Disk space lost after the restoration of Bootcamp - El Capitan

Similar Questions

• lost all the restore points after the reinstatement of windows

  Original title: have just re-recorded windows software, now Ifind I lost all the restore points. How can I get the old one back?

  Windows has been registered online. Checked restore points after recording and found that the only listed restore point was created when the software has been registered. How can I find the previous restore points?

  If you reformatted and reinstalled windows, you will lose any restore points. Theyre gone

• Error message, not enough of disk space to run the defragmentation

  Cleaning disc already used and removed unused programs.  Still get popups that say "disc not enough disk space for number of updates available" "not enough disk space to run defrag" "not enough disk space to run the system restore" I'm positive, I have more than 200 MB of free space on c:, (if updates are somewhere on my computer and using all the space?)  This xp computer is not much used, and certainly didn't have the amount of used space?

  Anyone know where is the problem?

  None of this has worked.  What has worked is that I discovered that Norton Antivirus used up to 57% of my c drive.  Entered their downloads of programs and the program downloaded 2012, which automatically deleated the old Norton application.  Apparently, whenever the old application done an update to download, it would wipe out not at the same time old files is no longer needed.

  in any case, I now 57% free space.

  Thank you

• How can you recover disk space occupied by the updates of Windows XP, leading up to the installation of Windows XP SP3? __

  How can you recover disk space occupied by the updates of Windows XP, leading up to the installation of Windows XP SP3?

  SP3 after Installation Cleanup - http://www.aumha.net/viewtopic.php?f=62&t=33827 MS - MVP - Elephant Boy computers - Don ' t Panic!

• How to eliminate the split after the restoration of browser screen?

  FF 29.0.1 running on OS x 10.8. From time to time, from FF (after killing him) and the restoration of all sessions, results in each window with tabs displayed in a split screen. The upper part is about 4 "high, followed by a seam, then the site itself. Resizing can completely eliminate the useful portion--unable to shrink beyond the joint.

  Open a new tab results in a screen divided; Open a new window appears normally.

  The problem occurs only after the restoration of the tabs - never when FF is normally closed.

  Suggestions?
  Thank you.

  Hi nxtr, your test Mode without fail gives strongly suggests that one of your extensions is to create the gap.

  If you have not checked recently updates to the extension, you can do it from the page modules. Either:

  • Command + shift + a
  • "3-bar" menu button (or tools) > Add-ons

  In the left column, click Extensions. Then, above the list, click on the "gear" button Check for Updates.

  If they are already up-to-date, you can try to disable selectively non essential. I hope that the problem is caused by one of.

• Firefox thinks that I don't have enough disk space and cancels the download when it is almost finished.

  So, recently, I was downloading a pretty huge file for a game (4.5 gigabytes), and it was almost over, when an error emerged, saying there wasn't enough disk space for Firefox to download the file. At the time, I had just enough disk space to download the file (Yes, I checked and made sure). Download became unresumable, and I was incredibly annoyed to find that I had to download it again, because my download speed is not very good at all. I put in the night and noted where he stopped, and in the morning, when I checked it, he stopped at the EXACT SAME place, which is at about 4.1/4.5 GB. I did a lot more room since then and I am downloading for the third time now. If this happens again, how can I solve this problem? Thank you.
  In addition, it is a .dat file. I don't know if this has an impact any on what can cause this, but if anyone knows anything, please let me know.

  Hello, please make sure, that you do not save the file on a volume formatted with the FAT32 file system, because it cannot store files larger than 4 GB...

• Not enough disk space to convert the iPhoto photo library

  My wife iPhoto library has about 9 500 photos. She has a MacBook Air, which has limited hard disk space, so we put his iPhoto library on a SD card (which is still in its SD slot). We decided to convert the iPhone photo library. When the process is started, it happens about 4% on the progress bar when a popup said that there is not enough disk space to perform the task (said to 72GO). How can I complete this process? She wants to ensure its iPhone and iPad Air can all share all the photos via iCloud. Can I put the library of Photos on the SD card too? Once the synchronization of library of Photos with iCloud, not all large digital images disappear from MacBook Air and only a miniature remain (like on the iPhone and the iPad)?

  I decided to try the procedure on my original post on my MacBook Pro.

  I copied the Library.photoslibrary Photos of my MBP to an external hard drive connected to my MBP.

  I did an "Option" + then click on 'Photos' selected the "Library.photoslibrary Photos" on my external hard drive. This produces the following pop-up message:

  "This library contains items to download from iCloud photo library".

