Slots for DIMMs

Similar Questions

• Working Mobile HP ZBook 17: HP ZBook 17 - how to locate the slot for failing to DIMM

  When running memory diagnostics, I get a failure where newspapers are pointing to "channel Num Num 1 DIMM 0"- but nothing on which four slots contains DIMM failure.

  Where can I find documentation that translates this DIMM/channel numbering scheme to the numbers 1-4 or location physical location (primary or Expansion) mentioned in the service manual?

  I tried to keep this brief and precise question, but I can provide more details if necessary.

  Thank you!

  I resorted to an approach of trial and error to swap DIMM and execution of diagnostic tests to find the bad DIMM.  It was tedious (especially where I had to keep remove the optical drive and the keyboard to switch to the primary slots), but I finally managed to determine that I had TWO bad DIMM, replaced those with the new, and I'm back running with 32 GB.

  I never got an answer about the Diagnostics DIMM numbering at the locations of the physical location to translate, but I managed to learn more through my tests.  Here's what I've been able to determine:

  PHYSICAL DIAGNOSIS

  Channel #? / DIMM #0 main site #1

  Channel #? / DIMM #0 main site #2

  Channel #1 / #1 location #1 DIMM Expansion

  Channel #0 / DIMM #1 Expansion Slot #2

  This should really be recorded somewhere and maybe I wasn't able to find the right document.  I hope this information helps someone else.

• 2 slots for ram, or I can use only a single slot?

  Hello..

  IV ' e bought 8 GB of ram for my MBP 2012 has 4 GB of memory.

  But I totally forgot that she has 2 slots for ram!

  so you can use only a single slot? or I have to buy another ram?

  Thankss

  For best performance Mac need pairs of corresponding RAM modules, swap or buy more is recommended all things being equal. I would however expect sentencing of incompatibility performance much smaller than the benefit of the upgrade beyond 4 GB, so you could run with 8 GB in a slot and the original 2 GB in one for 10 GB total installed.

• My Mac has 4 slots for memory, 2 slots hold 4 GB of memory each.  In the empty slots add 8 GB in each of them?

  My Mac has 4 slots for memory, 2 slots hold 4 GB each.  Can I add a 8 GB memory in each of the empty slots?  I can add memory higher in the empty slots or what I need to keep all memory equals 4 slots 4 GB each?

  It depends on what iMac you have. Some older models may not recognize 8 GB of memory chips.

• How many slots for RAM, model HP 250 G5 (W4M85EA)?

  How many slots for RAM, model HP 250 G5 (W4M85EA)?  What is the maximum amount of RAM supported HP 250 G5 (W4M85EA)?

  @Frodo9911

  Two memory non-customer-accessible/extendable module slots

  Supports up to 16 GB of RAM

  Your manual here.

  http://h10032.www1.HP.com/CTG/manual/c05087748

  REO

• NB100 supplied with Bluetooth and the slot for sim card

  I wonder what model come with bluetooth and the slot for sim card,.

  The NB100? Have a look at the brochures on the Toshiba site.

• How many slots for DDR2 is in my Satellite M100-221?

  How many slots for ddr2 in my M100-221 notebooks? And where I get instruction to change memory?

  Hello

  Sorry, but I really can't understand you. On the low side in the Middle it is placed memory fixed with a screw cover. Is it so complicated to remove this screw and look inside?

  In any case in your unit there are 2 slots available. Memory upgrade you need not all the manuals. Buy the right compatible memory module, remove the cover and put it in the location empty.

• Instructions for opening a Z930 satellite with a slot for SIM card

  Hello

  I have a Satellite Z930, which I would like to open in order to replace the original SSD with a higher capacity.

  Wire http://forums.computers.toshiba-europe.com/forums/thread.jspa?messageID=279122
  has been very helpful.
  But my PC has a slot for SIM card on the right side (side opposite the microphone and the earpiece)

  Even after the take-off of all 14 live (including the right of torx one downtown), back cover cannot be thrown on the side of the slot for SIM card. Something is holding back.

  Anyone in the community has already managed to remove the back cover to the confiuration?

  Thanks in advance for your help.

  Did you manage to remove the cover?

  There is no other method to remove the cover if your laptop is equipped with SIM card, first remove the SD card (dummy bridge media card), then the SIM card (you will need to insert a thin object into the hole on the sim tray) and then the 14 screws of the cover at the bottom of the unit.

  All that s

• How to install microsoft office on my HP Envy? There is no slot for a dvd/cd go in...

  How to install ms office on my HP Envy.  There is no slot for a dvd/cd go in...

  rnschmoopie

  Welcome to the HP Forum.

  The easiest option if you have friends nearby (those living with tech), is to borrow a DVD USB drive and plug it into the laptop for a few minutes so that you can download your software.

  You can buy this kind of tech pretty cheap, too.

  If you have your key, it should be in the CD box, you can probably download Microsoft Office - according to the version - and just use the key you already activate it.

  Click on the Thumbs-Up Kudos to testify and say thank you.

  Although I strive to reflect best practices of HP, I do not work for HP.

  When the answer is a good patch or solution to your Question, click accept as Solution !

• Windows 8 Yoga 13 have slot for sim card?

