ESXi cannot see FC HBA

Similar Questions

• Install ESXi cannot see the RAID array

  I tried to install ESXi 5.1 on a HP Proliant Dl160 G6, with 4 hard drives of 2 TB in RAID 1 + 0 array, using a HP b110i controller. When it comes time to select the installation media ESXi to, the installer sees the 4 physical disks, rather than the logical disk that I created with the controller.

  The b110i is a RAID controller-based software that does not support the ESXi.  As you have noticed it will not recognize the individual disks and it work perfectly with them as individual disks.  But if you are looking for a RAID array, you need to add another RAID controller.

• New ESX host cannot see SAN fiber - Clariion

  Hello

  I spent about two hours, passing through communities and have tried various things without success... basically, I have a new ESX host that I've built, configured, and networked, but I can't see our existing SAN.

  The SAN is a Clariion CX3 - 10 c and it hosts all of our existing VMs (we currently have two hosts attached to the SAN)

  I have installed the CLI and Navisphere agent on the new host

  I have started to host and that you have ENABLED the two adapters Emulex HBA (host contains two HBAs installed) because they showed as disabled by default BIOS

  I have one of the HBAs connected to the fibre switch

  On the fibre switch, I have a flickering green light where I plugged the fiber cable, which makes me think, it is connected OK

  On the HBA, I have a green light and an orange light blink, which still makes me think the wiring is correct

  BUT I do not see the front Navisphere host, and the host cannot see all storage even after re-reading.

  Any ideas what to try next? I suspect that it is perhaps something to do with zoning - I must say the Emulex HBA how to find storage processors? If so, how can I go about it? From the BIOS by restarting the host and pressing ALT - E?

  Any help or advice appreciated...

  Assuming that hard zoning this site should provide you with some

  Help

  http://TechNotes.twosmallcoins.com/?p=16

  Also once the switch is zoned if the host is not listed on

  the Clariion Navisphere agent system has a config file that needs to be updated

  with the IP addresses of the SPs.

  You can also manually enter the host if necessary, but your

  probably zoning question.

• cannot see the bengali fonts correctly in a Web page.

  Presenty using Windows 10 and Firefox 41.0b5. Cannot see the Bengali fonts correctly in any Web page, but the edge or the Internet Explorer can display Bengali fonts nicely.

  You can try to disable hardware acceleration in Firefox.

  • Tools > Options > advanced > General > Browsing: "use hardware acceleration when available.

  You will need to close and restart Firefox after enabling/disabling this setting.

  • https://support.Mozilla.org/KB/troubleshooting+extensions+and+themes

  You can check if there is an update for your display driver graphic card and search for hardware acceleration of related issues.

  • https://support.Mozilla.org/KB/upgrade-graphics-drivers-use-hardware-acceleration

• When I install the new version of firefox browser dose being not fit on my screen. I cannot see the tabs or the ul bar and not even leave the firefox avecjoint

  When I install the new version of firefox browser dose being not fit on my screen. I cannot see the tabs or the bar ul and can leave not even firefox without using ctrl-alt-del and opening a master and have it at the end of program. Help, please.

  You may have a corrupted file xulstore.json .
  https://support.Mozilla.org/en-us/KB/changes-toolbars-and-window-sizes-are-not-saved

• Toshiba Kira - Win 8.1 cannot see all files on the 64 GB flash drive

  Hi all

  Newbie on this forum. I just bought the i5 8 GB of RAM Windows 8.1 Kira Ultrabook, a great little machine.

  I have a SanDisk 64 GB flash drive that has about 20 GB on it in a dozen files. These folders and the content can be seen by my Windows 7 PC, even my mobile phone and Tablet Tower.

  However, the Kira cannot see both files, even if in the properties of the drive, he sees the space correctly. Turned on all folders and no difference.
  My wife has a 32 GB flash - no problem.

  I reformatted the flash disk, run a virus on the disk and the Kira. The Kira can someone verify the maximum size flash can see it please? I can't find it in any documentation.

  Any help or suggestions appreciated - I ran support Toshiba without a response, so maybe someone here can help you.

  Mark
  Brisbane Australia

  The appearance of the folder is not in your laptop model or your system!

  I recommend you to check some common view windows Explorer settings:

  (1) to see the hidden files and folders reported as
  Click the view tab, and then click Show hidden files and folders.

  (2) to display all the system files that are usually hidden from view.
  Click on the view tab, and then clear the Hide protected operating system files check box.

  Here you will find all the information about the folder views and behavior
  http://Windows.Microsoft.com/en-us/Windows-Vista/change-folder-views-and-behavior

• S75-b7218 Windows 8.1 satellite cannot see the bluetooth headset

  Satellite 8.1 Windows cannot see the Philips SHB5500 bluetooth headset.

  Driver: Intel (r) wireless Bluetooth (r)
  2014 08-12
  Version: 17.1.14342

  Help! Please, I beg you!

  Laptop certainly supports BT 4.0
  The question is: have you enabled the BT correctly in 8.1 parameters to win?

  Another question: have you tested the BT headset as part of another device?
  I mean, it is possible that the helmet is not working properly.

