Grafic of NVS 295 card work in a Compaq dc5700 SFF

Similar Questions

• Tecra M5 NVS graphics card adapter

  Hello

  My question is simple: can I change my Tecra (NVS 110) with an another NVS graphics card?
  If "Yes" how?

  Any help will be apreciated.

  M

  No, you can not replace or upgrade of the chip of the graphics card.
  This is not possible because the graphics card chips are not extensible parts.

  You should check the FAQ here box in the forum.
  I found here a nice article that explains it.

  The technology of the laptop is simply different and in most cases only the common areas like RAM or HARD drive can be improved.

  Cheers mate

• a vision tek hd 5450 graphics card work in my PC p6213w?

  I wonder if the vision tek hd 5450 graphics card work in my Pavilion p6213w. I wonder if I should find a different graphics card instead. I know I have to buy another power supply, I just want Advisor be cause I play several

  Online games and doing the research for the documents from the school.  I also use my PC to watch movies and television series like weather reports edge chipset does not allow some of the games and videos to be played correctly anylonger as they changed their policy.

  any suggestions for this help is taken into concideration. Thank you very much

  Hi Noel,

  Vision Tek HD 5450 video card will not work in your desktop PC without an upgrade of the power supply.

  Your PC came with a 250 Watt POWER supply and which does not respect the minimum of 350 watts required for the video card Vision Tek HD 5450. Here is a link to the plug of your PC. If you upgrade the PSU, the card will work in your PC.

  I recommend that you buy a PSU that has at least the ATX12V v2.2 / EPS12V v2 specification. Here is a link to a document on the Newegg.com web that shows some power supplies that work. Stick with major brand names such as OCZ, Corsair. The second level and no name power supply could disappoint you even if they are less expensive (which assimilates sometimes so lower quality).

  Best regards

  ERICO

• What is the problem with my iphone? He says still no service but my sim card works with other phones, after a reboot it says searching until I have to remove and reinsert the sim ive done all what is the factory reset to open the phone to verify any damag

  IPhone 6 64 gb

  iOS 9.2.1

  The phone says no service but the SIM card works, everything in the phone works except the flash still lights up and flickers sometimes before becoming stable but who don't mind not 'that' much, ive tried factory reset and everything, ive also open the unit and looked for signs of damage, the phone knows there is a SIM card in the phone , but he never says the name of the carrier, also after the restart he said looking and does not stop until I have remove and reinsert the SIM card.

  You can restore the factory state after an iTunes backup

  If this does not resolve the problem then you may want to align on Apple or an approved repair shop

• Portege R100: 4GB SD card works very slowly-> unable to format

  Laptop works fine, no problem when using 1 GB SD card. What SD 4 GB inserted PC card works very slowly. Finally, I am able to run the software Toshiba Format SD memory card (download the latest version). It does not seem to recognize the card of 4 GB. Unable to format. When later tried with 1 GB card, everything works fine.

  If someone was able to get a 4 GB SD card?

  I'm not sure if the laptop software needs a patch, or if the 4 GB card is not fully compatible with SD cards standards, however it was purchased from reputable suppliers.

  Graham

  Hello

  I think that it s nothing wrong with the software, but the SD card is simply not compatible 100%.
  In recent times, the SD card sizes are rising rapidly.
  I think that the card reader and the software were not intended to manage this big SD card like this.

  How to buy an external SD card reader?
  These devices are not very expensive and I think the new generation should be able to also handle 4 GB SD cards.

• What WIFI card work in Satellite 110CT?

  Hello

  I have a laptop 110CT (110CT/810 PA1224 YX - EN) Satellite that I am trying to get a wireless LAN card to work with it to connect to my BT home hub. I tried a modern bus adapter wireless card (GWK150 802.11 g) but she comes back as the laptop would not; no light showing power on the card either (I run Win98 SE). I know that the two locations to bus my card work as my TDK DF2814 modem card will work in the other slot.

  This bus card specifications interface is compatible with modern (32-bit card bus type II) wireless LAN cards or changed the standard?

  Perhaps I was unlucky and managed to buy a faulty card? Any information on what WLAN cards or LAN or interface card types are compatible with the CT 110 would be very welcome.

  Thank you, Robert.

  Hi Robert

  It is not easy to get info on this portable 10 years old. The fact is that this device has a PCMCIA slot and you can use 2 x cards of Type II or 1 Type III of x. card I can only imagine that you must put something in the BIOS settings.

  Check all the settings of the BIOS and see if you need to change some settings. I also think that you should try to use a little older wireless cards. Maybe you wait a little too long.

• None of my graphics cards work, not even in safe legacy!

  As the title suggests, none of my graphics cards work for my pavilion p7 - 1597c. The only way I can see my screen is when I have no graphics card in probably due to the fact of secure boot. It does not work even with this option disabled. So, I must also have a slot pciex16 security disabled to make it work, but now I can not detect any of my maps I have. I have disabled the start safe and active start inherited countless times with a bunch of different options without success. Having to remove my countless of times graphics cards is very annoying so I can reset the settings and try the different settings. Maybe theres something wrong with the bios? But I don't know, I'm just really mad that I can't play my games in my library of steam because of this.

  Here is the article I've tried: http://support.hp.com/us-en/document/c03653226

  Used graphics cards:

  MSI AMD RADEON 7730 1GD5

  AMD SAPHIRE 7770 1GD5

  NVIDIA GTX 660 1GD3

  Well I fixed, so for all models of p7 - 1597c, you must have the legacy mode and you must also have enabled pciex16 to secure, but it also disables the use of your other two dvi ports. This case is now closed.

