Recognized device! Now not to transfer from PC to Nook

Similar Questions

• error code 19; TSSTcorp CD/DVGW TS-H652M ATA Device will not load at startup upward due to incomplete or registry problem? What can I do from here now, Windows VISTA-32 bit; gives this code problem also 00000013, thanks for your time.

  error - coded 19; involved device is CD/DVGW - TSST Corp. CD/DVGW TS-H652M ATA DEVICE. does not load at startup, nor do I have an icon E:\drive on my related 'Computer', only C and D of backup disks, since it has failed to load.  E is my player device on the windows vista operating system to 32-bit.  I tried the driver down load and FIXIT online program, they say that my drivers are repairable, but the problem is in the registry and device instructions at the beginning upward. What should I do next!

  Hello

  19 code means there is a driver conflict such as two devices attempt to use the same resources.

  Try this - Panel - Device Manager - CD/DVD - double-click on the device - driver tab - click
  Update the drivers (this will probably do nothing) - then RIGHT click the drive - UNINSTALL - REBOOT
  This will refresh the default driver stack.

  Normally the above will solve this problem otherwise working your way down through them, even if you did
  them before.

  Your CD or DVD drive is missing or is not recognized by Windows or other programs
  http://support.microsoft.com/kb/314060 - a Mr Fixit

  The CD drive or the DVD drive does not work as expected on a computer that you upgraded to Windows Vista
  http://support.Microsoft.com/kb/929461

  When you insert a CD or a DVD, Windows Vista may not recognize the disc
  http://support.Microsoft.com/kb/939052

  Your CD or DVD drive cannot read or write media - A Mr Fixit
  http://support.Microsoft.com/GP/cd_dvd_drive_problems

  CD/DVD drive does not appear in Windows Vista, or you receive this error during the installation of Windows Vista after booting from the DVD (AHCI)
  http://support.Microsoft.com/kb/952951
  Drive CD - R or CD - RW Drive is not recognized as a recordable device
  http://support.Microsoft.com/kb/316529/

  Hardware devices not detected or not working - A Mr Fixit
  http://support.Microsoft.com/GP/hardware_device_problems

  Some DVD players do not use the Windows default drivers so check with the manufacturer of system and
  manufacturer of device to see if there is a firmware or drivers for your drive if necessary.

  Hope these helps.
  Rob - bicycle - Mark Twain said it is good.

• My USB devices are not recognized, but they have a power

  My USB devices are not recognized, the only ones to be recognized are my mouse and keyboard. Each device is powered (motherboard works fine), but Windows 7 isn't their read (although sometimes I'll get a code 43). I have the latest chipset.

  I tried right click and uninstall each device and rebooted the computer. Nothing has fixed this.

  My external hard drive, ipod and other devices that involve the transfer of data seem to ONLY get power and nothing else.

  It is not material because all my devices work on my laptop. Also my motherboard works fine (it's the 2nd RMA) and it has been tested at the factory to make sure of him.

  I would really appreciate help with this

  Hello

  Please follow the methods.

  Method 1:

  Run the troubleshooter from the link.

  http://Windows.Microsoft.com/en-us/Windows7/open-the-hardware-and-devices-Troubleshooter

   

  Method 2:

  Try to uninstall and reinstall the USB controllers

  a. click the Start button.

  b in the start search box, type devmgmt.msc and press enter

  c. expand Bus USB controllers

  d. right-click on the first USB controllerr under Bus USB controllers and then click Uninstall to remove it. Repeat these steps for the entire USB under Controllers USB Bus controller.

  e. restart the computer. After the computer starts, Windows will automatically check for changes on the hardware and reinstall all USB controllers that you uninstalled.

  I would also ask you to contact the manufacturer of the computer to help.

• Now my device is not taken in charge, but the sooner he used to run.

  I want to ask that with an older version of mozilla, it allows to launch on my htc explore a310e android 2.3 gingerbread.
  But now, it does show that this device is not compatible why?
  Thank you and try to make it compatible for gingerbread too.

  Hmmm, I don't see on the list here, but the same device may have different names in different countries: Will Firefox work on my mobile?

  Android still allows installation from outside the game store? The latest mobile Installer is available here if you want to try it: http://ftp.mozilla.org/pub/mozilla.org/mobile/releases/latest/android/

• devices are not recognized

  I have a 4th generation Ipod Touch and an IPhone 4 s, and no device is recognized by my ITunes. My laptop (Windows) however recognized devices and will allow the synchronisation etc. photo.

