Inspiron 4100 compatibility with SSD

Similar Questions

• How to replace HP Pavilion 14-v044tx with SSD?

  Dear experts,

  I would like to replace HP Pavilion 14-v044tx HDD with SSD, but I can't seem to find SSD compatibility information.

  Here are a few questions and I hope that some of you could give advice:

  1. the list of SSD compatibility?

  2 may I know if it is compatible with Samsung Evo 840 250 Go?

  3. is there a guide on how to open the laptop?

  4. it will affect my warranty?

  Thanks and receive a response.

  Rgds,

  Sam

  Here is the Manual:

  Manual

  Replacement hard drive is on Page 51. The good news is Yes, you can install the Samsung 840 Evo. It is the one I would recommend actually. There is no list because fundamentally, the laptop is compatible with any 2.5 inches wide 7 or 9.5 mm thick SSD or HDD.

  The bad news is to replace the average hard drive almost complete disassembly of the laptop. Access to the bottom door exposes that RAM, no hard drive. And Yes, if you're wrong in the process that HP will stand behind the warranty.

  These short videos will also contribute to:

  http://support.HP.com/us-en/document/c04331584

  If it's 'the Answer' please click on 'Accept as Solution' to help others find it.

• (Redirected) Cannot boot from the HARD drive on dell n5010 with SSD and HARD drive installed

  I have my old dell n5010 (15R Inspiron) with SSD (Samsung EVO 840 120 G) installed on the main drive Bay and the HDD (Samsung HJJ 500 G) on the optical drive Bay.

  It is a typical way to add an SSD on such an old laptop (bought from dell.com.cn in 2011).

  My Windows 10 operating system has been installed on the SSD using Samsung Data Migration software, so the previous C drive was pointless. So I formatted and installed an operating system Ubuntu 14.04 on it, hoping the grub OSs double beginning located on the HARD disk.

  However, I find no the Dell bios boot option to boot from the HARD drive installed in my optical drive Bay. All the choices are 'Hard Drive', 'Network' and 'Diagnostic '.

  But I was definitely sure that my bios program has detected the SSD and HDD with information on the main menu of the bios.

  And the LED on the optical drive Bay was immediately once I pressed the Start button on my laptop.

  As a general rule, all things were right except for options of the bios boot.

  Is there a way I can boot from HDD (with installed Ubuntu) while remaining has my SSD on the main drive Bay? I don't want to swap their positions, because the SSD is super fast on the main drive Bay.

  I have alse won't migrate 10 Windows to the HARD drive and reinstall Ubuntu on the SSD, because I'd like my windows be loaded quickly.

  Someone at - it the same problem with me?

  Any suggestion is appreciated!

  As you have a laptop, better make this laptop in the computer Forum post here:

  http://en.community.Dell.com/support-forums/laptop/default.aspx

  Bev.

• Discoloration spots on the monitor of Inspiron 4100

  I just took an Inspiron 4100 with 128 MB of RAM, 16 MB video card ATI.  He appears to have been very little used.  I wanted to strip down to the minimum because there very little RAM right now so I tried to reformat and reinstall Windows XP Pro.  It came with the original OEM and COA disc.  The disc has never been opened.  I also updated the BIOS to A13.

  At some point, something must have gone wrong, and I can't understand how to fix.  When the "Welcome" screen is in place there is a large pink ring on blue background.  When I log on the screen background (desktop Windows XP background with clouds and the green hill) has some pink spots scattered across the clouds.  The best I can describe it is it is it looks like the video is not done its display and the rose appears where another color should be.

  He did not have this problem until I started with the new facility.  In fact, all started during one of the updates later I was doing and began to show all the time I was doing a few optional upgrades, KB925876 Remote Desktop Connection Terminal Services Client 6.0 and KB920342 update for Windows XP.  I don't think that he had nothing to do with updates, but it's strange how it happened for them.  I tried to reformat and reinstall, but the problem continues.

