RAM in satellite S1410-304

Similar Questions

• BIOS resets on Satellite 1410 304

  How to reset the BIOS of Satellite S1410-304?

  Hello

  Here the instruction how to upgrade the BIOS to the latest version.

  1 extract the zip file containing the BIOS upgrade to a temporary folder.
  2. Insert a 1.44 MB diskette formatted in the floppy drive.
  3 run the *.exe extracted to the temporary folder. Follow the instructions on the screen. A BIOS update diskette will be generated.
  4. make sure that the laptop is plugged into the sector.
  5. turn off the laptop.
  6. place the floppy disk containing the BIOS upgrade in the floppy drive.
  7. turn on the laptop with the key (to the left of the space) which, depending on the keyboard layout, is located to the left of the space bar or to the right between Alt Gr and the INS from the keys. Press and hold until a short beep can be heard.
  8. If the message "ready for the update of the BIOS. Place the BIOS update floppy in the drive and press any key when you are ready to move forward"remains on the screen, check if the correct BIOS upgrade diskette is in the floppy drive and press a key any.
  9. FDD access will begin.
  10. If you are prompted with the message: "Please push the RESET switch (or turn the AC OFF power off / WE) to restart", remove the disk and turn off the system and turn it on again to restart the laptop. If the laptop turns off automatically, remove the diskette and reboot the laptop.

  Good bye

• Want to upgrade RAM HDD & on Satellite P10 - 304

  Help, please

  I have a Satellite P10-304. There is only a tiny 256 RAM and 30 GB hard drive.
  Can I put both?

  I was looking to upgrade to 2 GB ram at least and 120 to 160 GB of hard drive.
  Looked at the pc world, I know not which is compatible with mine.

  Thank you

  Hello

  Of course you can upgrade this P10.

  The RAM can be upgraded up to 2 GB and you use PC2100 DDR - RAM modules.

  I think that the laptop supports the HDD IDE ATA-5 and in my opinion, you would be able to update with 100 GB or 120 GB HDD

  Concerning

• Satellite P10-304 - memory upgrade

  Hello

  could someone tell me where to buy additional memory for my laptop?
  It has 256 MB. At the time were reading autour is better and possible to just buy a 1 GB and remove 256 and put in the same dwelling.

  Thank you any help welcomed.

  Hello

  Satellite P10-304 supports the * 200-pin PC2700 (333 Mhz) DDR SODIMM * modules.

  It seems that it would be possible to upgrade to 2 GB RAM max and that's why you can use 2 x 1 GB modules.

  Welcome them

• Satellite P10-304 - update Windows 7 problem

  I have a Satellite P10 304 to 2003 which has Windows XP, but I need to update for obvious reasons. I bought a copy of Windows 7 (32 bit) and installed without any installation problem, however I can't update Windows.

  I reinstalled, deleted the hard drive and reinstalled again. Tried the stop and start the Windows Update utility.
  Downloaded the stand-alone Windows Update.

  Updated the BIOS to V2.0 and downloaded the Toshiba Service Station application (who says no update is necessary).
  All this without success.

  My hopes were raised when I saw that the Station Service for Windows 7 32 bit software was available for the P10 304 but I am now at a loss.

  Anyone know if this laptop can be upgraded to Windows 7 and how to get updates of work?

  Help is welcome.

  Peter

  I'm sure that installation of Windows 7 update problems are not specific to Toshiba problems even if you use the Toshiba laptop.

  From my point of few, you should check the Microsoft support pages to find the solution.
  For example this:
  http://Windows.Microsoft.com/en-us/w...#1TC=Windows-7

  Just a tip: I had some problems in the past to install updates because of the antirust software. He locked the installation of some essential updates and after you disable temporal, updates could be installed...
  Missing Service Packs might concern the single installation of patches.

• Satellite P20-304 stops unexpectedly

  I have a laptop satellite P20 304 coming sometimes turns off without warning.
  The screen goes black and the power is off.

  This sometimes happens during a search, but alos is writing a letter. If not necessary a high workload for the laptop.

  Opening vents are free etc. I guess maybe an overheating problem, but wonder if this causes this kind of stop procedere.
  Also - there no poping blue screen or report failure upwards by re-start such as "the system will be re-stored after a major system crash ect.

  No idea what it could be.

