Upgrade memory for the old S320CDS Satelletie cell-is it possible?

Similar Questions

• Upgrade memory for the L-series satellites

  I have just installed a new 512 memory card that works very well.
  Is it possible to include the old card 256 as well?

  After trying to do, he does not connect and I'm afraid to do damage. If possible someone please give me the proverbial 'idiots guide '.

  Thank you

  Hello

  First, you must put the name of the laptop!
  How if someone help if the laptop is not known!

  In any case, if the laptop is able to handle 1 GB memory then it should be possible to use memory modules 512 MB and 256 MB!

  But I recommend to use the same modules. Sometimes, it happens that different modules are not compatible and so the laptop cannot start or run correctly!

• Pavilion e9220y: upgrade memory for the e9220y

  No errors.  Recently upgraded to Windows 10-64.  Always the equipment of origin, Phenom II X 4 910, and 8 GB of ram.  Computer will be used for audio editing and I was curious to know if the unit could benefit from an upgrade of ram.  If it were possible, the device can handle

  Hello

  1. the information says you can use the modules of 1333 MHz but * modules of DDR3-1333 runs at 1066 MHz, if three or more modules are installed.

  2. Yes, this will improve but as mentioned above: not noticeable.

  Kind regards.

• Question about the upgrade memory for my Satellite M40-307

  Sorry for the newbie question. But if I have 512 MB of memory for the time being, what are my upgrade options?

  Do I have to buy pairs of memory? So I can or buy 2 x 1 GB = 2 GB, or 2 x 512 MB = 1 GB + 512 existing. Or can I say just buy a single 512 MB or 1 GB chip?

  Since no one wants to answer:
  1. check if your laptop supports Dual Channel Ram (it should be, but just see the manual to be sure)
  2. knowledge of what type of RAM you have. This will add or remove a possibility of upgrade

  The thing with Dual Channel is, that you have the best performance if you use 2 RAM of the same type (really of the same type: company, size...)
  you could:
  3. Add a 512 MB of RAM of the same type you have
  3 b. buy 2 pieces of new RAM of the same type (1 GB + 1 GB, or 2 + 2 GB) and do not forget that your laptop supports this quantity (once again: manual to check)

  You will also find in the manual, if your computer supports DDR or same DDR2 RAM (faster)

  If you have lost your manual, you can download it here on the toshiba Web page

  I hope I could help a little.

• Upgrade memory for Satellite 2800 400

  I am trying to upgrade my ram to 128 on the laptop. After following the instructions for the instillation, that I turned the laptop on to find that it was slower than before and that the new ram had not registered as 128, and always thought it was 64 in someone can help me solve this ir is there anything I can do?

  Hi Ben

  Maybe you used the memory modules bad.
  As far as I know that you can upgrade memory for max 192 MB
  The 64 MB has been installed in an internal memory and cannot be deleted.

  I found these compatible modules:
  PA3003U - 1 M 03 32 MB
  PS3004U - 1 M 06 64 MB
  PS3005U - 1 M 12 128 MB

• Upgrade memory for Tecra CDT 550

  I have a toshiba tecra 550 CDT laptop with 64 MB of RAM.

  I want to migrate the RAM.

  Memory expansions I could install and what is the maximum size of the memory?

  Thanks for any help.
  Jochen

  Hello

  Well, as I know you can upgrade memory for max 160 MB.
  I found information on this module and it is compatible with your laptop:

  16 MB RAM Part number: PA2039U
  32 MB RAM Part number: PA2043U
  64 MB RAM Part number: PA2044U
  128 MB RAM Part number: PA2054U

  Good bye

• Upgrade memory for iMac 24-inch, early 2009

  I want to upgrade memory for my iMac 24 inch, early 2009 with 4 GB. What a memory of 8 GB will work Best Buy? I have a gift card I want to use.

  Thank you!

  Looks like you can get RAM for about half the cost at crucial.com

  You need 204-pin PC3-8500 (1066 MHz) DDR3 SO-DIMM

• 3097 memory failure allocating memory for the Variables

  Hello - have an old Lenovo tablet of 3 year with Windows XP. Its been performing very well. I get a message that appears randomly who says:

  3097 memory failure allocating memory for the Variables

  installedapp872 = StrSub (Apps, Start, stop-stop)

  WinBatch 32 2000

  WIL Version: 3.0cbv

  has ran a chdsk

  Reinstall the memory.

  Found nothing on Google about this message.

  I appreciate your help.

  Try R.clicking my computer, properties, advanced, performance, swap file,.

  Click Change button, with C: drive selected, the value to "let the system handle",

  2 X game, close, restart the pc.

  Also, try http://oca.microsoft.com/en/windiag.asp

  Download & run the test memory microsoft...

• Upgrade memory for notebook ZT3000

  Hello

  Looking to upgrade memory on an old ZT3100 Windows XP book. Permitted maximum configuration is 2 GB - my computer says it has 1.5 GB installed, but I see that 1.25 so want to check I'm looking in the right place.

