HP Designjet T3500ps: vertical bars

Similar Questions

• iMac screen distorted with vertical bars

  The display is distorted with vertical bars, then turns to a white, blank screen, so it can not be started.

  Tried Safe Mode; Disk utility (first aid) and reset the NVRAM all to nothing does not.

  Any other suggestions would be appreciated.  Thank you.

  The same display abnormalities occur after the Safe Mode boot?

  You can run The Apple Hardware Test / Diagnosis of Apple , but each of its possible results will lead to the same result:

  • identify a defective hardware that only Apple will be able to fix,
  • "no problem found" despite the fact that something is obviously wrong.
  • or an inability to run diagnostic tests due to the problem that you are experiencing.

  In any case, you've done everything you can do, and you will need to have your Mac evaluated by Apple for repair: Contact - official Apple Support.

• Home page and a few other Web pages have a vertical bar of 2 inches on each side of the page. How to permanently set set the pages to fill my screen?

  I have a HP - i5 with Win 7 and only use Firefox 35.0.5. Recently, I met some problems with my home page loading with blue text on the left side of my 2-inch screen and put it in the shop. Some viruses are removed and 35.0 FF was installed.

  Now my home page and pages loading with a 2 "empty bookmark bar vertically to each side of the page.

  Can I use zoom in on the view or the - + zoom and zoom to 100% to 133% increase, but this change is never permanent.

  Try to fix the problem I uninstalled FF 35.0 and installed FF 35.0.5 directly on the FF site. I also uninstalled AVG virus protection program. None of this has helped.

  How can I get rid of these vertical bars of 2 inches of empty space at all TIMES?

  I have a HP laptop with a processor AMD, Win 7 and Firefox 35.0.5 and he has never had this problem.

  Firefox should remember your level of zoom on a site-by-site basis. It is not "global browser" as in IE.

  Note: If you zap the history, make sure not to clear the Site preferences.

  If you need to adjust each site by about the same amount, you can use an add-on to set a higher level of the base line of the zoom. For example: Default FullZoom Level.

  Unfortunately, there is no unique zoom level that will work perfectly for all Web sites due to the preferences of individual positioning of their webmasters. But I hope you can find a good middle ground so you need not all zoom each time.

• When you type text in the forms, the vertical bar gets multiplied everywhere.

  Often, when I am typing text into a form on different sites, whether it be Facebook or the same site, the vertical bar that follows the text input gets randomized on the line and appears more than once. The glitch disappears about half a second after I stop typing (as soon as the pipe character begins to Flash), but he always drives me crazy when I type something on a regular basis. You can find a screenshot of the action of a form of Facebook here: http://imgur.com/mNr9Y

  Start Firefox in Firefox to solve the issues in Safe Mode to check if one of the extensions of the origin of the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > appearance/themes).

  • Makes no changes on the start safe mode window.
  • https://support.Mozilla.com/kb/safe+mode

  Safe mode disables extensions in Firefox 4, and disables hardware acceleration.

  • Tools > Options > advanced > General > Browsing: "use hardware acceleration when available.

  If disable hardware acceleration works then check if there is an update available for your graphics display driver.

• Printer HP 4 Plus: vertical bar on impressions, HP 4 Plus

  I'm getting a vertical bar on the documents printed on my printer. The bar is about 3/4 of the way around (from left to right) on a layout page "portrait." I took a picture of a printer test page, but I see no way to attach a photo. I took a cloth with light isopropyl alcohol and rub the transfer roller. The printer then produced a couple of good impressions. I thought I had solved the problem. Wrong, he's back. (I had already replaced the fusion Assembly through the troubleshooting guide in my user manual. Who did nothing). I have a new transfer roller, but I'm afraid that after I installed, the problem could simply continue. Is there a roll somewhere between the tray and the transfer roller that could break, getting Gummy and tranfering the residue to the transfer roller? Description: A vertical task bar approximately 3/4 "wide, oblong oval-shaped horizontal bars (spaced about 1 7/8" apart). Thanks in advance

  You have a bad toner cartridge. You can probably still find this fairly cheap laser scanner, if it still fails, and they are easy to replace.

