Keyboard yoga 900 arise does not in Tablet Mode

Similar Questions

• Satellite C850D-11 q - keyboard and the Touchpad does not

  The laptop is a little more than a year and worked ok until recently.

  Symptoms were the keyboard and the touchpad does not not on page 8 of windows logon. Pressing power to put the laptop into sleep and pressing still often got their work.

  He progressed to the keyboard and the touchpad works do not randomly points while the use of the laptop.

  Finally cleared the HARD drive and restored windows 8 alone, the laptop still BSOD quite frequently - refuses to install the updates required for 8.1 and the keyboard and mouse often do not work even in BIOS Setup page. I reinstalled the RAM and HARD drive.

  Short of ideas, the keyboard and the touchpad work and so I guess that their connections are correct - but often they just stop.

  Any ideas appreciated?

  Thank you

  Hello

  > Finally cleared the HARD drive and restored windows 8 only
  I hope that you created before Toshiba recovery disks you have formatted the system.
  Did you?

  The recovery disks will allow you to reset the laptop to factory settings; on the same State as at the first day of the purchase.

  > First symptoms were the keyboard and the touchpad does not not on page 8 of windows logon. Pressing power to put the laptop into sleep and pressing still often got their work.
  Well, usually the keyboard problems are not problems system or software as the keyboard driver is part of the system and an additional installation of some drivers is not really essential and necessary.
  That is why in most of the cases the keyboard problems could be the causes of physical problems.

  However, after using the recovery disc and the parameters of the laptop back to factory State, both parties (keyboard and touchpad) should work perfectly.

  > the BSOD laptop still quite frequently - refuses to install the updates required for 8.1
  BSOD doesn't look very good. As mentioned above; parameters of the laptop back to factory settings should solve all the problems in the system. In the case where the BSOD appears even if the power has been turned back to factory State, a hardware problem could be the reason for this.

  I had also some problems with the update 8.1 Win. The system to win 8 could not find the Win 8.1.
  But the reason for this was simply. I had to install all updates to Win 8 and had to update the State system before trying to update to the next level following 8.1 Win

  So, what can I say: I will try to put the laptop initial configuration using the recovery disk.
  Then I would try to get automatic updates (a few reboots were essential too). After that, I would check the functionality of the keyboard and the touchpad. In the case where them parts would not work, I would contact the service to check if the two pieces.

• Microsoft Wireless Desktop Keyboard/Mouse 6000 V2 does not work properly.

  Microsoft Wireless Desktop Keyboard/Mouse 6000 V2 does not work properly.  The mouse does not allow me to use the wheel to scroll down to option and when I look at the drop down list, it does not keep list open.  It opens and closes the list immediately. He continues to return the list to the top of the drop-down list.  I checked the batteries in the keyboard and the mouse (replaced) resync'ed the two keyboard and mouse ports changed the receiver performed in and checked for update on both keyboard and mouse and have restarted my computer several times and it still does not work properly. I bought this Office Microsoft Wireless Keyboard and mouse 6000 V2 there are three 3 months and he can't take back to store because it has a warranty of 30 days of the store.  Help.

  Try it on another machine to ensure that it is not the lack of equipment.

  And make sure you have the latest drivers/software installed for him.

  Restore point:

  http://www.howtogeek.com/HOWTO/Windows-Vista/using-Windows-Vista-system-restore/

  Do Safe Mode system restore, if it is impossible to do in Normal Mode.

  Try typing F8 at startup and in the list of Boot selections, select Mode safe using ARROW top to go there > and then press ENTER.

  Try a restore of the system once, to choose a Restore Point prior to your problem...

  Click Start > programs > Accessories > system tools > system restore > choose another time > next > etc.

  http://www.windowsvistauserguide.com/system_restore.htm

  Read the above for a very good graph shows how backward more than 5 days in the System Restore Points by checking the correct box.

  See you soon.

  Mick Murphy - Microsoft partner

• ease of access on the keyboard of the screen does not work?

  My easy access on the keyboard of the screen does not work. I have easy access to the centre and left click on the keyboard of the screen then nothing. I double click, then nothing. I'm using a head pointer and live the clicker. I can access the touch keyboard, but it doesn't have the function or alt etc. keys. Can I download the easy access on the keyboard of the screen and reinstall?

