup by using the power of the battery

  Satellite A85-s107 white screen at startup by using the power of the battery

  When I boot A85-s107 in battery power, it is get booted up in the background, but my screen is empty.
  After that if I connect it to AC power and switch deactivation/activation of the laptop power button, the screen comes back to life.

  There is no problem when I start upward when it is connected to an electrical outlet.
  Battery is fully charged and computer will work off the battery voltage if I remove AC after boootup

  Any suggestions?

  PS:

  also note that when I remove AC and then reconnect I start the computer on two occasions that it does not start the 1st time?

  Don t need to recharge the battery if the AC adapter is plugged ;)
  Try the tips posted by Alex otherwise it of a hardware problem, in my view, there seems to be something wrong with the motherboard...
  In this case, only the replacement could help and it could be a costly affair

• Can satellite T130 - I use Kensington power?

  The model Kensington 33197 (very useful for travel because it is lightweight and flat and can power/charging multiple devices at the same time) has two power tips Toshiba, including the N3 outputs (depending on the technical support of Kensington) 19V, 6a and 114W.

  Outputs of the PSU Toshiba 19V 3. 42A (so 65W).

  Tip N3 is safe to use, or will it FRY my T130?

  Hey Buddy,

  You can use another power supply if it has the same (19V) voltage and intensity or higher (3. 42A or later).

  So, it seems that the Kensington diet should work properly! :)

• Satellite L500 - heating power cord

  Hi all

  I have a Satellite L500 with a heating problem. When in the course of use, the power adapter gets extremely hot, if the battery is in or out. So much so, that melted the case around the adapter. My first thought is that it's the cord itself which is defective and will buy a replacement for it. If not, should what other things I look for?

  Thank you

  -Cord becomes very hot * with * or * without * battery
  -fans and vents were cleaned
  -the heat is in an area around the power adapter

  > the heat is in an area around the power adapter
  It of difficult to say what's wrong or if something is wrong.
  I have two laptops Toshiba and the area around the plug of AC adapter is not warm or hot.

  But in the worst case, it could be a problem with the power supply or the broken cable
  Maybe you should try a genuine Toshiba AC adapter and another, good work.

• Satellite L300D-12u: power supply works not - is threre a guarantee?

  Hello.

  Today, I was surfing the Internet when suddenly my laptop says, is no longer on electricity.
  I touched the power supply and the connector that is immersed in the laptop was very hot (not the big case which becomes usually hot, only the connector).

  I tried several times to make it work again to take a new start or cool connector, but it still does not work.

  To make sure, that it is the question of food, I used the power supply of my mother, who is similar to mine, and then it worked.

  So my question: do I have a warranty on my power supply?
  I bought my laptop to 29.8.2008 in Germany and is a Satellite L300D - 12u.

  Thank you for all the answers!

  Hello

  Adapter is covered by warranty for laptop.
  So if laptops warranty is still valid your adapter should be covered by the warranty as well.

  Visit this link for details of the guarantee:

  http://www.toshiba-tro.de/unitdetails

  Welcome them

• Put my C850D Satellite

  Even if a cell phone is activated simply is a problem for me, to say, I don't know anything about computers.

  It says in the manual for my C850D Satellite press 2-3 seconds. I the time by counting the exact number of seconds. Yet the laptop sometimes turns, other times on light turns off the coast and the screen goes black, laptop is turned off. Or the start screen comes on and then the screen goes black and computer laptop is turned off again.

  This means some days that I have to press the button several times, each time by counting the required number of seconds, before the portable lights. Isn't this bad for the hard drive?
  More importantly, is it normal, the button being so sensitive? Is there something that can be done to change that, so I can just press the button and the laptop turns on, each time just sometimes?

  Don t push button power 3 seconds. Just press top gently for a second and laptop will be turned on.

• Satellite A500-1GL - power of Windows 7 and the games options

  Hi all

  Some know maybe my previous posts about my problem with the fan on my Satellite A500-1GL worry when I'm online game. It is disturbing to hit the 90%. And his pass even with the update of the BIOS and Toshiba now advise to do a factory restore then fails to send in for repair.
  Looking at the power options,

  I was wondering if someone could recommend this power options I should consider and it would have made no difference for the wise game fan (secondlife seems to be the main problem with the fan turn the crank to the top)

  Any help would be appreciated, trying to think of something that might help which may be a simple solution to this problem of fan
  Torti :)

  Hello

  To be honest, a lot of activity of fan during the games would be normal I think because games need a lot of CPU and GPU power, they always run at a very high level. This means a lot of heat will occur and it must be cooled to avoid damage.

