Hi guys, im facing the same problem, if my computer if it remains unused, it fails and I get the error: State failure driver.
I'm using windows 7 64-bit proferssional, pls help.
Hi Rayan,
Thanks for posting your question in the Microsoft Community.
Blue screen errors can occur if a problem causes Windows 7 to stop or restart unexpectedly. You might see a message that says: "Windows was arrested to avoid damaging your computer."
These errors can be caused by hardware and software issues, and it can be difficult to solve the problem. The following methods and tools can often help get Windows running again.
. Did you recent hardware or software changes to your computer before the show?
I suggest you remove all external devices except the keyboard and mouse and check if it helps.
I also suggest you follow the steps mentioned in the link which can help you in the matter of fixing:
Resolve stop (blue screen) error in Windows 7:
http://Windows.Microsoft.com/en-GB/Windows7/resolving-stop-blue-screen-errors-in-Windows-7
Note: When you restore the system to a previous state, programs and updates installed later will be deleted.
Important: Running chkdsk on the drive if bad sectors are found on the disk hard when chkdsk attempts to repair this area if all available on which data can be lost.
Warning: Before performing a reinstallation of Windows 7, should be prepared for the worst scenarios that led to your existing data on your computer being deleted. These data include data personal, settings, information about the hardware and software drivers. In case of a worst case scenario, you may have to reinstall all the programs. Make sure that you back up personal data to disks or other external storage devices before you reinstall the operating system.
You can also download the last dump file so that we are able to help you. C:\windows\Minidump
You can use Windows Explorer and copy the dump files to your desktop or your personal documents folder. Then download them to your Sky Drive folder.
If you are not able to find the dump file, and then check if it has been activated. To so proceed as follows:
a. click Start, point to settingsand then click on Panel.
b. double-click on System.
c. click on the Advanced tab and then click settings under start-up and recovery.
d. in the Write debugging information list, click on image partial memory (64 KB).
Send a copy of your dump file in a shared file on your disc of sky with a link here.
http://social.technet.Microsoft.com/forums/en-us/w7itproui/thread/4fc10639-02dB-4665-993a-08d865088d65
http://support.Microsoft.com/kb/254649
If you need further assistance on this topic, let know us and we will be happy to help you.
Tags: Windows
Similar Questions
-
When the update fails and I get an error message 80070663 how to proceed?
I have windows vista home premium and when I try to download my security updates fails and I get the 80070663 error message and it does not allow me to get my updates. all of the suggestions. Thank you
This error means that one or more of the registry entries that are listed in the following table are missing from the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Nls\CodePage registry subkey. For more information about this error code and how to fix this, please visit this link below.
-
It opens fine in safe mode, I took it back to 10/01/2011 as suggested, and the problem persists.
On a Dell computer, it indicates a problem with the hard drive.
The reader will probably have to be replaced.
-
Trying to send a scanned document and I get an error of missing file: api-ms-win-crt-string-11-1.0.dll never had a problem before and I've recently updated to the office of 2016 and that's when I got this message. Anyone know if it's related to Adobe or Outlook? I am able to send emails on Outlook.
Thank you
Hi lorid74531323,
Latest version of MS office will not work with your Acrobat 9.
May be a compatibility issue, please check the web browsers and applications of PDFMaker
Kind regards
Nicos -
I am trying to install an update to iCloud on my Win 7 PC and I get an error message that there is a problem with my windows install. How can I solve this problem?
Hello grandpa_bill,
Thank you for your participation in the communities of Support from Apple.
If you get an error when you install an update to iCloud for Windows, try to download the latest version of download iCloud for Windows.
For more information, see get help using iCloud for Windows.
All the best.
-
I try to install the update of security for Microsoft Office System 2007 (KB972581), but if failed and I get the error code Code 57A
I have install the 2007 Microsoft Office Suite Service Pack 2I bet that if you check the size of the file that has been downloaded it will be probably very small, indicating that it was not downloaded correctly.
I don't think you have another computer at hand, or a friend with a USB key which may be able to download and copy it for you? Maybe burn it to a CD or something.
I could download it and save it to my desktop so I am confident that it is not a problem with the link itself or the file is available for download with success.
I know this isn't a very good suggestion, but the only other option would be to challenge support and see if a technician can take control of your machine and see if they can solve the problem of internet explore.
If you find my answer was what you're looking for, remember to click on the box "mark as answer" below!
-
I'm trying to upgrade to service pack 3 for xp and I get an error message and it will not complete the installation. What should I do?
Hi BartlettNYC,
Please see the links below, to solve the problems with Window XP SP3.
Steps to take before you install Windows XP SP3.
http://support.Microsoft.com/kb/950717
How to troubleshoot a windows XP SP3 Installation failure.
http://support.Microsoft.com/kb/950718
Good luck.
-
My outlook express no longer works and I get this error: the connection to the server has failed. Account: 'pop-server', server: 'pop-server', Protocol: POP3, Port: 110, secure (SSL): no, Socket error: 10061, error number: 0x800CCC0E. Can someone tell what to do?
Make sure that you can access your e-mail via webmail, if you have this option to ensure that it is not a problem on the server. Then locate the antivirus interference and ensure that the analysis of the electronic mail is disabled (see www.oehelp.com/OETips.aspx#3). Try to remove your e-mail account and then close OE and then add it back again and then see if it works.
