CS6 installation for the 1st time a updated for CS5

Similar Questions

• New Satellite C55-A-1UE trying to set up for the 1st time

  Hello

  Just got my new Toshiba Satellite C55-A-1UE turned on for the 1st time and went through the entire internet upward, account set up etc. Then it says loading software and please wait do not turn off.

  I've been sitting for more than 30 minutes of waiting and all I have is a circle go around round n as its load. Seems an awful lot of time for it to set up - someone can advise?

  > I've been sitting for more than 30 minutes of waiting and all I have is a circle go around round n as its load. Seems an awful lot of time for it to set up - someone can advise?

  Well, during the first configuration, the image of Toshiba must be configured and all necessary updates must be downloaded and installed. It takes time.

  However, it would be possible that the system would not answer more and in this case, you simply turn off the laptop and it should restart again.

  Usually the system would begin the configuration of the point of interruption

• had this message for the 1st time on windows, not sure if its real? performancewreckcontrol.in

  had this message for the 1st time on windows, not sure if its real?

  Hi Netbook,

  This isn't enough information.  What is the exact message and any word to Word with all the codes?  How it was received (a pop-up, aredirect, an e-mail (if so, what he want/say - leaving out personal information about you)?)  What were you doing when it was received?  Do you know what program sent you him?  What operating system?  What browser and version?  What security programs (names and versions of all of them?  The message say?  When it seemed (start-up or during work)?

  Here's help on how to respond to that and other information necessary to understand: http://support.microsoft.com/kb/555375.

  In the meantime, I would do anything he asked and guess that it's a scam, spam, malware and/or until we prove otherwise based on your comments.

  Thank you!

  Kosh

• can not find the installer for cs5

  Ive just upgraded my macbook with the new ssd and need to reinstall my photoshop. I can't find any installer for cs5 on adobe site. And the link to direct download where listed elsewhere in the forum serves me with an "access denied" - what to do? Monday closer

  If you follow the 7 steps, you can download the free trial here: http://prodesigntools.com/all-adobe-cs5-direct-download-links.html

  activate with your number of series.

  If you have a problem downloading, you don't follow all 7 steps.  Re-read, try again.

• How can I download Yosemite (for the 1st time)?

  I need to go to Yosemite (not El Capitan) for the first time.  To be clear, I'm not downgrading or restore - I never downloaded 10.10 before, so it is not an existing purchase.  Suggestions?

  Thank you

  Matthew

  PS: current execution 10.9.5 on a 13 "MacBook Pro (mid-2010)

  Go to a physical store of Apple and demand.

  (143911)

• Install BiApps for the 1st time

  Hi all

  I'm all bound again the question BI Apps, but read its documentation "Installation Guide for Oracle Business Intelligence Applications" on page 15 it is mentioned that the BI Apps has requirements such as OBIEE and ODI. However, I have to install OBIEE in 'Enterprise installation mode' and he installed WebLogic Server 10.3.5 and I have to spend to WebLogic Server 10.3.6 after installation of the Oracle's Applications of BI.

  The question is: How can I upgrade my version of WebLogic Server from 10.3.5 to 10.3.6?   What is an application of patch? Where can I find this patch?

  Thanks in advance,

  Concerning

  Here you will find the form in your Enterprise JDK install/MiddlewareHome/Oracle_BI1/jdk

  If you have installed Oracle Client libraries, then you can also use ORACLE_HOME/jdk

• I'm organizing the LR4 lib for the 1st time

  Hello

  I installed LR4.  When installing, it creates a Lightroom folder in my pictures folder (I have an iMac).  Also inside the images folder is a folder that I created called Mike LR pictures (I'm trying to follow the Kelby book).  In my "of Mike LR Photos" folder, I created a subfolder of practice and I was importing photos from my camera in there.  LR seems to have automatically created a folder of 2013 inside my practice folder and it is separated in the 2013 folder (created by LR) file for each of the 5 days I've been making and importing images.  Everything looks as it should in LR so at least LR know where my photos.  My question has to do with the 2 files generated in the folder LR LR:

  Lightroom4 catalog preview.lrdata

  Lightroom4 catalog.lrcat

  I leave these two files where they are in the folder LR?  There are no other files or photos in this folder.  Or should I "drag" them in LR Photos folder of my Mike where I store all of my photos?  I'm confused myself here, then you're probably very confused!  Bottom line, is that I have two and only two folders in my file photo of iMac: a Lightroom and the other LR Photos of Mike.  Soon I want to create a backup on an external hard drive, but I want to assure you that my LR library is organized as it should be the first.  I've read many warnings about to separate the catalog files and lrdata in the photos.

  Thanks, Mike

  Great!

  Now I would suggest you do something else immediately: Configure Lr for the backup of the catalog.

  In the library Module, will > edit > catalog settings > general tab. In the small window, select and click on .

  The next time that Lr closes, the backup dialog box will. You can select a location for your backup of the catalog - an external hard drive would be an excellent choice.

  You also have the possibility of or to make the backup. The optimization of the catalog and preview is included in the backup. This will keep both in good shape, while Lr will be no problem to open and work effectively with them.