  Of more if I have the games, it s not important how the fan noise creates because I hear music or dialogue game Isn t it so? ;)

  In any case, from time to time it s advisable to clean the cooling system of your laptop using a jet of compressed air:
  [How to clean a Toshiba laptop cooling system? | http://forums.computers.toshiba-europe.com/forums/ann.jspa?annID=40]

  And for games, you can use high power option or balanced Windows Performance.

• Satellite C650 loses power

  My Satellite C650 loses power, there is a loud click speakers, and then the screen goes black. Sometimes, the computer can be restarted, the screen, when it restarts, indicates that the computer has been shut down incorrectly and there are several options for recovery - mode of diagnosis, etc..

  It sometimes reboots then crash even less a minute sometimes she'll go longer but if I wait for an hour or so it will usually restart ok. It started during the summer and I thought that it was getting hot, but he started again recently (winter).

  Can anyone help?

  > My Satellite C650 loses power, there is a loud click speakers, and then the screen goes black.
  Do you say notebook computer is turned off or simply, the screen stays black?
  On this virtual path, it is not easy to say what the problem is here. You must perform some basic tests.
  For example, start computer laptop, enter the BIOS settings and let him for a period of time see if the laptop turns off only.
  Also try to boot OS in safe mode to see if the same thing will happen again.

  Alternatively, you can try to back up all your important data and reinstall OS using the recovery image just to see if the same problem persists with the factory settings.

  Test this and post comments.

• Is there a way to the target url by using the power of Attorney (I want to say is possible to use the proxy to target a site something like that.)?

  Is there a way to the target url by using the power of Attorney (I want to say is possible to use the proxy to target a site something like that.)?

  By default, you can not in Firefox.

  But you can use an add-on like FoxyProxy Standard, I think he understands the functionality you need.

• Guys, it is advisable to use low-power mode even if it is not yet on 20%? What will happen then?

  Guys, it is advisable to use low-power mode even if it is not yet on 20%? What will happen then?

  It uses less energy than if you don't.

• I have adapters and a power converter, but has been told by someone who travels internationally that the block performs the conversion of power for me.  I want to assure that I do not blow on my phone.  Use the power converter to charge my iphone and appl

  I have adapters and converter of power for international travel.  I was told by someone who often visits that the converter is not necessary for apple products.  I don't want to ruin my phone or watch - can I use my power converter?

  If you use the Apple adapter supplied, you will simply need an adapter to use in other countries. The adapter can be used with voltages between 100-240 v AC 50-60 Hz

• 27 "2013 mac only shut down using the power button / stop, is this a problem or a part of the new system

  After my upgrade that Mac is not closed by using the drop-down menu option, it also seems to crash the finder.  Finder raises with force quit.  I can only shut it down using the power button.  Is this a bug/problem of a part of the El Capitan?

  Wacom tablet software is known to cause this problem. Options:

  Uninstalling the Wacom software

  Completely and remove items from connection

  The Wacom driver update

• 750 HP envy: can I use Cyberlink Power Director to transfer a VHS to dvd? Thank you.

  Can I use Cyberlink Power Director to transfer vhs to dvd? Thank you very much.

  Hello

  No, unless your computer has a capture card. I used the following device:

  http://www.TopTenReviews.com/computers/peripherals/best-VHS-to-DVD-converters/Diamond-video-capture-review/

  Kind regards.

• recently, my mac started hanging. the screen freezes and I have to use the power button to turn it off

  recently, my mac started hanging. the screen freezes and I have to use the power button to turn it off

  Run this test and post the results here.

  http://www.etresoft.com/etrecheck

• 3 peripheral USB connected to the Macbook 4.1 computer tells me to restart using the power button / stop?

  I went to record a live concert, and I need to use a single interface to record the members of the group with microphones near directly to a computer and another interface running for my model of Macbook 4.1 end of 2007, to get signals from the map of the House.

  When I plug my converter USB 3.0 AD / DA in my Macbook 4,1 - the computer sends immediately a window indicating to me to "reboot" the computer using the power button / stop. Ideas or comments about why this happens?

  I read on this forum that USB ports should work with retroactive effect, or accept USB 3.0 devices, but just use a speed 2.0?

  Thank you.

  It could be that it is a requirement of your converter AD / DA she needs to be present at a properly accessible to the OS X when startup sequence it is plugged into a USB2 port.

  Its also interesting to note that, well that peripheral USB3 can be plugged into the USB2 ports... it could be that your device may not work properly unless it is used with a port USB3... for reasons of bandwidth or even certain types of power supply.

  But to be sure...

  Which converter AD / DA are you using?