A few websites that have things fade with jquery cut to a black box and then fade, rather than start as transparent

Similar Questions

• I have a pdf form that has 4 columns, with each column having 28 check boxes and text between. I did so he goes by column, but when I do anything for a checkbox it takes it out of line. How can I keep that from happening?

  I have a pdf form that has 4 columns, with each column having 28 check boxes and text between. I did so he goes by column, but when I do anything for a checkbox it takes it out of line. How can I keep that from happening?

  You talk about the tab order? If Yes, go to Edit - Preferences - forms and make sure the box "Automatically adjust tab order when changing fields" is NOT checked.

• I have currently problems with control panel Nvidia causing black outs and computer freezing/not not be able to start.

  I have currently problems with control panel Nvidia causing black outs and computer freezing/not not be able to start.

  1) update your nVidia/software drivers to the latest version for your model video card + operating system.

  (2) check that the equipment is not defective.

  This is not a Microsoft / number of the operating system.  For additional troubleshooting - contact the manufacturer (nVidia).

• Xp pro installation gets past the copied installation files and then restarts, rather than continue with install it starts from the beginning again.

  new installation of XP pro on a Dell Inspiron mini

  Xp pro installation went copied files Setup then restarts, rather than continue with an install it starts from the beginning again, laptop is configured to boot from the hd, but does not do that, I reset bios to default and hd settings has been reformatted, the cd for this laptop drive is usb because it has not built in 1... If I try and I remove the usb cd when reboots after copid setup files it told her there is no operating system...

  any help much appreciated...

  Hi, Leon,

  Always include computer make and model, please.  Thank you.

  Research in the Bios (reboot and press F1 or F2 depending on your system, check that all usb options are enabled (for example, USB legacy or support for USB 2.0 devices).)

  If there is a timeout parameter, set it to Max.

  Then, find the boot device priority section

  A USB flash drive, which is usually listed as USB - HDD, but may be listed as a removable device, will have a priority very low start.

  Rearrange the boot device priority so that the flash drive has a higher priority than the hard drive.

  Install Windows XP from USB key

  • Insert the USB key into the USB port on the computer.

  • Open the "I386" folder and find the file "Winnt.exe".

  Double-click on the "Winnt.exe" to launch a command prompt BACK to an installation of Windows XP.

  Type the path of the location of your "I386" folder in the DOS window. For example, if your USB is the letter "D" in your "My Computer" window, type "d:\i386" without the quotes and press the Enter"" key.

  Let the installation program copy the Windows XP installation files on your computer.

  Restart your computer to a command prompt. The Windows XP Setup will continue automatically.

  Follow the on-screen instructions to complete the installation. The program will ask you your Windows XP product key in this process.

  http://www.ehow.com/how_6912418_install-Windows-XP-USB-drive.html

  Make a bootable memory card or USB key using PEBuilder

  http://www.tech-recipes.com/Rx/2583/making_a_usb_drive_or_memory_card_bootable_using_pebuilder/

• Have new 4th gen tv apple. Home sharing is on. I'm unable to access my music library on my MAC other than a few titles that have been purchased. How to access my entire music library?

  Have new 4th gen tv apple. Home sharing is on. I'm unable to access my music library on my MAC other than a few titles that have been purchased. How to access my entire music library?

  Welcome to the Apple community.

  You wonder if you might be looking at the wrong place. You can watch/listen to house content shared app for computers not the music app.

• How to access the tab 'Save all' when I close several jpeg files that have been adjusted with the "color adjust tool? He is currently making me close and save one at a time. Thanks for any help :)

  How to access the tab 'Save all' when I close several jpeg files that have been adjusted with the "color adjust tool? He is currently making me close and save one at a time.  I've just upgraded to El Capitan.  Thanks for any help :)

  I assume that you use the application overview.

  I can't find an answer to back up everything, but a workaround could be while the file menu options are visible, press the option key

  and the point of the window will become close, if you click on that dialogue will ask you if you want to restore the changes or save

  pressing Save will close the image with the changes and then move to the next image and so on.

• Windows Upgrade Wizard has detected a few programs that is not compatible with 8.1

  Original title: 8.1 update

  Windows Upgrade Wizard has detected a few programs that is not compatible with 8.1 and must be upgraded.

  Will I upgrade first and then move to 8.1?

  What happens if 8.1 upgrade will not be successful? Upgrade programs works with 8.0?

  These aren't compatible programs

  My main concern! It takes to remap all my BT devices? Where I can get the re-installation of?	Intel (r) PROSet/Wireless for Bluetooth (r) + high speed Intel Corporation Reinstall this app point 8.1 Windows
  	iTunes Apple Inc.. Remove the CPA allowed
  	Yahoo! software update Update available
  	Realtek USB 2.0 card reader Realtek Update available

  Yes, should be updated first before upgrading to Windows 8. 1.

  You can always save before moving to 8.1 in case the update is not successful.

  http://techingiteasy.WordPress.com/2012/10/29/how-to-backup-your-Windows-8-installation/

• I have a problem with the simulation in Matlab 6.5 and LabVIEW for PID controllers

  I have a problem with the simulation in Matlab 6.5 and LabVIEW. I have a few methods for granting regulators PID in MATLAB to go but not of LabVIEW. Degree of international teams of two transfer but when I passed to the fourth degree is no longer working. We have changed the formula to calculate the parameters for the fourth year and gave me some good values for assignment of Matlab, but when I put on LabVIEW are not resolved. the formulas are available in PDF format and are. Please help me and me someone if possible. Thank you
  Lim.4 generation in comparison methods and the MATLAB program settings are for the service of transfer to the second degree.