  Again, I have a LaserJet 5 in my collection, so you said something that I know that there is at least one, but can't tell you if I have more. I also have a few things and parts.

• Vertical bars, thin, white full screen of WMP11

  With the help of Dell Dimension 4700, 3 GB RAM, EVGA GeForce 8400 GS with 512 MB, Windows XP SP3, SoundSpectrum G-Force 3.9.4.

  When I open WMP11, then select show improvements, then close show improvements, then go to the mode full screen... There's a mess of thin, white vertical bars.  This is equivalent to any visualization I select, or if no view is selected.

  No matter what I do - short of closing and reopening of WMP - him reappear the white vertical bars in mode full-screen.

  Is this a known problem with WMP11?  No matter what known fix?  I searched 'vertical bars' in music and its Forum and found nothing.  Thank you very much!

  I had the same problem, and before that I played with it too much I did research. These messages have helped me do a bit of that research. I also think that it may be useful to mention that I have a Radeon 5700 series, I use my TV 32 inches as my screen via the HDMI connection available on the vid card. Levels at 1600 x 900 is enabled. I am a COMPUTER professional and nothing of what I read seemed logical as to the root causes of this issue. I use this workstation for all and everything under the Sun, audio recording and mixing, capture video and administration of editing systems, encoding, gaming, etc. Basically, I make the most of my very competent and versatile Windows operating system. Sometimes, the simplest thing is the answer. In my case, it seemed that this was the case. I can't say I've done work for everyone, but it worked for me. That said, here's what I did to fix the problem. (I did all that, although not in full screen, still playing album The Roots Things Fall Apart I was listening too when I arrived in this issue)

  1. I disabled the visualization.
  2. I have a right-click on the screen and selected More Options...
  3. Click the Plug-ins tab. You should see the list of categories on the left and the right corresponding sub categories list.
  4. My category of visualization has been selected by default. On the right will be the list of visualizations that you have installed. (I have only the defaultAlchemy,Bars and wavesandbattery installed) When you have a view selected, you should see a section in this same window just below the list of categories.
  5. It should be a Properties button available when a specific view is selected.
  6. I tried to use properties for all the visualizations except battery and I got a message that says that this plug-in does has no properties that you can set.
  7. When I went into the properties of the battery there are 2 settings I could adjust. Screen size under full screen settings and the off-screen buffer size under Player settings.
  8. Only, I've adjusted setting the screen size to match my resolution (1600 x 900). I did adjust the other settings.
  9. I clicked OK to close this window. I clicked on apply and thenOK in the window main options.
  10. I activated the visualization of my preference. (Battery is being my favorite)
  11. I went full-screen, and the white bars. Visualization worked perfectly.
  12. I tried the other visualizations and got the same result with each of them.

  Hope that this clear and the most important is useful.

  http://www.Speedtest.net/result/888894683.PNG

  http://www.Pingtest.net/result/20846112.PNG

• Upgrade of Windows 8 has changed my graphics card driver, & now I get vertical bars on the screen.

  Upgrade of Windows 8 has changed my graphics card driver, & now I get vertical bars on the screen, sometimes flashing. It is sometimes difficult to use the screen, especially when it has a dark background. It is a HP Desktop quad core with card Nvidia GEForce 9600.  I tried to roll back the driver, but that didn't help. I assume that the driver I need is no longer available. I also went to Nvidia to try to find a better driver that would eliminate this problem, but no luck.  Before, this came with an update on Vista, & I could correct in the way to roll back the driver. Any help would be appreciated.

  Go to www.nvidia.com and download the WHQL 306,97 drivers updated successfully.

  With the installation of Windows 8, Microsoft provides only the "bare" minimum drivers in order to complete the installation of Windows.

• My Prem Pro program window image is blocky and green red yellow vertical bars when static - scrubs and exports ok... what's up?

  My Prem Pro program window image is blocky and green red yellow vertical bars when static - scrubs and exports ok... What is happening?

  This thread seemed to solve... (seems to be a question of el capitan). Super frustrating though, as I don't want to turn off automatic switching: Premiere Pro chart question?

