Restore settings facotry Equium A100-206

Similar Questions

• How to change the settings on the Equium A100 color & contrast

  Does anyone know how you change the settings on the Equium A100 color & contrast? Thank you.

  Hello

  Change the contrast and color?
  Well buddy, you can change the screen brightness level using the FN + F6 and F7 key combination of.
  The other settings are only editable in the properties of the graphics card.
  I put t know what graphics card you are using but usually you must search advanced options.
  Check if there is no gamma, brightness or contrast settings.

  I found these settings on my laptop. I have a graphics card intel and the option was called the color correction

• Equium A100-147: need a new disc of restoration as mine has been a scratch

  Having a little trouble with my Equium a100-147.
  Tried a recovery from disk and I got up to 75% and recovery stopped.
  Taken to a computer shop to get it fixed and they couldn't do anything because they do not have a disc of recovery in good condition.

  Is there anywhere I can download the image to a different computer, put it on a dvd and restart from that one?

  Contact the ASP in your country and order the necessary CD

  Here you can find near the ASP in your country
  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/generic_content.jsp?service=EU&ID=ASP_SUPPORT

• Equium A100-338 - Missing recovery Toshiba in the menu Wizard

  I have a Toshiba Equium A100-338 I need recovery to factory settings.
  I know I have to press f8 and go to the Toshiba Recovery Wizard.

  My problem is that this option is missing and has been replaced by 'Restore the whole Windows operating system'. When I click on this option, I get a generic message, saying that I have to restore from a restore CD.

  My question is, is it possible to manually start the recovery in the command prompt? The wizard needs to run a program. All I have to do is find this program. I know that I have the recovery partition (I used Ubuntu to recover files of the user, and should it upward).

  Hello

  Just a simple question: If you have problems to start the HARD drive recovery, why you n t use the Toshiba Recovery disk?

  It can also restore settings from the factory with all the drivers and tools, so it of the same wait it erases the entire HARD disk.

• Alarm of battery low battery/criticism on Equium A100-027

  I bought an Equium A100-027 running on Vista Home Premium this Feb. Since then, I installed some software, for example a software phone Nokia, bluetooth, Virus-A drivers & all updates from Ms.

  When the battery is low or critical, I get no sound alert, despite this option checked in the Advanced Power Options settings and using the template to default sounds Win.

  The card sound & speakers work certainly I get sound notifications of Win and can play CDs, etc.

  Is there a driver/software that can be reinstalled to get this working again as system restore would only let me go back a month.

  Thanks for any help,
  Markus

  Hello

  I saw your post before, and I understand that you need help.
  I can give you the following suggestion:

  -Updated to the latest version of the bios. (Check this site out: http://eu.computers.toshiba-europe.com/cgi-bin/ToshibaCSG/download_bios.jsp?service=EU&mode=allMachines)

  -Pick up your machine and update all THE drivers/tools/etc, but before installing some 'foreign' software, check if the "beep" is working properly (for things like go here):
  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/download_drivers_bios.jsp)

  -Install other software (Nokia Manager, etc.) and check after each newly installed software, if it still works. If after you install specific software, the "beep" doesn´t work anymore, then you know where the installation problem and you have some good software troubleshooting. ;)

  If you have questions: just after :)

  Welcome them

• Possible replacement of Equium A100 - 147 HDD 250 GB?

  Hello

  I own an Equium A100-147 with 60 GB HARD drive. I have a recovery disc and have restored the laptop several times.

  I am considering an upgrade to 250 GB HARD drive.

  Couple of questions...

  The motherboard will host a 250 GB drive?

  If I replace the HARD drive recover CD will install a new copy of the fatory software you (inc windows xp MCE)?

  Any advice would be welcome.

  Yes, you can use a 250 GB. The laptop has a SATA interface and there is no limit as to IDE.

  If you use the recovery CD, you will get to factory settings. This means an XP installation with all the drivers and tools.

• Where is the recovery for Equium A100 disc?

  My laptop has completely screwed up and I was going to do a full reinstall by using the restore disk provided when I bought my laptop. However, I can't find anywhere and I was wondering if there is anyway that I can get a replacement?

