Is there a way to create a link in a document that will draw the text in the document and open it in a separate text in the document box?

I am trying the link between the sections of a form in a PDF file and instructions in the same PDF document.  I want, instead of having this jump back to page in the document so that it can pull up the text identified in a contextual text separately on the same page where the form lives.  Is this possible?

Hi gwebster,.

Instead of linking to the instructions page, maybe you can use tooltips or comments so that the instructions are perceptible besides than the text.

Kind regards

Rave

Tags: Acrobat

Similar Questions

Maybe you are looking for

  • Cannot restore iPhone 7 more

    I was trying to upgrade my iPhone 7 + using "Backup restore" and this attempt to restore crashed on me. I restarted the phone and showed immediately connect it to iTunes chart. Then I connected the phone via cable and iTunes gives me a popup that say

  • iPhone 6 s, ios 9.3.1 Unable to sync in itunes and photoss

    There is a problem when I sync my iphone with itunes 6s, the phone load "beep" sound repeat non-stop and not able to sync with itunes and same iphotos... This happen after I have updated to ios 9.3.1... I try to stop my mac, then start it again, it d

  • El Capitan compatible external hard drive?

    I have a Macbook Air with OS Elcapitan 10.11.3. I want a recommendation compatible external hard drive. I heard that some external dives have"problems" with El Capitan.

  • Satellite A660 - screen does not work

    I have a Satellite A660 and when not hooked to an external monitor or TV, the laptop screen is white and you can't use it.The only way I can use the laptop and being able to see the screen is if I connect the laptop to the TV via a HDMI cable and use

  • How can I see Elvis II boardID

    'NOR ELVIS II pinout description' I know everything"BoardID- these eight lines mean the unique ID of each type of card prototyping by short-circuiting the VCC or GROUND."In my own Council, I connect 5 volts for pinout boardID, but I don't know how I