L50 - B - creation of recovery - satellite error message

Similar Questions

• Satellite 1900 shows a recovery on error message after reboot after

  My laptop Satellite 1900 305 after recovery uility, when commissioning for the first time shows an error message that indicates that the system has recovered from a serious error of a device. Can someone help me with this?

  Hello

  Well, it would be nice to have more information about your system. What operating system are you running currently installed Bios?

  This message appears again after a reboot?

  Good bye

• Satellite L850-ideogram - recovery stop error message

  Hello

  I have problem with my Satellite laptop. I can't recovery factory operating system.

  During recovery, it stops with 03-ffff-0001.
  What I have done:
  -run memtest - no error detected
  -updated the bios to the latest version
  -check smart hard drive and surface - no error detected (by victoria)
  -replace the hard drive with a good
  -Download the new recovery cd
  -change dvd - ROM

  Please hlp

  Satellite L850-CJK PSKDLR Win7HBx64

  In my opinion everything you tried has nothing to do with the recovery image installation, especially last two steps. I never heard that the recovery CD can be downloaded.

  Have you created a Toshiba recovery media s advice? If Yes, use please this media and try reinstalling the recovery image. On this forum, you can find several threads with similar problem and check what other people write about it.

• Satellite L750 / 04P - creation of recovery - an error Gx8004005

  Hello

  I bought a Toshiba Satellite L750 / 04P XC N 7944, for my son, we have tried to implement using the Toshiba Recovery Media Creator and the Windows 7 system recovery disks. So far, I've used 5 DVD s and can t go a disk without error.

  When you use Windows 7, an error comes up Gx8004005. All of the suggestions.

  I created an image backup and system, I hope I'm never confident until they save it properly.

  Hello

  Have you tried using different empty discs from different manufacturers? I recommend you to use DVD-R only disks. My recommendation is TDK or Verbatim discs.

• BSOD - 0x000000ed Unmountable Boot Volume on satellite error message

  Hi guys,.

  laptop was dropped and I now get the blue screen with this message at startup "stop: 0x000000ed unmountable boot volume.
  I read in some sites 'recover using xp disk', my laptop was bought with xp was preinstalled and I don't have a recovery disk.

  (1) can anyone identify the problem?
  (2) a recovery disk help?
  (3) if so where can I get one?

  Thank you

  Jim

  Hello

  I agree with Guybrush. The error seems to be related to the boot file system is defective and new resettlement could help.

  As we have already mentioned, the Toshiba Recovery CD could be controlled using the adresse_web above.
  If you are owner of an old series of laptop then the recovery CD could be ordered in the local ASP.

  But generally, you can use a Microsoft operating system CD too.
  You could install windows using this CD and all Toshiba drivers can be downloaded from the Toshiba driver page.

  Concerning

• Recovery disk error message? Try reformatting SL400 for sale

  Hello

  I have a SL400 I want to reformat and sell. He has XP Pro sp3 installed top of the plant. Recovery disks, he came up with that are for Vista professional.

  There are 3 disks for recovery, it is labeled start recovery, the next is the disc of the operating system (Vista professional), and the third is the drivers.

  When I boot the disk 1, it launches the recovery software. Then it tells me to put the recovery disk 1 in drive D:, then click Yes. The disk is already there. When I click Yes, a dialogue window tells me it's the wrong disc.

  How to operate?

  Thank you

  Scott

  I called technical support from Lenovo and here is the solution for this problem, if anyone finds this research for this problem:

  1. Reboot and press F1 to enter BIOS
  2. In the BIOS, go to the Configuration tab and navigate to the ATA (SATA)
  3. Change the compatibility mode
  4. Reboot with recovery disk 1 in the drive
  5. Now, when he asks you to disk 1, put in disc 2 and click OK
  6. It should start the formatting

• Mini 101NR - restore to fail, error message "cannot find the file.

  While restoring my Mini 1010NR with 8 GB SSD from the disk of XP SP3 operating system, everything fine until partially through the recovery an error message saying that it cannot find the i386\ASMS file.

  I tried the options "install fresh copy" and "repair" and get this same error message in both directions.

  I formatted the SDS with both regular and quick NTFS file system. My OSD software gives me the possibility of formatting of the SDS with fat? I have not tried. That I should?

  I looked at the CD, and in the i386 subdirectory, I see a subdirectory called ASMS. I see several subdirectories in this directory.

