VMware ESX does not recognize the local RAID volume

Similar Questions

• PCMCIA card does not recognize the connection to the local network on Satellite Pro 4340

  Hello world

  I have 2 Satellite Pro 4340, running Win2K, SP4. I bought a card PCMCIA 10 / 100MB of Ultron (more or less no name :-))

  When you insert the card, Win2k recognizes the card, but when the I plug the network cable, it does not recognize the connection. Cable is fine. It seems there is no power on the PCMCIA card. I read on some forums that there is a problem with the Topic100 Card Bus driver and voltage. I see that many people have the problem but not where to find the driver for the problem :-/ I couldn't find a driver on toshiba support site. A

  ll have an idea, or better a link where I can download this driver? Any help is appreciated and thanks in advance for your help, support and answers.
  Corey

  If this card needs a driver you will not find it on the download page of manufacturer of portable. You must check the card producer site.

  As you know in the world of computers, it has set different standards. Produced very often cheap are not designed for these standards, and you can have different problems. I recommend you to use high quality products.

• Satellite M50-A-110 does not recognize the new SSD?

  Hello

  I bought the M50-A-110 model and tried to replace the HARD drive by a Pro 840 Samsung SSD. The laptop does not recognize the SSD drive, so I sent him to the local Toshiba service for inspection.

  They discovered that the laptop does not recognize ALL of the latest SSD (they tried to Samsun, Intel, Crucial, Kingston and SSD Seagate). They checked, and I possible newer BIOS, so this isn't a problem, and the SSD worked fine on other computers.

  Someone knows how to solve this mess?
  Toshiba has a BIOS beta I could try?
  Any other ideas would be welcome.

  As a user of long date Toshiba, I must say that I am a little disappointed. I mean I work in it, and this is the first time that something like this happened to me with a new product.

  Hello

  I can't believe that Satellite M50 - A can not handle any of the mentioned SSDS.

  I upgraded my Toshiba laptop with SSD Pro 840. But before I did, the update of the firmware of SSD was necessary. Before the firmware update, the SSD has failed, after the firmware update, BIOS can handle the SSD.

  I would recommend to check the SSD for the firmware update!

• Tecra S3: Installation of Vista does not recognize the HARD drive

  I try to install Vista Ultimate on my Tecra S3, but installation does not recognize the HARD drive.

  I tried to find the driver for Vista for my computer, but not found RAID.
  Tried it with XP drivers, but no longer works.

  Do you have an idea where I can download Vista drivers for RAID?

  THX

  Hello

  Your suggestion is good. The Tecra S3 supports the RAID, and the RAID driver is required to install the OS on the HARD drive.
  On the European driver Toshiba page I found a RAID for XP driver.

  I put t know if this driver will run under Vista, but I recommend to test.
  The RAID XP 1.3.8.0 driver version can be downloaded from this site:
  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/download_drivers_bios.jsp?service=EU

  Please note; You can store the RAID driver on an external USB and Vista should recognize it!

  Good luck

• Satellite A110-294 does not recognize the wireless card

  Hello

  the question is:
  Why my Satellite A110-294 does not recognize the wireless card?

  I re - install Xp PRO with all the drivers.

  I have try all the drivers Wireless: Wlan intel + proset intel atheros wlan + wlesscmgr

  I don't understand, can you help me?

  Thank you
  André

  Hello

  To my knowledge, the A110-294 uses the Atheros WLan card and therefore the Atheros Wlan dirver should be the right one.

  You can find the latest driver for Atheros WLan here:
  http://APS2.toshiba-tro.de/WLAN/

  Just a question;
  You see the local network card in Device Manager? I mean, you should see an Ethernet controller or an unknown device in the network adapters
  The driver is missing, then the device must be marked with a yellow exclamation point

• Samsung kies does not recognize the phone on Windows 7.

  I bought a Samsung Galaxy s smart phone III. I installed their Keis software and drivers. The software does not recognize the phone.

  Origianal title: kies program incompatible with windows 7

  Hi Blueshockey9,
  Thanks for posting your question in the Microsoft Community Forums.
  You have a problem with Samsung Kies recognizes not the phone. It can be difficult when something that is important to you does not work as expected. It's pretty simple and we're here to help you solve the problem. We work as a team and get this sorted out.
  
  Please answer these questions-
  (1) did you try to install the software on another computer (running the same operating system)?
  (2) did you do changes on the computer before the show?
  I would like more information about the issue.

  Method 1-

  Samsung kies is compatible with Windows 7.

  Check out the link-

  http://www.microsoft.com/en-us/windows/compatibility/win7/CompatCenter/ProductViewerWithDefaultFilters?TempOsid=win7&Locale=en-us&TextSearch=samsung%2Bkies&Type=Both&CurrentPage=0&TotalPages=1&ShowCriteria=0&SortCriteria=Relevance&Compatibility=Unknown&LastRequested=14

  Method 2-
  You can try to Uninstalland reinstall the software. Check if this is useful.
  If the problem persists, I would have you contact Samsung for help.
  Check out the links-
  http://www.Samsung.com/us/support/SupportOwnersFAQPopup.do?faq_id=FAQ00029012&fm_seq=29180
  http://www.Samsung.com/in/support/usefulsoftware/Kies/JSP
  Let us know if you have other questions related to windows. We will be happy to help you. We at Microsoft, strive for excellence and provide our customers with the best support.
  
  Thank you.

• PIX 515 does not recognize the DIMM 128 MB

  PIX 515 does not recognize the DIMM 128 MB. Won't recognize only 32 MB. Also when the upgrade to 7.0, I get an error message that it has not enough flash, but I have 16 MB of flash needed.