  I opened the slot of memory under the laptop and who has what seems to be 1 GB installed. I can work there is a second slot of memory under the keyboard. I managed to locate that too - but he seems to have 256 MB in it - so I wonder if I am at the right thing and, if so, why Windows think that there are 1.5 GB instead of 1.25?

  Anyone have any ideas?

  Hello:

  There are two locations of memory in your model.

  A background and one under the keyboard.

  So, you are looking in the right places.

  As to why the PC reports 1.5 GB, he suggests.

  Run the analysis of crucial memory tool and see what it reports.

  http://www.crucial.com/systemscanner/

  Perhaps there is a 512 MB chip into the slot under the keyboard.

• trying to install photoshop CS-3, request serial number for the old version & not otherwise available?

  Try to install photoshop CS-3 on a new computer but did not have the serial number for the old version, and I'm pretty sure that it is the only version we have.

  Hello

  You may be using a serial key to upgrade to Photoshop CS3 license and would need the license serial key for the previous version (eligible article), which was a product of CS2 and CS3 license has been upgraded or purchased. You can access the link as shown below to help find the series product CS2 license key.

  Find the serial number of your Adobe product quickly

  Thank you.

• Change my Apple ID and now all the other devices asking me the password for the old ID.

  Using my MacBook Pro El Capitan 10.11.3 running, I changed my code from Apple.  We have two iPhones and two iPads.  All are running 9.2.1.  As I made the change to the ID, other devices constantly ask me to enter the password for the old ID.  Of course, it no longer works, but I can't find a way to stop messages.  When I change to the new ID, devices of ask a password.  The password does not work and I am asked to create a new password.  If I do that, I can connect is no longer in my ID on the MacBook pro.  At this time, I again wonder to change my password, and the circle continues.  How can I get all the devices and the cloud to recognize the new ID and password?  This gets pretty annoying, and data is not shared between all the devices for applications like the calendar.

  Try to change the ID to your old one, sign out iCloud on computers/devices, then replace it with a new and connect.

  What to do after changing Apple ID or password - email address

• Error: "cannot find the path specified for the old driver X5XSEx_Pr135.

  Original title : can not find the path specified for the old driver X5XSEx_Pr135 is the message I get.  How can I solve this problem?  What is a legacy driver?

  Can you help me solve this puzzle?  I have no idea how to solve this problem!  Help

  Hello

  (1) when you get the error message?

  (2) program who worked on when you got the error message?

  The computer game to clean start State to check which program is associated with error.

  http://support.Microsoft.com/kb/929135

  Note: When the diagnosis is complete, don't forget to reset your computer to normal startup. Follow step 7 of the above article.

• recommendation of the memory for the guest operating system

  Hi guys,.

  I need some advice

  I have a pile of vsphere 5 made of 2 servers on each server that I have on 5 VM

  (1) domain contoller 2008 standard edition + dhcp + dns

  2) exchange 2010

  (3) file server

  (4) primavera

  My question is what is the recommended memory and cpu for these VM configuration? I'm a bit confused

  What happens if I don't set up the limits and booking hotel and leave all default? What is the point of the week in this configuration? If I leave all default each VM does not use memory a cpu as it needs?

  Thank you specify in advance

  To add the tips of memory... Many people allocates memory for the virtual machines that will never be used, and ultimately you consume the memory of your host much faster than necessary. Start low when allocating memory to a virtual computer. Adding memory is simple to make, after you have collected on the functioning of your host performance data. The Performance tab will show you what is happening.

  Mike

• Pass the product ID through the URL of the payment page for the 'reception - buy' landing page. is this possible?

  Pass the product ID through the URL of the payment page for the 'reception - buy' landing page. is this possible?

  You can just the module module_shoppingcartsummary and liquid, you can return the items in the basket to.

  The developer reference

• Questions about the upgrade memory for gateway P55C-200

  It comes from an old computer from 1997. I'm trying to update and upgrade for the treatment of text and with older games who have worked on it, even if a bit slower that I liked. MDK is a favorite. I add that a little more RAM will help. It has windows 95 on it. He is currently in good working condition. I have a perfectly good printer and a scanner that I can't use it on my other computers with operating systems newer, but which works well on this one. The computer has a card? IRE 32meg with a spare slot, CPU Pentium 200 HZ and a 4G IDE hard drive.

  What type of card m? IRE this computer accepts it and how can I add? The existing memory card has no info about it. I visited the manufacturing sites of memory several, and they come in white for this computer only. I think maybe it's SDRAM PC66, but I don't know. Any information would be appreciated.

  I just ordered two 128 meg sticks, clock 4, CL3, PC66. Who will be my max at the limit of my system to 256 meg. I still don't know whether or not the card memory factory was PC66, as there was no label on it, and my manual is non-specific, because it covers a group of computers that use the same series of motherboard. The seller did some research and said the Board recommended will work for me. He gave me a link http://panam.gateway.com/s/motherbd/intel/m00260/m0026023.shtml that my Board is covered by the listed series. I guess in a week or so I'll know. Thank you all for your help.