  A lot of El Capitan being more respectful of the adobe!

• Everyone sees red vertical bars to the program and/or monitoring of the Source?

  I am the red vertical bars in the Source monitor and program when I load a project. The Red bars disappear when the video is started, and then reappear when the video is stopped. I'm on a MacBook Pro OS X 10.11 (El Capitan) running. I don't see this in any other application running video (like YouTube, QT Player or Vimeo). Anyone else does?

  

  Hi Dean,

  Go to the file/project settings/general and change the rendering on "Mercury Playback Engine software only" engine.

  Press OK, you will get a dialog box in which select "remove previews."

  Try these steps and it should work.

  Kind regards

  Navdeep Pandey

• Red and yellow vertical bars on the images

  In my source monitor and program monitor, I have red and yellow vertical bars on my images whenever it is paused. It plays well back, but as soon as I stop, the bars are displayed. This happens for a film of any resolution and codec. Has anyone seen this before, or know how to fix?

  Thank you.

  

  Screenshot of the problem.

  Premiere Pro CC 2015 running on an end of 2013 15 "MacBook Pro retina, is also running the beta version of El Capitan. Images is 4K (3840 x 2160) of a GoPro Hero 4 Black Edition, converted to Apple ProRes 422.

  Disable the MPE material.

• How t use a vertical bar character in the menu bar?

  I would like to use a character vertical bar between menu items, but not before or after the menu.

  I dragged a Horizontal Menu on the page. In the drop-down menu, I chose "the right icon: on". Now a square appears after each menu item.

  I reduced the width of the square to a pixel and adjusted the fill of the text of the menu item to vertically Center the tube.

  My question is, how do I get rid of the last pipe character, the one after the last item in the menu?

  I tried to uncheck edit together in the drop; but when I delete the last character, all the pipe characters are deleted.

  Is there a better way to accomplish this simple task?

  Hello

  It seems that the visibility of the icon on the right does not respect "Edit Together: stop.

  But hits do, then maybe you can get your design by setting the stoke weight (top: 0, bottom: 0, left: 0, right: 1) on all menu items, then edit together turn off and reset the kick on the last item in the menu to 0?

  Abhishek

• GREP search: vertical bar

  What GrEP expression is a vertical bar (like this: |)?

  I would have thought a simple escape (like this:------|) might do, but no.

  Try

  \x{07C}

• Qosmio G30 PQG32E - green vertical bars

  Hello

  I have a Qosmio as object at startup I see a vertical green bars it is second time I have this problem.
  First time I have send the laptop to repari and support the M/B change... when returned everything ok but after 1 month even problem... now I try to upgrade the bios I have download on site, but when I run progra say did not produce of ti... possible?
  any help

  PS
  another weird thing, it's memory is very hot others a little account of work...

  Hello

  I STRONGLY recommend to send the machine again to the same partner service because you must have at least 3 months warranty on the replaced part. I guess the graphics chip is defective and must be replaced by the replacement of the motherboard together.

  Welcome them

• 2 vertical bars using the master page

  If I use a master page from mouse shows two bars vertical in the browser. How can I solve this?

  This problem only occurs when you use a master page

  

  Hello Edi,

  This normally happens when you add any code iframe in Muse design.

  If you are using any 3rd party code that creates an iframe then you will have to style code iframe.

  However if it is a page by default to Muse without 3rd party widget or iframe code, I will propose you to publish the file and let us know the direct link here so that we can look at the site codes.

  Thank you

  Prabhakar Kumar

• stop the scrolling movement alignment vertical bar

  Hi all

  When a page has more vertical content that can fit in the browser window, a scroll bar appears.

  someone knows a way to stop the scroll bar to move the content?

  That is, if it appears on the right side everything going left

  Thanks in advance

  s

  Embedded CSS is placed between theandtags in your HTML encapsulated inside documents

  Tutorials HTML & CSS - http://w3schools.com/

  Nancy O.

  ALT-Web Design & Publishing

  Web | Graphics | Print | Media specialists

  http://ALT-Web.com/

  http://Twitter.com/ALTWEB