Photo instead of the paper support paper?

How can I get my picture to print on photo instead of the paper support paper?  I have a HP 6510 e - All in a series and the installation he had put me in the photo paper 4 x 6 for a sample.  He great printer!  Now when I try to pring another photo, he keeps putting it on plain paper.  (And the paper was the first photo impression too.)  Thank you in advance!

Hello beckyboo

You set the type of photo paper? In the application you are printing from you should go to print properties and can find media under paper/quality. The article below the link should help.

Printing of Documents

Tags: HP Printers

Similar Questions

  • Pressing forward slash (deselect the active photo) instead of the slash reverse (before and after changes)

    In module development, during editing, I sometimes make the mistake after pressing slash bad key and the end upward with the message no. Photo selected instead of "before" notice I wanted. If I have similar photos, find it me difficult to recover it - when I return to the library module to try to find my picture, it's been deselected, of course.

    Any ideas?

    Thanks in advance - Helen

    As soon as you realize that you pressed the wrong key, you can press Cmd/Ctrl + Z.

    This will cancel what you just did, which is bad press.

  • Photosmart HP 7520 - erasure of the tapes through photo printed on plain paper to A4

    Montain Lion 10.8.1 operating system

    I want to print some black and white photos on plain paper in A4 format and each time it prints with about 1.5 cm wide strips all the way across the paper in different shades of black (e.g. pale and dark).

    The tapes show vertical here because the page was printed in landscape mode.

    I cleaned and aligned to the printhead about 4 times but the problem persists.  Even when I print the print quality diagnostics page, it shows the same bands on the color blocks.

    This is what it looks like:

    Can someone please

    Thank you very much

    Tolo

    Hi stix4, thank you very much for your answer.

    All I have is genuine HP cartridges. I just tried (and managed to get to the HP Technical Support!)

    Had to go into the service menu and proceed with the instructions given, but the problem persists.

    They are sending me a new printhead that I hope will sort the problem.

    Once again, thanks a lot

  • print photo on the HP 7510, the photos are printed on the paper. How can they be corrected?

    I use a HP photosmart 7510

    the op of the pc OS is window7 64 bit

    There is no error message

    the printer is just this week installed. so there is no update not far

    Print photos, they are shown acoss the paper. This happens on diffenrent formats, for example 10 x 15 cm on A4 size

    Hi there z45I150,

    First lets try to download and run the doctor print and scan located here:
    http://support.HP.com/us-en/document/c03275041

    To ensure there is no software problems, the origin of the problem. It can fix its own much and if not to give a better idea of what is happening. Also can you tell us what program you print from?

    Good luck!

  • Support the weight of the paper in my printer?

    My printer is a HP Deskjet 3070.

    I want to know the weight supported the paper I use something too thick and end up blocking the printer.

    Thank you for your help.

    Hello

    This is the list:

    Paper weight
    Paper: 64 to 90 g/m² (16 to 24 lb)
    Envelopes: 75 to 90 g/m² (20 to 24 lb)
    Cards: Up to 200 g/m² (110 - lb index maximum)
    Photo paper: Up to 280 g/m² (75 lb)

    I hope this helps.

  • 7510 HP Print eFax entering using photo tray 4 x 6 instead of regular paper tray

    The free eFax sends incoming faxes to the printer in TIF format.  Unless you pay for the upgrade to eFax service, you don't have the choice of formats (PDFs, for example).  The problem is that the printer sees the TIF attachment when eFax sends it to the printer and wants to automatically print it by using the paper tray photo (4 x 6) rather than the normal paper tray.  How do you get the 7510 DO NOT auto select the paper tray according to the type of attachment?

    You have changed it on a free account. eFax does just not support customers who use the free service.

    The following private message and I can submit to eFax to it have switched over to the PDF format.

    • Customer name:
    • EFax number:
    • New or old account:
    • When he started to question:
  • How can I change the paper orientation when printing on Photos?

    In the Photos on OSX El Capitan, I would like to print photos. I put them up to two print by page, but when I went to print, the paper was not portrait and landscape oriented as indicated in the overview. (screenshot below)

    There seems to be no way to set the direction for the paper from Photos and no option in the print dialog box to change this. I looked up the other forum posts and proposed to set the default paper size in the printer setup... .mine shows 8.26 11.69 inches (A4), which should be the portrait.

