beep the speaker

Hello

I have a compaq PC running XP with service pack 2 and an AMD processor.

I used safe mode to create a new password because I wasn't able to connect with my old password. After I stopped and turn on my computer, there is a sound coming from the speaker and the screen is blank but it tested good.  I unplug/plug the devices before feeding it but he always made the sound signal and the screen is always blank.  I tried 4 times. How can I solve this problem? Any suggestions?

Thank you

Rose Estabrook

Hello RoseEstabrook,

In addition to Ing. Comment by Ladislav Cemak, I suggest to try some of the steps in the link below.  Please let us know status.

Advanced Troubleshooting for General startup problems in Windows XP:

http://support.Microsoft.com/kb/308041

Thank you

Tags: Windows

Similar Questions

  • my keyboard press by itself at the same time, it emits a sound (beep) the speaker inside

    PC is 2.40

    768 RAM

    Hello

    ·         Were there any changes made on the computer before the show?

    ·         Dose the problem occur on any particular application or Assembly?

    ·         Have you tried to connect check and different keyboard if you are faced with a similar question?

    ·         Do you use the computer laptop or desktop?

    ·         You use wired or wireless keyboard?

    Try to clean your keyboard and check if the problem persists. You might have a particle or a sticky substance that is causing the keys to stick and comes all the way to the top. You may wish to run a slightly damp cloth or a q-tip between keys.

    Method 1:

    I would suggest trying to use the screen keyboard and check if you are facing a similar question.

    To open on-screen keyboard,

    (a) click Start, point to all programs,

    (b) point to Accessories, point to accessibility,

    (c) and then click on-screen keyboard.

    http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/osk_overview.mspx?mfr=true

    Method 2:

    I also suggest you to start in safe mode and check if you are facing a similar question.

    A description of the options to start in Windows XP Mode

    Method 3:

    You can also run this Microsoft fixit tool and check if it helps.

    Hardware devices do not work or are not detected in Windows

  • Computer's noise beeps from the speaker

    original title: strange noises from the speakers:
    recently, my computer makes strange sounds through the speaker. He "loves"doot-doot"

    Joe

    Two DCOM errors suggest that it would be wise to check for malware.

    The other report suggests that your Norton Security software may interfere with the restoration of the system such that you have no restore points, if you need them. It is fine if you have made alternative arrangements but otherwise could be unhappy, if you need to restore to an earlier date.

    Download and install Malwarebytes (free version for individuals only), updated definitions and run in safe mode. Disable other security software while you do the analyses.

    http://www.Malwarebytes.org/

    Download and run SuperAntiSpyware (Free Edition)

    http://www.SUPERAntiSpyware.com/download.html

    You may experience download problems if you have some malware currently in circulation. In this case let me know.

  • iOS 10 no sound from the speaker of the ear or EarPods

    After update of iOS 10 (in 6 s iPhone and 5s) I have a problem then to make or receive calls. Most of the time it is no sound from the speaker of the ear or EarPods and I have to press the speaker during calls to listening. To get back what I have my iPhone and open it again. This seems to happen after that I used once the EarPods.

    Be aware that I have consume EarPods in 90% of my calls and iOS 9 I had no problem at all.

    Hello Billy78GR,

    Thank you for using communities of Apple Support. It is my understanding that you met the receiver and headphone audio problems after update to iOS 10. I know that it is extremely important to be able to hear others during calls. I'm happy to help you to get this resolved with you.

    First of all, I recommend you restart. This can solve many unexpected behaviours. Follow the steps below to restart.

    1. Press and hold the sleep/wake button until the Red slider appears.
    2. Drag the slider to turn off your device completely off.
    3. Once the device turns off, press and hold the sleep/wake button again until you see the Apple logo.

    Restart your iPhone, iPad or iPod touch

    As you use the headphones on most of your calls, I recommend checking and removal of dust or debris from the helmet. If the problem persists, please refer to the additional steps in the link below.
    If you do not hear a person, a call or a voice message or if the sound is not clear on your iPhone

    Have a great day!