  PIX 515 not recognizing 128 MB may be due to, in my opinion, pix-515 supports 64 MB. PIX-515e can support 128 MB. Now error Pix by reading not enough flash I got the same message when I tried to load 7.0 release using the tftp with padding interface configured to the local network with an attached TFTP server segment. I then tried the interruption during the startup control method, once the PIX reached ROMMON > issue 'auto of e1 interface', 'address 10.0.0.1', server 10.0.0.2, there are a few other commands. You may be familiar with them, otherwise use find under cisco.

  HTH

• Install Windows 8 does not recognize the system drive

  I built a new machine (chart below). Since this is a new machine and not an upgrade, I bought Win 8 Pro 64 bit OEM to do a clean install. The SSD is my system disk that Windows 8 will be installed. Four data drives are mirrored, two for the other two. Construction went perfectly. The BIOS recognizes all six disks: 1 SSD, 4 HDD, 1 DVD.

  Insert and boot the disk of Windows 8. Accept the EULA, enter the product key. Arriving at the page "Where do you want to install Windows?", only four hard disks are listed. The SSD (installation to go) is not found by Win 8. ??? I tried to change ports SATA, cables, power supply - no difference. For each new change of hardware, the BIOS still sees everything. This isn't a hardware problem.

  The question remains: why the installation of Windows 8 does not recognize the SSD drive. All five disks are on AHCI. I'm not in RAID.

  I spoke with crucial technical support of all (manufacturer of the SSD). They were also surprised that the drive does not appear in the list.

  Does anyone have a solution? I spent all the money on hardware, as well as the new version of Windows and I cannot install it.

  This is the real kick in the teeth: Microsoft won't support me. The OEM of Windows 8 version is the same as manufacturers, such as Dell or HP. Support told me I had the support of the manufacturer. HA! I am the manufacturer. Either that or upgrade from an earlier version of Windows. This means that any that a new construction machine will get ZERO assumption of Microsoft. All just great.

  Thank you in advance for any assistance.

  Windows 8 Pro 64-bit (full version) - OEM
  Intel Core i5 - 3570K
  Card mother GIGABYTE GA-Z77X-UD5H
  Crucial Ballistix 2 x 8 GB DDR3 1600
  Crucial M4 2.5 "128 GB SSD (system disk)
  WD Green WD30EZRX x 4 (data readers) 3 TB drive
  Rosewill Challenger-U3 ATX Mid Tower Case
  SeaSonic M12II 620W 620 Bronze PSU
  ASUS DVD writer

  The DSS must be LOW LEVEL FORMATE.

  Once, there may be no other [HDDs] not connected to the SATA ports.

  Install Windows 8 Pro now.

  [Edit] Can someone please mark this as answered? I can't because I posted the question. Thank you.

• Power mac g4 does not recognize the DVD/CD drive.  It has worked very well in Leapard

  I just newly installed Tiger on my PowerMac G4, and now it does not recognize the DVD/CD drive.  I did all the updates and it does not see the DVD in the DVD drive.  It works perfectly before a new clean install DVD of the Tiger.

  What is your indication that the DVD is not recognized?

  Run the utility disc with the disc in the optical drive.  The drive will appear in the sidebar of disk utility?

  I did all the updates and it does not see the DVD in the DVD drive.

  If you put another type of disc in the optical drive, as a music CD, it is recognized?

• I uninstalled flash on my mac now youtube videos will not play. the error says safari does not recognize the video formats available.

  I uninstalled flash on my mac now youtube videos will not play.

  the error says safari does not recognize the video formats available.

  Reinstall the Flash Player... Why did you remove it?

  Barry

• I have a My Passport to the top by car and I get error messages on this to be ejected (although it was still connected). Now my computer does not recognize the drive. All solutions?

  I have a My Passport to the top by car and I get error messages on this to be ejected (although it was still connected). Now my computer does not recognize the drive. All solutions?

  Drive, interface in the crankcase of training controller, or the USB port or the cable may be faulty.

• Siri does not recognize the voice.

  My Apple TV remote Siri works fine, but only of Siri does not recognize the voice. I just bought last month. No gross State aid.

  Are you pressing the button of Siri (micro) when you talk?

  Have you enabled Siri in settings > general > Siri?

  If so, then try a reset by unplugging the power cord for 30 seconds.

• ITunes does not recognize the phone

  IPhone SE, Windows 10, update ITunes, McAfee

  Connect the phone to the computer and the window phone company recognizes the phone immediately.  I close the phone company of the window and open ITunes.  ITunes does not recognize the phone.  I have the menu bar, select file > currencies, all the options are greyed out.

  Disable McAfee, and then try again.

• Apple TV does not recognize the Apple wireless keyboard

  My Apple TV (4th generation) does not recognize the wireless Apple keyboard I want to make a pairing.  All my other devices (Mac, iPhone and iPad) recognize the keyboard.  This should be done automatically on the Apple TV, but it's not.  The Apple TV has acknowledged the Apple TV remote and paired with her.  Any help would be appreciated.

  Thank you

  Ken Templin

  I paired a non-Apple clone keyboard and it was somewhat capricious. You go to the remote controls and devices-> Bluetooth, enable matching on the keyboard, and it should appear in 'other devices '. You select and enter the number to validate. It requires no tvOS 9.2.

• Does not recognize the external HDD PH3100U-1EXB

  Here's my problem...
  I unplugged my hardrive ex the other night and he fell about 2 feet. Today, when I plugged in again, the computer does not recognize the device. I get the message "disk or network connection that the shortcut, Toshiba - HDD is unavailabale.»

  Ive tried to plug it into different usb ports without success. The worst thing is that ALL my photos are there, is there a way to recover the them.or I'm screwed?

  You can test it on another PC or laptop?
  Just to be sure it is not somehow connected to your PC at home.