    Anyway I can change this so I can actually print photos on paper?

    I could not the orientation to be changed but found a workaround.

    1. Select two photos to print], Option (right) - click on it and select rotate to the left in the menu.

    to help you with this:

    Now print as you did and you'll get this:

  • Paper feeds through the back instead of the round print

    I have a HP Photosmart C4780, Windows 7, error message Out of Paper, no changes to the operating system

    The printer will feed the paper, but shoot it the back of the printer rather than enter this round and print, I was trying to print on cardstock, when the issue occurred, but continues to to happen when I try to regular printer paper as well. I followed the steps for a printer feed error I found at this link: http://support.hp.com/us-en/document/c02065582#N1040 but it did not help.

    Thank you very much for your help!

    I suggest you remove the rear panel as shown in the video on this page to troubleshooting, then replace the Panel back and make sure it snaps in place.

  • I have just Setup iPhone 3GS from my wife. Through iTunes, I loaded music, Photos, Contacts, and calendar. There is no Photos icon on the screen. They are responsible because appear it as choices in the selection of paper painted. help please. Thank you.

    I have just Setup iPhone 3GS from my wife. I.O.S. 6.1.6. Through iTunes, I loaded music, Photos, Contacts, and calendar. There is no 'Photos' icon on the screen. The photos are loaded because appear it as choices in the selection of wallpaper. I would be grateful for any help with this. Thank you.

    Jimbo1307 wrote:

    I have just Setup iPhone 3GS from my wife. I.O.S. 6.1.6. Through iTunes, I loaded music, Photos, Contacts, and calendar. There is no 'Photos' icon on the screen. The photos are loaded because appear it as choices in the selection of wallpaper. I would be grateful for any help with this. Thank you.

    Double check the app folder or home screen.

    Cannot delete the built-in app, so go to settings - general - reset - Reset available to the home screen.

  • I have a Mac and added the DNP DS80 printer but it will not let me print. He said "the paper size selected is not compatible with installed support." Anyone have this problem?

    I have a Mac and added the DNP DS80 printer but it will not let me print. He said "the size selected is not compatible with the installed support." All the answers for this?

    Refer to the discussion: Lightroom v4, v5, v6 Will not print to a DS40 printer

    Kind regards

    Mohit

  • Black photo using instead of the black regular for the general impression

    I have a printer C309a All In One Photosmart Premium.   He left black printing, so I replaced the black ink cartridge large and it would not print in black.  I checked ink levels in the settings and it says black of the Photo came out!

    I do not print photos.  Why he uses photography in black instead of the ordinary black?

    I have verified that my specific print settings 'General everyday printing"rather than photos, etc. I looked through all the settings on the hardware and the software, but was unable to find anything that solve this problem.

    Anyone know what I can do to make the printer to use the wide use, black General rather than the photo black ink?

    Covcomm wrote:

    OK, thanks for the quick response.  I tried to put into service of "plain paper" and reproduced, but still the black does not appear.  The other colors are, then it must use more black photo than the general use of the black.

    If I understand your answer, the printer requires that both black cartridges have ink to print any black, even if I'm not print photos?

    OK, if the printer goes through the motions of printing but does not print black it would indicate a problem with the print head.  Try to run up to three cycles of cleaning printhead from the Toolbox.

    While a photo of small amount black (and all other colors), ink will be used to serrvicing it will not print on paper for normal text.

  • How can I print multiple 4 x 6 photo on letter-size paper

    I used to be able to print more than 1 4 x 6 photo on a photo of letter size paper... what happened to this option?

    I can't select multiple images at once to print on that size of paper.  Who is losing a lot of photo
    paper... Someone at - it a response?

    The print Photo of Windows XP Wizard would print three 4 x 6 photos
    sheet size on a single letter. This option has been removed from the later
    versions of Windows.

    Using Windows Live Photo Gallery?

