can not activate win 7

Similar Questions

• Can not activate Win 8 - reports of problems with the product key

  Hi all

  I have just downloaded 8 Win and tried to upgrade my existing Win 7 Home Premium VM, which I run on VMWare Fusion 5.0.1 on my Intel MacBook Pro 2009. I wasn't able to do the upgrade in place - the installer told me that it was not possible to run Win 8 on this machine. Instead, I created a. ISO file and used to install Win 8 in a new virtual machine. Everything works fine, but I can't activate Win 8. The error message tells me that "something is wrong with the product key" even if I could install Win 8 with the same fine product key.

  I called various hotlines MS today but don't have anything got no solid advice. Am I the only one who experience this issue? Is there something I need to pay attention during installation of the virtual machine to win 8? Is it possible to install a fresh VM with a key product upgrade in the first place? I would appreciate any information you might have on this subject.

  Thank you in advance and Bravo,

  Georg

  Hello

  Had the same problem after installing Win 8 Pro Upgrade on Fusion 5. Follow-up to "How to do a clean install on Windows 8 Pro Upgrade VMWare Fusion" here, problem solved (for now).

  http://www.moosooboo.com/tag/clean-install-on-Windows-8-Pro-upgrade-in-VMware-Fusion/

  Good luck

  JKB

• Can not activate Win 8 after removing all of the Satellite P850

  I did everything remove and reinstall Windows 8.
  As in the factory setting.

  But I can't activate Windows. The product key does not work.

  The Windows 8 K OME on my Toshiba Satellite P850.

  Thank you.

  Cheers mate.

  Hello

  The key of product at the bottom of the device would not work!
  The pre-installed Windows 8 would be activated automatically during the startup and configuration of the system for the first time!

  You format the whole HARD drive? Did you remove the 8 Windows from the HARD drive?
  Have you created a disk recovery or flash memory stick recovery in the past?

  ISN'T IT?
  In this case, there is only one option to get to factory settings.
  You will need to order the Toshiba Recovery disk:
  http://backupmedia.Toshiba.EU/landing.aspx

• Can not activate win 8 error "the key provided is not for this edition of windows, use either windows 8 setup or enter an activation key for windows 8.

  OT: Cannot activate win 8 on my laptop due to the change of hard disk.

  Hi all

  I have a Samsung np550p5c-s05in and it came installed with 64-bit Windows 8, later, the hard drive developed a few problems and as I had guaranteed him, they were replaced by a new, but this one came with a victory 8 32-bit that is not enabled. Now, I got the product key of victory last 8 I had so I tried using them to activate, but an error came that said something like

  "The key provided is not for this edition of windows,

  Use the installer of windows 8 or enter an activation key 8 windows. »

  So it was logical that the key I had was for a 64-bit win 8, so I installed win 8 64 bits of an image file and then I repeated the same procedure to enter the key and the same error came once again.

  I would ask so you people to please help me with this, because I have no idea whatsoever what to do next.

  Thanks in advance,

  SamizZy

  All laptops with preinstalled Windows 8.1 are OEM version of the product that are modified by computer makers. You cannot activate a product of retail of Windows 8 with an OEM key.

  When get you the computer from the computer. I suggest that you create a recovery disk to help you in the future.

  http://Windows.Microsoft.com/en-us/Windows-8/create-USB-recovery-drive

• Can not activate Win 8

  How did you determine that the computer is infected is no longer?

  You still have your MBAM logs? [<=just a="" question;="" please="" do="" not="" post="" them="">

  The only way I know is through a new analysis with some antispyware I.  Once a week I do a full scan with Defender and Malwarebytes...

  Without that newspapers are no longer on my computer except a very recent log...

• I did a clean install of Windows 7 teacher instead of an upgrade installation and now I can not activate Windows.

  Setup for Win 7 Prof error can not activate.

