Battery fully charged, but by Satellite U500 does not illuminate

Similar Questions

• Satellite A300D does not illuminate

  Toshiba Satellite A300D does not illuminate

  The battery light is red when it is plugged in with the light of the white plug

  When I press the power button it lights up two other fires, and one that looks like a sheet a4 fact paper.it a vibration when turning it on also.

  Any help would be greatly appreciated

  Disconnect the power adapter and remove the battery.
  Leave the laptop unplugged and then hold down power button / stop along 30 sec.
  Then reconnect the two parts and check how the unit works.

  In which case nothing would be visible on the screen, try replacing the RAM modules. Perhaps one of the modules is the troublemaker
  Otherwise if the RAM modules are OK, the problem could be linked to the motherboard.

• Satellite M100 does not illuminate unless the AC adapter is pluged

  I am also having the same problem with my Satellite M100. The computer does not illuminate unless the AC adapter is pluged and plugged into the power outlet.

  Any ideas on how to solve this problem? The battery should be fine.

  B.

  Hello

  Well, to me it sounds like a battery problem
  Why you say that the battery must be good?
  Have you checked it or because the technician?

  In most cases if the battery is faulty then the laptop would have no power until it would be connected to the power adapter.

  So I think (but that's just my personal opinion) the battery must be enabled (by technician, ASP) and if necessary should be replaced.

  See you soon

• Battery fully charged but Equium M50 starts

  Hello

  I'm looking for some help with a battery problem.

  A couple of days, I was using my pc and is going to move in the kitchen, but as soon as I unplugged the AC cable unplug the laptop has been cut.

  I checked and it says the battery is 100% / full power.

  This happened to someone else or someone know what is causing this / how to fix it?

  Thank you.

  Hello

  First of all, if the laptop is connected to the power adapter then it should run and it lights without the use of the battery!

  Second, if the battery is old it might happen that he was running only for a few minutes even it s fully charged.

  Happens to me too my battery is about 6 years old and he says that a single minute. Then it s empty.

  I know that I have to replace it, but the battery is not very important for me because my old laptop is still on the table and still connected to the power adapter.
  If I can live with the bad battery

• Satellite L840 does not illuminate!

  I hope someone here can help me...
  I bought my daughter a new Toshiba Satellite L840 for Christmas and it will not light!

  He was charged for several hours and the power led lights up, makes a quiet noise as if it is going to start up, but the screen is completely blank. We tried a few buttons but still nothing.

  We have obviously not been through any process of implementation because the screen has not recorded anything yet. We tried to turn it off for a few minutes and start again, nothing helps...

  It seeks desperate to use his gift of Christmas, but so far has not been able to.
  Any suggestions would be greatly appreciated!
  Jenny

  Hello

  This new book of s a pity and it powers on
  Try this:
  Remove the battery and unplug the AC adapter.
  Now press the power button / 30 sec long.
  Reconnect the battery and ac adapter.
  Now, press the power button to start the laptop.

  If this does not help you, I would visit the laptop dealer and ask for replacement.

• Satellite M45 does not illuminate

  Hello

  I have a M45 series laptop Satellite and I have a problem. Its doesn't turn is not on. Earlier, I saw light battery on even when its switched to the broad, but not even now. When I try to turn it on after removing the battery and power, withdrawal left off tension and mounting battery alone, it works sometimes but shuts bery fast. Sometimes, the above does not work.

  Battery works, the charger is in operation. Tried with some other laptops.

  Help, please.

  Thank you

  Hello

  Is - that the power supply LED flashes?
  By the way: http://support.toshiba-tro.de/KB0/TSD57013H000JR01.htm

• Satellite U840 does not illuminate

  Hello

  Yesterday I went to turn on my Satellite U-840 ultrabook and nothing happened when I pressed the power button. I left the laptop plugged in and with an external hard drive connected (and turned on) I had several times previously.

  The LED lights up when the laptop is connected to the power supply and shuts off when it is not.

  On the audit of this problem on google, most of the advice said to unplug the laptop, remove the battery and hold the power for 30 seconds or more, then replace the battery and power and it should work.

