My KDSR70XBR2 turned off and now only red light blinks six times then pause of 2 seconds followed

Similar Questions

• Satellite U400-14 b turns off and now it won't start

  Hello

  just got a new Satellite U400 this week.
  Worked perfectly the first days, and then last night, it just turns off and now it won't start.

  I press the button and the row of lights beside him light up, but nothing happens that I n t even get as much as the Toshiba screen.
  I tried a lot of things. I left it plugged in all night, tried to take the battery and any results now.

  Little led lights on the bottom indicates that it is his stuffy, battery is white not orange when you press they light up only for a fraction of a second.

  The only thing I can compare it is too when a car won t start and you keep turning and turning the key, well in that case, pushing a button, and nothing happens, fans don t whir or anything...

  help please...

  Additional memory (RAM) has been installed? Try to remove a memory Module and try another memory location.

  If bad memory is not the problem, then there is not much else you can do except send it to an ASP for warranty repairs.

• Ex720 turns on and off the red light blinks 8 times continuously

  LED blinks 8 times continuously and turns on or off tv

  Follow the steps below to troubleshoot the TV.

• Trinitron TV turns off. The red light blinks 7 times

  I have A FD Trinitron WEGA. It works perfectly for the past year 8 and a half. Recently, he died while we watch. The red on the front of the TV blinks 7 times. I wonder if a repair is required, and how much it will cost, thank you for your help.

  Hi joehui,

  Check whether in the TV, clock/Timer is set. If so, disable the timed operation parameters.

  If the TV is connected to a power strip or surge protector, remove the power strip or surge protector and plug it directly into the wall outlet. If the problem is resolved, the problem is with the power strip or surge protector and not the TV.

  Follow the steps below to perform a power reset:

  • Turn off the TV.
  • Unplug the power cord of the TV from the power outlet.
  • Let the TV remain without power for 60 seconds.
  • Plug the power cord into the power outlet.
  • Turn on the TV.

  If the problem is still not resolved after following all the steps of troubleshooting, service may be required. Locate the centers of the closest authorized repair the link below.

  https://eService.Sony.com

  The exact cost of the repair can be determined only after a physical examination of the TV. You can contact the service centers to know exactly the cost of repair.

  If my post answered your question, please mark it as an "accepted Solution".

• I was on the internet and my computer automatically turns off and now when I press start for most all my programs do not appear and saying all the folders are empty

  Windows Update no longer works and my computer is extremely slow so

  Hello

  1. have you made changes on the computer recently?

  There is a possibility that another application is at the origin of the conflict with Internet Explorer. Let us check in safe mode with network and then we can check in clean boot to find the root cause of the problem.
  Step A.
  Please check if you are facing the same question when working in mode safe mode with networking.
  a. restart your computer.
  b. when the computer starts, you will see your computer hardware are listed. When you see this information tap the F8 on your keyboard key repeatedly until you are presented with the screen Windows Vista Advanced Boot Options.
  c. using the arrow keys, select the desired option of Mode without failure.
  d. press the Enter key on your keyboard to boot mode safe mode of Windows Vista with networking.
  e. when Windows starts, use check and Internet explore if the problem persists.
  For more information, refer to the article below.
  Troubleshooting in safe mode
  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshooting-problems-while-in-safe-mode

  Step B.
  If the problem exists not in Mode safe run mode startup minimum troubleshooting to find the root cause of the problem.
  How to troubleshoot a problem by performing a clean boot in Windows Vista or in Windows 7
  http://support.Microsoft.com/kb/929135
  Note: When the diagnosis is complete, don't forget to reset your computer to normal startup. Follow step 7 in the above article.

  I hope this helps.

• KDL-55HX750 red light blinks 3 times

  My TV no longer works, it feeds on. that it snaps and then the power light turns RED and flashes 3 times repeatedly. Please help me, cause I can't believe I have to pay so much to replace the main Board.

  TV works fine. I found that I had downloaded the version of firmware USA instead of the version of the MEA. Once I downloaded the correct software copied on the USB, the TV updated Firmware accordingly.

  Thank you

• I am unable to unsubscribe from communities of APPLE. mailbox had 3-4 pages of comments. Have everuthing turned off and saved the changes... Help

  I am unable to unsubscribe from communities of APPLE. Mailbox has 3-4 pages of comments by email. Have everything turned off and saved the changes... Help

  , You click on "stop following" in each community/thread you posted in?

