Windows XP system repair and commmand prompt still does not

Similar Questions

• I'm on the last update of lightroom 5 and captive capture still does not work with el Capitan. are there plans to upgrade or do I have to buy the new lightroom 6?

  I'm on the last update of lightroom 5 and captive capture still does not work with el Capitan. are there plans to upgrade or do I have to buy the new lightroom 6?

  Hi Yanni,

  Tethered shooting works fine with Lightroom 6.4 on El Capitan.

  You can then go ahead and buy Lightroom and perform the tethered shooting.

  Kind regards

  Tanuj

• I try to install the update of PS CS6 can read files camera raw Nikon D800.  The exe file fails and says trying to install the application manager.  I did it and the update still does not work.  Now what?

  I try to install the update of PS CS6 can read files camera raw Nikon D800.  The exe file fails and says trying to install the application manager.  I did it and the update still does not work.  Now what?

  update by downloading the files directly and then apply them: http://www.adobe.com/downloads/updates/

  If this fails, attach a screenshot of the error message if it is in English.  otherwise, quote it.

• Does not work. Removed from Firefox and downloaded. Still does not work.

  Can't use Firefox to access the internet. Deleted Firefox and downloaded again. Still does not connect to the internet.

  The works of Windows Internet Explorer.

  See this support article - difficulty of problems connecting to websites after Firefox update

• HP Dv6-7029 new notherboard and new processor still does not?

  First Ihad a noisy, then computer fan noise stopped 3 times after being on for a few seconds.
  Fan has been cleaned, then flashing light CAP lock.  I have replaced the motherboard, replaced the processor, fan works and I still don't have the blinnking cap light locks.  I just give my computer to my computer guy because he does not know what what the hell it hurt.  ALL the IDEAS that were not covered to a repair? Oh also, we checked the memory and which was very good.

  The only other thing I can think about is perhaps is the power cable from the CA Jack to the motherboard. You who reused right?

• Windows 7 slow down and MS security essential does not work with error "0xc0000185.

  My PC does not work well.

  I use Windows 7.

  When I tried to open it, it will take at least 5 minutes before turning into log in page. and after I entered my password again 5 minutes to load.

  When I connect successfully my essential security MS does not work with error "0xc0000185"... then my Explorer windows always crashing.

  After each action I did it takes time to load... also, I tried to turn on my Defender, but unable to locate... I also tried to analyse using malware bytes, but it also shut down the application...

  Help, please. I need all my files...

  Thank you.

  Hello

  Windows Defender is disabled by default when you use MSE and nothing to worry about.

  Analysis of Malware in Mode safe mode with networking.

  Download, install, update and scan your system with version free Malwarebytes AntiMalware and if necessary do in Mode safe mode with networking:

  http://www.Malwarebytes.org/products/malwarebytes_free

  'Advanced options boot (including safe mode).

  http://Windows.Microsoft.com/en-us/Windows/Advanced-startup-options-including-safe-mode#1TC=Windows-7

  _______________________________________

  And also scan with the free version of SUPERAntiSpyware

  http://www.SUPERAntiSpyware.com/download.html

  SUPERAntiSpyware Free Edition is 100% free and will detect and remove thousands of Spyware, Adware, Malware, Trojans, KeyLoggers, Dialers, Hi-Jackers, and worms. SUPERAntiSpyware features many unique and powerful technologies and removes spyware threats that other applications fail to remove.

  SUPERAntiSpyware Free Edition does not include blocking in real time or scheduled scan.

  ______________________________________

  It is a very good program to scan your system to remove adware, etc.:

  http://www.bleepingcomputer.com/download/adwcleaner/

  AdwCleaner is a program that finds and removes the Adware, toolbars, potentially unwanted programs (PUP) and browser hijackers from your computer.  Using AdwCleaner you can easily more of these types of programs for a better user experience on your computer delete and while browsing the web.

  _____________________________________

  And just to be sure, nothing is lurking in the background:

  'TDSSKiller Rootkit Removal Utility download for free'

  http://USA.Kaspersky.com/downloads/TDSSKiller

  See you soon.

• IM using ios 9.2 and game Center still does not

  IM using ios 9.2 and have still problem wirh game center.whne I open it, it's stuck and white page that happens... I tried to fixed setting but it stuck there too... .any solutions?

  iPhone 6 more

  I have the same problem too. I tried to fix install the latest beta (9.2.1), but game Center does not work too. When I open the game Center I can put my username and password, but the app is stuck on the loading screen.

  6 more 16 GB iPhone

• Windows 8 App store and settings from laptop does not open!

  Help! I'm having a problem where I can never find a solution I can not open my windows 8 app store or PC settings? I can not reset windows 8 because of this problem and have tried the troubleshooting utility. I'm not using ANY antivirus or firewall software to prevent me to access the features of windows 8, it just doesn't work!

  He is going through a phase in which the application seems to open (color of the screen with the logo of the app, for example, blue background and icon settings) for about, 1.5 seconds and then closes quickly to the start menu, I really get annoyed by this and would appreciate ANY help.

  I tried all these solutions, but ended up reinstalling windows keeping my files and settings.

  When I started reinstallation, Setup check internet for updates and installed updates, first.

  So when I reinstalled, everything works, store and PC Settings, etc. Try to reinstall from DVD if you have.

