Can I install a USB 2.0 5-Port PCI card on XP

I have a Compaq Presario AMD Duron processors 701 MHz 768 RAM.

Windows ME original system upgraded to Windows XP Home Edition Version

2002 service Pack 3.

Can I install a PCI 5 ports USB 2.0 on this system?


Tom Ferguson

Tags: Windows

Similar Questions

  • HP Clubhouse 15 088se windows 7 64 bit can't install 3 USB driver

    Laptop: PVailon 15 HP model 088se

    I installed Windows 7 64-bit professiona, but the 3 USB ports does not work.

    Download drivers USB 3 "pilot version Intel USB 3.0 host controller" "but the installation failed, I tried to install the versions and both vain."

    Help, please


    Try the driver directly from Intel and see if it works... Download, unzip and run the setup.exe file.

  • Can be installed on USB key


    I was now more difficult within two days to have to try to install ESXi free 3.5 on a USB flash drive.  I wonder now if the files I used were bad.  These are the files:

    ESX Server 3i U2 Installable Refresh

    Version 3.5.0 | 110271 08/13/08

    VMware ESX Server 3i U3 Installable Refresh

    Version 3.5 update 3 | 123629 06/11/08

    VMware ESX Server 3i U4 Installable Refresh

    Version 3.5 update 4 | 153875 03/30/09

    Images of dd kept lack of writing with a weird error (dialog box with the big red x and no explanation) when you use WinImage.

    Help, please


    I've had bad luck with WinImage.  Try dd for Windows instead.  Begin by zeroing on the existing partition, and then zeroing on the set of the device, and then write the image on the unit.  It's the only way I found to work around any reliability insistence Windows only have a single partition on a removable device.

    Jason Litka

  • I can't use my usb for Motorola V860 ports or Pantech USB modem need drivers.

    I can't have my phone interface to download pictures on my PC.  During my service of property intellectual was in decline due to failure that I tried to use my USB Modem of Pantech to access the internet, my computer would recognize as well.  Both seem to be driver problems, but I could not find the drivers for the 2 devices.


    the drivers for your phone from the phone manufacturer not windows

    read this:

    It goes the same for the modem

    Contact the manufacturer of the modem or your ISP

  • Can I use a USB-6501 instead of a PCI-6503 map?

    I currently use a card PCI - 6503 DIO into a Windows XP system. We have an old (7.1) version of LabVIEW. We are looking for a Virtual Machine in Windows 7, but he will not be able to communicate with the PCI Bus. We currently use a PCI-6503. A USB 6501 will work to place it?

    We are looking for some intot wiring problems, but I think it will do the job.

    Thank you.

  • Cannot install printer USB on Satellite L100-171 - specified port is unknown

    I can't install a USB printer on my laptop. I tried the Lexmark and HP printers, but after that they look as if they were installed OK, I get a dialog box indicating that "the specified port is unknown.

    I tried to just about everything, including the re - install USBPRINT. SYS and USBSCAN. SYS, but still won't work.

    I am running Windows XP with SP2.

    Could someone help?

    Thank you

    Can I use the USB ports with some other external devices? Have you noticed any problem in Device Manager?

  • How can I install Firefox on Samsung S5 via the usb port on my PC

    You don't have a Google account - don't want no one. Want to just Firefox. How can I install via the PC's USB port. I have the developer options enabled.

    You can use the Aurora of Firefox for Android version.

  • Portege 3490CT - I can't install XP using the USB dvd burner


    I can't install Windows XP Home edition. I have USB-DVD writer and also an external recorder Toshiba on PCMCIA (CPI 5025a Toshiba) but he couldn t find any external recorder.

    I remove the HARD drive and format the extern in 2 parts.
    I first install BACK and copy the files of Windows XP Home edition on the second part, but I could also install it because of the conflict of the FAT and NTFS t. In the BIOS, I chose cardbus-16 bit. My CD burner works (tested before).

    Please help to install Windows on my laptop.

    You cannot install Windows XP directly because there is no driver for the external optical drive to build.

    Mainly, you're on the right track.
    Format the HARD drive, make two partitions the two FAT32.
    Copy the folder I386 from your CD to install XP on the second partition.
    Start the installation calling winnt.exe.
    Install XP on the partition of frist.
    After the installation is complete, you can use the XP "convert.exe" command to change FAT32 to NTFS partitions. Run "convert.exe /?' in a DOS window to get the correct settings."

  • Can not install device driver USB IRDA Kingsun on Satellite A100 with Vista OS

    I have a USB IRDA Kingsun device that worked well on a desktop with XP but my Satellite A100 with Vista defies installing the drivers that came on a CD with the IRDA.

    How can I install or does anyone know one that works with Vista?


    If you are not able to install the 3rd party device IRDA driver on Vista, it seems that the disc is not compatible and don t support Vista.
    Seems you have to contact the manufacture of the IRDA device and ask the compatible reader

    But maybe that you're unlucky and the Vista driver does not exist?  :|

  • I can't install VISA driver and driver USB GPIB on my PC with VISTA... help me...

    I have LabVIEW7 and VISTA, it's ok, but I can't install the driver VISA and USB GPIB driver on my pc... it is necessary to connect my pc with instruments? Or LabVIEW7 have this files? Thank you


    LabVIEW 7 is not supported on Vista and the version of NI-VISA supplied with LabVIEW 7 is not supported. You can download the latest version of NI-VISA - I ALREADY GAVE the link for you.