  Thanks for the reply. He started working now. Very strang. Well.

• Qosmio X 300 - 11W - TouchPad does not work in mode 'sleep'

  TouchPad does not work in mode 'sleep'. I can't wake up my computer using a touchpad. I downloaded and installed a driver for Windows 7 32 bit from a page of the Synaptics driver, but it did not help.

  Can you wake up your Qosmio using the power button / stop?
  You close the lid when the laptop enters the sliding mode?
  After you open the laptop lid should wake up. It work correctly?

• OfficeJet HP 6830: officejet hp 6830 does not respont in mode 'sleep' via an ethernet connection

  HP officejet 6830 does not respont in mode 'sleep' via an ethernet connection.

  This isn't the case via a usb connection.

  What can I do?

  Hey @George5500,

  Welcome to the HP Forums!

  I understand your JO 6830 unresponsive when it is in standby when you are using the Ethernet connection, but it does not occur when connected via USB.

  We will perform a hard reset. To do this, leave the printer and unplug the power cable for 1 minute. While it is unplugged, press and hold the power button on the printer for 10-15 seconds to release built his power, then after the minute, plug the printer in. Also, even if you have used a surge protector/power bar this whole time and you feel this isn't the cause, please plug it in to a wall outlet so that we can eliminate the source of energy as the primary cause.   Questions when it is connected to an uninterruptible power supply/Strip/surge protector power

  * In this document, you will see, QUESTION: questions or problems may occur when a printer HP LaserJet series printer is connected to a UPS (UPS), a power strip or a surge protector that is not limited to the Laserjet printers.

  I can't wait to hear back on your part. If performing a hard reset, or move the printer to a socket solves the problem, please click Accept as Solution button below so that the community can see your problem is solved. If the problem persists, please don't forget to leave me and I'll do everything I can to help.

• MS-DOS 16-bit subsystem. The system does not support the mode full-screen.

  I when even run some dos applications, which allows to work ok under XP mode full-screen, but when you use Vista or Windows 7. I can only rum these applications in a window.
  The error message is

  MS-DOS 16-bit subsystem. The system does not support the mode full-screen.

  Please is anyway I could run in fullscreen... I don't want to use a virtual machine.

  Any advice would be greatly appreciated

  Of Ernest24

  http://www.dosbox.com/

  You might be interested in reading about DosBox.

  See you soon. Mick Murphy - Microsoft partner

• The system does not support the mode full screen for cmd

  Respected Sir/Madam

  I am user of Windows vista HOme basic... .also I have Windows 7 user... I'm basicllly, a student in computer engineering...

  I get an error "The system does not support the mode full screen" for cmd.exe in C++ turboo or JDK.. .then I getproblem by entering n compiled the program...

  my PC configuration is

  :-AMD 6000 + dual core Athlon 64 X processor

  Monitor:-Viewsoni

  RAM :-1Go

  Please give me a solution to problem 4 I wanted to run cmd mode full screen...

  your help will be appreciated by me highlly...

  thanking you

  Philippe

  Vista + do not support a command prompt full screen, as indicated by the message. You can manipulate the available to the command window to specify the width and height to be as big as you want, but this isn't quite the same thing...

• Drop-down page does not work in mode 'Fit a full page in the window.

  Drop-down page does not work in mode 'Fit a full page in the window.

  It's still doesn't work is not in V11.0.10 y at - it a new patch?

  Don't know exactly what you mean. Maybe it's you saw continuous activated, rather than the display of the page.

• your processor does not support long mode. use a 32-bit Vmware Data Recovery distribution

  Hi all

  When I tried to start VM in Vmware Data recovery, her gives me error as

  "your cpu does not support long mode. use a 32-bit distribution"

  I tried searching for the 32-bit version of data recovery, but not able to find out.

  Help, please

  Kind regards

  Selim Desai

  You can add a 64-bit host to a virtualized session of ESXi. The ability of VT is not transmitted to a guest operating system.

• Error starting data recovery - "your CPU does not support long mode.

  Hello

  When I turn on the VM data recovery, and after that he begins the boot process, it displays a message "your CPU does not support long mode. Use a 32-bit distribution"

  Data recovery is installed on an ESX 4.0 update1 then the ESX is installed on a VMware Workstation 6.5.2 as a virtual machine in my home test environment.