  • The speaker on my iPhone seems to be blown out and suddenly the muffled sounds and very low quality.

    The speaker inside my iPhone seems to be blown out and smothered. The quality is low and seems to not be as strong as before. Are there ways to solve this problem or replace the speaker inside the phone?

    < object edited by host >

    Try troubleshooting help here > If you hear no sound or distorted sound of your iPhone, iPad or iPod touch speaker - Apple Support

    If nothing helps, check your warranty coverage > https://checkcoverage.apple.com

    The iPhone may need repair > repair - official Apple iPhone Support

  • I like to use my speakers instead of always put in my ear. How to turn the volume of the speaker on the iPhone OS?

    I have an iPhone SE I would use the speaker instead of always put the phone to my ear, but the volume is not good at all on the speaker. Is there a way to increase the volume for the speaker?

    You would turn the volume for the speaker during a call speaker. The volume buttons control different aspects of the volume, such as the ringing, the music, the volume of the speaker during a call. You change certain volumes based on what you happen to be in time. When you first unlock the phone and are simply looking at the home screen, if you press the volume buttons then, you set the ring volume. Change the speaker volume when in a call of the speaker, is that in the call itself, just like changing the volume of the earpiece, that while in the call.

  • iPhone 6 How increase the built in the volume of the speaker above the ordinary limit?

    iPhone 6 How increase the built in the volume of the speaker above the ordinary limit?

    I use the phone as a hands-free device and the volume is not strong enough by the speaker button.

    The person I'm talking to can hear me very well...

    If you are on a call tap the speaker icon to switch to the speaker at the bottom on the phone.

  • New iPhone SE no sound from the speaker of the brand

    I just bought a new iPhone SE and I'm getting no sound from the speaker. Does anyone have any ideas on a possible resolution?

    I restored from an iPhone 5 to the top, both phones are on the latest version of iOS.

    Once the synchronization is complete, I ejected the phone correctly. But there is no sound coming from the speaker:

    • Key "secret" in both positions, no sound from the speaker
    • The top volume, using the volume buttons and the sound, no sound from the speaker settings
    • Headset plugged in, sound comes from the helmet, remove them, the iPhone recognizes, but still no sound
    • I tried the music app, ringtone from another phone, videos, podcast app, no sound from the speaker
    • Past the phone power off & on again, no sound speaker
    • Reset iPhone (hold both buttons down for 10 seconds), no speaker sound
    • Reset iPhone settings, no speaker sound

    I begin to suspect it is a hardware problem, but as I am not near the Apple Store, I would try as much as I can before you go this route.

    Thank you

    Hello Andy,

    Thank you for using communities of Apple Support.

    I understand that you have restored your iPhone backup iPhone a precedent, and now there is no sound from the speaker.  Given the troubleshooting you have already done your next step is to restore the factory settings to see if the problem persists:

    Use iTunes on your Mac or PC to restore your iPhone, iPad or iPod to factory settings

    If the problem persists, then please make an appointment with the Apple Store is close.

    http://www.Apple.com/retail/Geniusbar/

    Take care.

  • Satellite A300 - no sound, the "speaker" with a red icon

    Hey there!

    So, I got this Toshiba sat idle until I decided to restore it to factory settings and start using it again. I remember exactly if I didn't sound the last time I started before restoring it, but now, after three reinstalls I've still no sound, all I have is the speaker with a red x icon.

    This laptop is using Windows Vista 32 bit, I had no problem during the restore, everything has been properly installed except audio drivers. I'm sure I should have something in the sense of "Realtek High Definition Audio Driver" or something on the Manager devices, but all I have is "ATI HDMI Audio" and three devices not recognized and the only thing that appear on the output devices is "Realtek HDMI Output/ATI HDMI Audio" and say that it is not. Already tried to reinstall the Toshiba drivers, Realtek, even went as far as to try to force Windows to install the correct driver, but it ended in a BSOD.

    Then... I'm really at a loss. I really want to restore the sound, and I refuse to believe that there is no solution. The device is detected every time even though she has not recognized... Then... Am I missing something?

