Mac 10.5.8 update?

Similar Questions

• updated for CS5 running scanner Epson Perfection Photo 700, Yosemite (mac os 10.10), updated click on 'Import' and CS5 does not show scan dlick on "Import" in photoshop

  updated scanner Yosemite (mac os 10.10), updated running CS5 software Epson Perfection Photo 700 - when I click on "Import" CS5 does not scanner - what should I do so that he can recognize the scanner?

  TWAIN is 32 bit and you most likely run CS5 in 64-bit mode. See the following article:

  PHOTOSHOP PLUGINS TWAIN why then I scan inside Photoshop more? TROUBLESHOOTING TIPS

  Gene

• Graphics card for Mac Pro 3.1 update

  Hello

  I recently bought a Mac Pro 3.1 running El Capitan and desperately need a graphics card update.

  Looked at a Nvidea GE Force GTX 980 and found one on ebay. Spec as follows:

  NVIDIA GeForce GTX980 graphics controller

  Tech stuff:

  Plug motor GTX 980:

  2048CUDA carrots

  1126Base clock (MHz)

  1216Boost clock (MHz)

  144Texture fill rate (GigaTexels per second)

  Memory card GTX 980:

  7.0 clock GbpsMemory

  GBStandard 4 memory Config

  Interface GDDR5Memory

  256 - bitMemory Interface width

  224

  Display support:

  5120x3200Maximum digital resolution *.

  Resolution VGA 2048x1536Maximum

  Dual Link DVI - I, HDMI, 3 Standard display connectors x DisplayPort 1.2

  4 displaysMulti Monitor

  YesHDCP

  InternalAudio input HDMI

  Dimensions 980 GTX graphics card:

  4.376 inchesHeight

  inchesLength 10.5

  Double-widthWidth

  Couple of questions...

  1. I asked the seller if is compatible with Mac (he did not know the answer). They are compatible for both mac/pc or is there a version for each? It will work in a mac pro 3.1?

  2. do I need to provide a source of additional power for this or already installed cables will suffice?

  Thank you very much

  Yes it will work in a 3.1 based on:

  http://www.macvidcards.com/store/P42/Nvidia_GTX_980_4_GB.html

  You must 10.10.5 or later version.

  You don't need additional power but yoo must Nvidia drivers

  http://www.macvidcards.com/drivers.html

  If you do not have a card that has the firmware flashed for a Mac you will not see a splash screen, you can't use special startups like recovery, startup key Option since nothing appears on the display

  This place with flash a card PC for a Mac for $180

  http://www.macvidcards.com/store/P81/Nvidia_Flashing_Services.html

  You need to install the disks required before exchanging cards. If the existing card does not require the use of one of the connectors on the logic voard yo can likl; EU uhave two installed maps

• Mac incredibly slow after update of El Capitan

  Hello world

  I own a Macbook that I bought in 2013.

  Data sheet:

  13 "medio 2012

  Processor: 2.5 Ghz Intel core i5

  Memory: 4 GB 1600 Mhz DDR3

  Four days ago, that I've updated my system to El Capitan v10.11.6. At first, he seemed to be well-developed, but after about 12 hours, it started to become really slow - and I don't speak incredibly slow. Almost all of the clicks or typing a letter takes forever.

  I downloaded a free version of CleanMyMac, and it shows that I have to constantly only between 50 and 300 MB of RAM free. I also read that you should let Spotlight indexes all yout files, but it maintains at the end and starting over.

  I have about 90 of my 499 GB hard drive on the left.

  Any ideas or solutions?

  Two suggestions:

  Dump to clean my mac it's crapware.

  Run EtreCheck and report results here - often your problems are caused by incompatible third-party software and someone here might be able to spot it.

• Thunderbird Mac will not automatically update if I re - install (overwrite app) will be always kept all of my old emails and local files?

  Im stuck on the 24.4.0 version and its always asking me auto update, but when I do its still stuck on the same screen below after leaving it ages.