• Had cracked screen but the phone works still. Today screen is become white, and the phone rang again.  Did hard reset and now the phone is completely turned off and will not be exposed - not even the Red of the battery is displayed

  Had cracked screen but the phone works still. Today screen is become white, and the phone rang again.  Did hard reset and now the phone is completely turned off and will not be exposed - not even the Red of the battery is displayed

  He broke. Make an appointment at the genius bar and get it fixed / replaced. There is no magic words that will do well.

• Time Capsule A1355 no light, no sound? worked this morning now after connecting it, first go-ahead for colid quickly followed by the longest fixed Orange, which turns off and then nothing? He's dead now?

  Time Capsule A1355 no light, no sound? worked this morning now after connecting it, first green light solid, quickly followed by amber is more solid, which turns off and then nothing? I'm not in the airport or if directly connected to the Macbook air utility. It is running the latest firmware, updated 7 days ago and everything was fine until now. Tried both a soft and a hard reset factory but still nothing, but the same brief glow only after restarting each time before going dark again? Any ideas if it can be fixed or if it's as I read elsewhere dead now?

  Thank you

  Any ideas if it can be fixed or if it's as I read elsewhere dead now?

  He died... the fact that the main witness turns off is unusual in this model.

  It is common to the next... A1409 (gen4)

  What happens in the Gen3 is normally a few deaths on the Board... or a bunch of capacitors is low...

  See s/apple-time-capsule-repair/new-issue-with-a1355-gen-3-tc https://sites.google.com/site/lapastenague/a-deconstruction-of-routers-and-modem

  If yours is a very fine introduces Gen3 just before Gen 4, it is possible that the same fix on the Gen 4 could work.

  s/Apple-time-capsule-repair/GEN4-a1409-issues https://sites.google.com/site/lapastenague/a-deconstruction-of-routers-and-modem

  I found early Gen4 may fail as Gen3 but must admit that I am yet to see the Gen3 with welding problems.

  I doubt repair is worth it. The Gen3 is now about 6 years... give or take... This is way beyond the standard lifetime of a TC.

  If you want to play, I'm happy to help you... but I would not spend money on it.

• iOS block report because of the third-party application, I answered and they managed remotely on the computer, now I know it's a scam, I turned off and reset the password, I'm in the clear?

  iOS block report because of the third-party application, I answered and they managed remotely on the computer, now I know it's a scam, I turned off and reset the password, I'm in the clear?

  If you allowed anyone remote access to your computer (and you're talking about a computer since you mentioned iOS which is the OS for iDevices; computers run on Mac OS X), while no one knows what they were able to install. Assume the worst and:

  Notify your credit card company / bank of potential fraud

  Change your bank accounts and report your fly/fraud credit card

  Change all of your passwords

  And, finally, erase your entire hard drive and reinstall the OS from scratch using recovery or your original installation disks.

• Sony Xperia z3 Turned off and will not charge after being immersed for about 5 minutes

  As the subject says. My Xperia Z3 was submerged for about 5 minutes in less than a foot of water. He was in charge at first, then it started to vibrate. The model will thus: 1 (typical to indicate the load power) Vibration, then a Triple vibrator. At this point the LED on the phone turns off. Now he's going to restart this process again and again until the phone is disconnected. That submerged while the phone components were closed and did not open. As far as the damage is concerned, it is a crack in the root of the hair in the backglass and part of the bezel has started to peel off near the camera for unknown reasons. Once again this damage is very slight, and only someone who knows what the phone looks like new would see same. Any help would be apperciated.

  I'm sorry to see it, but you will need to contact your local care Xperia

  http://support.sonymobile.com/global-en/contactus/

  Request a trial of vacuum.

  The crack may be the cause of the water damage.

• Unable to turn off the read-only

  I tried to turn off the read-only on a folder in my Program Files (x 86) folder so I can edit a file for a game.  I tried everything I can find on the internet without success.  Here's what I did until now (I'm on an administrator with maximum permissions account):

  1. I tried to uncheck the read-only box.  Whenever I close the properties and reopen, it is checked again.

  2. I tried to run the attrib - r + s function cmd as admin, but nothing has changed

  3. I ran a chkdsk, still nothing

  4 changed property in the security properties, as well as assuring you of my account has full permissions with all of the Program Files (x 86) folder. I then tried again the first 2 steps, is always checked.

  Anything else I can try?

  What you need to do is Notepad opened by right-clicking on the Notepad icon and then selecting run as administrator.