• NETGEAR WG511T PC Card works fine on Satellite Pro A10

  A Netgear WG511T 108 Mbps Wireless PC Card works perfectly on this laptop?
  Thank you

  I n t have this card but theoretically it should work. Please read carefully the instructions to facilities and install it correctly. If you don t have the maximum speed of WLAN is not because of the laptop.

  Please inform us of the results. It will be very interesting to read your report how it works.

  Good luck!

• MiniPCI Wifi card work with Satellite A200-1V0?

  Wifi miniPCI card works with Satellite A200-1V0?
  Specifically the Intel Pro/Wireless 3945 ABG Mini PC will work with this laptop?

  See you soon,.

  Prashant

  Hello

  To my knowledge the laptop supports dual-band built-in antenna and it was a 802.11(b/g) 13ch-minPCI WLan RTL8187B Realtek card.

  The replacement of WLan should be possible, but it s very delicate because whole books must be disassembled to gain access to the WLan module

  This can be done by a technician of the ASP.

  But why you want to replace the WLan?

• Satellite A30: his missing - pilots & sound card works fine

  I have a toshiba a30 and all in the distance suddenly my sound disappeared, pilots are intact and he says my sound card works fine, start melody can be hear very low if the room is in total silence and you hold up to your ear for it.

  Recently, I have restored my computer hoping that would solve the problem but unfortunately not...
  can someone help me please?

  Remove the sound card in Device Manager. After doing this material use of the control panel option. Let the system to detect and install the sound card again. All of this will happen without restarting.

  When the sound card is installed in new test it please with windows media player. Please post the results.

• Satellite L40 - 14F - can't make my sound card works with XP

  I can't make my sound card works. I tried to install all versions of drivers, but not sound.
  Then I tried installing high-definition sound updated for windows XPSP2 and still nothing.

  Ultimately, when I installed the drivers for another computer, I could see a sound card in Device Manager, but I got! the driver and it says "the device cannot start. I installed a new original drivers and once more, nothing has changed.

  Is there a possible way to solve this problem?
  PS. using Toshiba L40-14 f :-) and Windows XP pro with service pack 2.

  Hello

  Satellite L40 - 14F belongs to the series of PSL4CE.
  XP drivers for this series don t exist on the Toshiba page at the moment!

  I have found that the package of XP driver for PSL48, PSL49, PSL4C and PSL4B model number!

  So, it seems that you simply try to install incompatible drivers!

  If I m not wrong not the device uses the Codec Realtek ALC660 chip and chip high definition audio Intel HDA (Azalia)!

  Check the driver from the Intel page and upgrade the XP to the last State at the beginning

• P7-1036: what cards work with desktop Pavilion P7-1036

  Hi all

  I have a desktop computer Pavilion P7-1036 with integrated video, Intel i3, 3.1 ghz and 8 GB of ram. already updated the PSU to power internal 500 Watt power supply (ATX-ILG-500R2) run Windows 10 as well.

  I want to upgrade to a video card with HDMI and make a few plays of light. I tried two cards without success, each installation ok but monitor freezes on the splash screen or stays black. After that I removed the card everything works well again. I guess I'm missing something in the configuration or possibly need to know what video cards will work with this motherboard.

  Any help would be great appracieted

  I've tried so far without success of cards

  NVIDIA GE force GT 720 - 2GB

  MSI R5450-1 GB

  Thank you

  Hello

  Dell's OEM specifications may be different compared to the specifications of HP.

  The reality is that there is no guarantee that any particular graphics card will work in any particular PC, even if the graphics card works in other PC or even the same or similar model PCs. Know what the return policy is before you buy.

  Thanks for posting on the forum.

• SlotMusic cards work with Clip Zip?

  I know the Clip Zip has a microSD slot, but I don't see Compatibility SlotMusic mentioned in the specifications.

  SlotRadio and SlotMusic cards work fine in the Zip.

• What video capture cards work with Media Center?

  I use Windows 7 Media Center and I content HD through DirecTV, my system has STB (2) with outputs HDMI (outputs of the component also), I want to know who (2) video capture cards work with Media Center as would make a key pair?

  It seems that MCE works with the capture card (1), but not two...

  Help, please...

  Saturday, December 20, 2014 08:46:27 + 0000, RonaldPeterson wrote:
   
  > I use Windows 7 Media Center and I content HD through DirecTV, my system has STB (2) with outputs HDMI (outputs of the component also), I want to know who (2) video capture cards work with Media Center as would make a key pair?
  >>
  >>
  >>
  > It seems that MCE works with the capture card (1), but not two...
   
  Try posting this question at the http://thegreenbutton.tv - Media Center has been
  designed to work with the tuners for television recording, but the people he could have
  a few ideas.
   
   
   
  __________________________________________________________________________________________________
  Barb
  MVP Windows Entertainment and connected home
  My Blog - http://digitalmediaphile.com/
   
  Please mark as answer if that answers your question
   
   
   

• I use LR 6.5 on an iMAC. Files RAF Fuji originally, I imported from an SD card worked and exported in the form of PSD and then after saving the files on an external hard drive RAF erased from Lightroom. I now want to import some RAF b HD files

  I use LR 6.5 on an iMAC. Files RAF Fuji originally, I imported from an SD card worked and exported in the form of PSD and then after saving the files on an external hard drive RAF erased from Lightroom. I now have to import some RAF of the HD files but LR shows them as dazed out and said that they have already been imported when I hover over the thumbnail. I have this problem when importing files in the same HD Canon CR2, and who have been treated exactly the same. Anyone got a clue as to why this is happening? Thanks, Phil

  Hi Phil,

  If Lightroom then reads these as duplicate files, it shows that they are already present in your Lightroom Catalog.

  You can search by file name and check if the image is present in your library.

  Kind regards

  Claes