His SUCCEEDING with Microphone continuously
Hello
I'm working on a project and I need to be able to know when an alarm (alarm) is light with LabView. I try to directly use the microphone on the computer and now I can read the signals with the block "succeeding her.
I want to do is listening constantly and do a FFT of signals every 100 ms to see if my alarm is present (with a specific frequency).
My problem is that there is always a dead time of almost 300 ms between each measurement of the sound with the microphone and if I lose a large part of the signals.
Is it because of my hardware system (micro computer) or it is possible to improve it with the help of another block or other configuration?
I already searched the forum but not found this information.
Thank you
Jérôme
Hello
There is an example in the Finder for example called "continues its entry.
I think that this VI can solve your problem with the sync.
Concerning
Marco Meier
Tags: NI Software
Similar Questions
-
HP 15 r-022TX: how to headset with microphone build installation in hp 15 r-022tx
Hey,.
I have hp 15 r-022TX laptop and in this laptop as you know there is only 1 location of jack of 3.5 mm headphone jack.
I want to use the headphones with microphone in the generation (philips SHM1900) and for that I bought a jack 2 in 1 to connect to the laptop
Jack details are here ("http://www.flipkart.com/callmate-asc-iphone-audio-split-data-cable/p/itmdh9nfhfjz35fc?pid=ACCDDRSYRH... )
but using this laptop still jack uses his microphone in the generation not the headset.
headset works with the plug, but I can't use his microphone.
I am using windows 7 ultimate (64 bit).
can someone help me.
Thank you.
HI @Rajatsharma_yam ,
Thank you for your request, I will do my best to help you.
I understand that when you connect your headphones combo and mic the MIC part does not work.
You did all your Windows updates?
Did you run HP Support Assistantto ensure you have the latest HP drivers installed.
If you look at the physical connector can bands how you see on it? You should have 3 or 4 strips.
Are you sure that they are connected in the helmet and the port on the laptop.
When you have the combined headphone connected go to control panel / sound and open the window.
Click the recording tab, is the listed microphone? You should be able to select and configure from this window.
Here is a link to headphones and headset problems (Windows 8) resolution which can also be of assistance.
Good luck!
-
Because my father died, he left his phone with us. ID or pword is available and now its blocked. Can I reuse and reset or do I throw? Cannot find even the purchase of documents.
If you are unable to prove original owner Apple cannot help you.
-
Using headphones with microphone
If I buy a Logitech G230 helmet. It has two audio jacks of 3.5 mm (one for the microphone) and one for the actual headset
I have a MacBook Pro (13-inch, mid 2012) that has an audio jack.
If I bought this headset adapter:
Would I be able to use a headset with my laptop?
-Thank you
I don't know anything about this product but suggests that you can get a USB headset with microphone.
-
the friends hyii UA HUD need help how to make a backup of the files from his deleted with (shift + delete) memory card
Hello
It seems that you want to restore the files removed from the memory card.
I will definitely help you with this.
I would say you can search the Internet for data recovery software by using your favorite search engine.
Warning: Using third-party software, including hardware drivers can cause serious problems that may prevent your computer from starting properly. Microsoft cannot guarantee that problems resulting from the use of third-party software can be solved. Software using third party is at your own risk.
It will be useful. If you have any other questions, feel free to let us know. We will be happy to help you.
Thank you.
-
What does the acronym for error 800F020B code?
I tried to update my new S3 Galaxy and some updates succeeded with the exception of
one with the error 800F020B code. It holds until the completion of the update. Help, please
as I'm not in the computer. Thank youIf the update is for your 3 contact your telephone service provider or Samsung Galaxy.
-
SBH 52 headphones with microphone
I used this camera and everythink works fine except one thing. When I connect my headset with microphone (romaric Piston 2.0), and then uses SBH52 build-in microphone instead of what is in my helmet. I tried Googling this problem, but without success. I got something misconfigured or this device cannot manage an external microphone? Thanks for the responses...