  I did a clean install of Windows 7 teacher instead of an upgrade because of idiocy. Now it does not accept my product key. Is it possible to set which does not imply a costly phonecall?
  Partial product key: PW487
  License status: Notification
  Reason for the notification: 0xC004F009 (grace period expired).
  Remaining Windows rearm count: 4
  Trust time: 19:51:25 08/02/2012
   
  Try the Activate by phone:
  
  How to activate Windows 7 manually (activate by phone)
   
  1) click Start and in the search for box type: slui.exe 4
   
  (2) press the ENTER"" key.
   
  (3) select your "country" in the list.
   
  (4) choose the option "activate phone".
   
  (5) stay on the phone (do not select/press all options) and wait for a person to help you with the activation.
   
  (6) explain your problem clearly to the support person.
   
  http://support.Microsoft.com/kb/950929/en-us

• Hello, I can not activate photoshop lightroom cc and after the purchase of adobe in installments I do?

  Hello, I can not activate photoshop lightroom cc and after the purchase of adobe in installments I do?

  Hey stefanog60680004,

  I see that you have the subscription for: -.

  Piano Fotografia Creative Cloud (rinnovo all year)

  Mac/Win, all the available languages

  Please Sign Out and sign in again using your Adobe see identification code also the steps mentioned in this document https://helpx.adobe.com/creative-cloud/kb/activation-connectivity-errors-creative-cloud.ht ml.

  Kind regards

  Nicos

• Can not activate it three fingers after updating to Mac OS Sierra

  After the macOS Sierra update, I somehow can not activate this three finger drag more: I tried multiple combination: activation and reactivation of the finger three, activation and reactivation of the research, restart my MacBook Pro and nothing happens. That bothers me a lot because I get used to it.

  Just in case where to try this support article > turn on "three fingers" for your touch trackpad of Force - Apple Support

• can not activate ipad?

  can not activate ipad 2?

  It's a 2nd hand iPad, I assume. It is important that the previous owner had taken all these steps: what to do before you sell or give away your iPhone, iPad or iPod touch - Apple Support

  If it does not, you may have a big problem.

• can not activate iPad after extinction

  can not activate iPad after extinction

  The iPad battery is not empty? If this isn't the case, then have you tried a soft-reset/reboot to see if that gets it to start? Press and hold the home button and sleep for about 10 to 15 seconds, then the Apple logo will appear if all is well and it will start.

• NB305-N410BN-G = FN + F8 can not activate 3G / but FN + F8 can activate WIFI

  Hello world

  You also have a problem with the switch of Toshiba FN F8 on Windows 7 Starter x 86 (32 bit). I can turn on and off the transmission of my built-in WIFI, but not my built in 3 G mobile broadband (Sierra Wireless Gobi 2000). It has worked well so far. But then I had to send my Netbook for service because the screen stays black. An external monitor and it worked fine... In any case; They exchanged the motherboard and now LCD is well again. But my 3G connection does not work, because I can not activate the transmission of the antenna.

  Real conditions / situation / comments:
  (1) sierra Wireless Gobi 2000 3 G card is present in Device Manager, it is activated and shown without problems or restrictions.
  (2) I can even test the modem successfully!
  (3) under network connections the Sierra card is present but displayed with a red X. But I can't activate it.
  (4) in addition I can disable there despite the red X already indicated.
  (5) when I run Toshiba Wireless manager shows that the card is present but transmission is switched off. "Please switch on with FN + F8"... arrgh!

  I tried already following as follows:
  (1) all installed available and past Sierra drivers Sierra 3 G driver (v1.1.140; 05/03/2010; 37.58 M)
  (2) because of the BIOS update to the latest version 1.50 = wireless connection switch is activated = and the WIFI worked very well...
  (3) installed last Toshiba Value added Package (v1.3.6; 09/04/2010; 44.36 M)
  (4) installed last Toshiba Flash Cards Support Utility (v1.63.0.5C, 28/12/2009; 9.38 M)
  (5) installed last Toshiba 3 G Connection Manager (v2.1.97, 20/05/2010; 29.28 M)
  (6) perform a restore of the entire system with recovery system (installation of a 1:1 copy of the delivered original from drive C :) partition
  (7) tried another way to complete a new installation of Windows 7 starter x 86 emty C: drive and installed the drivers from the Sierra as well as the added value of Toshiba utility to support package and flash cards
  (8) tried 3rd party software to control the connection 3 G MWCONN (found here: www.MWconn.info)-the config.exe can activate the transmission for a few seconds using the function "device / network analysis / start". This causes the broadband connection blue LED on the fronside of my netbook to be turned on for a few seconds. But üfter the test off again. So I turn on the transmission temporarily but not permanent. AND - THERE IS A MEANS OF TRANSMISSION OF SWITCH ON BY MEANS OF THE SOFTWARE! - But HOW...! ?

