Older program installed on XP. Now the error message always appears when Windows starts.

Similar Questions

• Downloaded the trial version of Acrobat DC. Now cannot open any program acrobat. I get the error message when needed to connect: connect to the internet and try again. Computer is out of connection or your computer's clock is out of adjustment

  Downloaded the trial version of Acrobat DC. Now cannot open any program acrobat. I get the error message when needed to connect: connect to the internet and try again. Computer is out of connection or your computer's clock is out of adjustment

  Log, activation, or connection errors. CS5.5 and later, Acrobat DC

  Mylenium

• 0x000000F4 beginning physical memory dump, this is the error message I got when I perform the adaptation of data operation or run heavy programs, and when I play the music of his tempo becomes slower.

  Original title: 0x000000f4 beginning physical memory dump

  STOP: 0x000000f4 (0 x 00000003, 0x89cb3a18, 0x89cb3b8c, 0x805d29b4) beginning physical memory dump

  This is the error message I got when I perform the adaptation of data operation or run heavy programs, and when I play the music of his tempo becomes slower... What do I do? Help, please...

  Hello

  You did changes to the computer before this problem?

  Step 1: Check if the problem persists in the clean boot state.

  From your computer by using a minimal set of drivers and startup programs so that you can determine if a background program is interfering with your game or program. This type of boot is known as a "clean boot".

  Reference:
  How to configure Windows XP to start in a "clean boot" State
  http://support.Microsoft.com/kb/310353

  When you are finished troubleshooting, follow these steps to reset the computer to start as usual:
  1. click on start and then click Run.
  2. type msconfig and click OK.

  The System Configuration Utility dialog box appears.

  3. click on the tab general, click Normal Startup - load all services and device drivers and then click OK.
  4. When prompted, click on restart to restart the computer.

  Step 2: Also, look for error messages in the event viewer. If you find error messages after return the exact error message so that we can help you better.

  Reference:
  Using the event viewer
  http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/snap_event_viewer.mspx?mfr=true

  Understanding of event viewer
  http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/event_overview_01.mspx?mfr=true

  Procedure to view and manage event logs in Event Viewer in Windows XP
  http://support.Microsoft.com/kb/308427

• I used the Paypal widget pour a book to the amount of 29.00 and this is the error message that appears:

  I used the Paypal widget pour a book in the amount of 29, 00euros without tax or shipping charges and this is the error message that appears: pay the privilege you have used access the PayPal system contains incorrectly formatted amount

  Thanks for your help ;)

  Please check the amount and the currency selected, also try to check the settings of paypal account in case it is limited to any specific setting.

  Thank you

  Sanjit

• When I try to install KB2686509 I get the error message 2686509.

  When I install the update to windows I get the error message #2686509

  Hello

  This isn't an error Code; It's the KB2686509 of update:

  Here is the link to direct download for KB2686509 for XP 32 bit and you need XP Service Pack 3 must be installed

  "A security update for Windows XP (KB2686509)"

  http://www.Microsoft.com/en-US/Download/details.aspx?ID=29804

  See you soon.

• Try to install iTunes and get the error message 0 x 80070020

  I come at the end of the installation and the error message...

  I come at the end of the installation and the error message...

  You should ask the people in the Apple forums.

  Problem installing iTunes or QuickTime for Windows

  http://support.Apple.com/kb/HT1926

  iTunes for Windows

  https://discussions.Apple.com/community/iTunes/itunes_for_windows

• Paper stopped, pulled the half rest disappeared. Now the error message

  When printing I wanted to print on the back of the paper and jammed paper.  I managed to get half outside, but I think the machine ate the otherhalf and now I get the error message.

  I thought that I already wrote a thank-you note.  I followed the instructions step by step until I came to move the ink cartridge tray, slowly, without too much force and voila, there is the other half of the book that I had tried out.  After restarting, the printer is fitness.  Your advice step by step solved the problem and thank you.

• Display driver hangs on the computer and the error message "display driver NVIDIA Windows Kernel Mode Driver Version 306.97 has stopped working and recovered."

  Original title: NVIDIA Windows Kernel Mode Driver Version 306.97 display driver has stopped working and recovered.