  "To download the complete library, delete the incomplete elements, then set this library as the library of the system preferences and activate iCloud photo library. This will disable iCloud photo library on other libraries. »

  "Delete the incomplete items" or "quit".

  I clicked on "Quit" and posted above.

• Explorer.EXE error after the restoration of the ERD Commander

  Dell Inspiron B130

  Windows XP Service Pack 2

  Recently performed a HD format and new installation of XP SP2. After I installed all the drivers and others, I checked that the system was operating normally. After a few days of use, Windows Update downloaded Service Pack 3 and asked me to install. I started to install SP3, but at about 50%, the laptop battery is dead at Midway through the installation. I plugged the laptop on the power source and power. I restarted the laptop and XP started only a completely black screen and the white slider. No ALT + CTRL + DEL, desktop icons, etc.

  I rebooted the laptop of ERD Commander, ran the restore system and selected the first available Restore Point. Point of restoration chosen was recorded a few days before, and was the first recorded point after the clean installed XP. I rebooted the XP system. Wallpaper loaded with white cursor, but NO start menu or desktop icon. A message appears saying "Explorer.EXE Application error, press OK to exit the application" or something very similar. Did not write the error code, but can get if necessary. If I press the OK button (which is my only option), there is still no icons on the desktop or the start menu. Only the cursor. No access ALT + CTRL + DELETE or something like that.

  Thinking about completely wipe the system and reinstalls the operating system. Any suggestions before I jump in this solution?

  Explorer.EXE error after the Restore Point of ERD Commander. Dell Inspiron B130. Recently clean installed XP SP2 on laptop. Installation of SP3, to 50%, battery dies the laptop right in the middle of the installation of the SP3 update. Restarted, XP starts with black screen with cursor only. ERD restart order and restore XP to the last known good config (I choose point immediately after XP clean install). Reboot to XP. Now the wallpaper shows as well as the error message saying "Explorer.exe Application error, click OK to exit Explorer" dialog and then I can't access anything. Any ideas?

  Hello

  What is the full and exact error message?

  Step 1: Check if you are able to boot into safe mode without any problem. If you are able to boot into safe mode without any problems then try to perform the clean boot to safe mode. Also disconnect any external devices connected to the computer.

  Reference:
  To start the computer in safe mode
  http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/boot_failsafe.mspx?mfr=true
  How to configure Windows XP to start in a "clean boot" State
  http://support.Microsoft.com/kb/310353

  Step 2: If you are still having the same problem, then you can the steps at the bottom of the article.
  How do I recover from a corrupted registry that prevents Windows XP startup
  http://support.Microsoft.com/kb/307545

• Windows Vista - after the RESTORE partition HARD drive: WINDOWS COULD NOT COMPLETE the INSTALLATION. TO INSTALL WINDOWS ON THIS COMPUTER, RESTART THE INSTALLATION

  Hello

  I have WINDOWS VISTA and just tried to reinstall my laptop of restoration on a HARD disk partition.

  The restore went through, but then I got the error: WINDOWS COULD NOT COMPLETE the INSTALLATION. TO INSTALL WINDOWS ON THIS COMPUTER, RESTART THE INSTALLATION

  When I press 'OK' (which is the only option), it tries to start again, until I get the same error through the black screen.

  How can I get out of this loop please?

  Thank you.

  Lucie

  Hello

  For any problem with the help of the recovery Partition that has been copied to the hard disk by the computer manufacturer, you must contact them.

  This recovery process is the manufacturer, not Microsoft.

  ________________________________________________

  You never told us why you wanted to do a restore. If you had serious errors and the recovery process does not work, you will have hardware problems. BUT we're only guessing at this stage due to lack of information to help you.

  See you soon.

• There is not enough disk space to create the shadow copy of volume of storage location 0 x 80780119

  Original title: create system image error - not enough disk space?

  I am trying to create a system image on my external hard drive reformatted with over 400 GB of free space. I get the following error message: «is not enough disk space to create the shadow copy of volume of the vault...» 0 x 80780119"backup should take up to 82 GB of disk space. I have more then enough available space.  External hard disk is formatted NTFS. My internal hard drive has more than 150 GB free. 64-bit Windows 8

  Any suggestions?

  Hi Mohammad,.

  I thought that's kind of a joke to check the drive on my brand new Microsoft Surface, but I figured it's worth a try. It worked! You are a genius, thanks man.