  I am booting from an external CD/DVD drive. This seems correct, as the installed much restoration program file until stopping in the message saying that it couldn't find the file ASMS.

  This OSD provided with the computer when I bought it new at HP.

  Thank you

  Peter

  The cd is corrupted or damaged or installation loses communication with the CD-ROM drive. If you can, try another cdrom drive.

  http://support.Microsoft.com/kb/q311755/

• Satellite A100 - recovery will not be finished and stop error message occurs

  Satellite A100-S2211TD, OS is Windows XP Home Edition of recovery disk,

  I have updated the BIOS to 2.20 and laptop was working fine. The old installation of Windows factory has worked well.
  After a few weeks, I tried to use the recovery disk to remove the noise from the HARD drive.
  The recovery of disk task completed and the computer restarted.
  I got the stop error message
  STOP: 0x0000007B (0xFA335528, 0xC0000034, 0x00000000, 0x00000000)
  I removed the memory that I have entered over the past two years and return the PC in the factory scene.
  However, recovery will not be finished (he worked to restore).

  I am able to boot in dos with a separate boot disk (Dr. back, windows does not start, not even in the safe control mode) and I did chdsk of the disc and disc is fine.

  I've never used before recovery disc, the only thing different is BIOS 2.20 instead of 1.50.
  WEB of TOSHIBA said that if you upgrade the BIOS most 2.00 you can not return to 1. XX

  Thank you
  g

  Hello

  The A100-S2211TD doesn t support the Intel Chipset!
  This laptop was equipped with the ATI graphics card and the graphics driver on the Toshiba page contains us the graphics driver and chipset driver!

  Have you received 100% good recovery CD?

  In your case I would try to install Win XP from the Microsoft CD to check if the same error would appear if no drivers are included in the CD of the OS.

  Check it out

• Error message using on Satellite A135 recovery CD/DVDs

  Hi Forum:

  I try to restore the factory default in my laptop Satellite A135 where to finish the process I have received an Error Message and press ok and disable my laptop automaticlly.

  NOTE: Only use the CD/DVD, my laptop does not have the partition hiding any help?

  Hello

  I googled a bit for this error message and it seems that the error would have apparently due to HARD drive failure.
  So in your case, it would be desirable to replace the HARD drive and to verify if the error persists using a new HARD drive.

  Best regards

• Satellite A135-S4666 - recovery disk displays an error message

  The hard drive crashed while I replaced it. I am trying to use the recovery disk to take the computer to the "out of the box configuration.

  I chose to 'recover' rather than erase the hard drive based on this choice. Then it copies the files from the first disc and pushes me to the second. After putting the other continues to copy files. Finally, she moves more to 'recover now' she does and seems to be using the hard disk newly installed something between 35 and 50% of the task. At this point, I get an error message stating "error recovery" and invites me to press ok to shut down the computer and spits out the CD. The error message is coded 10-FC12-0002. I tried 4 or 5 times with the same result.

  Am I supposed to use disc erase first, and then use the recovery mode since it is a new hard drive? Or I have a defective recovery disc?

  Any comments or ideas would be greatly appreciated, I do not get the case at this stage.

  Hello

  It's not easy to tell if it s a recovery disk problem or if the new HARD drive is the problem. Have you tested a Microsoft disc for example? If the disc of Microsoft is, it seems that your recovery disc is noisy and needs to be replaced. Otherwise the new drive HARD cause this problem.

  Check this box to determine the cause of this problem!

  Good bye

• Satellite L300D - recovery disk stops with an error message

  Hello

  I don't read a lot of the other post, but foung no response...

  My problem:
  I bought a L300D Vista 1Y there are no included recovery disks, so I made the recovery disc. Now, we wanted to reinstall Vista, so I tried the recovery disk, but after 15 minutes, it failed with an error message:

  After successfully in 3 partitions of partitioning and formatting them the ImageX tool starts to extract VISTA

  After about 57% C:eindows\winsxs\x86_microsoft-windows-ehome-ehcird_31...35.6.0.6000.16663_...\ehcir.ird [removeExtract ToFileByStruct WIMcopyFileEx failed]

  Retry...
  [error 1117]

  What happenes about 5 times with similar messages (but other numbers), til message
  The request could not be performed because of an i/o error

  ERROR: ImageX could not to VISTA Lawrence drive HARD C: 2 V: HDD

  Press a key...

  Aftre reading the threads, I ordered an official recovery (35 Euro!) since the Office of service Toshiba disc, but I got the same errors and messages...