  What have I not tried again:
  (1) find someone with the same netbbok NB305-N410BN-G-online exchange the hard drive temporarily to test and market the Sierra 3 G in my netbook. It will be very difficult because I'm sitting in Germany actually...

  !!! Help, please! = does not, or no matter who else had same or similar problem...?

  Thanks in advance for any kind of useful tips and ideas!
  E U C A L L I

  and I also tried following:

  (9) the "Reset Flashcards" software solution

  EUCALLI

• can not activate ipad 2 after update March 2016

  downloaded the iOS 9.3 update.

  Update completed, connected to the network, then charges during a certain time but says impossible to activate iPad due to a network problem.

  tried unplugging the device from my iCloud account still does not. tried rebooting several times and tried a new wi - fi network.

  Seems that Apple has temporary problems with their activation servers. Many users report similar problem on older devices.

  https://support.Apple.com/en-us/HT206203

  You can also try the troubleshooting steps here: If you can not activate your iPhone, iPad, or iPod touch after installing iOS 9.3 - Apple Support

  Latest news:

  http://9to5Mac.com/

  r http://www.IMore.com/Apple-Working-iOS-93-Fix-Older-iPhone-iPad?utm_medium=Slide & utm_campaign = navigation & utm_source = im

  Hoppefully Apple will highlight the top soon.

• Can not activate iPad IOS 9.3

  Can not activate iPad 2 after upgrade to IOS 9.3. Error message: your iPad could not be activated because the activation server is temporarily unavailable. Also tried to connect to iTunes via a PC without success.

  Many people try to update right now. Try again later. If you still can not turn on, contact Apple support. -AJ

• Can not activate WIFI on Satellite P200-1FY

  Hello =)

  First of all, I apologize for my bad English, I will do my best to be understandable!
  So, I got a problem with my satellite P200-1FY: I can not activate the WI - FI card. I have try the combination of keys (fn + F8), and it does not work. I check the center of mobility of Vista in the Control Panel, it says that WIFI is not activated, but [I can't click on the button to activate it. | http://anonlinepieceofmymind.com/blog/images/wifi.jpg]
  I have the latest version of the driver for the wireless card, so I can't understand why it won't work. (but maybe just because I'm just a total beginner ^_^')

  Thank you for your time and help,
  Edward.

  Have you turned on the switch on the side of laptops?
  I put t know not which way the switch is present, but check it must be somewhere on the side.
  This switch must be turned on everything first, then you can use the FN + F8 key combination.

• has taken a hard drive from a HP pavillion laptop and I put it on a Toshiba laptop and now I can not activate

  I took a hard drive from a HP pavillion laptop and I put it on a Toshiba laptop and now I can not activate it and its telling me that windows is not genuine but also telling me that my product key is incorrect. I maybe need to all system files and things for a Toshiba.How can solve this problem?

  Hello Eduardo Montoya when you traded player having Windows installed on it? If so you will not be able to activate the operating system is an OEM manufacturer and will only work with the original system. If it is a retail facility, you will need to use the phone activation steps listed in the link below. Let me know if it helps. Thank you.

  Windows XP

  http://support.Microsoft.com/kb/307890

  Windows Vista

  http://support.Microsoft.com/kb/940315

  Windows 7

  http://Windows.Microsoft.com/en-us/Windows7/activate-Windows-7-on-this-computer