  I installed Sandra Sisoft to monitor the temperature, but it only shows me no module to control the temperature,
  respectively, that it does not work.

  My warranty runs out in June, so I want to make sure that I can claim any defect prior to that.

  Thnaks for any input,
  concerning
  Birgit

  Hello

  It's not very easy to say why this laptop stops. It could be an overheating problem or a malfunction of the software. But I tend to overheat.
  Well, the problem of overheating occurs due to her malfunctioning fans or malfunction of the equipment.
  I assume that your warranty is valid, so I recommend you to check your laptop in service partner. Maybe, it can give you a good answer, why this problem occurs.

• Satellite P10-304-DVD-ROM/CD-RW questions!

  Hello world

  I own one of the original computers Satellite P10-304, which has a DVD-ROM/CD-RW combo drive. For these last months, we have one or two problems with that. It was a little skittish in which CD it reads, but in the last days he almost completely stopped read correctly (audio/data) CD / DVDs. He doesn't seem to know they are there. However, the Player opens and runs well, as if it were playing the CD, but nothing happens on the PC.

  Curiously, I then looked on the list of the system, and the DVD-ROM/CD-RW driver had an excalamation mark. Even more curiously, the pilot was called TOSIICA! DWD something or other, when I'm sure it should have been DVD TOSHIBA etc.etc. Following the instructions, I uninstalled and then tried to reinstall, but it does not appear now when I try to add hardware.

  Confusing.

  I would be very grateful if anyone has any suggestions?

  See you soon,.

  Ian.

  Hello

  It looks like a car damage registry entry.
  But that is only my suggestion. The other possibility is broken (lens calibration problem) by car.
  You say that you have already removed the drive from the Device Manager, but the peut t OS recognizes the drive again. Well, in this case one of the possibilities is to use the System Restore tool or retrieve the device with the recovery CD.
  But if the drive is broken recovery procedure doesn t help. In this case, only the replacement of the drive can solve this problem.

• Satellite P10-304 - need driver for "multimedia audio controller".

  Hello

  I had to reinstall the operating system on laptop Satellite P10-304 PSP10E ORCJM-EN, but I do not have the drivers for the hardware. I can't find the drivers for the "multimedia audio controller" on the Toshiba site:
  NES http://UK.Computers.Toshiba-Europe.com/innovation/download_drivers_bios.jsp?service=UK&mode=allMachi & action = search & teddProduct = 526 & selShortMod = 356

  All suggestions will be welcome.

  Thank you very much
  Mark

  Hello Mark

  I guess what you're missing is driver sound.
  Please also check document Setup Instructions and install all the stuff after this installation order. It is very important.

• Satellite P10-304 and recovery procedure

  Hi all
  I have a problem with my Toshiba Satellite P10-304, the problem is that I can't plant recover, it does not boot up to windows xp, so I need to recover it, in any case. When I put in the recovery of 1/2 disc it works fine. recovery comes to ask...

  '1... recover the entire hard disk.
  2... mode Recovery expert
  3... exit ".

  I choose the number one, once I kicked a a similar scree comes up saying...

  "Attention!"
  The contents of the hard drive should be removed
  1... Cotuninue
  2 Cancel... ".

  Yet once I press number one to continue. Now once I have this button the screen goes black and a message reading...

  ' GDISK (E) no Suck disk fixed - 1.
  Status
  GDISK (E) No. suck fixed disk - 1"

  Teh screen turns off again and toshiba screen flashes for less than a second and goes off again, with the words

  "!!!!! ERROR!

  Press a key to continue. "

  Once I press any key, the screen remains black with this message now on the monitor.

  "Date: Fri Aug 1 12:51:36 2005.
  Number of error: (11030)
  Message: Invalid Destination drive

  -------------------------------------
  "[PgUp] / [PgDn] [ESC].

  Once I Press esc, this screen comes up and it's been I can't go any further.

  X:\ >

  X:\ >

  It comes to have I'm stuck and can't get that much. I do not think that when recover what it is supposed to go that far, but there is, y at - it another way to reset the laptop may be a reset button on one of the panels under somewere I'm missing or batch should be thrown in the trash. Any help would be greatly appreciated and well thanks. A response as soon as possible would be great, thanks in advance.

  James

  I am sorry to say that it resembles a discarded HARD drive.