Hello
As a built-in microphone in SBH52, the audio jack in SBH52 is reserved for the headphones and headsets with an external microphone not.
-
Remember - this is a public forum so never post private information such as numbers of mail or telephone!
Ideas: in my laptop is Explorer.exe does not load at startup on my account, his work with the guest account. Also it does not manually with the new process. Kindly help me.
I have seen at redistry Edit it's explorer.exe in winlogin sell attribute.
Hi HiteshAstan,
one) don't you recall making any changes to the computer before this happened?
(b) what exactly happens when you sign in to your account? You get a specific error message?
Step 1: Let us check if the problem persists in safe mode
Access the menu advanced startup options by turning on your computer and pressing the F8 key before Windows starts. In the advanced startup options select safe mode
http://Windows.Microsoft.com/en-us/Windows-Vista/advanced-startup-options-including-safe-mode
If the problem persists, you can deduct that the user account is corrupted
Step 2: Create a new administrator account and then try to repair your user account
Create-a-user account
http://Windows.Microsoft.com/en-us/Windows-Vista/create-a-user-account
Difficulty of a corrupted user profile
http://Windows.Microsoft.com/en-us/Windows-Vista/fix-a-corrupted-user-profile
After the back if you have any questions
Thank you, and in what concerns:
Ajay K
Microsoft Answers Support Engineer
Visit our Microsoft answers feedback Forum and let us know what you think.
-
Gigaware USB headset with microphone, has problems hearing Netflix on Firefox
I have a gigaware usb headset with microphone. I searched for the latest driver updates. I am able to hear the system sounds, pandora on my helmet, but Netflix via firefox is still coming through the laptop speakers. I use a toshiba satellite with windows Vista
Hello
1. have you checked if the problem occurs with other browsers?
2. have you installed the latest drivers for your helmet?Check if the problem occurs with Internet Explorer.
In addition, uninstall and reinstall the Silverlight player and check if it helps.
You can post your request in the Mozilla Forums for assistance.
Here is the link:
http://www.Mozilla.org/about/forums/Kind regards
Afzal Taher-Microsoft Support.
Visit ourMicrosoft answers feedback Forum and let us know what you think. -
Headset with Microphone plugged in but not detected
Recently, my brother got a Philips SHM7410U Philips PC Headset with Microphone and tried to make it work for him. It's probably 'plug and play' as it came with no instructions except that. It is plugged in, but my computer does not detect the microphone or headset. The headphones are not listed in the playback devices, and while the microphone is listed, it is said that it is not plugged. They are certainly in the right decision. Not too knowledgeable in the resolution of this type of problem and could use some help.
Hi Genae,
I thank you for your message and gives us a chance to help you. I see that you can not use the headphones and the microphone.
The headphones and the microphone work on another computer?
You can follow these methods to check whether the problem is resolved.
Method 1: Run the hardware troubleshooting tool.
Follow the steps in this link
http://Windows.Microsoft.com/en-us/Windows7/open-the-hardware-and-devices-TroubleshooterMethod 2: Select the default values of the device
(a) click on 'Start', then 'Control Panel '.
(b) click on 'hardware and sound '.
(c) Under sound, click "manage audio devices.
(d) click on the playback device you want to output sound.
(e) click set default.
(f) do the same for the microphone and then click OKMethod 3: Updated drivers
You can follow the steps in this link to update the drivers.
For more information.
If the headphones do not work on another computer, contact the manufacturer.
Feel free to use the forum for any other issue of Windows, you may have.
-
I am a webmaster for a non-profit, 501 c 3 organization. I managed to get a (educational) license non-profit for Acrobat Pro XI, some time ago, but the PC has spent since then, taking his information with her, unfortunately. How can I restore Acrobat Pro XI on my new PC?
I am also interested in getting some kind of equivalent license for standalone applications (not CC), or something similar to your previous suites of e-learning. My company (Gilbert & Sullivan Light Opera Company of Long Island) cannot afford to pay the monthly fee for cc licenses and prefer something I can download and use on my PC.