  Anyone know what is happening and how to fix it? Thank you.

  Try the following:

  1. Open Control Panel > Device Manager
  2. Plug in your device
  3. Locate Bus USB Controllers > Apple Mobile Device USB Driver.
     It is also possible that the device may appear under imaging devices, portable devices or other devices or as a device USB of MTB.
  4. Right-click and select software update of the driver...
  5. Click Browse my computer for driver software
  6. Go to C:\Program Files\Common Apple Mobile Device Support\Drivers or
     C:\Program Files (x 86) \Common Files\Apple\Mobile Device Support\Drivers
  7. Click on let me pick from a list of drivers for devices on my computer
  8. Click on Apple Mobile Device USB Driver
  9. Click Next, then close and exit the Device Manager

  Or try If iTunes does not your iPad, iPhone or iPod - Apple Support.

  If not try a complete tear down and rebuild iTunes in accordance with the resolution of the problems with iTunes for Windows updates.

  TT2

• removable usb device is not recognized by windows

  my camera and GE multi card reader no longer recognized by windows.   in the Device Manager is no longer visible. I plug it into the computer and nothing, no sound connection and no autoplay more. This is due to an update. also install adobe air appears as damaged when starting computer installation. all I want to do is load the holiday pictures to my laptop as I have always. but now nothing. all ideas

  Hello

  1. What is the brand and model of your computer?
  2. What is the version of Windows installed on your computer? For example, Windows 7, Windows Vista.
  3. this happens with all USB devices?

  4. have you done any software or hardware changes on your computer before this problem?

  You can run the fixit mentioned in the following link.

  Method 1:

  Hardware devices do not work or are not detected in Windows
  http://support.Microsoft.com/mats/hardware_device_problems/en-us

  Method 2:

  I suggest you to update the chipset drivers and other drivers on the manufacturer's Web site.

  In addition, you can search the hardware changes in Device Manager and check if it helps.

  In addition, I would ask you to answer these questions and add additional information so that we can guide you in the right direction.

• Wireless device does not work after downgrading from Windows 7 to Windows Vista.

  Original title: wireless device does not.

  recently, I got my os from windows 7 to vista, now my wireless device does not work. I checked the Device Manager and the report shows that my network controller driver is not installed and the modem on high definition audio bus device. I tried to install it, but in vain. What should I do?

  If your computer manufacturer does not have Windows Vista drivers available, you're probably out of luck.  Without drivers for these devices will not work.

  'spyc' wrote in the new message: * e-mail address is removed from the privacy... *

  recently, I got my os from windows 7 to vista, now my wireless device does not work. I checked the Device Manager and the report shows that my network controller driver is not installed and the modem on high definition audio bus device. I tried to install it, but in vain. What should I do?

• Bluetooth can not receive files from other devices

  I use windows 7 ultimate 32 bit on dell vostro 1510. It uses the bluetooth 360 module dell wireless. Bluetooth of my laptop has no problem when sending files, but during the reception of files, the connection is lost to halfway. The error that says "Windows could not transfer files. "The transfer was canclled by bluetooth device or computer compatible bluetooth. And this error is the same for all devices I get files from. And Yes, I have re-installed driver bluetooth several times.

  Hello

  Follow these methods and check if that helps:

  Method 1:

  Make sure that the Bluetooth services are running on the computer. To start the Bluetooth services follow the steps below:

  a. click on start

  b. type Services.msc and press enter

  c. in the list find Bluetooth support services and double click on it.

  d. make sure that the service is set to automatic and started.

  Method 2: try to run the hardware troubleshooter and check whether the problem is resolved or not.

  Open the hardware and devices Troubleshooter

  Method 3:

  Try to run this Microsoft Fixit and see if it helps:

  Hardware devices do not work or are not detected in Windows

  http://support.Microsoft.com/mats/hardware_device_problems/

  Also try to follow the tutorial video on the links below and check whether the problem is resolved:

  Connect to Bluetooth and other wireless or network devices

  Add a Bluetooth device to your computer

  Change settings for a Bluetooth compatible device

• BlackBerry Smartphones Emails sent from the device is not displayed in the "sent"box and "BIS" question

  Dear all and Rim:

  New to the BB world, need more help...