  Hiya,

  I have recently installed Windows 8 Pro, installed all of my usual applications etc..
  The problem I've encountered is maintaining display driver crashing. Or have waiting periods. The exact error message reads;
  "Display driver NVIDIA Windows Kernel Mode Driver Version 306.97 has stopped working and recovered."
  Until now it expires randomly even when the computer is idle, and more frequently when I watch videos online. Also, watch a clip full screen on some sites like YouTube is ok, but on others, it is very laggy (updated maybe once per second the image) and the sound is out of sync.
  I can't find a way to properly uninstall the graphics driver.

  At least yours is working semi... I have the GTS 450 (uses the same drivers) and the mine does not at all... Stuck with the regular game pilot integrated ATM and can not all games... Microsoft told me to wait a few weeks and for the reminder and Nvida said 10 ways to uninstall and reinstall the drivers for same. Hope someone with to get a fix for this soon.

  Hi guys,.
  Looks like this isn't just me.
  Just an update, that I can not confirm it as a solution, but I have not encountered any problem (a little screenlag aside) since the installation of the drivers beta. For me, the beta version of the driver is 310.33, R130. The only other change to my system updates Adobe Flash version packaged with Google Chrome to 11.4.31X to 11.4.402 to eliminate serious problems when you watch the video in full screen.
  Information system;
  Operating system: Windows 8 Build Pro with Media Center 64-bit, 9200
  CPU: AMD FX-8150 eight physical cores
  GPU: ASUS NVIDIA GeForce GTX 560 TI
  Main hard drive: OCZ Vertex 3 120 GB
  It may be useful
  Edit: Still not falling down, 11/02/12, 4 days
  
  
  New edition;
  
  
  If you still receive the error message, try the following steps;
  Has. try to perform a clean installation of the driver.
  Download the latest drivers for your graphics card. Run the downloaded file, and select "Custom Installation". In the next screen, you will see a checkbox or similar labeled "Clean Install".
       
  
  You can do so by visiting nVidia Driver Downloads (www.nvidia.com/Drivers). Automatically detect the right driver or download using the form. The best way in my opinion is to use the GeForce experience, who will do anything for you in two clicks and a reboot.
  B. close all other programs
  It is possible that the error was caused by too many programs that need to use the resources provided by the graphics card/chip. It is also possible that a certain program caused a conflict that pilots crashed.
  You can try closing some currently open programs one by one and see if the error persists, or restart your system with disabled startup programs and allow them one by one to find the culprit. If the error is too persistent to do the above, it would be easier to start in safe mode option.
  More information can be found below
  http://support.Microsoft.com/kb/2665946/en-us

• C310a - I can't stop all the HP error message pop up when I start my computer

  Lately and since the fitting (authentic replacement) cartridges, the error messages - jam paper, cartridge problem paper loading, insist on popping up over and over again, even if I click on the relevant Red Cross to close.

  I tried the * beep * and on this forum for a solution.  I found the one nearest asked that the printer had to be checked for stray pieces of paper or other debris which would cause these messages to appear.  Apparently, they are all related to this type of error.

  I checked the printer including the duplex unit, but found no debris, lint or other debris.  I have downloaded and run the Diagnostic tool but still once, found nothing untoward.

  I'm happy the printer works fine, (it prints, copies and scans perfectly fine).

  I have to reset anything?  If so, how?  Or can someone tell me what I may need to do to solve the problem?

  Thank you very much

  Alright. I think it's safe to say that it is a software issue and not a hardware problem. So reinstall software has to deal with the problem.

  Click Start Menu > all programs > HP > HP Photosmart C310 Seris > uninstall to uninstall the software. Download the latest software and drivers for your printer using the link below, then run it to install the software again. This should solve the problem.

  http://h10025.www1.HP.com/ewfrf/wc/softwareDownloadIndex?softwareitem=MP-85745-1&cc=us&DLC=en&LC=en&OS=4063&product=4231205&sw_lang=

• "wfcrun32ERROR, failure of the set event logging" appears when I start my computer.

  I would like to know why this is and how I can fix this problem.

  Best regards

  Hello

  1. have you made changes on the computer before this problem?

  2. What is the error message or an exact error code?

  I would suggest trying the following methods and check if it helps.

  Method 1:

  Secure boot and check whether or not you receive the same error message.

