Cannot turn off the field from the date of entry into application workflow

Similar Questions

• Help, please! I plugged a new plan "creative cloud membership (one year)", but cannot turn off the "Plan of creative photography of Cloud (one year).

  Help, please! I plugged a new plan "creative cloud membership (one year)", but cannot turn off the "Plan of creative photography of Cloud (one year). What to do?

  Hello

  You can try the steps on the following link to cancel, cancel your membership Adobe Creative Cloud

  If it does not you or if you get an error contact Adobe to contact customer service

• Cannot turn off the issue of jam and paper cartridge (both at the same time)

  I have a HP Officejet 8600, running on a wireless home network.  The printer will not work.  We get two messages. 1. Introduction to jam, and I'm going through all the steps to clear paper, including the search for pieces of paper, as well as any leaves.  I found no paper, whole or in part anywhere in the printer.  2. at this point, I get a message that I have a problem with a printer (of ink, installed correctly, etc.) cartridge.  Simply replace us all cartridges, so I know that we are not out of ink.  However, when I opened the door to the area of printer cartridge, the cartridge does not move where I can check it out.  There's just right.  So I'm "stuck".  I don't know how to get the cartridge door to roll over so I can check!  I turned off the computer several times and tried to reset things, but nothing seems to work.  Any suggestions?

  Followed - I turned off the printer.  Then opened the cartridge and reaches into the printer access door.  Without moving the cartridge door, I pressed each cartridge to make sure it was placed correctly.  Then, shut the door and back running the printer.  The printer seems to start correctly.  I then opened the door, the door-cartridge moved where I could access them normally.  I double checked that each cartridge is installed and closed the door.

  At this point, everything seems to work properly.

• Cannot turn off the LEDS on Cisco Aironet 1141

  I am trying to turn off the LED on a Cisco Aironet 1141 p/n AIR-AP1141N-A-K9.  It is a standalone AP and the CLI I publish this command:

  turn off the display of #led AP (config)

  The light does not go out after you type this command.  If I "run" it appears in the config so that the order has been accepted.  Is there another way to turn off the LED?  I'm under JA1 IOS Version 12.4 (21a).

  If you have the AP 1141 under warranty, you can send an email to [email protected] / * / PA serial number and they can post you the picture ask you.

  You want to say "Thank you"?
  Ne. Just note the useful responses,
  It is more useful than 'thank you'.

• Cannot turn off the keyboard

  After pressing the power button on my PalmZ22 and the disabled keyboard appears and I type to disable the keyboard this screen disappears.  Tapping to turn off the screen to put my password does not work. I tried to reset my Palm with Soft and Hard Reset function, and always with let me not disable the keyboard.

  ecwmoore2106, please do not double - post.

• cannot turn off the old computer to Acrobat Pro

  I bought a new computer and installed Acrobat 9 Pro. I went to use it today, but I get an error message

  Nancy Pommerening: "Do not use this product at this time. You must repair the problem by uninstalling and then reinsatalling this product... or contact help Adobe customer service. »

  I have this on two computers relatively old I can't access is no longer to turn off the program. How to solve this?

  HI nancyp.

  Please contact the customer service. A customer service agent can help you deactivate the software on your old computers. For more information, see Activation & deactivation help - Adobe .

  Best,

  Sara

• Turn off the music player built into the Droid 3?

  Hello. If I have a podcast in my Droid 3, the player built-in music play the podcast automatically file whenever it receives a stereo Bluetooth to my audio system automatically. I don't like the music player because there is no function "Resume Play" where I can pause the game, save the position and resume playing when I restart the music player later. My MP3 Clip + SanDisk player can do, but the most expensive Droid 3 with the built-in music player does not have this feature.

  In addition, if I have another podcatcher application, the integrated music player seems to prevail and will even play on the the third podcast player app, then you start to get several podcasts playing at the same time.

  No idea how to turn off the music permanently player? I of course can't uninstall it.

  Thanks in advance.

  
  

• I stop using the computer for a few minutes. Then the screen of the computer turns off. Its does not sleep I need to turn off the computer then put into market and re - turn on the computer.

  If I have not used the computer for a few minutes then the screen of the computer turns off. The computer is not sleep. I tried to use the space bar to wake him but he won't answer.  I have to turn off the computer. Then turn on the computer. This has happened for 2 months. I have a Dell DM051, 446 GB HDD with 329 free GB, 2 GB RAM, Intel (r) Pentium (r) CPU 2.80 GHz, ASUS A7 Series 240 and Windows 8 Pro graphics. I replaced the graphics card because I thought that this could be the problem, but it wasn't. I need to replace to fix this? Thanks for your help.

  You have disabled things like Hibernate and hybrid sleep, etc. on the power options screen in Windows?

  Have you checked the USB settings in the Device Manager? Search tab power management for each listed root USB hub and uncheck the box "allow the computer to turn off this device...". »

  And do the same for entries under Human Interface Devices (HID) device as Manager.

  Then restart...

• Cannot turn off the location Services on the new iPhone

  For some reason, there is no way to disable the location Services on new iPhone 6 s daughter. We have switched/updated sound from an old iPhone 5, but were sure disable settings find my phone/Find My Friends. In addition, iPhone 5 has been wiped clean. However, location Services are unable to be activated off the coast on the new iPhone... the toggle switch is "grayed out". Even in circles iCloud, even in the General settings.

  The idea was to find it on my friends for the new phone, but this is not possible, since it states that this service is managed by the iPhone 5... is no longer active. No matter what I try (reboot, reset location/privacy settings, turn off all network connections), I am unable to adapt localization Services (On / Off) and subsequently, the share location parameter.