  Please note: this backup of the catalog, not photos. There is no provision in Lr for photo backup, you must do this in your operating system.

  Lr beginners sometimes make havoc with the catalog. In such a case, a backup is handy!

• Satellite P750 stops at the start of the 1st time but then works great 2nd time

  Hello
  My Satellite P750 always stops on the first time every day, but the 2nd boot works fine and no other problems...

  I press the Start button and it runs for maybe 10-20 seconds then stops... She does both on battery or power outlet...

  If I try to start again after that, it starts fine... sometimes, it gives the possibility to start in safe mode, or run the Startup Repair tool, but it always starts well and works normally...

  I tried to start repair when the option was given, and it is immaterial that the next day, he does the same thing again...

  Any advice appreciated, and Im a bit concerned that one day he did not start the second time...

  The laptop is only around the age of 6 months and otherwise runs great...

  Thank you

  Hello

  Recovery of the laptop back to factory settings.
  You use the Win 8 or Win 7 system?

  Usually, books Win 7 supports a HARD drive recovery by pressing F8-> fix my computer-> drive HARD recovery.

  If the same problem appears on the right after the system has been recovered, I guess there is a hardware problem and a technician must check the hardware parts.

• Where can I find the installer for CS5 Production Premium page?

  I need to reinstall my copy of CS5 Production Premium. Where can I find the installation for this page?

  Check your Adobe account online to see if there is a link to download from there.

  Alternatively, you can download the demo version of the software through the page linked below and then use your current serial number to activate it.

  Don't forget to follow the steps described in the Note: very important Instructions in the section on the pages of this site download and have cookies turned on in your browser, otherwise the download will not work correctly.

  CS5: http://prodesigntools.com/all-adobe-cs5-direct-download-links.html

• CS6 installation with the new MacBook Pro problem

  I just got a new MacBook Pro. It is currently running 10.9.1

  I have installed my software CS6. Other programs seem well but AE does not open and gives a message of error-10810

  Any advise?

  Stan

  Have you installed the 11.0.4 update?

  http://www.Adobe.com/support/downloads/product.jsp?product=13&platform=Macintosh

  http://helpx.Adobe.com/after-effects/KB/effects-launch-Mac-OS-109.html

• Watch multiple videos at the same time in first Pro CS5

  Hello

  Recently, I did a performance with two cameras. I was wondering if there is a way to see two sources at the same time (side by side) to help me choose which images to use at this time.

  All advice is appreciated.

  Bob

  You have two choices:

  (1) use multicam: http://www.youtube.com/watch?v=C8M-Ez9r58Q

  (2) place a clip on top of the other, balance each clip to 50% size and reposition so that they are next to each other.

• Di Shutdown does not work, got the blue screen, beware, if it's the 1st time, etc., bios .updated .shutdown worked for awhlie, then got the same blue screen on another attempt to stop

  I had trouble with the fans so I unplugged everything, pulled out the memory and put it in. Shortly after received warning on a stop. I've updated the bios and things worked fine for one night. The following day I uninstaaled some programs and blue rebooted and got the screen again. I can right through the blue screen and sign, but have to stop with button / stop.

  Hello

  What is the exact error message on blue screen?

  This error message can point to a hardware or software that causes this problem. If the computer restarts after the Blue error screen, disable the automatic system failure restart option allows to capture the error message on blue screen.

  Check if the problem persists in safe mode and after the same return.

• Firefox "Unable to connect" message after installation for the 1st time on the new computer Windows 8.1

  Following install unable to access any site

  See this support article:
  https://support.Mozilla.org/en-us/KB/Firefox-cant-load-websites-other-browsers-can

• update of security - KB2538242 has been downloaded and successfully installed the thirteen times. Update always calls the installation

  I downloaded and installed successfully KB2538242 security update, thirteen times. Calls to the update and if I use auto update update end of session, the computer does not stop

  Hi joe_76,

  See the article after some troubleshooting for your question:

  http://support.Microsoft.com/kb/910339

  I hope this helps!

• Trying to use the 'Digital copy' DVD for the 1st time, I received instruction to upgrade the security of my Win Media Player 11 components but the upgrade button is not selectable.

  I'm running Vista 32 bit SP 2 on a laptop HP Athlon X 2 with 4 GB RAM & nVidia graphics.

  For some reason, the upgrade button is "grayed out".  I searched for the upgrade of security required through various web pages of MS nothing helps.  What should I do next?

  Hi GregRosychuk,

  Follow the steps in the article.

  After that you are prompted to upgrade the DRM components on a Windows Vista-based computer, Windows Media Center cannot perform a security update

  http://support.Microsoft.com/kb/945612

  When you try to use Windows Media Player 11 to play a digital camera digital rights management (DRM) - multimedia file protected, the media can not play

  http://support.Microsoft.com/kb/925705

  For reference:

  http://answers.Microsoft.com/en-us/Windows/Forum/windows_vista-security/security-component-upgrade/2d378793-f646-44b5-A710-d6d6888a8717