Access NI9263 and NI9205 from my computer

I am a beginner in LabVIEW Development and have a question.

I have the controller OR cRIO-9004 with rear panel FPGA real-time.  It has the NI9263 and NI9205 C Series modules.

The real-time controller is configured as a DHCP IP address.

When I launch Measurement & Automation, it detects the chassis, but it does not recognize the modules.

When I run LabVIEW 2010, I can only program the FPGA level, if that makes sense.

Is it possible to run these modules data acquisition in workstation in the LabVIEW project?

Thanks in advance for your advice.

Thank you for your advice.

Tags: NI Software

Similar Questions

Maybe you are looking for