  My processor is a 64 bit CPU (AMD Phenom 9950 Quad-Core).

  I wonder if this message is because the ESX is running in a virtual machine on the workstation may be that it not only Duke that the processor is a 64-bit?

  Someone at - he of the idea?

  Thank you

  Marcos

  You can run the 64-bit if clients your ESX is a virtual machine. VMware Workstation does not pass through the VT extensions that are necessary for the performance of a 64-bit as VDR host.

• RH EL 4.6 64 bit-> your CPU does not support long Mode?

  Hello

  I try to create a guest RH EL Linux 4.6_64bit on a HP DL585G1 ESX3i server build 123629.

  After the start of the guest, I get only the Message: "your CPU does not support long Mode. Use a 32-bit Distribution"

  The fool is, when I boot the direkt ServerHardware with this installation of EL HR CD, the installer runs fine!

  So what is happening here?

  Any clue?

  Thank you

  Thomas

  You may need to test if:

  (a) you run a review of 'good' (in terms of supported 64-bit comments) CPU (for example, several AMD chips have been officially ranked 'not kosher' VMware because of the inadequate support of segmentation) - see http://kb.vmware.com/selfservice/viewContent.do?externalId=1901 for more details.

  (b) AMD - V / Pacifica (VT if it is an Intel CPU) is not disabled in the BIOS of the computer.

• Yoga 900 - no keyboard on the screen in Word in tablet mode

  I have noticed that when I have my 900 in the configuration of the pad and open Word I can't bring up the keyboard

  Comment to Moderator: New thread is created. Edited topic. A: Re: 900 Yoga has arrived! What do you think?

  shack1968 wrote:

  I have noticed that when I have my 900 in the configuration of the pad and open Word I can't bring up the keyboard

  It is a problem with Word, rather than the 900 of Yoga, I think. I see the same thing on a Surface of 3 in tablet mode. You have two options to work around this problem:

  (a) turn off "Tablet Mode" to display the icon of the keyboard on the taskbar. Touch which will bring up the keyboard on the screen. Your physical keyboard should always be disabled when the 900 Yoga is bent in the Tablet configuration.

  (b) use the Word Mobile instead of the full word. It has all the features, but at least it will bring up the keyboard on the screen automatically in tablet mode.

• Dell coming Pro 8 with 10 Windows, all of a sudden not in tablet mode on-screen keyboard

  Yesterday it worked.  -Although I'm worried I'm headed on a bad road for the last month, I started to have to hold the power button about 5 seconds to turn it on.   I upgraded from Windows 8 to 10 Windows on this tablet more than 6 months, in August 2015.

  This new problem is that when I'm in tablet mode and use an application non-tablette as the browser Chrome, the on-screen keyboard fails to materialize when I type an entry field.  The same thing happens when I use another Windows program which is a map file.  But he can't, it's that the on-screen keyboard is launched even in tablet mode, when using Office programs such as Word or Excel or Microsoft browser instead of Chrome Edge.

  If I manually switch non-tablette mode, on-screen keyboard doesn't show when I type an entry, either field, but at least I put in place so that the keyboard icon appears in the taskbar in non-tablette mode.  So I can choose the keyboard from there I can enter data into the search field of the browser.

  This used to work, up until yesterday, while without having to manually switch off the table mode, I could choose the browser from Google app from the START screen, he'd jump open on the screen and when I typed an entry field research, the on-screen keyboard will be launched automatically.

  Hi, I had the same problem and found a way around - hold - click the lower panel until a small window with 4 options of additional icons will appear. One of the options is 'See the keyboard key' - check it.

  In case that the keyboard does not appear in Chrome automatically, you can fill it with this button.

  It will be useful.

  Miro

• Hello. Keyboard shortcuts in Mozilla does not include the window shortcuts. Please update this content. Thank you

  Mozilla Web page keyboard shortcuts.

  Reading the title of this thread, so a different answer.

  Firefox does not use the Windows key for all of the keyboard shortcuts in Firefox. Mac and Linux do not have a key "Windows". This article is for Firefox strictly keyboard shortcuts.