  However, with this ultrabook, it is not possible to remove the battery.

  Is there an alternative solution for this?

  Hello

  Unfortunately this mentioned workaround does not work always and only if the laptop's hardware is not affected.
  As an alternative, disconnect the power adapter and leave the laptop disconnected for a longer period of time, but I guess that's not very useful

  I think the warranty to be valid, so in this case, you don't have to wait for some auto magic cure, but you should contact the technical service to check the hardware.

• Satellite 210cs does not illuminate.

  I recently met an old 210cs satellite, the first time I turned it on I got an incorrect checksum. Then tried again and after a quick memory check, Windows 95 starts.
  Had the laptop down for about 5 minutes then it turns off, tried again the next day and it wouldn't start.
  During his tour on the disk hard grinds once then stops, a few seconds later there is a dull thunk. All I get is a white screen. I thought it was a hard drive crash, but who would stop the bios from?
  Help, please.

  Hello

  The CMOS Checksum Bad Error is an error that occurs when the CMOS values are incorrect and the error message can appear for different reasons;
  It seems built-in.
  -CMOS battery does not properly
  -the BIOS has been updated
  -the cell phone was off not normally

  In your case I would ignore the last two points and would presume that your problem is related to the faulty motherboard or the ROM chip (chip BIOS).
  Unfortunately, it looks like a serious problem, and I think that only a technician or a motherboard replacement could help. Is that a new party would be more expensive than your oldi. Then maybe you can visit some websites of auctions for a second hand mobos or a laptop another :(

• Satellite L750 does not illuminate

  Hello.

  I recently acquired a portable Satellite L750 who has a problem where it not light but annoyingly he teases me by working perfectly on rare occasions, it seems to me as if there is little hope for it. When I press the power button, the power light comes on for a second or 2 then goes off again, the fan does not turn and nor does the hard drive.

  I got him pressing the escape key while pressing the power button, I could access the menu of the BIOS but I left it overnight after that day. In the morning, he failed put on, this time it remained under tension (e.g. fan, HARD drive, and lights were on) but apparently not POST correctly because there was no hard disk activity or anything on the screen. This has been rectified by moving the single module of RAM from one location to the other, after that it worked perfectly again and I was able to use it for 4 hours with no sign of problems that until ever I turn it off.

  24 hours later the laptop is back to its original problem where only the power LED turns on for a second then it stops again. I tried the main thing of escape as before, moving the ram several times, remove the CMOS battery for a few minutes, but nothing works. I deleted each item one by one and tried to power on but the problem remains. I swapped the RAM module with a well-known work. Food looks good even under a load of 10 ohms. There don't seem to be all components damaged visually on the motherboard.

  If anyone has an idea what so ever then I would be delighted to hear it, be as technical as you want.

  First I thought it might be a memory problem since the first attempt to move the RAM module has helped to get the laptop to life. But since the good use of new modules of work does not resolve the problem, I think that the problem is related to the fault of the motherboard.

  This is of course just my personal opinion, but I think you know that only a few rare parts could cause such problems. It could be a faulty motherboard, CPU and graphics card.
  Possible RAM problem has been already excluded so probably it s a very affected mother board

  What do you think?

• "Accu full, 100%" but the green light does not illuminate.

  Until today, the light load on the front of the laptop went from yellow to green when the charge reaches 100%. It remains now to yellow.

  No idea why - and how to fix it?

  Thank you.

  Hello

  What brand / model of the laptop?

  If the light does not change to green and the battery is not getting fully charged. Try the methods provided and check.
   
  See the link, then run the Fixit.
  The problems of power consumption and extend laptop battery life
  http://support.Microsoft.com/mats/windows_battery_power_settings/en-us
  Method 2:
  
  Battery meter: frequently asked questions
  http://Windows.Microsoft.com/en-us/Windows7/battery-meter-frequently-asked-questions

• Satellite A200 does not illuminate

  Hello!