  Any ideas what I should do now?

  Thank you!!

  PS I never had these problems with my other laptops...

  Hello

  My friend who s a long story.

  It's not easy to say what the reason is for this, but to me it sounds like that there is something wrong with the HARD drive. In your case I would format the HARD drive before launching the recovery disc. You can do this with a Microsoft disk to format the whole HARD drive. After that try the recovery disk again.

  If it doesn't work, you should check the HARD drive with a special HARD drive diagnostic tool like Drive Fitness Test. use Google to find it, it s freeware and takes only a few minutes.

  Welcome them

• Satellite A500 - problems with the creation of recovery disks

  Hello
  I bought a Satellite A500 yesterday and now I'm trying to create the recovery discs before anything else.
  However, towards the end of the 1st DVD I get an error message saying "Faile dto open the next file. e:\Boot\BCD (0201123-F1-00000000 error code)"and then when I click 'OK', the DVD is ejected giving a message"unable to create recovery 1' media. Physical examination, I noticed that the DVD is written almost entirely.

  Any advise on this? In addition, in the interface, it shows a USB option and says to insert a USB media with more than 7 GB of free. That I can use it to create the recovery disk? If Yes, when I reinstall windows 7, this allows as a bootable drive?

  Greately appreciate any help on this matter. If it is defective, I want to return as soon as POSSIBLE.

  Thank you
  Mercier.

  As far as I know, that you can not use external device for recovery, it is therefore very important create recovery DVDs.

  Try to create the recovery disk using only DVD-R media. Use high quality media like TDK or Verbatim.
  Last month, I've created on the Satellite A500-157 recovery discs and everything went well.

• Satellite Pro C660-239 - restore from recovery media error

  Hello!

  I have a laptop from a client, it is a Toshiba Satellite Pro C660-239, and I'm having a strange problem.

  The original hard drive failed, and as the laptop is out of warranty, we bought a new hard drive and ordered the recovery media to this model, our assistance to repair local toshiba.

  After the installation copied the files on the disk, the imageX command fails when you restore the image with error files:

  "the file or directory is corrupted and unreadable."

  The hard drive is new, and I also tried with more than 2 hard drives, as well as with an external cd-rom drive.

  I spoke with the support of assistance local repair, and told me that this happens because the ins new ' t compatible with the recovery media hard drive?

  One of the new disks hard I tried, was the exact same model as the original hard disk, and the error persists, so the hard drive may not be the problem.

  Y does it have that no change in the recovery media is corrupt?

  Could also be a motherboard problem?

  Thank you

  > Is there any change in the recovery media is corrupt?
  Of course, this is possible.
  In case the HARD disk is OK, the recovery media may be damaged.

  > Could also be a motherboard problem?
  I don t think so. I imagine that the HARD drive is recognized correctly in the BIOS and the error message says something about corrupt directory. I guess the disk directory that is the meaning and I think that the media should be replaced.

• Error messages when you try to retrieve satellite L300 Vista

  I have a Satellite L300, which keeps freezing upwards so when I tried to do a recovery I got an error message 10 D 045 fa12 and when I tried to completely erase the disk, I got an error of the FFE 20 045D

  This unit was sent to toshiba for repair and technicians said there was nothing wrong with the unit, but my research tells me there is probably a fault requiring the replacement of the HARD drive - so now that my warranty just expired do - what I do? Can I still take the unit for repair since the issue of original warranty has never properly addressed? or is there a way I can fix the error?

  If the warranty has expired, this can be a problem now, but I wonder why you did not react immediately when you saw that there is a problem.
  On this forum, you can find several threads with the same problem and if you have time try to read this that people writing here.

  I can imagine there is problem with HARD drive, the HARD drive can be replaced but you can do it alone.
  It's really not a big deal.

• Satellite Pro M10 will not start again and comes up with the error message

  My laptop Toshiba Satellite Pro M10 will not start again and comes up with the error message "load error" when I press the power button.
  The arised problem after installation of the 'symantec system works' and try to restart windows XP Professional to make the installed executable program.

  What can I do to get the notbook again reboot?

  Hello

  Seems that there are problems with the files of GoBack.

  Try to boot in safe mode and remove the Norton System works from your laptop ;)
  If this does not help, you will need to recover the laptop with the recovery CD Toshiba delivered!

  Also I recommend to visit the Symantec support site and to check the solutions to the problem with the Norton System Works programs

  Good luck