No boots motorcycle no G580 os

Similar Questions

• Satellite A200 - boots motorcycle cycle Post - in touch with Toshiba tomorrow

  Hello
  I have a Toshiba Satellite A200 when start does not get past the message, get you the commercial display of system "In Touch with tomorrow Toshiba" press F2 or F12 for the boot of friends menu. The blue bar get about 3/4 of the way through, then it restarts. Even if you press F2 or F12, you get the same result.

  Any help would be appreciated.

  Concerning
  Brett

  Hello

  Looks like a corrupted Bios and reflashed need. The problem is that you need bios under BACK and disk it reflash. On the page of the Toshiba driver, there is only victory - a basis.
  Notice, I guess it's Bios troublemaker, but it may be associated with mobo issue itself.

  In any case, you should contact the service center, it is not impossible to solve these issues in this virtual forum

• HP Probook 470 go cancel the loading image and then start boots motorcycle option

  My HP Probook 470 GO

  Suddenly I appeared cancel loading image and then start option boots on the output screen and can not do anything further to will not windwos raise.

  When the father of the F7 to do an iybaci my spare key hp not registered recovery recovery

  Hi @mdcom,

  Once access you the link provided discussion forums should be the category where you can ask your question.

  Kind regards
  George

• T400 incredibly slow Windows 7 boot

  Hello

  I came across a problem that I can't bring myself to its cause is a mystery to me:

  I got OEM Vista Ultimate installed on my T400, which worked well, but since I installed Windows 7 today, the windows startup takes unusually long, make me stuck "starting Windows" screen for about 10 minutes each time. Once it starts, it works OK without hiccups or lag whatsoever.

  I have no idea where the root of this problem may be, perhaps this will give you an idea.

  I had two T400 lying around, it had taken defective helmet (stuck somewhere, so the computer assumes that the headphones are always connected, so I could not any sound on the speakers.) As the headphone jack is soldered to the motherboard, I needed to replace the mobo) and the other had it bad LCD. So I decided to use the functional components to build a fully functional T400 and sell the other for parts.

  So what I did:

  -Exchange of the LCD screens (LCD good + good mobo, bad LCD + bad mobo)

  -Exchange processors (because one with defective plug had 2, 53Ghz - anything but the sound was very good! - while the other had only 2, 4 GHz)

  -swapped hard drives (as those with defective jack was the computer I used usually, there were W7 installed, while the other had Vista)

  I put them together and all in one that has Vista booted up quicky as usual (although as before, his mobo was used with a processor more fast and Windows 7), that now with W7 took forever to start up, which has never happened before. I thought it would be because of the CPU (the BIOS reset or disconnect the battery helped CMOS), if I swapped processors once more (-> back to their original mobos). The defective machine with Vista had no problems turning, but it did not help the machine running W7.

  Here is the mystery:

  I swapped hard drives too, so the only change in their original configuration was the display (swapped defective TFT 1280 x 800 for good LED 1440 x 900) and after that two of them were able to start normally.

  But once I erased the disc HARD with Vista on it, which worked very well in the machine where the drive of W7 took forever to start and reloaded Windows 7 at this disk, the problem returned.

  Now I have two T400s with Windows 7, but rather of takes ages to start.

  For the best image:

  T400 No1, original config:	T400 No2, original config:
  Faulty motherboard	Good Mobo
  Good display 1440 x 900	1280 x 800 screen faulty
  PROCESSOR P8700	PROCESSOR P8600
  4 + 2 GB OF RAM	1 + 1 GB RAM
  Intel graphics card	Intel graphics card
  Hard HARD 160 GB w / Windows 7	HDD 160 GB with Windows Vista
  works	works

  T400 No1, current config:	T400 No2, current config:
  Faulty motherboard	Good Mobo
  1280 x 800 screen faulty	Good display 1440 x 900
  PROCESSOR P8700	PROCESSOR P8600
  1 + 1 GB RAM	4 + 2 GB OF RAM
  Intel graphics card	Intel graphics card
  Hard HARD 160 GB w / Windows 7	160 GB HDD with Windows 7, Vista previously
  boots motorcycle quickly	takes forever to start, was OK with Vista

  Please, you have ideas how to redo the slow one usable without going back to vista?

  Any help will be much appreciated, thank you for your patience.

  Hello world! You can check for bent pins usb ports? It sounds weird, I know, but it could be as simple as that...