  I thought that might be better to download the latest 31.5.0 and overwrite the mac app, however I fear that it may trash all my folders complexes and 5 email accounts Ive configured there?

  Everybody does it work before or a way to sort the automatic updates?

  Thank you!

  All your mail and your preferences are stored in your profile for tuberculosis and are not overwritten when you update to a new version; However, it is always a good idea to make a backup of the directory profile, just in case something goes wrong. See https://support.mozilla.org/en-US/kb/profiles-tb to locate your profile directory.

  See also https://support.mozilla.org/en-US/kb/thunderbird-software-update-failed

  BTW, I'm not a MAC person, but the foregoing applies to all systems.

• The limits for OSX Mac Pro 3.1 update in early 2008

  I wonder till I can upgrade the operating system of my Mac Pro 3.1

  I currently have El Capitan

  I would spend the money, do some hardware upgrades (SSD, RAM)

  and I wouldn't, being an early 2008 to discover the next year general hardware of the machine is too old

  and does not receive any other updates or any new OS

  I do not pretend to have updates of the system for another 10 years but I don't find me 'old' next year

  Unfortunately, there is no way of knowing what will be obsolete next year or the year after, etc.

• No one knows what Citrix and doesn't load it on my Mac after the last update?

  Hello: I downloaded the OS X El Capitan (10.11.5) update and when I restarted my Mac Pro, I see a program called Citrix.  Can someone e tell me what Citrix and how does it work?

  Citrix manufactures of network connectivity. It's probably a corporate VPN software. There is no part of Mac OS X and does not come from the update.

• It displays "unable to verify the account name or password" in the Mac mailbox after I updated my individual mailbox password

  I have updated my 163 mailbox password and tried to update in the mailbox of the Mac, but when I type the password he showed "unable to verify the account name or the password". What should I do to re-connect to my Mac mailbox account?

  Hello Sara,.

  Thank you for using communities of Apple Support.

  I see that you have trouble with your e-mail account. I suggest the following article to get tips on troubleshooting your e-mail account.

  If you cannot send or receive e-mail on your Mac.

  Best regards.

• Mac Pro 2006 - 2007 update

  I have improved the original core dual processors in my Mac Pro (1,1) 2006 with quad core Xenon 5355 processors. "About this Mac" shows as unknown processors, but acknowledges there are two, with a total of 8 cores. I have downloaded and run the firmware utility; However, the gray bar of the screen and progress only briefly illuminate. Then, the drafts of the screen and the computer starts. The firmware version is still listed as 1.1 vs 2.1, and processors are unknown. I would appreciate any suggestion that this tool has apparently worked for others. Thank you.

  Provided by Apple firmware upgrader installs only the original firmware.

  Amateur of the firmware upgrader is available through netkas.org. When you have found the right forum, you must register on their site to access the update. This is not supported by Apple, and it is not for commercial use.

• events calendar mac is not being updated on iphone

  Running latest software on the iPhone 5 c and Mac Book.  ICloud drive have enabled on both devices.  However, added or changed in the Mac calendar events are not updated on the iPhone.  Suggestions?

  Try to switch the calendar switch in iCloud on the iPhone, or logging on iCloud and back in to see if it works.

• Cannot connect iphone to mac pro 5s after update

  Hi, I have a Mac Pro OS X 10.6.8 6 GB of memory, 25GB available on my hard drive. I did an update to find, and he said that he was unable to find the updates for my computer. I have an iphone 5s who ran out of space, so I recently did a restore and installed iOS 9.2. Once I did, I could not connect my iphone to itunes on my mac, it says it requires a newer version of iTunes, and I need to download the latest version of iTunes. I went to itunes.com and download the last file to iTunes, and he says he couldn't have downloaded the latest version of iTunes, I need to download the latest ios, El Capitan. I went to the app store to download the last iOS El Capitan, and he said "this version of Mac OS X 10.11 cannot be installed on this computer." Does anyone have any suggestions on what I might have missed? I want to be able to connect my iphone to my mac and drag on music and playlists, and I don't want to get a new mac just so I can connect it to my phone.