• Updated to 4.3 and D600 NAVE still does not

  I've updated to 4.3 today and I was still unable to import my D600 NEF/RAW files.  After I updated, I restarted and it seemed that I could actually import the NAVE D600 files.  However moments later, somehow these images were no longer in my library/catalog and when I try to re-import them he says once again the files are not compatible and no preview was available in the import screen.  Any thoughts?

  Win 7, 64 bit

  When you import these files from? They are already on your hard drive? If they are on your hard drive, how you transfer? If it's an older version of Nikon Transfer that could be your problem.

• I ran Recover and my iMac still does not start.

  My iMac is frozen and will not restart.  I ran recover and repair disk permissions, still won't start.  The progress bar freezes approximately a third of the way across and stops.  Any ideas?

  Click on the following 3 links & make the necessary:

  On the screens, you see when you start your Mac - Apple Support

  Reset the management system (SCM) controller on your Mac - Apple Support

  How to reset the NVRAM on your Mac - Apple Support

  

• After internal reset PRAM and SMC microphone still does not work properly

  I've recently updated to el capitan. For the first time that I had to use the microphone internal, so I went to the system preference, the maximum capacity, the value clapped my hands, but the microphone reacts just as shown on the scale bar. So I reset the SMC first then the LANDAU and now it reacts a little more because I clap my hands, I want to tell the scale bar that detects the incoming sound shows like 5 spots (and there are 15 points). I tried to register and the sound of the recording is very low. Is this normal? What I need to fix my mac (3.06 GHz Intel Core 2 Duo, 4 GB of DDR3 memory a 1067 MHz, GB 999,35-909, 89 GB free)? Thanks for any response.

  Susan of morro bay , October 28, 2014 16:21
  in reply to Sirae87   Useful

  I cleaned the little tiny micro holes - and it worked:

  I also had a problem with my internal microphone. In system preferences > Sound > entry, I had the internal mic selected, and the entry level bar would show some activity when I typed in the top of the computer, but not when I spoke. So first of all, I had to figure out WHERE the microphone was actually and I googled and found this on top of my iMac - a very small circle of TINY holes, right in the Middle at the top of the screen. Turns out I have had covered with a decorative Angel, using a sealant that is usually used to stick things to the surfaces. I removed the little angel and PuTTY... but did not always receive my voice recording in the bar of entry-level in sound preferences. I used canned air to blow at the level of the tiny holes, but that did not help. Finally I found a brooch (thinking it was actually too thick, drill holes of small microphone) but I WAS able to push the small holes - so I poked each other - and voila - my internal microphone now work! Yay!

• Nikon D810 and DNG files still does not

  I have the D810... I just downloaded the DNG Converter and still no display in LR. Help!

  Also, please indicate your DNG preference, the parameters used to convert the D810 images.

  Thank you!

• I am now on iOS 9.2 Game Center still does not work. When I open the app it freezes on a blank page. When I open the Game Center in the settings, it freezes and then crashes. Please Apple can solve this problem of Game Center iOS 9.2.

  I am on iOS 9.2 and Game Center still does not work. When I open the app it freezes on a blank page. When I open the Game Center in the Middle it hangs just. For this reason, I can't back up my data on my games. Please Apple can solve this problem of iOS 9.2.

  Hello Vaishnav,

  Thank you for using communities of Apple Support.

  I see that you are having problems with Game Center on your iPhone. I have a number of things for you to try.

  First force quit Game Center.

  1. Press the Home button twice quickly. You will see small glimpses of your applications recently used.
  2. Swipe to the left to find the Game Center app to close.
  3. Swipe up on the preview of the Game Center to close.

  Force an app to close the iOS

  If this does not work, then the next step would be a restoration. I recommend restore like new, without backup restore and everything first. If it works there, you can restore the backup.

  Use iTunes to restore your iPhone, iPad or iPod to factory settings

  Best regards.

• Laptop Pavilion dm1 4010us and beats audio Panel does not work.

  I have a pavilion dm1 laptop 4010us, running windows 7 64 bit and beats audio Panel does not work.  I click Start, Panel, Sound and the Beats Audio Control Panel icon is there, but nothing happens when I click on it, so I can't change my audio settings.  Help, please

  Hello

  Try to use Recovery Manager to reinstall the IDT HD Audio Driver (this will also reinstall the Beats Audio interface) - how to use the Recovery Manager to reinstall the drivers and software is detailed in the document at the link below.

  http://support.HP.com/us-en/document/c01868333

  After reinstalling, restart the laptop.

  Kind regards

  DP - K

• PIXMA MG5220. While changing ink got the C000 error code. Tried to turn on. It still does not.

  I changed the ink when I got a C000 error code. He said turn the printer off, then on and if it still does not read the manual. The manual is no refernce this error code. Any ideas?

  Thanks in advance.

  Hello.

  This problem may occur when there is a loose object stuck inside the printer, or if one of the ink tanks was not sitting correctly.  Please, try the following:

  1. with the cover open, disconnect the power supply to the back of the printer or the wall.

  2. search for all objects or in the printer packaging material, delete if necessary.

  3 gently move as close to you as possible ink tank support.  Try to push the nearest ink tank down.  Once activated, try to close the ink tank support, repeat as needed.

  If you encounter resistance, do not go away while: support of the ink tank.

  If the error persists, find more help contact us.