VLAN Tagging (VST) and VLAN native on the same vswitch

Similar Questions

• a vSwitch does support internal traffic between the VLANS configured on the same vswitch?

  Hey gurus - I know that the virtual machines on the same port group will communicate internally - but a vSwitch will support internal communications between virtual machines on different VLANS configured on the same vSwitch?  Looking for definitive answers only.

  gman

  Welcome to the MSFN - no traffic is not internal when communicating through different VLAN-

  If you find this or any other answer useful please consider awarding points marking the answer correct or useful

• VMkernel and Service Console in the same vSwitch?

  Hello

  Be aware that this may have been covered elsewhere (and I should be grateful if you would be redirected to the correct answer), but I need clarification on the installer to our servers ESX 4.1. I have a switch virtual vswitch1 with webcam live and test port groups running through a NIC 4 etherchannel trunk to a Cisco switch stack with load balancing of the IP Hash for our virtual machines (works fine).

  Due to limited network adapters, I wanted to know if I could have the VMKernel (vmotion) and the Service Console on the same virtual switch (vSwitch0) but separated by VLAN ID in 2 groups of ports, run through an another etherchannel to our Cisco switches (mounting similar to vswitch1 etherchannel trunk). Are these two functions OK on the same vSwitch?

  I say with this configuration, we will have redundancy with 2 network cards in vswitch0 and traffic will be isolated between the SC and vmotion with VLAN. Im not sure if best practices should have the VMkernel SC on separate vSwitches, or even if the VMkernel and HC would work even as a separate Exchange with an ID vswitch1 VLANS separated to release 2 network cards.

  As a result, I read elsewhere, that a default installation with a switch distributed (that we want to use in the near future) would use a dvSwitch for VMs and a vSwitch for SC and functions VMKernel, separating them, so at this point would be a good idea.

  Any advice would be welcome.

  Thank you

  John

  When I have 2 NICs for network management and vMotion, I use usually 1 vSwitch for them. I configure ports of physical switch as connection ports (no etherchannel), set the VLAN ID on port groups and configure groups of two ports for active / standby. For example, the management network has active vmnic0, Eve and vMotion active vmnic1 vmnic0 a vmnic1, as yesterday. In this way each "service" uses its dedicated uplink unless there is a failure.

  BTW, you should consider installing instead of ESX ESXi, ESX 4.1 is the latest version of ESX. ESXi will only be available in the future and transition from ESX to ESXi requires a fresh install of the hosts.

  André

• use java edition and edition of native at the same time in a single java application

  Hello
  
  I have a situation where I need to use both versions of berkeley Db at the same time. I have an external library that I use and which requires the Java edition and my own code which uses the native version. Unfortunately, the library source code is not available and I don't want to see my program to use the Java edition.
  
  Some packages in je.4.0.103.jar and db.jar (version 5.1) contain the same naming structure and classes for example. com.sleepycat.persist.EntityStore. I removed the packages duplicated in je.4.0.103.jar however, it seems that the implementation is slightly different between the two versions I get
  
  java.lang.NoSuchMethodError: com.sleepycat.persist.EntityStore. < init > (MBCA/sleepycat/I/environment; Ljava/lang/String; MBCA/sleepycat/persist/StoreConfig ;) V
  
  When I had just two available versions my code for the preserved native version using the packets from the Java edition and an external library maintained on the use of the native version and therefore I had loads of errors.
  
  So how I differentiate them. The problem is because the two sets of packages have identical names and the names of classes for Java does not know which ones to use. I use eclipse then maybe there is an option where I can say that some classes to use some packages.
  
  
  Any ideas?

  Hello

  We do not officially support using BDB and BDB I from the same JVM process.

  It is possible to circumvent this limitation by creating two [url http://download.oracle.com/javase/1.4.2/docs/api/java/lang/ClassLoader.html] Chargers of Java classes which load a file two jar. When you call BDB or BDB I methods, the call should be put in brackets with calls like this that cause the correct class loader to use:

  ClassLoader saveLoader = Thread.currentThread().getContextClassLoader();
  Thread.currentThread().setContextClassLoader(/* specify correct loader for BDB or BDB JE here */);
  try {
     // do something with BDB or BDB JE
  } finally {
    Thread.currentThread().setContextClassLoader(saveLoader);
  }
  

  We are not experts in the field of chargers for custom classes and we do not have an example of this. We don't him did not ourselves, we know only that users have done.

  I hope this helps.

  Kind regards
  Alex Gorrod
  Oracle Berkeley DB

• Is it allowed to use the name of the alt and title all at the same time in an img tag?

  Just a quick question of simple semantics/syntax.

  I have an image file, and after some research, I discovered the difference between alt and title. However, I still don't know if it's good practice to use all or an attribute and name them all the same thing.

  "" for example < img src = "... / nsd/sdg.jpg" alt = "a pic" title = "peaking" name = "peaking" >

  It would be the good use of the use of attributes, including about crawlers like google?

  Thanks Dreamweaver forum, people are so great and very helpful. -I am committed to helping others when I can, too.

  Sam

  The image alt attribute is for the accessibility of the web. He picked up some screen readers & displays in browsers when the image does not load.  To all intent & purpose, alt attributes are not important to the search engines.  If that is your goal, use a

• I forgot my password for apple and have permission to stage the 2 and broken my old phone and do not have the same number of what I can do my account is already waiting to be reset, but it takes apple long to to deal with the what else is there to do?