  I have an Equium A100 running on Windows XP. I bought it in November 2006 PC world.

  Any ideas greatly appreciated.

  You can order the necessary recovery discs with the service provider authorized in your country.

  On the page of European support of Toshiba, you link to the global database of ASP where you could choose the nearest ASP.

  Best regards and have a nice day ;)

• Equium A100-147 - deleted CD/DVD drive

  I uninstalled the readers of DVD/CD ROM of my Equium A100-147 model PSAABE by mistake. How I can I restore it? I'm not very technical

  Hello

  It means that your CD/DVD drive is not more?
  Have you already checked the Device Manager if the drive is visible or not?

  Otherwise, you must follow the instructions in this Microsoft KB article:
  http://support.Microsoft.com/kb/314060

• Equium A100-147: I get an error during the recovery procedure

  Hi again,

  I had trouble with my equium a100-147.
  I tried a restore, but the disc is scratched so I phoned in ESL and it snet me a new recovery image.

  I tried the new recovery disk and am now errors when I boot the disk.

  error is

  "internal error crc file: \WINDOWS\$NtUninstallKB895200$\msdtctm.dl.

  any suggestions are welcome. get really annoyed with my machine as my warranty expired only one month

  Thank you

  Hmm... I studied a bit and it looks a bit like a malfunction of the partition.
  It would be desirable to boot from the original CD of Microsoft XP and to start the repair console.
  Then you could try these various commands which help to repair the boot manager, repair errors, locate bad sectors and recover readable information.

  -fixboot
  -fixmbr
  -bootcfg /rebuild
  -chkdsk /r

  If this does not help, you should erase the entire partitions and must format the HARD drive in NTFS file system. Then access the BIOS and set it to the default value.
  Once this procedure tries to start again on the new recovery CD!

  Good bye

• Equium A100 - unable to boot from the bootable disc

  Equium A100-549

  My son s partner has a 2 year old Toshiba which has become slow over time. I had done a backup of the system with office installed etc using Acronis. Anyway, decided to rid running Acronis and recorded image. The program runs normally, and he falls down to a denial of service as the ready to restore screen. It is then with the cursor flashing as usual and then it crashes, and doesn't allow you to access the image.

  I am that it can be altered, so reinstalled Acronis. Make an Acronis boot disk to run the image, and he does not take into account the disk boots directly to the normal hard drive (IDE 0) still no joy. Then I tried the restore of laptops disc. In the BIOS, I said peripheral CD as everything first and also the restore disc says place in the drive and turn off.

  While it starts up press F12, which brings a menu allowing you to boot from the CD drive. I did, but it doesn t appear to look at the CD and just load windows from the HARD drive. I removed the CD for system devices and rebooted. He found and added the new device to herself and asked to reset. Still no joy!

  Scanned with Norton, but still not good. Norton removal. The result is the same. Able to read the CD and also write to it as well. Diagnosis Toshibas ran on the unit and everything seems ok with it.

  Tried to make a bootable flash stick on floppy, but it is ignored, well specified the amorçage using other devices.
  Basically, it seems that I can t get it to watch prior CD onto the HARD drive.

  Flashing the BIOS would heal it? -Registry error causes this?

  Y at - it everywhere where I can talk to someone from Toshiba about this?

  Any info / help much appreciated

  Hello Nick

  Put the delivered device DVD recovery DVD and turn on the laptop. Press the C button and keep it pressed for a few seconds. This will force the DVD player to read the DVD, and I hope that you will be able to use the DVD of recovery for the installation of the OS.

  If possible, test it with some other bootable CD installations. Please post the results.

• Equium A100-338 - required key for keybord

  Hi helpers.

  can someone point me in the right direction in order to get a couple of new keys on my keyboard. It's a laptop equium a100-338 and I accidentally broke up the great shift and I'd love to restore to the original state.

  any help appreciated

  Thank you
  Ian.

  I doubt you can buy each of the keys, you need to buy a new keyboard to an ASP.