  • Can I install Driver Visa and USB-GPIB on LabVIEW7?

    Can I install Driver-NI-VISA and USB-GPIB on LabVIEW7? Or I need to install LabVIEW8?

    Thank you


    Veronica wrote:

    Can I install Driver-NI-VISA and USB-GPIB on LabVIEW7?


    Or I need to install LabVIEW8?

    Only if you want to program in LabVIEW.

  • Devices not recognized USB / can not install updates

    Original title: starts to feel like a Tennis Ball!

    I have an IBM ThinkPad Laptop and it can't recognize all usb devices. Windows asking me to contact the manufacturer and IBM wants me to get Windows updates... that will not be installed. I just want to SEE my flash drive. It has enabled updates Auto but as with "Satellite enabled", it is rarely if at all connected to the Internet at the right time. I want to just make sure everything iskosher, so I can eliminate all possibilities of why I can't see my flash drive.


    ·         What happens when you connect the Flash drive to the computer?

    ·         Is the drive detected in Device Manager?

    ·         What is the version of Windows installed on your computer?

    ·         What are the updates pending or not installing on your computer?

    You can configure the computer to clean the start state, and then try to update the computer and check if that helps. To set up the computer in a clean boot state, follow the link below.

    How to troubleshoot a problem by performing a clean boot in Windows Vista or in Windows 7

    For Windows XP:

    A description of the options to start in Windows XP Mode

    Note: When you are finished troubleshooting, follow step 7 article to start on normal startup.

    Hope this information is useful.

    Amrita M

    Microsoft Answers Support Engineer
    Visit our Microsoft answers feedback Forum and let us know what you think

  • can I install NI 9227 on NI USB-9162


    I have an application where I need to measure the difference of current using cRIO and save to file

    I'm not familiar ith FPGA but can do it with cDAQ.i

    So I need to install it on the NI USB-9162, I already have.

    But it did not work on my laptop

    Pleasef tell me if it is possible?


    You can not install the NI 9227 on the USB-9162. It is not compatible.

    The NI 9227 is only compatible with CompactDAQ or cDAQ-9172 according to the table of compatibility here:

  • I tried to install 300 photos on a USB I installed 170 photos and come with an Ox80070052 error message. Please advis how can I install the rest of the photos without the passage of the error.

    I tried to install 300 photos on a USB I installed 170 photos and come with an Ox80070052 error message. Please advis how can I install the rest of the photos without the passage of the error.

    Hi BrendaMay,

    Take a look at this link and check if the post by Ira Horowitz to Monday, December 24, 2007 15:04 is a good one to try.

    Kind regards


  • I tried to install 300 photos on a USB I installed and come with an Ox80070052 error message. Please advis how can I install the rest of the photos without the passage of the error.

    I tried to install 300 photos on a USB I installed and come with an Ox80070052 error message. Please advis how can I install the rest of the photos without the passage of the error.

    Hello BrendaMay,

    ·         What exactly do you mean by saying that you install photos?

    ·         You try to copy photos from your computer to the USB key?

    Try to format the hard disk to the NTFS Format USB and check if you can copy the photos.

    If does not work, try to format to FAT32.
    1. type devicemgmt.msc in the Vista Start menu or in the Run dialog box.

    2 expand disk drives, right-click on your USB key that you want to format it in NTFS file system, and then select Properties.

    3. on the Policy tab, select optimize for performance option. Click OK and return to my computer.

    4. right click on your key USB. Select Format.

    5. Select NTFS from the drop-down list (you can also select FAT32).

    6. click on apply to format your drive to NTFS.

    Note: The pilot of formatting will destroy all data on the disk.

    If this does not work, try to create a new folder in the drive, and then copy the photos on this folder.

    Thank you

    Irfan H, Engineer Support Microsoft Answers. Visit our Microsoft answers feedback Forum and let us know what you think.

Maybe you are looking for

  • Why is Apple silently discard mail send to my iCloud without warning?

    I have a Web site and lately I noticed that I started to receive less e-mail in my inbox icloud, after some research, I discovered that iCloud is silently throw a lot of emails from my site. they never reach my Inbox, not even my spam folder. Accordi

  • Wireless LAN on Equium A210-1AS connection with WPA-TKIP encryption problem

    I have a 1AS Equium A210 with Vista but cannot connect to the internet via a wireless router cable modem NTL using WPA-TKIP encryption and 5600 philips. The laptop shows the base station wireless with a beep sound intense but said that the base of th

  • Strange phone call

    I was contacted thid morning from someone who said he was from microsoft windows.  He said that my computer has been hacked and that it might crash.  He said he could help me if I did what he told me on the computer.  I was leary I had a hard time to

  • a repeat loop

    Hi, I need the error message that the first time, seems. See the attached file. When the error in the string it appears errormessage, but he continues to repeat every time it senses the right channel Match.What is best way to handle this case? any su

  • Problems with 'Runtime Error '.

    The system is Windows XP Professional 64-bit After I enter the password and login to the system as an administrator. a small window opens, who says: ------------------------------- Microsoft Visual C++ Runtime Library Runtime error! Program: C:\Progr