• Are the available PCI drivers if you are using the recovery/Application for an AMD Compaq5610F 64 x 2 driver

  Boots motorcycle only in safe mode without network and new

  printer driver installation fails.  Grand? mark in

  For other devices such as Device Manager:

  Other PCI bridge device

  PCI device

  PCI Simple Communication controller

  SM Bus controller

  Video controller (VGA compatible)

  I'll be able to find and reinstall these

  drivers missing using the Application or driver

  Recovery program?

  If your machine does not start with the hard drive, and I guess no recognition in the BIOS, it's about confirmation that the drive is dead. Not a good way to start the weekend - but for about $60, it can replace the hard drive and order the recovery media to reinstall the OS.

  BTW, have you checked to make sure she didn't burn an OS Recovery DVD set & ranger? She would have gotten a pop-up reminder to do that when the machine was the first installation. Wouldn't be the first time someone put it away and forgot to push.

• G580 (20157) Lenovo usb boot does not not after installing windows 8

  Hello

  I have lenovo G580 model (20157). previously I had installed Windows 7 and Ubuntu 12.04 without problem. Today, I decided to go for windows 8.1. is it installed without any problems (no legacy mode UEFI) perfectally and works very well but ubuntu live USB is not initialize when I select Boot from USB windows 8 starts. I really need Linux in my laptop. Could someone help as soon as POSSIBLE.

  Hello

  Can try you other media, Imean another model may be different from the flash player / brand see if that will make a difference with the boot process.

  Thank you

  Solid Cruver

• Random voice of motorcycle boot

  If I activate the voice of the bike and train with the sentence of starting it opens sometimes just randomly. Like say when pkayer music plays music, this voice of motorcycle arises suddenly... anyvody noticed this... I'm something wrong... I am a first time user these characteristics

  Looks like you will need to choose a new sentence, the more complex, the launch. Please try a new sentence and see if it helps.

  -Tom

• E for motorcycle boot animation

  There is a new boot for the 1st generation of bike e animation? If so where can I find that?

  At this time its not visible on the game!
  
  We can only go off if he has a direct link to that! And I want something new not official...
  
  Even football entertainment was cool... can someone tell me what was this version?

• Why do I need a memory NVRAM reset after boot USB?

  Sometimes, I want to test another version of OS X on an external USB drive. I can attach the disc, choose as a boot volume and restart. This part works fine.

  If I want to go back in the same way (choose the internal drive as the boot volume and reboot), it does not. What I usually see is a slow progress bar, which finally ends with the Recovery Wizard. Motorcycle boots never the internal drive.

  The only way to recover is to unplug the USB drive and reset the NVRM. Then the Mac boots again normally from disk internal, until I restart all restarting on the external drive.

  The Mac is a Mac Mini 2012 with the original disc of fusion installed. The internal drive is encrypted, but I had the same problem exactly one year before running Yosemite and try to El Capitan. The drive was not encrypted. Also, I used another external drive.

  Did anyone see similar questions? Is there any solution for this?

  continues wrote:

  If I want to go back in the same way (choose the internal drive as the boot volume and reboot), it does not. What I usually see is a slow progress bar, which finally ends with the Recovery Wizard. Motorcycle boots never the internal drive.

  There are two ways:

  Hold the option key at startup to select the startup disk

  While  initialized and running > System Preferences > Start up disc and unlock the padlock to select or re - select your startup disk. Lock the padlock

• Motorcycle G XT1063 Stock on Bootloader

  My motorcycle G XT1063 suddenly got in bootloader and with the following errors:

  bad check failed to start

  Impossible to check the bad image boot

  could not validate the boot image

  Fastboot pattern: Fall-through of the normal startup mode

  48-86 (sha - 54975c 4, 201504-17 15:10:51)

  CPU: MSM8226 CS

  MEM: 8GB Toshiba RV = PV = 51 TY = 17 06

  DRAM: 1024Mo Elpida SDRAM DIE S4 = 4 GB

  Battery OK

  Device is LOCKED. Status code: 0

  I never put all ROm that came with Marshmallow installed with OTA was last updated.

  If anyone can help me identify the problem and show me how to solve this problem.

  The only help we offer here is a reset. If this fails then service is the only option user from the point of view of Motorola.

• Marshmallow stuck on the boot loop after encryption

  Hello! I have improved my motorcycle G 2nd Gen to Marshmallow Friday. Today, I chose the option to encrypt my phone for security reasons, and once I chose the model and it restarts, it is stuck on the boot animation. Unlocking scheme but then returns the boot animation shows and pass. After more than 4 hours, I tried to enter the quick recovery and it says that the device is locked. I have tried factory reset without the quick recovery result. If I turn off the phone it boots on its on and so on and so forth.

