PC2-5300 667 Mhz RAM for Qosmio F30-141?

Similar Questions

• Is - 2 GB module or a work of memory PC2-5300 / 667 mhz for Latitude D610?

  Shows spec Dell Latitude D610 will have 1 GB of memory by Bank, total, up to 2 GB and also uses memory PC2-4200 / 533 mhz.

  What I was wondering if this can be exceeded and D610 would always be OK:

  • If the memory stick 2 GB would work by Bank, up to 4GB total, assuming that the use of memory PC2-4200.
  • Or, if memory PC2-5300 / 667 mhz would work, assuming that using memory of 1 GB.

  I have above that the technical running in my office and usually faster memory memory can be used, just that it runs at a slower speed.

  Has anyone put in memory in D610 which is faster or more dense than does the spec? Believe it or not, part of the problem is that modern memory is denser and faster, and it is cheaper just get a faster or more dense memory.

  Message edited by Teknouser on 09/26/2008 19:33
  
  

• Satellite A60 does support Kingston 2 Gb 200pin Sodimm DDR2 PC2-5300 667 Mhz

  Satellite A60 does support Kingston 2 Gb 200pin Sodimm DDR2 PC2-5300 667 Mhz

  Thank you.

  Hello

  Satellite A60 supports PC2700 DDR SODIMM 200 pin like on this page says:
  http://www.orcalogic.co.UK/ASP/ProdType.asp?ProdType=8333&ft=m&St=3

  Only a single memory is expandable! So, you can use only one slot for an upgrade!
  You can use max 1024MB module and memory can be improved for max 1.25 or 1.5 GB. (according to the amount of memory the memory internal)

  The speed of the module can be different! I m not 100% sure, but I guess that the laptop supports a 533 MHz FSB (front side bus) and therefore, you can use the modules of PC2700 memory with 533 MHz speed.

  Best regards

• Where can I buy a motherboard for Qosmio F30-141

  where you can buy a motherboard for Toshiba QOSMIO F30-141?

  Hi mate

  You need a special Council which has been designed especially for the Qosmio F30-141.
  These motherboards and all compatible parts can be purchased from the Toshiba ASP in your country.

  Here you will find the ASP:
  http://EU.computers.Toshiba-Europe.com-> supported downloads &-> find an authorized service provider

• Is it possible to use 667 MHz Ram for Satellite A100-233?

  I want to improve my laptop with an another 512 MB of Ram and I called several dealers here in Egypt & I can't find 553 MHz ram!
  So can I use 667 MHz instead of 553 MHz one?
  If not, can you advice me where I can buy it online?

  If you buy 667 MHz DDR2 SO-DIMM for your laptop, even though the memory will not work at the maximum speed of (667 MHz) it should work at 533 MHz

  memory modules are not designed to run only at their maximum speed; they could also work at a lower speed; usually at low speed they will also benefit from lower latencies (which is a good thing!)

  If you want to buy memory online, then you could try to http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=25123&ft=m&st=3
  (as a recommended Jimi scs00 in http://forums.computers.toshiba-europe.com/forums/thread.jspa?threadID=22442)

• Qosmio F30-141 - choose RAM models

  Dear all,

  I'm about to buy extra RAM for my laptop! Currently I have by default installed 1 GB model! I give you the model current installed full 1 GB and also who want to buy.

  * Installed _Currently: _ *.

  + SAMSUNG: +.
  1 GB 2Rx8 PC2-4200-444-12-E3
  M470T2953CZ3-CD5 0647

  * _Want to buy: _ *.

  + KINGSTON +.
  DDR2 SODIMM
  Capacity: 2GB
  Speed: PC2-5300 (677 MHz)
  Calendar: CL = 5
  Voltage: 1, 8V
  Memory type: Non ECC DDR2 PC2 - 5300 SODIMM
  Configurations: 256 M X 64-bit
  Pins: 200 - pin SODIMM Unbuffered

  * _QUESTION ARE THE FOLLOWING: _ *.

  -My laptop motherboard supports PC2-5300 (677 MHz) RAM? (See do you buy model above)

  -Si OUI - how it will be installed with default work? Average return?

  - Or better to buy PC2-4200 (533 MHz)?

  P.S. [Qosmio F30-141 | http://eu.computers.toshiba-europe.com/cgi-bin/ToshibaCSG/jsp/productPage.do?service=EU&highlightOption=123682&P RODUCT_ID = 123229 & DISC_MODEL = 0 #0]

  Awaiting your response on the case!

  Thnaks in advance...

  Hello

  I found a site of memory very useful.
  You will find good memory with straight plug.
  The page displays memory for Qosmio F30-140 but it of the same as the Qosmio F30-141.

  [Memory for Toshiba Qosmio F30-140 | http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=29637&ft=m&st=3]

  So according to this age, you can use the * DDR2 667 MHz (PC2-5300) 200 - PIN SODIMM * memory modules.

  Just to note: you can use modules from different manufacturers. It is only important that you use the modules that support the right specifications!

  Good bye

• I installed new memory will not successfully identify an additional memory of 1 GB (DDR2 PC2 5300 667) in my IBM Lenovo Thinkcentre desktwith Windows XP SP 3

  I installed 1 stick of memory, 1 GB of DDR2 PC2 5300 667 mhz, in the second slot of memory the computer of my IBM think Center Desktop.  On booting, the computer does not recognize the 1 extra GB of RAM.  What is the problem?

  Have you checked that your computer supports only support a lot of RAM? If it is not, it does not recognize anything on its maximum design.

  Are you running 32-bit or 64-bit? The 32-bit version cannot access a little more than 3 GB of RAM.