  I forgot my password for apple and have permission to stage the 2 and broken my old phone and do not have the same number of what I can do my account is already waiting to be reset, but it takes apple long to to deal with the what else is there to do?

  You know the e-mail password what do you use? I lost over $ 30 on my old Apple ID because I couldn't get into the email and apple would not transfer my money to my new account.

• Should I iMatch and music Apple at the same time?

  Is there a point I iMatch and music Apple at the same time?

  These are two different services > iCloud library: understand the differences between music from Apple and iTunes game - Apple Support

• Why I have Photo and Photos open at the same time?

  Why I have Photo and Photos open at the same time?

  When what's going on?  When you connect a camera or a card reader?

  Or after the Mac is restarted?

  If this occurs after startup, check system preferences > users and groups.

  Select your account and open the connection. Deselect the applications you want to open at startup.

  If this happens when you connect a camera, open the iPhoto preferences > general.

  Set the preference "Connecting camera opens" to "no application".

• I made my largest site and how can keep the same size for all other sites?

  I did the 2 larger site and how to keep the same size for all pages when I re - open the web browser?

  You can use an extension to set a page zoom and the size of the default font on the web pages.

  • Default FullZoom Level: https://addons.mozilla.org/firefox/addon/default-fullzoom-level/
  • NoSquint: https://addons.mozilla.org/firefox/addon/nosquint/

• can I play the guitar and midi keyboards at the same time?

  IM using the 3 main stage, I would like to play guitar and midi keyboards at the same time. I know that I can have more than one keyboard will at the same time, but I can't understand how to play the guitar too. I use a core Alesis 1 plug the guitar and a Keith McMillen 12 Step midi controller, he reads both just fine alone, but they play together. How can I get there? In addition, Im using a MacBook Pro OS X El Capitan.

  Thank you

  Mike

  You add a bunch of audio channels and affect the Core 1 Alesis entry?

  

  

• I get an error message Firefox is already running. I rebooted and redownloaded the program and continue to receive the same message

  Question
  I get an error message Firefox is already running. I rebooted and redownloaded the program and continue to receive the same message

  See:

  • https://support.Mozilla.com/kb/Firefox+is+already+running+but+is+not+responding
  • http://KB.mozillazine.org/Profile_in_use

• Satellite A200 - 14 d - i.LINK and FireWire - it's the same thing?

  Hi, guys :)

  Well, I'm about accurately - and a new external hard drive My Book by W * digital Stern (the Studio Edition with 1 TB of storage).
  So I have a Toshiba Satellite A200 - 14 d. I read in the manual to my laptop it has port i.LINK (IEEE 1394-a).

  Ext.hard My Book drive has FireWire 400/800. I read on the internet that FireWire and i.LINK are the same for the IEEE 1394 standard.
  They're just different names. i.LINK is by S * ny and FireWire is by Ap * the Inc. Because I'm not sure I would ask here: if I connect an external device (in my case - ext.hard drive) which is supposed to be with the ability to connect via FireWire 400/800 to my laptop i.LINK port, there will be a kind of incompatibility?

  Thanks in advance!

  Hello

  Yes, i.Link, firewire or IEEE 1394 has the same meaning. ;)

  See this Wikipedia article on firewire:
  http://en.Wikipedia.org/wiki/FireWire

  Welcome them

• I used to write in two languages (English and Italan). When I use my Mac, it's easy: I just change the language, and my keyboard is the same (i.e., International English). What I use my iPad pro, instead, he also spends my hardware keyboard.

  I used to write in two languages (English and Italan). When I use my Mac, it's easy: I just change the language, and my keyboard is the same (i.e., International English). What I use my iPad pro, instead, he also spends my physical keyboard, so that for example if I type [keyboard I get an e. It is very annoying and makes the keyboard quite useless. Keeping fixed language I would get bad suggested words.

  You will need to define your physical layout being the same for English and Italian in settings > general > keyboard > keyboard > keyboard material

• I was using my MacBook today and it crashed and the dock turned silv, I restarted the mac and it was always the same, then I loaded the disk utility and checked the disk and it says disk is fine. It flashes inconsistently gray and the dock turned

  I was using my MacBook today and it crashed and the dock turned silver, I restarted the mac and it was always the same, then I loaded the disk utility and checked the disk and it says disk is fine. It flashes inconsistently gray and the dock has transformed money! I tried to restore Mac OS and then also the same!
  OS El Capitan

  This can help:

  Reboot safe mode (it is a slow process):

  -stop of the mac

  -Start up the mac in shift, press and hold until you see appear it to progress bar, so you can let go

  -When everything started, connect

  -Once connected, stop the mac once again, nothing else is necessary.

  -restart normally.

  Lex

  PS: This clears all system caches.

• Hello everyone! I need an application where I can hand write or type and draw, all in the same...

  Hello everyone! I need an application where I can hand write or type and draw, all on the same page,.

  I'm taking courses in biology and chemistry and sometimes I need to draw and explain

  Can someone help me?

  Thank you!

  I need an application where I can hand write or type and draw, all on the same page, I'm taking courses in biology and chemistry and sometimes I need to draw and explain

  @manuelito.castro,.

  Discover the "Mobilenoter" application, that includes the possibility of ink in free form. If you need to be able to classify and organize your writings, Mobilnoter works perfectly with a single Note.

  -Doc