  AOL mailbox to connect with 'Tour' with success, the service provided by Verizon.

  Emails sent from the device are not show to AOL "Sent Box" or "IMAP" Outlook Express / outgoing server "POP" record "SMTP."

  Really need copies of "Sent Box", thanks for the help!

  Also try to put in place 'BIS' accout, error message says:

  "Your account is not accessed through a browser HTML...".

  Please use your device to access the Black Berry Internet services"

  I used this link:

  https://bis.na.BlackBerry.com/HTML?brand=VZW

  Thank you,

  Jan

  For the mail issue seems to send me a copy is the only way to go, right?

  This would be a solution.

  And on the BRI, my test was on a PC, it did not work...  Anyway, I was going to connect to the BIS to work on my question above, but seems that it does not help now, then it does not matter if I enter or not.

  Well, it's quite strange... I just used who link me (from a PC) and get my BIS account very well. You can, however, use the interface for device BIS - watch this demo that I you provided above for instructions on this. BIS is simply a service provided by your operator. The PC/Web site method and device interface - these are simply two different interfaces in the same Department, so using one or the other is not serious... they cause the same thing.

  Good luck!

• my iphone 6s is stolen I had activated find my iphone, but now the device does not appear on my icloud find my iphone please suggest what to do.

  my iphone 6s is stolen I had activated find my iphone, but now the device does not appear on my icloud find my iphone please suggest what to do.

  If your iPhone, iPad or iPod touch is lost or stolen - Apple supports

• My notes have disappeared from all my devices

  Hello all,.

  My notes have disappeared from all my devices. How to recover. I also accidentally deleted a backup to iCloud. When I tried to restore the notes were not there to restore

  Have you checked the file 'deleted recently? Deleted notes are stored there for 30 days before it will be automatically deleted.

• About to transfer from Windows to Mac. Need tips and tricks regarding the transfer. That ExtHD does not need reformatting?

  Transfer from Windows to Mac. Need advice on the brand and model of HD Ext for compatibility which will not need reformatting? Advice welcome.

  If you want a HD post to be read by windows and Mac OS. The best choice would be the format ExFAT.

• USB 2.0 devices are not recognized on Satellite L

  Hello

  All of the usb 2.0 device is not recognized on my laptop.
  I got a message stating that the driver are not installed. I'm looking for the driver on the support site, but could not find them...
  I've updated the bios and chip set utility, but still nothing.

  Any idea?

  Hello

  What model of laptop do you have?
  What operating system do you use?
  Since when you noticed this problem?
  Did you test all USB ports?

  Have you tested with different devices USB ports?

  Please post a little more information.

• Want a Smart Touch 23-065: I've upgraded to Windows 10 and now my bluetooth devices do not work

  I have a Smart Touch 23-065 envy that I have upgraded to Windows 10 and now my bluetooth devices do not work. They are detected, but not pair

  OK, line background peripheral bluetooth is not supported until the vendor provides a Windows 10 driver which is not yet and my never be available. Suppose if I want to use bluetooth, I'll have to get a usb adapter

• niDMM.cs exception: "the device was not recognized. The device is not supported with this driver or version. »

  Hi all!

  I have a question about using a DMM (PXI-4065) with VStudio 2008 and Measurement Studio 2009.

  Because DMM are not always supported in .net, I downloaded niDMM.cs 3.0 wrapper of the web site of NOR.

  I also downloaded example c# measure DC Voltsto compare with my request.

  Both an example and my application fail trowing the exception [-1074118656] 'the device was not recognized.  The device is not supported with this driver or version. " class constructor is called.

  DMM = new InstrumentDriverInterop.Ivi.nidmm ("PXI3::12:INSTR", true, true);

  I guess it is function of device PXI!

  I also tried to use a VISA alias as "pippo" and then I tried to insert a device unexistent name. In any case the same exception was trown.

  NOR-DAQmx 8.9.5

  NOR-DMM 3.0.1

  NI-VISA 4.6.1

  NOR-MAX 4.6.2f1

  Roberto

  Hello Robson,

  Maybe you areusing an incorrect descriptor itrument, try please the instructions contained in the following document:

  KB 33A96PCW: receive error-1074118656 when running OR DMM screws

  Let me know if this might help.

  Best regards.