• Upgrading RAM on Qosmio F30-140

  Hello world
  My Qosmio F30 - 140 maximum expansion memory is 4 096 MB, but when I installed 4 GB (2 X 2 GB Transcend SODIMM 667 MHz) RAM, the operating system can it recognized as only 3.25 GB. The Bios still shows that I have 4 096 MB of RAM.
  So why Windows cannot show the size of RAM?

  Hello

  4 GB of RAM support depends on not only the operating system.

  To use the full 4 GB of RAM, BIOS, Chipset and the operating system must support the 4 GB.
  If one of the parts mentioned would not provide the capacity of 4 GB, then you would not be able to use it.

  Good bye

• Satellite A200 - 14 d: 533 MHZ front bus 667 mhz RAM equipped?

  Hello!

  I have the following problem! I bought the Satellite A200 - 14 d and on the packaging and in the shop was written with 1 GB DDR2 667 mhz RAM.
  When it came time for the upgrade, I put Everest and CPU - Z to find out exactly what to buy.

  I was amazed when I saw that my FSB 533 MHZ. The strangest thing is that RAM is really at 667 mhz, but what for?
  Now I think that's not quite legal. When I bought this laptop, I thought that it is with 667 mhz and I never doubted because it is written on the box that this computer is with 667 mhz ram!

  Please give me some advice what do I do?
  Advanced thanks!

  > was amazed when I saw that my FSB 533 MHZ. The strangest thing is that RAM is really up to 667 MHz, but what for?

  Why is it strange to you.
  This is nothing unusual. Is that you can also use 667 MHz modules! But they will run at 533 MHz due to the speed of the FSB. As I see it s clear to you.
  Always it is that there are several A200 series and some of the Satellite A200 supports FSB 667 Mhz.
  But it seems that all mobile A200 were equipped with RAM 667 MHz modules and they are certainly better than 533 Mhz modules.

  Best regards

• Satellite A100-847 does support 667 MHz RAM

  The A100-PSAA9 (A100-847) supports the 667 MHz RAM? The FSB is 667 MHz, but the laptop comes with 533 MHz RAM and everywhere that I looked for upgrades of RAM I've seen 533 MHz for this model.

  memory Finder: http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=25716&ft=m&st=3

  Hello

  It should be able to use the Ram 667 MHz module, but the difference between the 533 MHz and 667 MHz is not noticeable.
  I think the 533 MHz module is great and you are on the good side, if you use the modules to recommend Toshiba.

• Is PA3512U-1M1G 1 GB memory PC2 DDR2 667 MHz compatible with Satellite A100-847

  Is PA3512U - 1M1G 1 GB memory PC2 DDR2 (667 MHz), RoHS compliance version compatible with TOSHIBA SATELLITE A100-847?

  Hello

  Please visit the page European Toshiba under http://eu.computers.toshiba-europe.com > Products > Options & accessories

  It has listed all the compatible memory modules for your laptop model Satellite A100.

  By the way: as far as I know all the compatible memory modules are 533 MHz module.

• Can satellite A100-784 - I register at 667 MHz RAM?

  Hello

  I would change my modules of memory in my A100 - 784 (PSAANE).
  Can I apply 667 MHz RAM instead of the original (533 MHz)?

  Initially, I have 1 GB (512 + 512) DDR2 533 MHz. I put in 2 GB (1 GB + 1 GB) DDR2 667 MHz.

  Can I do it?

  Thank you very much for your answer in advance!

  Hello

  You can do it.
  The point is that the speed of the RAM depends on the bus (FSB) front.
  If the FSB supports only 533 Mhz then your modules would go only to 533 Mhz even if the modules support 667 Mhz.

  If you n t know how fast is supported by the FSB then install a tool of free diagnosis, for example; Everest home edition and check out the unique values.

  See you soon

• Is it better to have GB usable (at speed = 667 mhz) RAM 3.00 or 4.00 GB of RAM (with usable speed only 2.99 GB = 800 mhz?)

  Original title: RAM

  Is it better to have GB usable (at speed = 667 mhz) RAM 3.00 or 4.00 GB of RAM (with usable speed only 2.99 GB = 800 mhz?) I apologize if this sounds like a newbie question, but I'm not too familiar with that.

  3 GB sticks are 5300 and sticks of 4 GB 6400, if it matters?)

  Hello

  If you have Windows 32-bit instead of 64-bit so not all 4 GB cannot be used.

  As I said, download the 4 GB at 800.

  Rob - SpiritX

• New update of added value package is available for Qosmio F30-140

  Hello everyone.

  I was wondering if Toshiba had released a new version of package of added value that is compatible with Windows Vista 64-bit for Qosmio F30-140?

  To check, if Toshiba published new versions of the extra value package, drivers or BIOS, refer to the following page:

  http://EU.computers.Toshiba-Europe.com (Support & downloads)

  But, in my view, that nothing new has been posted, yet.

• Need a second drive hard "holder" for a Qosmio F30-141

  I bought the second hard drive (Toshiba 160 GB sata) for my Qosmio F30-141. There is no 'holder' (metal platform for mounting of hard disk) in the second slot. There is no "springs" protection too. How - he called and where I can buy things?

  Hello

  The hard drive carrier is available in your Toshiba dealer in your country

  Reference No.. P000457790 ASSEMBLY OF THE HARD DRIVE SUPPORT

  and you need 4 screws to fix the HARD disk and 1 screw to fix the door--:--.

  Reference No.. P000417800 TSCREW M3X4CR 4 live
  Reference No.. P000318000 M2.5X4BN 1 screw

  Note: You can Type the part number in Google and you will find many online dealers
  Kind regards

  Reaver