Problem of color correction between the initial and the multicam sequence... Help, please

I used three cameras to record a youth dance recital.  I created a sequence of orginal for three camcorders and another sequence using multicam editing dances.  After I finished editing, I went back to the original sequence to do some color correction and adjustment of brightness using the Quick Color Correction controls.  After that, I just sent in again to create a DVD.  When I watched the DVD, I noticed some of my settings were always off, the color correction so I went back to the original sequence to make some changes.  Unfortunately, the multicam sequence would not read the new settings.  After a few unsuccessful attempts to get the element from the sequence multicam to read the original sequence clip, I decided to start by disabling fast Correction of the colors of the clip commands.  The adjusted multicam sequence then return corresponding to the original sequence.  However, when I started a new control for fast Correction of the color in the original sequence, the sequence multicam wouldn't take the new settings.  How to get the sequence mulitcam read the orginal sequence?

Look for the error of the operator on this one.  Check that you are working in the source used for the multicam sequence.  You can do this by going to the multicam sequence and pressing SHIFT + T.  This will open the original with the ITC on the same chassis.

Tags: Premiere

Similar Questions

Maybe you are looking for