    Windows Vista / Windows 7 - tips for printing digital photos at home
    http://www.Microsoft.com/athome/photos/printdigitalpix.aspx

    Learn how to print multiple photos on one page
    http://www.HP.com/United-States/consumer/digital_photography/print_better_photos/tips/multiple-photo-printing.html

    Picasa free software has also a few very useful printing patterns:

    (FWIW... it's always a good idea to create a system)
    Restore point before installing software or updates)

    Picasa
    http://Picasa.Google.com/

    Picasa: Printing at home: printing at home - the basics
    http://Picasa.Google.com/support/bin/answer.py?hl=en&answer=11212

    Picasa tutorials - print photos
    http://Picasa.Google.com/support/bin/topic.py?hl=en&topic=9022

    Tutorial Picasa: Collages: creating a montage
    http://Picasa.Google.com/support/bin/answer.py?hl=en&answer=19539

    FWIW... MS Digital Image Suite includes
    a large collection of print templates
    which one that prints 3 - 4x6s on one
    8.5 x 11.

    Even if this product line has been
    abandoned... There is a free trial 60 days
    still available for download if someone would
    like to experiment with it.

    After 60 days, the defeatures software.

    Microsoft Digital Image
    Starter Edition 2006
    http://www.Microsoft.com/download/en/details.aspx?displaylang=en&ID=11954
    (this offer is no longer
    promoted, but you can still
    Download it and run it for 60 days)

  • HP Officejet 4622 will not print simple controls because it does not recognize the paper size.

    Product: HP deskjet 4622 All In One

    operating system: Windows 7

    Software used: Quicken Starter Edition 2011

    My printer refuses a single cheque due to the size of the paper being not recognized by the printer. The actual size of the individual audit is 8 1/2 inch wide and 5 1/4 inch from top. There is no size in the settings of the default paper size that matches the paper size... The quicken software print 1, 2 or 3 controls on a sheet so if I print 2 verifies that leavesme with a single cheque that is wasted because my printer does not recognize the size. My previous HP printer did not have this problem.

    Someone at - it suggestions?

    xgdude, unfortunately this printer does not support true custom paper sizes, he acknowledged instead the paper types that are commonly used in the United States. This is because the non-traditional types of paper are difficult for the printer to recognize and inside the right margin of the printing error.

    I hope this information is useful!

  • Photosmart C5280: a component ' to ' falling apart after the paper stuck. "

    I wanted to spring 6 pages, 2 of them when printed, then a stuck. I pulled it out, but when I tried to continue printing a stuck. This time when I pulled it out (it came out softer the usually), I found a black plastic piece down on the document reader.

    Here's an album with 4 photos of this component:

    https://drive.Google.com/folderview?ID=0B0K5k8LpitTlUDVJMnZMWGlrVXM&USP=sharing

    Please can someone tell me how to put it back in its place?

    Thank you.

    Hello @DimitrisPl,

    Welcome to the Forums of HP Support!

    I understand you have problems paper jam printing of your HP Photosmart C5280 All-in-one printer and after removing a jam you found a piece of black plastic at the bottom of the printer that needs to be reinstalled. I would like to help you to solve this problem today.

    To begin, please can I you click here for the jam troubleshooting steps. Once the support document opens please run through the Solution one, two, three, Solution solution and four Solution. This includes all sub-steps under the listed Solutions. Once we have determined that no other debris or jams are stuck in the print on your printer path, we will be able to reinstall this piece you found. Now, normally parts like this are non-replaceable. Therefore, it is not supposed to get out of the printer. However, I find in your printer which parts seems to come from a sector.  In the support document, I'm going to have run through to see the Solution three: step 1. The rear access area of your printer where the paper pick roller seems to be where will this piece of black plastic.

    The image is under "Figure 10' in the support document. I think that you can just cut that part into its slot. Once you have reinstalled the game, please try again to print.

    Please reply to this message with the result of your troubleshooting. Good luck!

  • All-in-one HP Deskjet 2541: whenever I have something to print there are spaces at the end of the paper.

    So I had this problem since I bought the printer. Whenever I print photos or documents, anything, there always seems to be a white border at the each end of the paper in a horizontal position. a bit like the printer just abandoned at the end of printing. I tried to align the cartridges, but this does not seem to work and even tried to change the setting. The print alignment page prints nor for the right proportions. Sort can help guys?

    Hello

    The specific model does not support printing without margins (edge to edge), minimum margins are as follows:

    As you can see, 1.45 cm from the button is not a printable area and it is an expected behavior for the printer.

    You can find the specifications of paper below output:

    http://support.HP.com/us-en/document/c03811750

Maybe you are looking for