Steve
-
I try to go to the website of tomtom and I get an error message DNS-cannot find server.
I try to go to the website of tomtom and I get an error message DNS-cannot find server. I tried the computer desktop and laptop and do not know what the problem is. I thought it was the Web site, but I could put my internet work top. Help, please.
How your internet connection are connected, if you use Proxy, then try to uncheck bypass for local addresses...
If you use a direct connection without proxy, even try to open in another browser, firefox IE, if its opening try to update the browser to your desktop computer.
Thank you & best regards
Alex k
-
Original title: .net framework 4.6
I try to install the software and I get an error message saying
Setup cannot continue because a previous installation requires your computer must be restarted. Restart your computer and run the Setup again.
so I restart my pc and run it again and the same message appears
Try to perform a "clean boot" to start Windows by using a minimal set of drivers and startup programs. This will eliminate software conflicts that occur when you start Windows, install a program or an update or when you run a program in Windows.
http://support.Microsoft.com/kb/929135Perform a clean boot to determine if background programs are interfering with your game or other programs
http://support.Microsoft.com/kb/331796One by one add back an application both in the boot list to find the software application incriminated.
J W Stuart: http://www.pagestart.com
-
original title: pc maintenance
Make a right click on the folder responds slowly and sometimes get an error "windows does not.
Make a right click on the folder responds slowly and sometimes get an error "windows does not.
This could be due to so many things. Malware, applications in resources, solutions anti-virus, hard drives damaged, damaged file system, processor ram capacity limitation...
can't tell what your problem exactly, you can use the reliability monitor, event viewer to discover additional problems...
What does it mean when a program is not responding? http://Windows.Microsoft.com/en-us/Windows-Vista/what-does-it-mean-when-a-program-is-not-responding
-
I use a mac and would like to buy the package of Lightroom. I had the trial and it was fine. I was enrolled in the Belize and I get an error message saying that the country is not supported. In the United Kingdom, I changed my region and I still get the same error message?
Hello
Try to subscribe through pricing and membership creative cloud plans | Adobe Creative Cloud
Hope that helps!
Kind regards
Sheena
-
How to recharge my hard drive with photos that are stored in iCloud? After installing a new hard drive, there's no pictures found in the Photos, and I get this error, "could not find the picture of system library named"Library.photoslibrary Photos".
Soon as your App Photos or iPhoto lost track of your photo library, or there has not been migrated from your old drive. You can create an empty library and probably enable iCloud photo library for photos to upload to the cloud.
-
I try to print from quicken and I get an error message that says that I have to be in the mode of administration and run restore pdfdriver.bat. I don't know what is a mode of administration, nor I know what is a pdfdriver.bat. Can anyone help?
Hello
1. what operating system do you use?
2. what web browser do you use?
3. have you made changes on your computer?
4. What is the brand and model of the printer?
5. are you able to print from other applications?
When a printer is installed, members of the Administrators group on the computer are given permission to manage the printer by default. If you have an administrator account, you can probably change the printer properties. Otherwise, you must obtain permission to manage the printer before you can change the properties of the printer.
Method 1:
If you are using, I suggest you send the link to learn how to open a session as an administrator.
How can I connect as an administrator?
http://Windows.Microsoft.com/en-us/Windows7/how-do-I-log-on-as-an-administrator
Method 2:
I also suggest you to see link and check.
Error when printing to a PDF file: PDF driver is not found
Cannot print from Quicken
http://Quicken.Intuit.com/support/help/not-able-to-print-from-Quicken/GEN82237.html
-
could not access vb run time for custom action script
I try to install an air 320u sierra wireless card and I get an error message "could not access vb run time for custom action script. Cannot install the Manager of mobile broadband services. Any ideas?Hello
I suggest you run the fixit and see if it helps:
http://support.Microsoft.com/mats/Program_Install_and_Uninstall
Also check out this link:
It will be useful.
Maybe you are looking for
-
Cannot copy AVSEQ01: the parameter is incorrect
It is a copy of a publication in the field of technology, I did. If this isn't the appropriate forum, let me know where to post. Thank you. I'm having a problem. I am trying to copy a. DAT file to a VCD on my hard drive. This particular file is betwe
-
Windows xp home edition ULCPC Greek
I have a netbook Multirama S.A. (rename of MSI) and I need to format it. It has windows xp home edition Greek ULPCC and I can't find the software to download. Of course, I bought the product key with my netbook. I wonder if I could install with the s
-
Hello I'm not able to generate the cod file after making a few changes to the code. I didn't add a new class or method for the code. I just had a 2 lines of code and generated my cod, but due to a problem file, I get null pointer error. I tried almos
-
NFC: Exception NDEFTagConnection.read (invalid)
Hello BlackBerry Bold 9930 OS 7.0.0 Bundle 1739 I work with NFC and were able to read/write/erase NDEF tags NFC Type 2 and Type 4 Messages. However I can't get it to work if the NDEFTagConnection.read () is done from the main/event thread. For exampl
-
Windows 8 delay of registration line
When I try to record on my computer Windows 8, I use a mixer go to the Line In input, but when I followed the Live recording in headphones, there is a delay in what I hear, of what I sing. I had this problem in Windows 7, but it was resolved by turni