  3 other phones that we have obtained (6s as well) do not present the issues and working properly, including the activation of location Services button.

  Hi, pairof9s.

  Please visit Apple support communities.

  I understand that you can't change the setting of location Services on iPhone again your daughter 6 s.  It looks like may have restored the old iPhone backup and restrictions are activate that prevent changes to certain characteristics.  You can check by going to settings > general > Restrictions and see if they are enabled.  You can then temporarily disable restrictions you can change this setting.  Take a look at the article below for more information.

  On Restrictions (parental control) on your iPhone, iPad and iPod touch

  In regards not being not able to find my friends, you need to maybe just remove the iPhone 5 find it my iPhone via iCloud.com service.  Take a look at the article below for instructions on how to remove the device.

  iCloud: remove your device, Find My iPhone

  See you soon

• Cannot turn off the spigot in 23

  There is only one tab and a plus sign next to it in 23. I thought that we had the ability that turns off.

  Even if I'm here, I'll also to say for a while now it has been weird, open a new window flashes open for a while and then turns back to my original window. Sometimes he makes the multi window navigation difficult.

  Before ask you, no, I never use tabs. I hate tabs.

  Hello

  In Firefox 23, as part of an effort to simplify the firefox options define and protect users against unintentially damage their Firefox _{and prepare a scheduled browser overhaul}, the option to hide the tab bar has been removed.

  Fortunately, this can easily be solved if you want the tabs to keep hidden. You can install "hide the tab with a tab bar", an extension hosted on the site of Mozilla Add - ons, which will restore the ability to hide the tab bar.

  Thank you and I hope this helps!

• Cannot turn off the Local network

  Message icon and get XP Pro SP3 right click LAN "it is not possible to disable the connection at this time. The connection may be using one or more protocols that do not support plug-and-play, or it may have been initiated by another user or the system account.

  I am the only user and administrator.

  When I di ipconfig/all, I get this:

  Microsoft Windows XP [Version 5.1.2600]
  Copyright (C) 1985-2001 Microsoft Corp.

  C:\Documents and Settings\Administrateur > ipconfig/all

  Windows IP configuration

  Name of the host...: laptop
  Primary Dns suffix...:
  Node... type: hybrid
  Active... IP routing: No.
  Active... proxy WINS: No.
  ... DNS suffix search list: domain_not_set.invalid
  domain_not_set. Invalid

  Ethernet connection to the Local network card:

  The connection-specific DNS suffix. : domain_not_set.invalid
  ... Description: Intel(r) PRO/100 VE Network Connection
  Physical address.... : 00-0F-1F-A1-0C-53
  DHCP active...: Yes
  Autoconfiguration enabled...: Yes
  ... The IP address: 192.168.1.67
  ... Subnet mask: 255.255.255.0.
  ... Default gateway. : 192.168.1.1.
  DHCP server...: 192.168.1.1.
  DNS servers...: 192.168.1.1.
  184.16.4.22
  Lease obtained...: Tuesday, October 12, 2010 10:18
  End of the lease...: Wednesday, October 13, 2010 10:18

  Ethernet wireless network connection card:

  The connection-specific DNS suffix. : domain_not_set.invalid
  ... Description: Dell Wireless 1350 WLAN Mini-PCI Card
  Physical address.... : 00-90-96-A7-2C-08
  DHCP active...: Yes
  Autoconfiguration enabled...: Yes
  ... The IP address: 192.168.1.68
  ... Subnet mask: 255.255.255.0.
  ... Default gateway. : 192.168.1.1.
  DHCP server...: 192.168.1.1.
  DNS servers...: 192.168.1.1.
  184.16.4.22
  Lease obtained...: Tuesday, October 12, 2010 10:18:29
  End of the lease...: Wednesday, October 13, 2010 10:18:29

  Hi cciaffone,

  If you can't turn off your connection to the local network by going to the network connections

  Please try to disable it via Device Manager

  go to RUN and type the following command in the RUN: DEVMGMT. MSC

  under network card try turning off your ethernet card.

  hope that helps

• How can I turn off the data execution prevention in Vista.

  I am trying to download the Ikea home planner and it won't let me.  I get a DEP error message and it stops my internet explore.

  Hello

  turn off DEP is not recommended

  How to enable or disable DEP in Vista

  http://www.Vistax64.com/tutorials/120778-DEP-enable-disable.html

  How to enable DEP on or off for a program under Vista

  http://www.Vistax64.com/tutorials/65790-DEP-turn-off-programs.html

• Cannot turn off the facial recognition in elements Organizer 10

  I tried several times to disable facial recognition in items Organsiser 10 but the boxes 'which is' continue to flow upward. Does anyone have any ideas as to why it does not turn off.

  Vaishali, I thank very you much, that was the solution. Such a simple fix for a problem that I have been working on for so long looking through countless forums. Can't believe I didn't notice that option before. Thanks again.

• X 230-cannot turn off the Adaptive function contrast or backlight?

  X 230, have tunred off the coast of the brightness and adaptive contrast in Intel and power settings, but the screen becomes even darker on the dark pages and then lit upward on whites.

  All the hidden settings should I Explorer?

  
  

• I am trying to turn off the DEP to run an application (angry birds space) in simple words, how should I do this?

  Help, please

  Hello

  For security reasons, it must be very careful to turn off DEP.

  Here is some information for you:

  "How to turn on DEP on or off for a program in Vista and Windows 7"

  http://www.Vistax64.com/tutorials/65790-DEP-turn-off-programs.html

  "How to enable or disable DEP in Vista and Windows 7"

  http://www.Vistax64.com/tutorials/120778-DEP-enable-disable.html

  See you soon.