  Hello Lascarica,

  I noticed that you are using the screw of PID. Gains on these screws are based on TIME instead of GAIN. You should be able to build a PID regulator and vary the gains and then compare the results.

• On the right of the adressbox, I always have Yahoo then Google, how can I solve that, I already delete Yahoo from the list in the box search, but every time I start firefox Yahoo is back. Thanks Ron Mijtelen ter, Amsterdam.

  Question
  On the right of the adressbox, I always have Yahoo then Google, how can I solve that, I already delete Yahoo from the list in the box search, but every time I start firefox Yahoo is back. Thanks Ron Mijtelen ter, Amsterdam.

  Hi Ron,

  Have you looked at article in the Knowledge Base using the search in Firefox bar? There are lots of good information in there. You happen to have an installed Yahoo! toolbar? You must disable or delete as well if you do. Try to start Firefox in Mode safe mode by holding down the SHIFT key while starting Firefox. If you have any problems using the safe, it's a matter of add-on or extension.

  Hope this helps!

• I have a project in iMovie HD6 and want export to Final Cut Pro.  I see that it is not possible from the previous questions, but is it possible that I could maybe create a dvd of the iMovie project and then who import in Final Cut?

  I have a project in iMovie HD6 and want export to Final Cut Pro.  I see that it is not possible from the previous questions, but is it possible that I could maybe create a dvd of the iMovie project and then who import in Final Cut?  I just want to make a new trailer for the project.

  What you suggest is possible but it takes software and third-party quality loss.

  Instead, export a QuickTIme movie. If you have a choice of codecs, choose Apple Intermediate Codec. You can save it where you want it-maybe in the movies.

  Then import the movie into FCP as a clip.

  Good luck.

  Russ

• I have a Compaq with vista home basic 32-bit preinstalled and I want to upgrade to 64

  I have a Compaq with vista home basic 32-bit preinstalled and I want to move to 64-bit is it possible to use the sticker on the side of the case to just upgrade the same version of windows, but just for the 64 bit for windows vista home basic 32-bit new installation of vista home basic 64-bit will be the key oem on the sticker.

  Yes.  The product key on the sticker will work with both versions of the software.

• VM have been storage vMotioned to another data store, and now I have 3 VM with white "!" inside a red square and I want to understand the cause of this.

  VM have been storage vMotioned to another data store, and now I have 3 VM with white "!" inside a red square and I want to understand the cause of this.

  Can you try to make a vmotion host and see if it gets resolved? If not, can you close the virtual machine and start again? I have seen this problem before and a stop and start resolved.

• fill with links on websites that have nothing to do with this Web site

  Words are underlined and provide links to Web sites that have nothing to do with the site I'm. So I get a pop up video advertising that started the same time these links that presented themselves. How can I stop this?

  You can have an unwanted extension that injects these ads sites. Try this:

  Disable all non-essential or unrecognized extensions on page modules. Either:

  • CTRL + SHIFT + a
  • "3-bar" menu button (or tools) > Add-ons

  In the left column, click Extensions. Then, when in doubt, turn off.

  Typically, a link will appear above at least an extension disabled to restart Firefox. You can complete your work on the tab and click one of the links in the last step.

  Which empty ads?

  Note: If no delete button for an extension, you can usually uninstall via Control Panel, uninstall a program. I suggest clicking on the column heading "installed during the" group by date to see if all the grouped items dragged to your computer during a recent free software install.

• Can you open/edit indesign CS3 files that have been created with CS5?

  I recently purchased indesign CS5 and use that for my internship. However, my boss is still using CS3 and said that she could not open or edit the indesign file that I sent him.  I looked to see if there was an option in 'export' and have not found anything.  I use a mac and I think she uses a P.C., too, when I finally sent him the file, I was still with my free trial - all this make a difference?  Help, please!

  What has been covered time without end, but anyway, I'll do it again!

  You must export a CS5 idml file, and then open the idml in CS4, export a file inx there then that open in CS3 and save it as an indd.  Sorry but there is no way round, presence, end of history etc etc.  If she's using CS3 and you use CS5 there are no roads between them unless you have CS4, and even in this case the road is littered with pitfalls!  Look at here for a pretty long discussion / sometimes write on the subject.

  Ultimately it will have to be upgraded, or you could see if you could buy a CS3 or version 4 but it is very difficult to get a legitimate copy, the only way is to buy it off someone you know and most of the people do not sell because they upgrade.

  Best new last, there is a solution in the short term to this guys blog and you can download a trial version of CS4 that will last for a month.

• Others have had trouble with Trojan infected by downloading Adobe CS2 and Premier Pro?

  Last week, I contacted Adobe to help activate the Creative Suites program, that I bought years ago but never used. I could not activate it after using my disks to load on my laptop. The tech I spoke told me that Adobe is stronger and I could go to the site and download the programs in CS2. I removed the original software and downloaded from https://www.adobe.com/cfusion/entitlement/index.cfm?e=cs2%5Fdownloads. The 3rd 'CD' CS2 wouldn't download, hung up. I closed and finished hearing and Pro. After that installation, that I suspected that a virus may have been placed on my computer then ran McAfee, who said my computer was free of any virus and ClamWin, who says: I have various forms of a virus Trojan horse in all programs Adobe Acrobat. I have not tried to use them again and am wary of doing. Others have a problem downloading these programs? Do I have to uninstall, run ClamWin to ensure I have no more Trojans and then reinstall?

  These are false positives.

  Mylenium