• How can I my Equium A100-338 connect to AOL

  How can I get aol my previous pc connection works on my new laptop?
  I can't make it work at all. The DSL light is not my modem. Do I need settings to log in again?
  I have the model Toshiba Equium A100-338.
  Please answer.
  Thank you.

  Hello

  I agree with James. AFAIK for AOL users there is an AOL software that needs to be preinstalled. By using this software, you can configure DSL connection.

  By the way: do you use modem for DSL connection only or also a router between your laptop and the DSL modem?

• Equium A100-338 - do I have to buy a recovery disk?

  Hello

  I have a bit of a dilemma. Vista on my Toshiba Equium A100-338 sticker is worn (was like that when I bought it). I upgraded my hard drive, installed Windows 7, then gave my old one (forget were the top recovery partition). I want to sell the laptop so back to its original State would be ideal.

  Toshiba said that I have to buy a drive for recovery for 29.90, which is ridiculous. Can someone help me?

  Details of the laptop: Toshiba Equium A100-338 PSAAQE-006008AV

  See you soon

  Hello!

  If you want to return factory settings as in the first start of the laptop, you can buy a Toshiba Recovery disk. This disc contains a picture of the factory settings, and so you can install the laptop in minutes with all Toshiba drivers and tools.

  But I put t understand why it is ridiculous for you. I mean normally get you on laptop Toshiba with Vista after the first start a message that you must burn the recovery disc yourself. It takes 10 minutes and you need only one or two DVD discs. I did it on my Toshiba laptop and I think you should take 10 minutes of your time to do this too.

  However, nobody says you have to buy the drive because you can also use a disc of Microsoft and download Toshiba stuff on the Toshiba page but you need so much more time.

  Good bye

• Equium A100-027 touchpad not responding

  I have an equium a100-027 and today the touchpad was funny.
  For example, I went to move and sometimes it wouldn't be no move, moved very little, or when he moved quickly moved to around to the same place that it was before.

  I assumed that maybe it's just that my computer has been used too much memory or something. But then later, it no longer responds. I restarted my computer and the same problem, it does not move.

  Before anyone suggests, I in fact checked all the settings for it. I know there is a shortcut (fn + f9) to turn it off.
  However, I already checked and it is activated.
  I am falling quickly with this computer, six months old and already had two problems with it.

  Anyone can suggest a way to solve this problem, or should he be returned to be repaired?

  If it must be returned, how should I do this?
  I bought of Dixons, and when I came down to them with my last number, they said they have no responsibility and I had to call "the tech guy".

  This ended up being A £1.50 tech support number overcharge, which I'm not call again.
  This laptop has only 6 months, clearly under warranty. I don't have to pay who knows how much on a phone call just to get it fixed.

  Sorry if this sounds like a hangover, just in a bad mood with this computer at the minute.
  Thanks for any help! =-)

  Hello

  I see that you're desperate. Sorry to hear this story.
  But before you send this laptop to any point of service, you must reinstall the laptop with the Toshiba Recovery CD.

  This procedure will put the laptop to factory settings!

  If the touchpad does not work after reinstalling new contact ASP in your country.
  The service provider authorized in your country will be able to help you and if your warranty is valid, everything must be done for free.

  I can't believe that the appeal could cost about £1.5 because it s a common phone number.

  If you want to find the ASP please check this:
  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/generic_content.jsp?service=EU&ID=ASP_SUPPORT

• Equium A100 - 306 PSAABE - cannot start and the error of the BIOS

  I have a Toshiba Equium A100-306, which does not go beyond the BIOS screen. Last thing I did was delete the second partition on the hard drive and the boot configuration Winodws via DVD. Then he stopped display

  If I hit ESC on the post screen, I get a screen that says this: http://i57.photobucket.com/albums/g232/Medabot_Metabee/BIOS_ERR.jpg

  Ive read that theres a method of emergency crisis of flashing, is possible to run it on this laptop?

  Thank you

  Hello

  This looks like a malfunction of the motherboard, you can enter in the setup of the BIOS for example? If Yes, load default settings then save & exit it.

  If you can t get into BIOS try remove the battery and the AC adapter at least an hour. Then connect the two again and try to start your laptop.

  He starts correctly now?