No sound on speakers internal HP w2207h monitor.

Similar Questions

• No sound on speakers internal on mac 21 inches

  version is 10.10.5 mac 21 no inches no sound from internal speakers, but I can only hear the chime when the opening mac working on the yosemite system I checked in the system pref for speakers, there is none listed it the checkmark is mute and not changing its greyed out, please notify

  1. connect and remove the headphones.

  If you see the red light in the headphone port, plug the headphones

  in and o ut of time port 5 or 6 to swing the microphone inside.

  Audio output can be blocked using digital technology.

  2 reset the PRAM.   http://support.Apple.com/kb/PH18761

  3 reset the SMC.   https://support.Apple.com/en-us/HT201295

• Qosmio PX30T - no sound from speakers

  I just replaced a failing on my PX30T HARD drive and now I get no sound from the internal speakers. I used the media restore and also put all the patches and windows 8.1. Still no sound from the speakers, but the headphones work well.

  As a last resort, I started with an image of Ubuntu USB and also no sound. I think I might have loosened a wire when replacing the HARD drive, but I don't see how because there are no other wires in the region. Ideas?

  If the headset work correctly, the audio driver must be already installed and I don't think that a parameter must be checked and changed.

  Reach:
  Control Panel? sound? Recovery tab
  Here, you should see the speakers and speakers must be marked as default device.

  Make and check if the sound seems once again

• 2207 monitor: HP: w2207h monitor startup problem

  My HP monitor only has not been commissioning correctly several months now. When it appeared everything first, the monitor has refused to start when the power button has been pressed. I noticed a noise "rattling or burst" and could see that the blue power light was bike works at short intervals. After some time the monitor came; However, as the time (weeks) traveled by the monitor continued to click and not to open the splash screen. When it happened I pressed the button of keyboard sleep and distributed, and for some reason, the monitor eventually would come on.

  The monitor is not connected to a TV, it is only connected to the computer by VGA cable. I thought that the problem could be something to do with either the screen saver sleep or the settings mode, so I checked the power options and found that the two 'turn it off display", and"Put the computer to sleep"parameters had never chosen as their option. I ran the HP Hardware Diagnostic tools to monitor, but the tests were only good for alignment, color, brightness, etc.  I also checked to see if she needed a driver updated by the following process: computers > properties > tasks > Device Manager, and then clicking on other devices and by double clicking on the monitor; on the general tab, it displays the message, "this device is functioning correctly.

  After a few weeks over time, sleep button thing has stopped working and I tried to leave the monitor on the night with the computer turned off. When the computer was returned the next day, the monitor took over the rattling again, but still it would end by lights.

  Currently, I've resorted to press the button sleep when the monitor does not start alone, so far successfully startups, but I'm afraid it will cease to begin.

  Does anyone know a solution to this problem?

  The computer is a desktop PC of HP Pavilion a6637c-b with a HP w2207h monitor LCD 22 inch flat screen with Auto Picture Rotation function. The OS is a Windows Home Premium, 64-bit edition. The computer has 5 GB memory and 640 GB hard drive. I will provide more information hardware or software if necessary.

  Hi @oldognutrix,

  Yes, it sounds like it is the monitor.

  Please use the following http://www.hp.com/contacthp and create a folder for your question and contact HP. If you do not live in the United States / Canada, please click on the link below to get contact information for your region.
  http://WWW8.HP.com/us/en/contact-HP/WW-phone-assist.html

• Presario CQ 57-339wm: no sound from speakers, Driver date, don't watch working properly?

  My Compaq Presario CQ57-339WM running 64-bit Windows 7 has no sound coming from the built-in speakers.  The headphone jack works with headphones, but the built-in speakers have no sound.  I just downloaded the driver update and still no sound.  When I check the speakers in the Manager, it indicates that the device is functioning properly.  Short of redo the original back recovery point system does anyone have any suggestions of how I can check to see if the problem is in the speakers or with the card or what?  I looked on the boards here, but nothing seemed to fit my problem exactly if I'd appreciate any help.  Thanks in advance.

  Hi @cnickels,

  Welcome to the HP Forums!

  It's a great place to find answers and suggestions!

  You have the best experience in the HP forum, I would like to draw your attention to the Guide of the HP Forums.

  Learn how to post and more

  I understand that you have the sound through your headphones, but not the internal speakers.  When you checked the Device Manager it says it works.

  Here is the link for HP laptops - no sound on speakers (Windows 7) that should help you.