  Guys, dose windows 8 yoga 13 have slot for sim card...?

  Thank you 1 million for your time

  Note from Moderator: Edition subject to the content of the game.

  No.... this computer has no capabilities of 3G / 4 G/LTE... Just Wifi and bluetooth.

• I have a faulty ram (top) slot for a Mid 2012 Macbook Pro 13 "i5.  Can I install a 8 GB Ram in the slot below or is maximally 4 GB?

  I have a faulty ram (top) slot for a Mid 2012 Macbook Pro 13 "i5.  Can I install a 8 GB Ram in the slot below or is maximally 4 GB?

  This was after the 3 beep error and I couldn't restart the Mac with one of the 2 GB of Ram into the lower slot.

  Is there a way to test if the top housing is faulty or just dirty?

  Thank you

  svchild wrote:

  I have a faulty ram (top) slot for a Mid 2012 Macbook Pro 13 "i5.  Can I install a 8 GB Ram in the slot below or is maximally 4 GB?

  Yes, the MBP will work with a single module of RAM installed, but there will be a slight performance decrease.  A MBP 2012 will accept a module of 8 GB RAM.

  Is there a way to test if the top housing is faulty or just dirty?

  Install each RAM module individually in each slot, leaving the other empty.  If the two RAM modules work in a slot and not the other, the slot is faulty.  Sometimes the adjustment screw can resuscitate the slot.  If this is not the case, make an appointment at an Apple store for a FREE evaluation.

  Ciao.

• Is it possible to access the USB ports and a slot for card SDX?

  Is it possible to access the USB ports and a slot for SDX card at the back of the iMac?

  Rotate the iMac autour to see ports.

• Broadband for iPad pro because there is no slot for broadband on my iPad air

  How can I get my broadband sim card I use on my iPad Air to work on my iPad pro because it has a slot for Sim Card

  I quote http://www.geeksquad.co.uk/articles/apple-ipad-pro-manual-setup-guide#connect%20 to % 20internet

  For starters, check inside the box that your new iPad came, there should be a small envelope of documents. Inside this home is a small ring of metal with a peak, it is the SIM removal tool and is used to eject the SIM card tray. With the back of the iPad in front of you, there will be a small hole on the bottom left of the tablet. Push the SIM removal tool in this hole and a small tray ejects. Put your SIM card in this tray and drag them new in the iPad to complete the process.

• HP COMPAQ 8200 Elite Micro Tow: Can you tell if this system has slots for SSD or hdd adapter necessary - & gt; SSD?

  Can you tell if this system has slots for SSD or hdd-> ssd adapter need?

  WIN INITIAL 7pro

  i5-4-core - 16GB - RAM - fresh install [new 1 TB HDD] 8.1pro win 10pro Win

  HP COMPAQ 8200 Elite Micro Tower

  P / N:XY139EA #AB7

  PURCHASED 07/03/2012

  For w10pro c: / recommend reinstall to ssd or migrate ssd or even is...?

  SSDS all have sons the same size and holes threaded on the bottom and sides.  They all use the same fine metric threads live short (short, so they don't lower).  These screws must come with the adapter, and I live in general using the lateral holes.  Parts of the adapter have threaded, 3 holes and you will use the back ahead and away from those for channels of the drive Bay.  If you look at each side of a standard 3.5 "HDD, you will see the same same spacing holes.

  Some jobs need the SSD to shift to the left so the orientation of the SSD SATA power and data ports match exactly where they would be if the current drive was a 3.5 "HARD drive clutter.  An example is the drive in a Z620 of drawers which accept 3.5 form factor devices "and slides of drawers in the deep part of the case and automatically mesh with ports of power/data SATA back inside.

  Jobs that fuel just a loose cable and the data cable for the SSD is really doesn't matter much if the SSD is an adapter which keeps it more centered or offset to the left.  I've seen cases where a disk HARD 3.5 "given in the lower Bay and a centered SSD is in the upper drive Bay and there was nearly not enough cable length to reach easily shifted left for drives staggered in the Center.  You can see in the photo below that the Garland of feeding on the HARD drive has two unused SATA power below connectors, and there is not a lot of room between them.

  The card you chose seems good... solid metal.  For the HP 8200 Elite CMT I have access to screws 4 total special 6-32 UNC silver HP threaded screw threaded back ahead and away from the screw holes on both sides of the adapter, and then you use the extraordinary end threads metric short screws mentioned above to fix the SSD to the adapter, as shown in the pictures of Amazon.  These HP silver screw 6-32 no metric I'm talking using Torx or flat screwdriver and their leaders are trained to slip into the channels of the drive Bay.

  There are also other designs which are designed specifically for some HP workstations that include mounts insulation rubber with the sliding mechanism.  I don't think you have that... Here is a picture of eBay one of the 8200 Desktop Elite CMT demonstrating the existence of space on the left for 8 of these silver screw to store, which 4 are missing and used on 3.5 "single drive, you see there.  Don't throw those... they are not something, you can go to Ace hardware and buy.

  

• slot for camera memory card

  Do we know if the compaq presario v2555ca has a slot for a memory card from camera and where is it located?

  Thank you

  After Googling it. the v2555ca was interrupted in June 2007... does not show that there is a reader on the subject.