  You can boot from a floppy drive and see the HARD drive at all. If you can, then I suggest trying to format the drive in this way and then tries again.

  If this isn't the case, then you should get a new drive.

• Satellite 2410-304 s - how to access the BIOS?

  Hello!!
  I need to access the BIOS of my computer. It is of a Satellite 2410 304 s. I tried with ESC then F1 but I can not adhered.

  Thank you for all

  Hello!

  Normally, you can access the BIOS using the ESC key at the beginning upward.

  I had Satellite 2410 too and I was able to access BIOS by pressing ESC. You must press on immediately after power on the laptop.

  Check it!

• Satellite P10-304: USB does not work after the upgrade to XP Pro

  You just bought a satellite SP10-304. Beautiful machine, but comes with XP Home edition. I've updated to XP Professional but seems to have lost the USB Ports. Device Manager indicates that they are working, but plug 'all' USB devices produces no reaction/recognition.

  Any ideas, please? What I put in the recovery disc and go back to XP Home?

  Thank you

  Ian

  Have you installed Microsoft all MS on this unit?
  I recommend that you install all updates.

  Win XP Home uses the same drivers as WinXP. In this case, everything should work without any problems.

• Need drivers for Satellite P10-304

  Hi all

  I was wandering if someone could point me in the right direction.

  I bought a second hand satellite P10-304, had to replace the hard drive and operating system and now need drivers. Unfortunately the P10-304 model doesn't seem to be on the list of drivers.

  If someone could let me know what letter it is or it is a pro, etc, I would be very grateful.

  Thanks in advance

  Steverino

  Hello

  All drivers for older models of laptops you can find under http://eu.computers.toshiba-europe.com > support & downloads. But please, under product type choose ARCHIVE. In the lower corner you can find the label with the exact model number. This model number must be set to download under Model No short option page.

  If you have any other questions please post again.

  Bye and good luck!

• Satellite P10-304: the problem writing and erasing CD - RW discs

  Some need help pls. I own a Toshiba satellite P10-304 with a combo player SD-R2412 installed. When I try to burn a new CD - RW, it does ok, but wouldn't allow no other written on the same CD in another session. The written CD - RW is then recognized as a CD-ROM. In addition, it is not possible to erase the cd - rw usinig this player. When I take the cd written for my laptop office of deletion, as it's done with success and my toshiba can then burn again. Any ideas on what to do?

  Additional information: laptop computer came bundled with "drag n dro cd" but I had to install Roxio and even tried the cd writing software provided with windows XP are done everything to nothing. I checked the 'advanced system info-error log' and the report there is 'the device, \Device\CdRom0, has a bad block'; I don't know what that means.

  Cheers.

  Nthunderbolt

  Hello

  In my opinion, it's probably caused by software. In my opinion, you should remove all burning software and verify all burning functions with windows option. After deleting some software, it can happen that, in the registry editor it is a lot of waste that will not be removed completely.

  In any case, delete all the burning software, and you can also try to remove the device from Device Manager DVD. Restart the laptop and DVD should be detected and installed correctly. Try using the option of engraving of Windows and if there is still problem writing once again please.

• Need good drivers for Satellite M30 304

  I have a Satellite M30-304. I rebooted the laptop and formatted everything, including pilots. Unfortunately I have lost my CD of restoration as well. So, I tried to download it online on the official website but I downloaded the wrong drivers making my laptop more low and I can't even use my special functions of the keyboard and my screen become darker.

  Does anyone know how to download the right drivers and whence?

  Hello

  In my opinion the wrong drivers are not responsible for these problems, but of course, you should be 100% sure that you have installed the correct drivers!
  Unit you seems to be a part of the PSM30E series.

  Need to select the model of laptop and this part number in the download form. All that s

• Satellite 1410-304: how to solve the error IDE #1?

  I read on the pins of connection 45 & 47 to solve 'error ide #1' and my question...
  How to change of mode c / salt/slave differently (without connecting pins)?
  I bought liteon dvd - RW drive (sosw - 833 s 51 c) and satellite 1410 304 facility and my laptop will not work with this drive (at startup 'ide #1 error', os do not drive)

  Hello

  I'm not 100% sure but c-salt/slave can not be changed. It is factory defined essentially as slave.