  I have a Toshiba satellite a200, it lights, it gives me a black screen and 1 long and 2 short beeps, the only lights that light up are the witness of load and the light of the HARD drive, what's the problem?

  I emptied the power from the motherboard and replaced the RAM.

  Well, usually its nothing unusual for the laptop to do one or two short beeps during the startup process.
  But if the laptop will beep and the system does not have a serious hardware problem may exist.

  I'm afraid there is a problem of serious motherboard and no doubt that replacing the mobo would help you to solve this problem.

• My Satellite P300 does not illuminate

  My Satellite P300 (PSPC4A - 03Q 018) switched on me unexpectedly while I was playing a game. I noticed he was running a little hot (it was on a level with clear vents office). I checked the time CPU. with the software and it showed levels up to 80 c while just browse Internet and up to 100 C + all playing games.

  So I blew the vents with compressed air - no change.

  After a little research, I decided to renew the thermal grease. The pulling down of some of the fat has hardened as it seems like a useful exercise. After putting together I have nothing. The only life that I had was a quick flash of the LED AC (the symbol of the plug on the front of the palm rest) when I plugged in, but that's all.

  What I've tried so far: I stripped down and everything reinstalled at least three times. This includes the processor, even if I didn't remove it at the beginning when I replaced the thermal grease. I reinstalled all the cables. I tried it with just the battery, just the AC line and at the same time. I tried to remove the RAM chips and put one by one in different locations. I tried to remove the battery and the AC, holding down the power for 30 seconds button line and try again with just the battery, just the AC line and at the same time.

  I think I either ESD'ed the card or mother or other component/s but I hope it is something much much painful/cheaper. Any suggestions?

  Thank you

  Hello

  Sounds that something bad happened to your hardware for laptop
  Maybe the RAM modules are faulty or the motherboard.
  I think that no one here would be able to tell which part is malfunctioning.

  What to say; If you n t know what part is affected, so I recommend asking a technician for a short control, I mean it is the best step before buying parts including don t need to be replaced

  After the hardware parts have been checked, you can decide what you want to do. sell this laptop faulty or replace parts
  But the new motherboard is not cheap...

• Satellite L635 does not illuminate

  I have a Toshiba Satellite L635-S9320 machine today, when I turned it on it not to launch at all so I plugged the adapter and who got the white flashing of the LED DC and power LED orange flashing and the
  computer does not respond to the switch that I wonder how to solve this problem.

  > DC LED white flashing and power on an orange flashing light

  It seems that the laptop has developed a hardware problem.
  The motherboard provides a code flashing, which means there could be a problem with electronic power supply

  I think you should get in touch with the Toshiba ASP in your country that could control the unique parts in the worst cases the mobo must be replaced, but it's just a suggestion

• Satellite A100 does not illuminate

  When I press the power button the orange battery light flashes but nothing happens.
  It worked fine until he slid my knees yesterday. He has not hit the ground because I caught, but now it will not work.
  I wonder if the battery or the charger may be damaged?

  Hello

  What happens if you connect to the laptop adapter?
  Are the LEDs on?

  You can also remove the battery and was able to connect the laptop to the power adapter and could check if the laptop turns on.

  Good luck

• Satellite A80 does not illuminate

  Hello

  When I push the power button / nothing happens. 2 of the 4 leds are on - the blue on the far left (when you look at the front) and orange, 3rd single along the left. The power adapter is in, but there not all leds not sure if it is on, but it does NOT get hot.

  However if I take the power cord, the 2 leds on the front of the laptop turned off.
  Any suggestions? The Toshiba needs to have a good battery to work even when you run the network?
  Thank you

  Hello

  It seems that your computer has a hardware malfunction. Have you already checked if you have an image on an external monitor? Perhaps your display is faulty.

  Otherwise I would contact a service partner chartered for a checkup of material. You have always guaranteed on your machine? If so, I strongly recommend to contact the service provider, because repairing your machine would be covered by the warranty (which means that you didn t spilled some liquid or broken something on your computer by yourself ;)))

  Just give a few comments if you get a signal when connecting to an external display to your machine.

  Welcome them