  To say thank you for the answer, click on the thumbs up icon below.

  If this allows a resolution please let other posters know in choosing the solution provided.

  Good luck and have a wonderful weekend!

• B120, no sound from speakers, headphones ok.

  Got a B120 with XP and SP2 re-installed.  I have no sound from the internal speakers, but the headphone jack works fine.  The speakers work (checked with Dell Diagnostics); played well from there, every time.  Side note - Ubuntu 8.04 live no longer had his No.

  Sometimes I get a notification of the popup of Sigmatel (something about and audio event this - as I plug something at one of the outlets when I did not.)  I usually just select 'status quo '.

  I've scoured the forums and read posts on installing drivers in the correct order.  I tried to uninstall the drivers and related software files so I could continue on their relocation in order.  But, what is happening on the re-start, is that it starts automatically install hardware "found," so I don't get to put them in the order I want. How could avoid this or how do I UN-install/reinstall drivers more effectively.

  When I look in the hardware Manager, everyting seems to be good... except that I get no sound from the speakers.  Sigmatel hardware is selected, sliders are at midway up, nothing is muted, select a system of his event and he seems to play but without sound.

  Any help would be appreciated.  Just half a hair to pull to the left. : smileysurprised:

  
  

• HP w2207h monitor: HP monitor crashes if connected to the Mac Mini

  My w2207h monitor works fine connected to 2 computers. A Dell laptop connected with a cable HDMI and a Fujitsu PC connected with VGA cable. I spend between the 2 with the menu key of monitors and the function 'change the video input '. However, I just buy a Mac Mini and connected via HDMI but now, pass the VGA to HDMI causes the monitor to crash/power down. Even the light around the power button goes off and nothing works. To relight the monior screen, the only way is to disconnect the cable from power for a few minutes. The monitor works with an another old laptop connected via HDMI as doeas the Mac Mini connected to an old television set. I thought HDMI HDMI was, but this monior dislikes my Mac. Any ideas?

  Thanks for the information Dunidar. A long session, running tests with Apple confirmed that this monitor does not work with Mac Mini. The only solution was to buy a new monitor :-(

• NO sound from speakers or headphones

  HP ENVY 15-3033cl laptop PC

  Windows 7 64 bit

  no error message, I was watching a movie when my laptop died. I plugged it into the power source and now there is no sound from speakers or headphones when I plug. I already went through the troubleshooting steps sound but it says there is no problem detected by the device. The computer is still failry new less than a year, but lies outside of the 90 day warranty. Help please.

  Hello

  Try the following.

  Download IDT Audio Installer on the link below and save it in your downloads folder.

  http://ftp.HP.com/pub/SoftPaq/sp56501-57000/sp56900.exe

  One time finished, open windows control panel, open Device Manager and open sound, video and game controllers.  Right click on the IDT device and select uninstall - also, you should get a command prompt to delete the current driver, check the box allow this and then proceed to uninstall.

  When you're done, shut down the laptop and perform a "Hard Reset" for your model, as described in the document of HP here.

  One when you're done, press next to the key ESC that you start the computer to launch the Start Menu, then select f10 to open the bios menu.  Press f5 to load the default values (sometimes it's f9, but the menu below indicates the correct key), use the arrow keys to select 'Yes' and press ENTER.  Press f10 to save the setting and still use the arrow keys to select 'Yes' and press on enter.

  Allow Windows to fully - charge it will automatically load an audio driver, but let just this complete.  Then open your download folder, right-click on the IDT Installer and select "Run as Administrator" to launch the installation.  Once this done, do a right-click the speaker icon in the taskbar and select playback devices.  'Speakers and headphones' left click once to highlight, and then click the Set Default button - check if you now audio.

  Kind regards

  DP - K

• USB ports on the side of the w2207h monitor

  I plugged in the USB ports on the side of my w2207h monitor, but I get an error message saying that the USB device has malfunctioned and it is not recognized by Windows whenever I start my computer.  Is it possible to get the USB ports on the side of the screen to work?

  Excellent response. Remove the "unknown device". Then restart.  Only his own to the top of the error.

  It is important to always use 'remove hardware safely', found in the system tray, to select the USB device your disconnect. Just by pulling the cable will cause this error.

  Removed Hanspuppa caused response she said it was a problem with the driver for the monitor. We all make mistakes, it's human. But it's kind of ridiculous to remove the cause of the answer, you make a simple mistake. Not of him to ask, but an empty answer is worse than facing her.