  Then, while in Notepad, open the .ini file.

  Change it and then you will be able to save him.

• BlackBerry 8520 smartphones turned off and won't turn on! Help!

  I may be wrong pressed a few buttons (sleep) and I woke up to see my vocation as a voice configuration 8520 and it was completed at 98% (so I thought it was better to leave full since he was almost finished). I woke up again a few hours later and she's not coming. I removed the battery several times, but only the red light comes on for a few seconds then it turns off and the screen remains blank... What I've done wrong and what I would do!

  Leave the device in 2 or 3 hours of charging and then, still connected to the charger cable, remove the battery of the device a few seconds and plug it back. If it starts - let - the charges to 100% (check the Options > status for the percentage). If it is not restart on the first attempt, leave several hours. I had a charge for two days before, she came back to life after extreme exhaustion of the battery. Every 3-4 hours with the device plugged into the charger, you can remove and replace the battery to see if it restarts.

  If this does not work, if your BlackBerry remains powered turned off with a black screen, follow the instructions below. The only indication of life may be the flashing red indicator light in the upper corner. Nothing seems to wake and Desktop Manager does not recognize that a device is connected.

  (1) make sure that you have Blackberry Desktop Manager installed.
  http://NA.BlackBerry.com/eng/services/desktop/
  (2) on your PC, go to start > run and copy and paste the following line exactly (i.e. with quotation marks):

  'c:\program files\common research in motion\apploader\loader.exe' /nojvm

  (3) the Application Loader Wizard will appear - click on "next".
  (4) in the ' connection: ' drop-down menu, you should see "USB - PIN: UNKNOWN". Click on the button "next".
  (5) you should see a list of applications ready to be installed for your Blackberry. Press Next and finish, and that you are well on your way to get your Blackberry to life. Just unplug and let the process finish completely.

  NOTE: If you do not display the list of applications mentioned in step 5 and instead to see the message "the Blackberry Desktop Software has no Blackberry Device Software for the device you have connected to the computer. Contact your wireless service provider or system administrator', then you must download the Blackberry operating system for your support and your device.
  http://www.BlackBerryFAQ.com/index.php/BlackBerry_Operating_System_Downloads
  Just select the appropriate type of carrier and network, select your Blackberry model from the list and download the latest version. Install this download and follow the steps above again and you should be on the right track.

• iPhone 5 turned off and won't turn back on

  Hi guys, my iPhone 5 turned off and won't turn back on despite my efforts to load. He doesn't have anything happen when the charge as the battery showing it is low or that the phone needs to be recharged.

  http://cosmouk.cdnds.NET/15/43/1445347217-iOS-low-battery.PNG

  It doesn't have this show in any every time I try to turn it on and even while there is no evidence a load.

  I corrected it when I contacted Apple support. They broke down the power and Home button to force restart it. Works fine now, battery has been replaced but because she is "consumed".

• The browser does not start after you have turned off and turned on the computer

  The browser does not start after you have turned off and turned on the computer. I tried to remove the program entirely (as well as personal preferences), to create a new account, install a different browser versions. All this has not helped. (I have Windows 7). Help, please! Every day I have to reinstall Firefox!

  Hello Nastena, try a clean reinstall, some Firefox issues can be resolved by performing a clean reinstall. This means that you Remove Firefox program files and then reinstall Firefox. Please follow these steps:

  Note: You can print these steps or consult them in another browser.

  1. Download the latest version of Firefox from http://www.mozilla.org office and save the installer to your computer.
  2. Once the download is complete, close all Firefox Windows (click on quit in the file menu or Firefox).
  3. Remove the Firefox installation folder, which is located in one of these locations, by default:
     • Windows:
       • C:\Program Files\Mozilla Firefox
       • C:\Program Files (x 86) \Mozilla Firefox
     • Mac: Delete Firefox in the Applications folder.
     • Linux: If you have installed Firefox with the distribution-based package manager, you must use the same way to uninstall: see Install Firefox on Linux. If you have downloaded and installed the binary package from the Firefox download page, simply remove the folder firefox in your home directory.
  4. Now, go ahead and reinstall Firefox:
     1. Double-click on the downloaded Setup file and go through the steps in the installation wizard.
     2. Once the wizard is completed, click to open Firefox directly after clicking the Finish button.

  Please report back to see if this helped you!

  • Also check if your antivirus or other access security software (firewall, antispyware etc.) blocks firefox.

  Thank you