  Boot safe mode in Windows Vista:

  http://Windows.Microsoft.com/en-us/Windows-Vista/start-your-computer-in-safe-mode

  Method 2:

  If you do not receive the error in safe mode, and then turn on the computer in a clean boot state, then check if that helps you.

  How to solve the problem by running the clean boot in Windows 7:
  http://support.Microsoft.com/kb/929135

  Note: Once you have completed troubleshooting, perform the steps in the step 7: to reset the computer as usual.

  Hope the information is useful.

• any installation of windows 3.1 program and can not install that is getting the error message send

  I have no windowsinstaller 3.1 and when I try to download that I can not install either get error messages

  and to send to microsoft / close window

  Impossible to download whatever it is and the other software does not not need help as soon as possible...

  Hello

  I suggest you to download the package from this link and check if it helps: seehttp://support.Microsoft.com/kb/893803 try also perform the clean boot and check if it helps:

  http://support.Microsoft.com/kb/310353

  NOTE: When you are finished troubleshooting, make sure that restore you the computer mode normal startup such as suggested in the article above.

  For more information, see this link:
  http://support.Microsoft.com/kb/822798

  Check if that helps.

• I tried to install java and get the error message of bin\awt.dll is not found

  I tried to install java and when I try I get the dell bin\awt.dll error message cannot be found. Please help I do not know what or how I can get it back to make it work so I can download java thank you for your time.

  Look at the thread next help with your Java error:
  http://answers.Microsoft.com/en-us/Windows/Forum/Windows_7-windows_install/Java-Update-failedmissing-file-binawtdll-cannot/939b47ab-d644-46AE-9553-fd55bbb160cf

  It should help.

  Marilyn

• When installing CC, I get the error message 'download error. Please contact customer support.

  Today, I'll try to install Adobe CC, so I have error message "download error. Please contact customer support. I search the Internet, and nothing has been useful.

  Hello

  Please refer to the threads below where this issue was discussed:

  Creative cloud "Download error" message

  Persistent Cloud error - error download - creative

  Kind regards

  Sheena

• I have a xp system and I am getting the error message following, that c:\windows\system32\nimariwu.dll is not a valid windows image several times. How can I fix this problem?

  Error message for several packages of software that I installed, including Outlook and Adobe. Where can I get a copy of the correct file to copy on the wrong file I have. I have no installation disk, and need this file to be correct.

  Looks like some sort of malware infection.

  I suggest talk us a bit about your system and then run the scans indicate below, then when the scans is clean, the persistent problems.

  What is your system brand and model?

  What is your Version of XP and the Service Pack?

  Describe your current antivirus and software anti malware situation: McAfee, Symantec, Norton, Spybot, AVG, Avira!, MSE, Panda, Trend Micro, CA, Defender, ZoneAlarm, PC Tools, Comodo, etc..

  The afflicted system has a CD/DVD drive work?

  If the system works, what do you think might have changed since the last time it did not work properly?

  This will minimize back Q & A and eliminate guesswork.

  While you wait, I could do this:

  No matter what you use for protection against malware, perform the following analyses for malware, then correct any problems:

  Download, install, update and do a full scan with these malware free
  detection programs:

  Malwarebytes (MMFA): http://malwarebytes.org/
  SUPERAntiSpyware: (SAS): http://www.superantispyware.com/

  They can be uninstalled later if you wish.

  The scans by operating clean, then to solve any problems.

• Get the error message after upgrade to Windows 10: peer certificate has no Secure Connection has an invalid signature.

  Error message trying to connect to Facebook after update to Windows 10: secure connection failed

  An error occurred during a connection to www.facebook.com. The peer certificate has an invalid signature. (Error code: sec_error_bad_signature)

     The page you are trying to view cannot be shown because the authenticity of the received data could not be verified.
     Please contact the website owners to inform them of this problem.
  

  Hey, if you're an avast user, please disable https scanning software:

  1. Open the Avast dashboard on an affected system.
  2. Select settings in the left side menu.
  3. Adopt a Protection Active.
  4. Click on customize next to the Web Shield.
  5. Uncheck the option "Enable HTTPS analysis", and then click ok.

  http://www.gHacks.NET/2014/10/31/avasts-HTTPS-scanning-interferes-with-Firefox-and-other-programs/