• Equium M50-192: no sound from speakers or headphones

  Sound disappears after working for three months. No sound from speakers or headphones. Verification of the hardware system breaks down.

  Help!

  Hello

  If after checking the sound settings package (Panel, controller next to the laptop, etc.) the sound doesn't come out so I guess that the sound card on the Board is dead.
  In this case only the ASP will help you solve the problem. Maybe the motherboard must be changed.

• My sound from speakers and shit

  (I have the IdeaPad y510p, btw).

  Then I updated level to Windows 10 Home and noticed that my JBL speakers now sound like shit.

  I reinstalled the sound drivers, nothing works.

  I noticed, however, that things sound beautiful when you use headphones... so I don't think that it is the sound card, but the speakers that have reset or whatever the update.

  I remember when I bought this PC firstly that there was only some built in Lenovo crudware to change sound options, and most of them makes the speakers sound bad, as they do now - slender and away a little weak. So I uninstalled.

  Now that my sound from speakers like this again, is there a way I can get this program once again? I have no idea what it was called, but it allowed you to adjust your speakers for stuff like 'movies' and 'music '. I want to see if fiddling with making my speakers together again.

  And otherwise, a Council? Any ideas?

  Grazie.

  Of course, how selfish of me.

  Type in "change the settings of the sound card" in the search bar and open it. Double-click on your speakers to open the speaker Properties window. In this, go to the tab called Dolby and click the power button in the upper left corner to switch it off.

• can connect my playstation 2 to my pc, so far I have sound but no visual on my monitor

  can connect my playstation 2 to my pc, so far I have sound but no visual on my monitor

  Hello

  You can post the question on the Playstation to support help forums:
  
  http://community.us.PlayStation.com/T5/PlayStation-2/BD-p/22013

• No sound from speakers when watching videos on YouTube.

  Original title: speaker problem

  No sound from speakers while the suite tube you

  Hello

  ·         Is specific to the YouTube Web site?

  ·         You will remember to do recent changes on the computer before this problem?

  ·         Are you able to hear the sound of the computer normally?

  ·         What web browser do you use?

  Response with above information to better help you.

  If you use Internet Explorer, you can enable sound in Web pages and check if you can hear on you tube. Follow these steps:

  a. close all the open Internet Explorer window.

  b. open Internet Explorer. Go to Tools>Internet Options.

  c. switch to the tab 'Advanced'.

  d. scroll down to the 'multimedia' heading

  e. make sure that "play sounds in web pages" is checked. Click on 'ok '. Restart Internet Explorer. A test to see if the sound will now play.

  You can also check the playback settings.

  For your reference, take a look at the link:

  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows

• No sound from speakers (Windows 8)

  Hey, guys.

  I see where several issue after you upgrade to windows 8 for 7 or vista, you have no sound from speakers.

  In case someone runs into this problem going forward, please make sure that:

  1. your laptop is supported for Windows 8.

  AND

  2. There are Audio drivers available for the laptop.

  I'll link a Document here for you guys to take a look at if you encounter this problem anywhere on the line.

  

  THX

  I hope it's useful!

  THX

• No sound from speakers, headphones, but works very well.

  Original title: wendows System 7

  my computers speakers stoped working while watching a DAD / BUT MY HEADPHONEYS WORK FINE. CHECK MY SYSTEM / ALL THINGS ARE NOW AND WHERE NONE ARE VIRESES OR OTHER PROBLEMS. A RAN ALL MY TEST SOUND AND ALL FINE-ALL JUST IN MY HEAD BUT NOT MY SPEAKERS, ANYMOOR. HAVE CHECKED/WAVE DRIVERS/SFS./SCANE. RAN AAUDIO TROUBLESHOTER PLAYS AND FOUND NOTHING.../ ME ANY IDERS?

  Hi Jerome,

  Thanks for the reply. I really appreciate your efforts to solve the problem. As you have tried most of the methods and troubleshooting procedures, and the problem persists.

  Please, try the steps from the link below and check the issue.

  No sound from speakers (Windows 7).

  http://h10025.www1.HP.com/ewfrf/wc/document?cc=us&LC=en&DLC=en&docName=c01912228

  If the problem is with the hardware of your HP computer, I recommend you contact your manufacturer of the HP system so that they can help you resolve the problem with your HP computer's built-in speakers.

  Reference: http://support.HP.com/us-en/contact-HP/

  Please do not hesitate to contact us if you have any questions or difficulties with the help of your Windows.