  Thanks for any help.

  
  

• El Capitan compatibility with Office 2016

  Are you convinced that install OS 10.11.1 El Capitan can solve the problems of compatibility with Office for Mac 2016?

  First of all, the only available version of El Capitan is 10.11.4, second, you, what are the problems with compatibility? I'm not aware of anything. Maybe you can offer them upward.

• Whenever I start Firefox (version 10.0 - release version) it checks compatibility with Add-ons as if I just installed firefox.

  I had the problem of the Firefox page successfully updated the opening whenever I started Firefox and have been since fixed one, but whenever I start Firefox (version 10.0) it checks compatibility with modules whenever

  Hi organicdj,

  You should watch the unsaved Preferencessection. It could be a problem with the pref file that does not store the fact that this control has already been run.

  Hope this helps!

• How to recharge the old version of firefox? A new not compatable with roboform.

  Downloaded the new version and discovered not compatable with robo form. tried to use my computers systems restore points but now nothing happens when I try to open firefox.

  What version of Roboform, what version of Firefox?

• Updated by Satellite Pro L450 with SSD

  Any advice on installing a SSD 128 GB in place and place of the hard drive, use this for the operating system (Windows 7) and put the old HDD in the optical drive slot to serve as storage.

  Is this easy to do on this model, and a new facility would be wiser than cloning?

  There is no files on the drive apart from the operating system that must be preserved - all documents etc. are on googledrive, dropbox and onedrive.

  Adjustments will have to be made when you perform a new installation to keep the recovery on D files?

  Earlier, I created a system restore disk - does that include Windows 7, or would I need to download it and get the license number.

  Is it fairly easy to connect and use the USB "System Restore" to re - load Windows?

  Thanks for all the answers

  It s a good idea to replace the HARD drive with SSD drive.
  You will definitely get a boost huge performance.
  I did these updates in the past, and my laptop runs a lot faster.

  But the question is whether the HARD drive would be recognized by BIOS placed in ODD Bay.

  To be honest I n don't know if this will be possible since the laptop does not support the special feature of selection-Bay. In the past, some other laptops Toshiba Tecra and Portege series supported these updates (HARD drive in the Bay of WEIRD) but I'm not very well on laptops Satellite m.

  Of course, you can try these updates, but in the worst cases the HARD drive will not be recognized by the BIOS if you put in the ODD Bay

• Portege R830 - model with SSD or HARD drive?

  Hello!

  I am considering buying a Portege R830. I've yet to decide between the Portégé R830-10R (model with HARD drive) and the Portégé R830 - 10 p (model with a 256 GB SSD). To do this, I would like to know:

  -What is the SSD model assembled in the Portégé R830?
  -It uses a standard SATA connection or an owner like the previous Portégé R700 SSD?
  -Have someone replaced the original HDD to the Portégé R830 by a whole new SATA 3 SSD? Wich one? It works fine?

  Thanks in advance for your help.

  Hi MadVet,

  The SSD of Portege R830 - 10 p is a model of Toshiba 2.5 so it does not work in Portege R830. In addition due to the 2.5 form factor it uses SATA standard interface as normal hard drives.

  In my opinion, you should take the model with SSD. 256 GB is enough for the operating system and applications as well as for some important data. If you need more disk external HARD disk space use. SSDS are very fast and you will see the performance of the SSD HARD drive instead ;)

• Re: Portege R500-11 with SSD: I want to install Win XP

  Sorry if this is a common question, but I haven't had no luck with the research.

  I have a Portege R500-11 pair with SSD and I want their downgrade to XP. (speed issues)

  First question. Is it possible or are there problems?

  Second: I guess I have to install the SSD driver, with nlite or F6 during installation of the victory, but which is the correct driver? Can someone give me the exact link, please?

  Is this? Intel Storage Manager.