There are two addresses of email related to my account: [email protected] and [email protected] .
I hope I can get support or useful information on this subject.
Thanks in advance,
Andrew Schwartz
Webmaster, Gilbert & Sullivan Light Opera Company of Long Island
Hi Andy,.
Please see the following documentation for non-profit organizations:
http://www.Adobe.com/mena_en/education/nonprofit-eligibility-Guide.html
Kind regards
Rave
-
I do P2V of a Linux Machine, his failure with the error "FAILED: an error occurred during conversion:"root is not found""If anyone can suggest how to solve this...» He does not drive partition root to copy don't know why his account right there.
I solved the problem myself... This is because the Version of Vcenter Converter. I'm using Vcenter Converter 5 to P2V a server Linux RHEL5.2, its not supported by Vcenter Converter 5. That of why I've done P2V using Vcenter Converter5.2 and accomplished.
-
Hello
When I try to download standard acrobot his inviting with login user password and its not be downloaded.
When you (or someone) first put on your computer, you (or someone) had to choose a password. This protects your computer, and you need to install most software or change the system. We cannot help you if you forget it, sorry.
-
How to get the IP or hostname of the computer that the user is connected to his office with view 4.5
Is this even possible and server display does not store this information?
Best regards, Najtssob
This information is stored in the registry of the virtual office. For more information, see this page: use the VMware View Client information.
-
Problem with microphone recording in Windows 7
Original title: problem with the microphone
Sir my drivers are perfectly fine but my microphone does not work and my default set and apply the buttons are grayed out in the record of devices.when im trying to put my problem its evrything saying isn't alrght theres no problem in my drivers... when im recording my voice, I found another seems not my voice... what should I do Sir
Hello
1 - is a built-in microphone? If Yes, what is the brand and model of the computer?
If not, then what is the brand and model of the Microphone?
2 did you recent hardware or software changes to your computer before this problem?
3. what applications do you use to make use of the Microphone?
4. are you able to record sounds using the sound recorder?5. what exactly do you mean when you say an different sound and not my voice?
I suggest you to follow the steps and check if it helps.
Method 1:
Try to run the Audio recording utility and check if it helps.
http://Windows.Microsoft.com/en-us/Windows7/open-the-recording-audio-Troubleshooter
Method 2:
I suggest you to check if the microphone is set as default as playback devices.
a. click Start, type Sound in the area start search.
b. click on his research at the top of the start menu.
c. click the Read tab. Notice the check mark next to the default device. For most users, the default device is speakers. Make sure that the audio settings are configured as expected. Follow these steps:
d. on the Read tab, select the playback device, click Properties, click the Advanced taband make sure that the default Format is set to the value you expect. When you are finished, close this window to return to the previous window.
e. on the Read tab, select the playback device, click set upand make sure that the configurations are set correctly.
f. Select the audio device you want as default audio deviceand then click on set default.
g. click OK to save your settings and close the sound dialog box.Hope this helps and keep us posted.
Maybe you are looking for
-
I use the latest version of Firefox (31.0) on Windows Pro 8.1. I wanted to mimic OS X way of scrolling in the window of the browser called 'natural' to scroll. I edited the registry setting for my logitech mouse and scrolling works perfectly as I wan
-
Satellite L50-A-160 does not start after the Bios Update
Hi, first of all, this is first post. I have 2 satellite L50-A-160 with bios 1.1 Problem: seems to go to sleep after a few minutes, even working on them (even with both) So, I found an updated version 1.9, downloaded and running on one of the laptops
-
replacing the hard drive for 212us cq60
How can ensure me that I will order the right drive? What part of the card product will tell me that the replacement of the hard disk will adjust the 212us cq60?
-
Images appear as grey areas with the link, ex: CIMG3399. JPG, but I am unable to do anything. Any suggestions?
-
Windows update error: 0 x 80240036, the page cannot be displawed.
The same multibordure error in Microsoft update as well. I've reformatted HD and re-installed Windows XP to the original settings. Now I can't update any software!