Lync2010

Similar Questions

• Lync 2010 - different tone for internal vs external calls

  Is there a way to Lync 2010 to make a distinction between internal vs external calls? Now, if you are already online, you get a beep if a call comes in to the general response group or if it comes from an internal caller.  How can I configure the system so that people can make a difference? All suggestions will be useful!

  Hello

  The question you have posted is related to Lync2010 Forum, and would be better suited to the TechNet community.

  Please visit the link below to find a community that will provide the support you want.

  http://social.technet.Microsoft.com/forums/en-us/category/OCs/

  You can also check this link: http://technet.microsoft.com/en-us/library/gg195677.aspx

• Cisco VCS and integration Lync2013

  Hello!

  Could you tell me please, when CISCO officially support Lync2013 - free new software for VCS - C and documentation on integration?

  The main interest is the possibility of transferring video between CISCO/MCU and Lync endpoints on the H.264 Protocol, who hails from Lync2013.

  Right now, I've got VCS - C and RTM Lync2013 X7.2. During the video call without AMGW appeal established as audio only.

  When using with Lync2010, it worked on Protocol H.263 and CIF resolution.

  Evgeniy salvation,

  We are currently investigating the possibilities to achieve interoperability between Lync 2013, VCS and video devices on the side of the VCS standards-based, it is a work in progress and at this stage, it is to early to provide any factual information on when interop will be available.

  In contrast to Lync 2010, Lync 2013 does not support H.263 for video and it so that will remove the OCS/Lync integration. I do however think that you should be able to make a two-way video between Lync 2013 and VCS-joined endpoints if you use an AMGW tried that yet?

  Thank you

  Andreas

• GW 3610

  Hello

  I'll set up an AM GW 3610 but in Lync 2010 infrastructure there is not a "Director" server, config. manual says what OCS/lync destination address field must be a Director signaling server, lync Server I set up with?

  Thanks in advance.

  Please always mention the version numbers of the components used and some info about the deployment.

  As a general rule to check the documentation of all first:

  http://www.Cisco.com/en/us/docs/Telepresence/infrastructure/VCs/config_guide/Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2.PDF

  http://www.Cisco.com/en/us/docs/Telepresence/infrastructure/VCs/config_guide/Cisco_VCS_Microsoft_Lync_and_Cisco_AM_GW_Deployment_Guide_X7-2.PDF

  If you see lync2010 on page 35 deployment guide:

  

  So, if you do not have a director (pool) and only have the FEP (front-end server / processor), point you to the EFF.

  Please remember useful frequency responses and identify useful or correct answers.