Nexus 7009 does not show the N7K-F248XP-25 modules ethernet ports n sh run

Hello world

I have a question...

I'm going to install two Nexus 7009 with N7K-F248XP-25 three modules on each of them, I plan to create 3 VDC, but initial configuration, the system does not display the Ethernet ports of these modules, even with the inventory of show and show module that I can see that the modules are recognized and its status is OK. Is there something I need to do before you start to configure these modules...? allow some feature or the license in order to see the ports with show running CLI...?

You can activate the F1, F2, M1, M1XL, and M2XL series modules. There is no restriction on the type of mixture allowed for the order of module-type system. Control module-type system allows a mixture of F1, F2, M1, M1XL and M2XL series of modules in the VDC.

Note The module-type limit-resource command handles the restrictions on the types of module that can be mixed in the VDC.

Note Use the f2 type module-system command to allow the F2E series modules in a VDC. The ports of F2 and F2E series modules can be distributed as all other ports.

Note The modules that you do not select must not be powered on after you configure this feature and enter Yes. An error message will force you to manually disable these modules before you continue. You will avoid significant disruptions and problems of service within a VDC.

No form of this command resets the configuration mode to enable all modules.

hope this helps

Tags: Cisco Support

Similar Questions

Maybe you are looking for