  Thanks for your help and sorry again if it is a question of RTFM.
  Good bye

  Chris

  I found it!

  http://APS2.toshiba-tro.de/KB0/TSB85017Z0000R01.htm

• HP Pavilion 14-AL022TU: can I replace HP Pavilion 14-AL022TU HDD with SSD?

  I have two questions:

  I want to buy HP Pavilion 14-AL022TU of HPSHOPPING. IN and need for clarification on the sub questions: -.

  1 can replace HDD with SSD? What is the back panel opening?

  2. is there the free Slots of RAM available? While I can improve in the future?

  3 there DVD player?

  4. What is the exact weight of this laptop?

  Here is the Service Manual:

  Manual

  Plug

  Weight

• HPE-495 desktop - HARD drive is u/s, please help to rebuild with SSDS

  Hi all

  [[2 TB Hitachi SATA 3.0 GB/s] HARD drive GL8E]. The current failed HARD drive is connected to the sata1 and there is a spare on the motherboard sata2. Spare power supplies available [CH 4 & ch 5]. Office was running Windows 7 Home Premium 64-bit.

  I would like to install a 840 EVO Samsung 250 GB SSD SATA 3 with Windows 7 Home Premium 64-bit Service Pack 1 and a second [still undecided 2 TB Western Digital SATA 3] as data drive.

  These discs are backaward compatible with the existing architecture of SATA - y at - it all isuues with this proposal, would I need to make changes to the BIOS, other than this initial boot off dvd player to install the new windows on the ssd drive?

  Thank you very much.

  If you replace the current HARD drive with SSD in SATA1, new in SATA2 HARD drive and let the CD/DVD in SATA3 on your HP Pavilion Elite HPE-495uk desktop, your computer should boot the Windows 7 Home Premium 64 bit DVD into the CD/DVD drive. This assumes that the disks are new with absolutely no data on them. You may need to, press the "ESC" key or the "F # ' suitable for your computer, select the CD/DVD drive as a boot device.

  If you have any other questions, feel free to ask.

  Please click the 'Thumbs Up' white LAURELS to show your appreciation

• Replacement of HHD with SSD in HP Pavilion TouchSmart Sleekbook14-f027cl

  Is it possible for me to replace the HHD with SSD in my HP Pavilion TouchSmart Sleekbook14-f027cl? And if so, how? For example, I'm looking for (a) a guide to open the computer without damaging it (I found one for Sleekbook 15). Also (b) I would like to know if I have to update the BIOS / other computer settings.

  Finally, (c) are there brands of SSD, I should not do?

  Thank you for your help.

  What has been said here applies to you:

  http://h30434.www3.HP.com/T5/hardware-upgrades-replacements/HP-Pavilion-Sleekbook-upgrading-hard-drive-to-an-solid-state/m-p/3190769#M28503

  Your model is very difficult to upgrade. If you want to move forward in any case post back for assistance.

• Satellite Pro L100: USB2 drivers do not have compatibility with Win XP

  SAT Pro L100 - I loaded the USB 2 drivers received using a prolific USB to Serial Comm Port (Sunix - UTS1009B) a single port USB to serial port cable.

  In each instance of loading the drivers message appears "did not the Windows Logo test for compatibility with Win XP. If continue or stop, drivers do not work.

  Seems as if there is a problem loading the USB 2 drivers. need assistance?

  Expensive branded

  That s nothing unusual.
  Many 3rd party drivers have not been tested by Microsoft and the message appears so that the pilot didn't make the Windows logo test for compatibility with Win XP!

  But if you use a driver that was designed for Win XP, you just continue and finish the installation.

  So, don t worry not and follow these steps!

  Best regards

• 10.11.2 OSX compatibility with EpsonScanner V330

  10.11.2 OSX compatibility with EpsonScanner V330

  Check the Canon website to see if they support the unit on OS X 11.11.2. Apple does not have the printer and scanner drivers, these are provided by the manufacturers of the devices.

  If Epson does not support the unit on 10.11.2 so be sure to visit Vuescan and download a trial version and see if it works for you.