• Error 16 after the restoration of Photoshop Time machine

  My HARD drive died. After the restoration of Photoshop CS6 and Photoshop Time CC14 Machine again SSD or opens. I get the error 16. I restored adobe all the library files and all permissions are correct.

  Migration of Mac with Time Machine WILL NOT WORK with the Adobe program activations due to hidden registration files

  Sign out of your account... Uninstall... to run vacuuming...

  -http://helpx.adobe.com/creative-cloud/help/install-apps.html (and uninstall)

  -using the vacuuming after uninstalling and prior to the relocation is necessary

  -https://helpx.adobe.com/creative-suite/kb/cs5-cleaner-tool-installation-problems.html

  -Restart your computer... Sign in to your account... Reinstall

• How can I restore Adobe Acrobat Professional XI (bought earlier this year, in February; education version) after the restoration of Windows 7 to factory settings? I tried the download link provided by email I received when I just bought, but it didn't wor

  How can I restore Adobe Acrobat Professional XI (bought earlier this year, in February; education version) after the restoration of Windows 7 to factory settings? I tried the download link provided by email I received when I just bought but it did not work.

  Hello

  Use the following link to download:-

  https://helpx.Adobe.com/Acrobat/KB/Acrobat-downloads.html

• You do not have enough disk space to create the database...

  Hi all
  
  During the creation of the database, I received this message:
  
  + "You don't have enough disk space to create the database. +
  + You must at least 939008 on/U01 KB, you only 1981480960 available KB. +
  
  + Please allow more free disk space. » +
  
  I checked:
  Root@server# df h
  Size of filesystem used avail capacity mounted on
  / dev/dsk/c4t600A0B800033696A000017534E2F6F67d0s0
  2.2 T 2.2 G 2.2 T 1% / U01
  
  My Info:
  DB-INSUP2-C2VAS of SunOS 5.10 Generic_142909-17 sun4u sparc SUNW, Sun-Fire-V890
  Oracle database: 10.2.0.1
  
  
  Help, please!
  Thank you!
  Dan.

  Thank you all,

  I got the same warning messages and I created the point of editing/U01 with 50 GB for installation of Oracle and creation of database with no caveat. In my opinion, the warning appeared as the point of Assembly/U01 is too large (2.2 T).

  Sorting.

  Published by: hqtri on August 4, 2011 23:33

• Cannot reinstall PSE 7 after the restoration of PC (Win XP). Impossible to uninstall, STUCK. Help, please.

  Error message when you try to start the 7 Elements after the restoration of PC (Win XP) "couldn't start b/c the application configuration is incorrect". When you try to uninstall 7, it doesn't appear in the Conrol Panel. But there is a Photoshop 7 folder in Program files. If someone could HELP Please, it would be greatly appreciated. I use this program so much!

  Thank you in advance...

  Here's the Adobe documentation to manually uninstall PSE7:

  http://kb2.Adobe.com/CPS/405/kb405847.html

  Ken

• Database is underway after the restore and recovery

  Database is in the waiting state after the restore and recovery.
  The database cannot start today and it displays an error message: 2 log file can be archived. Then I run the following command:

  SQL> select group#, sequence#, bytes, members, status from v$log;
  
      GROUP#  SEQUENCE#      BYTES    MEMBERS STATUS
  ---------- ---------- ---------- ---------- ----------------
           1        452   52428800          1 CURRENT
           3        451   52428800          1 INACTIVE
           2        450   52428800          1 INACTIVE
  SQL> ALTER DATABASE CLEAR UNARCHIVED LOGFILE GROUP 3;
  
  Database altered.
  
  SQL> ALTER DATABASE CLEAR UNARCHIVED LOGFILE GROUP 2;
  
  Database altered.
  SQL> alter database open;
  
  Database altered.
  
  SQL> shutdown immediate;
  ORA-01109: database not open
  
  
  Database dismounted.
  ORACLE instance shut down.
  SQL> startup
  ORACLE instance started.
  
  Total System Global Area  566231040 bytes
  Fixed Size                  1220580 bytes
  Variable Size             125829148 bytes
  Database Buffers          432013312 bytes
  Redo Buffers                7168000 bytes
  Database mounted.
  Database opened.

  But when I try to log on by using the EM console, it shows that the database is not open. Then I restore and recover the database by using the EM Console. But the database and then enter in pending status.
  What to do next?

  Stop the console 'EM, and then restart it. I hope all is well.