Tecra A2 power led flashing

Similar Questions

• TECRA 9100 - power light flashes and won't start system

  my laptop does not start - all I get when I push the power on button is the power LED flashes on the following sequence. S-S-S-S-L-L-L-S (S = SHORT, L = LONG)
  ANYONE KNOW WHAT THIS CODE MEANS.

  The only thing I could have done was to put a (b8 that is 12mm) screw in the network card lock switch slot on the bottom of the laptop that says MAX 4 mm.
  Any information would be appreciated to [email protected]

  Hello

  This is unfortunately no public document on the explanation of these hexadecimal codes and I can't tell you what that means exactly. The fact is that electronic power supply has detects some malfunctions and sends the code.

  Sorry, but I don't believe that you can do something alone. Try it please contact the customer Service of your country partner and explain the situation.

• HP mini 1109tu does not illuminate and has its power led flashing

  Well I just got my Bill Mini of the day the following day and while they were inspecting it this morning the power led flashes and it won't turn (even on the battery mode).

  [IMG] http://i168.Photobucket.com/albums/u171/Arnaehl/img_96221_hp-1000.jpg [LINE]

  Will or may someone help me solve this. I can't bear to look at my dead minis.

  Thanks in advance.

  HP mini 1109tu

  Hello

  Arnaehl wrote:

  Well I just got my Bill Mini of the day the following day and while they were inspecting it this morning the power led flashes and it won't turn (even on the battery mode).

  [IMG] http://i168.Photobucket.com/albums/u171/Arnaehl/img_96221_hp-1000.jpg [LINE]

  Will or may someone help me solve this. I can't bear to look at my dead minis.

  Thanks in advance.

  Try a hard reset.

  Disconnect the electric plug. Remove the battery.

  Press and hold the power button for 15 seconds.

  release the power button.

  Plug the AC adapter.

  Press the power button.

  Best regards
  ERICO

• Tecra 9000 - DC led flashing light 01001110

  I have a problem with my laptop, it's a Tecra 9000. When I press the button start power
  Tour LED from yellow to orange. Then the LED flashes 8 times. SLSSLLLS = 01001110. Peut
  can you tell me what this error code means?

  Thank you for all your answers

  Post edited by: fanatic

  I solved the problem by connecting the 2 PCBS together.

• Tecra A8: Power led blinks orange twice and does not start

  trying to turn on PC toshiba laptop tecra a8. the light on the power button flashes two times once green and orange and it won't start.

  any suggestions?

  Hello

  It seems that there is a hardware failure.
  The flashing LED provides a microcode of dysfunction. The short flashing 0 flashing medium-long and 1.
  The full code can be read by a maintenance technician, and the reason for the failure could be found very easily.

  But before you contact the ASP in your country, I recommend trying the suggestion given by Robin.
  Remove the battery and unplug the AC of the laptop. Then wait a little (15-20 min) and then connect everything again. Then check if the laptop starts.
  SE not-> ASP.

  Good luck

• Portege R100 stoped working - the power LED flashes error codes

  I have a R100 that has suddenly stopped working.
  The power led (clear amber with the image of the power wire) flashes what appears to be an error code of 5 flashes with a long pause on the last flash, followed by 3 flashes.

  That - what it means, and where can I get a list of all codes error?

  I changed the main battery, changed the spare battery and changed supply - and again, I get the error permanently. I was not able to power the laptop at all since it started. When you press the power button / nothing happens.

  I hope someone on this forum has some information that may help you diagnose this problem. Tech support representatives Toshiba post here?

  Thanks in advance.

  Hello

  I m not a R100 owner but to me it looks like a card mother malfunction because you have already tried to exchange the battery and the AC adapter.

  In this case, the best solution would be if you go to an authorized service provider. Technicians can consult the specifications and they know what means this code I think.
  Here it s only a user to user forum and I have never seen anyone from Toshiba again.

  Anyway, here you can search for the nearest ASP:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported downloads & => find an authorized service provider

  Good luck!

• IdeaPad U310 tactile power led flashing

  Hello

  I just noticed that the power led of my touch u310 flickered continuously. The led on the power button also flashes constantly. The flashing happened even after I shut down the computer. The only time wherever the lights flash when I disconnect my ac. Anyone know what could be the cause of the problem?

  Thank you

  It turned out that I disabled the smart update of lenovo and my problem went away.

• HP Jet 11: 11 flow does not illuminate. Power led flashes 3 x

  I am trying to fix a 11 HP flow for someone and I'm running into some issues here.  Basically, the computer does not light and the power led blinks three times.  I did all the options to reset that I could find online, and the power brick works.  The person said that she may have fallen, so I think this has something to do with that don't turn only not on.  No idea what the three blinking lights could mean in this case?  Thank you.

  Hello

  Flashing codes mean.

  1 blink = CPU does not

  2 flashes

  -L' laptop can load if given enough time.

  -If the laptop starts to load, try to start the BIOS of several times the ESC key until the Start Menu appears. Press the F10 key to enter in BIOS

  > Started the laptop?

  -Yes. The laptop started

  -No, the laptop is not started. At the moment, it seems that the BIOS is damaged.

  3 flashes = Module of Ram error

  4 flashes = failure of the graphics card

  5 flashes = hardware failure

  6 flashes = BIOS authentication failure

  I hope this helps.