    Help, please. =(

    >... until I decided to restore it to factory settings
    Original recovery image contains all the necessary drivers for all hardware components, so its driver must be installed correctly.
    Can you please open the Device Manager and check the status of the sound card it.
    Please post comments.

  • How can I add the speaker notes to a slide using applescript?

    How can I add the speaker notes to a slide using applescript? I am able to create slides, add a title and bullet points, but when I try to add the speaker notes, it does not work.

    say thisSlide

    -set the title

    set the text of the object to the default title at "TITLE" element

    -create a bulleted list

    the text of the object of the item to the default body ¬

    "Bullet Point 1" & return & "Bullet Point 2" & return & "Bullet Point 3"»»

    -put the presenter notes

    ¬ the text value of the object of the presenter notes

    '' Here is my presenter notes.

    How can I add the speaker notes to a slide using applescript?

    Maybe like this:

    say thisSlide

    -put the presenter notes

    Set presenter notes to "here is my presenter notes.

    end say

  • I just spilled some water on my iPhone 6 near the speaker and listener made holes idk if water has penetrated or does it damage my iPhone please help!

    I just spilled some water on my iPhone 6 near the speaker and listener made holes idk if water has penetrated or does it damage my iPhone please help!

    See if there is an indicator of Contact liquid on your iPhone > liquid for iPhone or iPod is not covered by the warranty

  • Replace the speaker on BDVE390 taken

    I have home cinema blue ray with 6 speakers. One of struggling to become damaged and I need to replace just the Jack. How can I order or replace?

    The Jack is easy to remove, cut some wires off and insert the return wire into the socket?

    Thank you

    Hello Phil,

    The speaker sockets are not replaceable by the user.

    It is necessary to ship the system Home Theater to the Sony authorized service center to replace the speaker jack.

    You can run the query service from the link below:

    https://eService.Sony.com

    Kind regards

    Colby

  • Skype - cannot change the volume of the speaker + Info

    My friends and I are living wrong with Skype these days, none of us are able to adjust the speaker volume + Skype is constantly evolving our Microphone volume, even if we have disabled 'automatically Adjust Microphone settings'.

    If someone has encountered this problem and have you been able to solve this problem? Or do we wait for Skype to release a new update?

    When you are on a call and you have this problem, open Call -> call Technical Info. Right click on the Info window call and select copy. Paste the copied text in any text editor (Notepad, for example) and save the file on your computer. This zip file and attach the file to your message here.

    http://community.Skype.com/T5/Windows-desktop-client/Skype-auto-adjusting-mic-I-have-done-everything...

  • Satellite A350-how to disable the speaker internal while external speaker jack

    Hi all

    Anyone knows how I can cut the House speaker while connecting to the external speaker?
    I want to use my laptop in libuary, but when I plug in the headphones, the speaker still his, when I put in muted, the speaker and the headphones the two silent.
    How can I configure the silent speaker, while external speakers can only keep silent?

    > Knowledge how can I mute the speaker internal while connecting to the external speaker?

    I guess you have a Realtek sound card and Realtek HD audio Manager should appear in Control Panel.

    Please check this Realtek HD audio Manager.
    The speakers on the right tab, you will see the options analog & digital.
    Right click one of the option and check if you could see a few options that provide a framework in order to mute the speakers.

    You will also see the option called: the advantage of the device settings.
    Check this box too.

    PS; my laptop automatically the internal speakers if the headphones have been connected.
    I read in other threads that update the audio driver might help too, but first test the settings as mentioned above.

  • No sound from the speaker to the right computer - Satellite A60-124

    Since 2 weeks I have not more of her in the right computer speaker (Satellite A60-124 (the left one works very well fortunately))
    What can I do?

    Thank you

    [Edited by: admin on 21 January 06 20:50]

    Hello

    It sounds like the right speaker is broken.
    Did you check if the headphones work correctly?
    Please check. If the headphones work properly, so I guess that the speaker has a failure. In this case, you must contact the service for a replacement.

    By the way: Please check the Speaker Volume option in the sound and Audio devices.

    Good bye

Maybe you are looking for