  The model is XT1068.

  Activation of the encryption on the 2nd Gen Moto G is not a good idea, unless you are really paranoid. It's too slow as the CPU supports a few commands that deal with some of the encryption at the hardware level.

• Lenovo G580 - menu to start cannot find CD/DVD, HARD drive

  Hello everyone

  I have a little trouble with this laptop lenovo G580, which cannot start.

  Problem: HARD and CD/DVD drive is visible in the tap in the bios info, but they are not visible in the faucet of the boot, only an IP4 and IP6 EFI network are visible.

  I tried to change the HARD disk first to ensure if she would do anything, but did not work, so I spent back.

  But I've never seen this kind of problem before, so I really have no idea what to do.

  The version of the bios installed is V9.01 I hope that if someone has an idea that could help solve this problem.

  -Mootix-

  It seems ok I solved my problem, I will report how and what I have done, so anyone with the same problem can try this.

  OK, so apparently the Bios have been installing only the boot devices to reqister who had something to do with Windows 8, which means that the hard drive that was completely empty of any data, had nothing to do with Windows 8 and therefor can not be started with the current Bios settings.

  1. open the safety valve and turn off temp only "secure startup.

  2. go to the tap of Boot and change 'Boot mode' for Legacy Support UEFI.

  3. in the tap water Boot changes 'Boot prio' "first Legacy.

  4 reboot and press F2 and verify tap boot to the disk under "Boot device prio.

  Fact

  I think that since the drive HARD have Win8 installed it will not display as boot device unless it is on Legacy Support.

  because UEFI on the G580 only supports the HARD disk with a Win8 installed operating system.

  Now, I should be able to reinstall Win 8 - 8.1 on the HARD drive.

• G50-45 - it can boot from USB 3.0?

  Hello

  I want to buy a compact USB to allow me to start my computer to Linux when necessary. Obviously, USB 3.0 will be faster, but I don't know if USB 3.0 is bootable with this laptop. I have version 1.07 of 'Insyde H20' BIOS (even if it also says Rev. 3.7 - don't know which version this is why he - 1.07/3.7?)

  Anyway - does anyone know if it is bootable USB 3.0? Google no did not help me this time.

  Thank you.

  USB 3 is backward compatible with USB 2, so everything that boots from USB should be good. I've not seen anyone suggesting the contrary, and my G580 USB boots all the time.

  Check your BIOS make sure that USB boot is enabled, Secure Boot is disabled. Try to start (boot order ether), or manual selection of the startup list.

• Black screen after the boot animation

  My wife has just contacted me to tell me her phone is broken.

  She was the motorcycle 2nd Gen LTE

  Whenever she tries to turn on, after the boot animation screen becomes black (the screen lights up but). The phone is charged, she insists.

  She wants me to fix his phone when I'm working.

  Any advice?

  What are the options should I expect to see on the fastboot screen?

  I am hoping does not need to do a reset to factory if possible...

  Ended up doing a complete reset.

  Thanks for the offer of solutions.

• Lenovo G580 Bletooth are not not in Device Manager after upgrade Windows 10

  Hello everyone, I'm sorry for the question once again, but after that I have upgraded to Windows 10 my Bluetooth did not appear on the Device Manager. I tried everything to fix it, but all the solutions on the previous posts has not worked for me. When I press Fn + F5, the window opens and the Bluetooth is turned on but is nothing on Device Manager, as well as the drivers do not work, I mean I can install drivers but still nothing appears in the Device Manager. initially I had 1 single unknown device, but it's the card reader, I found a driver for it and it worked, but I tried everything with the bluetooth, but nothing worked. BTW, I tried to boot Ubuntu just to see if the Bluetooth works and Yes Ubuntu see my Bluetooth adapter and he works on it, but when I run Windows 10, nothing works with Bluetooth.

  My device is: Lenovo G580 20150

  Thanks in advance

  Thanks for the quick reply,

  I installed the driver bluetooth of windows 8 and still not recognized. I have haveup windows date and not helped, so windows update doesn't work for me. My before OS was Windows 7 Pro 64 bit and everything worked well, and will very likely downgrade to windows 7 to make everything work. I'll wait for the proper drivers and I'm going back to Windows 10.

  Thanks for the help and have a nice day.