  Synchronization with an iOS device 9 requires iTunes 12.2 or later. This requires OSX 10.8.5 or later version,

  For Mac Pro desktop computer, which requires a computer desktop Mac Pro 2008 or later version.

  Decommissioning of the iOS version is not supported by Apple

• PC can connect to the printer, but Mac cannot even with updated drivers.

  We have an HP Photosmart Premium C309g, which is connected to a Cisco Linksys EA2700 wireless router. The printer connects easily to the PC with windows 7. However on macs with Lion, the printer will be displayed when you type the IP address in the browser. However when you try to load the printer it does not appear. If you use the IP address to load it does not connect to the printer. He used to work. The only changes are a new PC and a new wireless router. I tried to update the drivers and software on the Mac. It did not help. Still the same problem.

  Hello

  Unlike Windows, peripheral Apple uses Hello (which is based on the multicast) to connect with the HP device over the wireless network.

  As far as I'm aware routers Linksys not configured for multicast by its default value.

  Try the following and check to see if that can help you:

  1. Enter the router from your browser homepage.
  2. Enter in the Security tab,
  3. Check filter multicast.
  4. CLCK save changes.
  5. Reboot the router and check any change.

  Kind regards

  Shlomi

• View full screen on Mac after 6.6 update

  Hello

  I just upgraded to 6.6 Lightroom on my Mac and have lost the ability to view in full screen/display mode, usually active lightroom by "command + control + F" or the green button top left of the screen.  My old version of lightroom allowed this and I could switch between applications, the home screen and finder.

  Any help would be appreciated.

  Thank you

  Hi all

  This issue should be fixed in the 2015.6.1 CC update that went live today. Please upgrade to Lightroom to the latest version. Check out the link Lightroom CC now available 2015.6.1

  Kind regards

  Assani

• Mac SP6 not showing updated Camera Raw of 8.3 to 8.8

  Just got a Nikon d5500 has been added and download and install Adobe Camera Raw 8.8 (which seems to be called dng converter) but it does not appear.  This is supposed to be the whole dng converter and camera raw.  During the installation, he said 'clear old files' or something in this direction, but 8.3 appears always in/Library/Application Support / plugins... Despite research 8.8 does not appear anywhere that I can find despite the installation "successful."  I hope someone knows how to solve this problem!  Note: I am a user of mac PS6.  HELP Please!

  What version of mac os x are you using?

  Adobe has not consolidated the plugin raw dng converter and camera for quite awhile.

  I don't know why adobe is not clear, but they have not, which leads to confusion.

  So what you have downloaded and installed was just the 8.8 converter dng, which is in Applications > Adobe DNG Converter.app

  It is a separate application to convert camera raw in best dng, which can then be opened in adobe photoshop cs to cc 2015

  using the existing camera raw plugin.

  For photoshop cs6 go help > updates in photoshop cs6 to download the camera raw 9.1.1 update.

  Then your d5500 nikon has been added files should open directly in photoshop cs6.

  If your mac os x 10.6.8 help snow leopard, then unfortunately photoshop cs6 can only be updated camera raw 8.3

  And we can only use up to the converter 8.3 dng so.

• Impossible to update CC, PS, LR on a Mac because I just updated window shooting

  I used to be able to update CC, etc on my Mac via the Update window, but it has stopped working.  Just dial turns.  I tried to get the updates via the PS and LR applications, but the same thing happens.  My internet connections are very good and I can get other updates from other sites.

  Hello

  I think you found the turning wheel on the Adobe CC application.

  Please check the help below document:

  Does not open App | Wheels of progress turn continuously

  You can also view the nets below where this issue has been addressed:

  Adobe Creative Cloud / Desktop App / Home Screen: constant spinning wheel

  Creative Cloud Desktop App taped blue spinning wheel after update.

  Kind regards

  Sheena