• the G7 1113eo lights. Power led flashes 3 times pls help

  Hello, im hoping someone can help me, I have a 1113eo of the g7. that does not start. the battery has been dead for a while, but his works well with just the adapter. But yesterday it no longer starts, I tried to do the hard reset (remove battery and hold the power button for 15/30secs) but who did not work, so I started to disassemble that he virtually stopped when I discovered that I didn't have a screwdriver. then press the button power again just to check, and the pc started. a stroke of luck was good cause I tried to restart and it started again.

  whenever I press the power button, the little led next to the power supply, flashes 3 times. No its or other led´s flashing

  Please help me

  (ps the warranty is no longer valid)

  Hello

  It is certainly not good if you are able to check the adapter - my main concern, as you was able to get the laptop to start only once, is that this may also indicate a possible problem with the power supply Board.

  Kind regards

  DP - K

• Pavilion a1130n block of POWER LED flashes when it is connected to the mobo

  We had a power outage and now PC won't start at all and power and power supply lights both blink.  I went through the list of power supply.  When everything is unplugged PSU led remains lit.  When I plug in the mobo light starts flashing again.

  On another forum, someone suggested clearing CMOS as check/solution possible, but I've seen suggested once on all of the controls/solutions out there.

  Should I try clearing CMOS or who would really do something to help here?

  Also, I am trying to determine the most cost-effective path of repair/replacement.  The main consideration for me is software and data on the hard drive, I would really like.  I know that the machine is old so I'm thinking the mobo may need to be upgraded in any case of 6 years and the PSU, should probably due to his age and the likelihood it will fail before too long.

  Any guidance is appreciated.

  lardfw wrote: I deleted CMOS (using the pull method) and there is no change. Well, I understand that it was a long shot. I followed the checklist (do not skip steps).  I was a little fuzzy on the checklist is should I go ahead and take memory cards and disconnect the headset, microphone, usb ports, etc to the MoBo? During the only thing connected to the PSU is the MoBo.  Nothing connected to the PSU = green fixed.  Connected to the power supply flashing green = MoBo. So my concern is passed: the hell of the MoBo or PSU is (because I'm buddy up to the idea that it is).  in order to use the hard drive in a new configuration (specifically the software and data on the hard drive).

  Hello lardfw, with nothing connected to the motherboard and you try to start the system, if the motherboard was not defective, with the power supply work as it should, you get all kinds of sound signals, especially when the memory is removed.

  I'm sure that the motherboard has failed. You should be able to remove the hard drive and install it into another system such as a secondary drive and not the bootable disc and be able to copy some files from the hard drive. You would not be able to access the applications.

  Once you have recovered all the data you may be, you could then reformat the hard drive and use the total capacity of the disk as a backup, or even use it as a bootable stick with a new operating system installation.

• Re: Power LED flashes on Satellite A200

  My laptop A200 seeing power just flashes no pwer to the system, place a new battery, power supply output is 19volts.

  If the power light blincks she sends a flashing code. In other words, there are a few detected probem and its flashing code sends mit code to identify the problem with technicans.

  Therefore, it is recommended to contact the nearest service and ask for help.

  By the way: If the same thing happens with AC power supply and removed the battery?

• what it means if the power LED flashes red, that I am plugged into the power outlet

  help what is a flashing red light on average power

  Yes, the batteries in laptops are like any other rechargeable battery, they have a life cycle. Since the bits of information so far, it sounds as if you do not want to replace the battery. You can see what is essentially a stack to the page linked below:

  How to replace your laptop battery
   http://www.Dummies.com/how-to/content/how-to-replace-your-laptop-battery.html

  What I would say has visited support site for the manufacturer of your laptop; using your specific model name/number search for laptops support page. You should be able to get some type of documentation that will explain the flashing red light. Also get the specifications for the battery of your specific model (see technical data). Though on checking support site for the manufacturer to see if they have their own forums, if so you may be able to find details about the light, and what is involved in the specific battery in your laptop.

  Computer manufacturers
   http://Windows.Microsoft.com/en-us/Windows/help/contact-support/computer-manufacturers

  Kind regards

• Tecra 9100 don't start - power suplly LED flashes

  Hi all.

  I have a problem with a laptop Tecra 9100. When I push the button start the suplly power LED flashes orange for eight times to make a quick stop in flash 2 and flash 8. Can someone explain to me this error code is this?

  Thank you for all your answers

  Hello

  If electronic power supply detects that some portable problem send a blink code. This code allows you to identify the problem. I can't tell you much these codes, but what I know for sure, is that you need professional help.

  Please contact the service allowed in your country and explain the problem that you have.

• Satellite A200-1ZF starts not flashing power led

  Hello

  Today, my laptop Satellite A200-1ZF wouldn't start, instead, my power led flashes orange-orange-blue-orange-orange - blue and so on and so forth.
  The HDD led transforms the blues when I turn on the computer and seems to work fine (I hear the normal sound of market from the HARD drive).
  I tried to remove the RAM module to see if there is a fault in one of the modules, no help. I tried removing the battery and it works only on current alternative, also no help.

  Anyone have any idea?

  Hello

  I'm a bit confused of m.
  If I understand you just your laptop starts up but screen is black or how figure you?

• Power light flashes

  I have a late 2009 Mac Pro, that will not start and the power LED flashes continuously. I tried all the different buttons start without success.  Any suggestions?

  This error code means that there is not enough RAM to work.

  When yo get that open the side cover and search lights lit by strips of RAM