• Whenever someone calls, I'm not able to take the call and cannot see the identification of the appellant as well. However, he gets noticed in the missed calls.

  I have an iphone 6. Whenever someone calls, I'm not able to take the call and cannot see the identification of the appellant as well. However, he gets noticed in the missed calls. Help, please.

  It is a problem of carrier - I would like to talk with my carrier

  Your signal may be weak or you can be in a dead zone - or there may be interference - those that can cause the call to go directly to voicemail

• Cannot see/Run JCarousel with FireFox

  Cannot see/run JCarousel with Firefox.

  I am able to see the main image and the images over the primary image line; but the javascript code which changes at each successive image does not work.

  I can't run any JCarousel with FireFox. National Geographic is just one example of the most recent which does not work.

  You have quite a few extensions you installed that can cause problems like that (Adblock Plus, Ghostery).

  Start Firefox in Firefox to solve the issues in Safe Mode to check if one of your modules is causing your problem (switch to the DEFAULT theme: Tools > Modules > themes).

  • Makes no changes on the start safe mode window.

  See the extensions, themes and problems of hardware acceleration to resolve common troubleshooting Firefox problems and troubleshooting questions with plugins like Flash or Java to solve common Firefox problems

  • If you have many extensions then you first activate half test extensions that half the problem.

  Continue to divide the bad half that still has the question until you find that one is causing it.

• I can see the other person, but they cannot see me

  I have windows 7 on laptop and am using skype7.25

  I see the person, but they cannot see me

  Its only recently its been the case, can you help me?

  Garry

  Thank you, when I'm skyping it says don't send not video, I will use the link now

• I can not eject a dvd from my drive iPhoto super-cannot see the drive open up Adobe Photo Elements and organizer and then apps get hung up "not responding" and cannot do anything - I've fixed dozens of times w msg success drive.  Help

  I can not eject a dvd from my drive iPhoto super-cannot see the drive open up Adobe Photo Elements and organizer and then apps get hung up "not responding" and cannot do anything - I've fixed dozens of times w msg success drive.  Help, please.  Thank you!

  Hello golden2,.

  I understand that you have a DVD picture in your SuperDrive drive, but it is not mount on the desktop and will not eject.

  Please, try the procedure described in this article using the disc is ejected.

  Get help with the SuperDrive slot on your Mac - Apple Support loading

  Do not eject discs or discs eject slowly

  1. If the drive ejects discs slowly or appears to have difficulty, insert and eject a disc several times. Check the disc to see if it has a label or other material stuck to the disc which increases the thickness. Remove the label if possible.
  2. If the disc does not eject, try pressing the eject on the keyboard button. Some older keyboards may use the F12 key to eject the disc.
  3. If the disc does not eject, try dragging the icon of the disk to the trash.
  4. If the disc will still not eject, try to hold down the mouse or trackpad button after you restart the computer. The Superdrive should attempt to eject the disc.
  5. If the disc still does not eject, reset the System Management Controller (SMC) and repeat steps 1 to 4.
  6. If the disc still does not eject, Contact Apple or an provider of services authorized Apple, or make an appointment with a Store Apple Store for further assistance.

  Take care.

• Satellite Pro L40 with realtek card: cannot see wlan Vista networks

  Hey

  You just bought the L40 (Realtek card) and it cannot see wireless networks. The diagnosis of Vista, is that the wireless adapter must be turned on. Then, it will fail to start. Function key and F8 (wireless on/off switch) does nothing.

  The wireless router is well - connected to an XP machine. I can connect to the router without a problem by using an ethernet cable.

  Running on the latest Microsoft drivers.

  Pointers much appreciated.

  Thank you
  Frank

  Hello

  you turned on the wireless the case switch on "ON"? Maybe you forgot this one, and this is perhaps the reason why it won´t work.

  Please check and make sure that you then use the FN + F8 switch.

  Would appreciate your comments on this...

  Welcome them

• WMC cannot see my Homerun Tuner now and it worked before

  Map double Tuner TV SiliconDust HomeRun

  WMC cannot see my Homerun Tuner now and it worked for a long time without problem before and WMC don't download the guide. He wants that I open the paper Guide of WMC and read it. But I can not find it?

  Hi Tommy,.

  quick question for you: what you use an antivirus/security program?
  Most of the time I have seen questions like these, it was because of an update an AV/security application, which changed its firewall settings.  Result: HUBERT pilots cannot communicate with the tuner; Media Center is no longer allowed outbound connections (eventually kill communication with the tuner, permanently killing the abilty to retrieve updates to the Guide.)

• XP service Pack 3 cannot see express airport

  XP service pack 3 cannot see the apple Airport express. No problem with the windows machine 7.  All thoughts

  Do you have airport utility installed?

• MShome suddenly cannot see my computer or other people on the network since downloading the last XP updates

  This morning my XP machine could see my Windows7, another XP machine and my own machine on the network.
  Mine and the other XP are on MSHOME

  After that improvement with the last XP fixed, it cannot see any other machine on the network, including himself.

  Tried the wizard network on my machine
  Apply the seven 2011 Msoft fixit.

  Restored the machine backwards from 5 days.

  Still no luck

  Any ideas?

  I have reset the router and everything is now OK :(