C4100 printer all in one, to the power message "problem with the color cartridge.

You are prompted to remove and inspect.  No evidence of damage. Reintegrated and same result.  Tried again

cartridge but same result.

See the troubleshooting steps described in this document, especially step 3.

Cartridges HP or third party?  The latter usually have bad results for reliability, see the study here for the results of the tests.

Tags: HP Printers

Similar Questions

  • D7360 does not print in "Black Only", unless the color cartridges are also not empty

    I try to print a document in grayscale mode with Photosmart D7360 printer.

    In the Print Setup dialog explicitly checks the possibility of using 'Black Print Cartridge Only'.

    The printer refuses to print, in saying:

    «The following ink cartridges are empty: Light Cyan.» Replace the ink cartridges to resume printing.

    "The printer doesn't have enough ink to ensure printer health. Empty ink cartridges need to be replaced to resume. »

    This means that even if it does not use the color cartridges, each of them must be non-empty when the printer is in operation?

    Yaro says:

    Thanks Zacabeb!
  • 926 printer all in one, half the time that it crashes scan only

    I have a dell XP 530 and using a printer AIO 926. Great work expect half the time it crashes when I want to scan something. It gets to 98 or 99% then stops. I have to finish the program, then shut down the computer and restart to try again. It scans very well to a fax. I went to the control panel and clicked on scanners and cameras, and then clicked on Wizard scanners and can analyze every time using the scanner Wizard.

    Scanning problem is only when you use Dell all in one Center to try to sweep.

    Scanning works very well when the works using Fax and large printer...

    Event viewer reads as follows: Hanging application dlcxaiox.ece, blocked module hungapp, version0.0.0.0, version4.22.0.8, block address 0 x 00000000.

    When I click on link ms the below error:

    Product: Windows OS

    ID: 1002

    Source: Application Hang

    Version 5.2

    Symbolic name: ER_HANG_LOG

    Message: Hanging application %1, version 2%, hang module version %4 %3, hang address 0 x %5

    end

    wb8slqgak,

    Please always allow the printer beyond the firewall. Have you tried the information that I have suggested in the THREAD above?

    Rick

  • What printer all-in-one works the best?

    I have order a MX922 from Amazon, but too late saw the comments on problems with printing on envelopes and cardstock.  Is there a Canon model that still has a lot of features like MX922 and a reputation without problem?

    Hi sandrawolf,

    Our PIXMA MX922 can print on envelopes and special paper without difficulty; However, we recommend you some paper sizes, types and weights be used with the printer for optimal performance.  Please see the link below for our paper recommendations:

    PIXMA MX922 paper recommendations

    It has not responded to your question or problem? Please call or write to us at one of the methods on the page contact us for further assistance.

  • I have a Kodak printer all in one, and the only thing I want to do is yellow ink. Can someone help me?

    I just put this new ink in my printer and print all my papers in yellow. I turned it off and waited, then walk back and I always get yellow ink.

    Hi vickiemullis,

    ·         What is the model of the printer that you are using?

    It seems like it might be a problem with the cartridge.

    However, try the following.

    Method 1: Run the next Fixit tool and check if it helps.

    Problems printing and printing errors

    Method 2: Check if the following might help.

    Printer in Windows problems

    Contact Kodak for help.

    Support home page - Kodak

  • my printer all-in-one bother 9440cn continued to come with the printer cannot print offline can help you

    Remember - this is a public forum so never post private information such as numbers ofmail or telephone!

    Ideas:

    • You have problems with programs
    • Error messages
    • Recent changes to your computer
    • What you have already tried to solve the problem

    Start, printers, right click on the brother and the selection unit online.

  • OfficeJet 5470 e-all-in-one: Subscriber instant - problem with #62 color cartridge - Cyan Ink only

    I just installed a new color cartridge and our copies look right.

    I aligned the printer and then cleaned them (the two cleanings) and Print quality Diagnostic report shows nothing in the column "Cyan".

    Is it possible that the cartridge is defective?

    Thank you very much for your help!

    Hi @fiveinthetree,

    I understand that you are having some print quality problems with your HP Officejet 5740. I'll be happy to help you.

    It is possible that the cartridge you received is defective, however, there are some troubleshooting, you need to try before you can replace as defective cartridge.

    I recommend contacting instant ink 1-855-785-2777 for support in real time with an agent. If they determine that the cartridge is defective, they can help you with the replacement.

    If this help will testify of my answer by pressing the 'thumbs up' below, or click on the button "Accept as Solution" if I helped you reach a solution.

    I hope this helps and have a nice day.

  • DeskJet HP3512 Windows 7 can continue to print black-and-white if the color cartridge is empty?

    If my color cartridge is empty, can I continue to print in black?

    DeskJet 3512, Windows 7.

    HI oldtoot,

    You should be able to print with just the black cartridge installed.

    Here a link to the manual. On page 30 in details how to use mode single-cartridge to operate your printer using only a single print cartridge.

  • HP officejet 8500 has more will not print black and white because the color cartridge is low

    I have entered the property and set it to 'levels of gray' and 'use black ink only', but the printer still will not print because "the yellow ink cartridge is low.

    incredibly frustrating that the cartridges of color completely stop you from printing, even if you are trying to print in color.

    Proffessional OS-windows 7

    is there a known solution for this?

    Unfortunately, the printer does not print until the replacement of the yellow ink. There is no work around for low ink message.

  • 7520 e printer all-in-one: international tension

    I have a 7520 e printer all-in-one to the Canada and want to know that if it will work in the United Kingdom with just a sheet of adaptation, in the same way a laptop does.

    Hello

    Thank you for using the HP Forums.

    Yes, it supports different tensions:

    The following table contains specifications voltage and the input frequency.
  • Printing printer Lexmark 2600 problems - it prints half a line after replacing the color cartridge

    It prints half a line, if the top or the bottom of it and the cutting of the other party.  This happens on every third line.

    This started happening when I replaced a color cartridge and ran the alignment page.  Before replacing the cartridge, it prints very well (except that the color cartridge started missing).   When I noticed what was going on, I took both cartridges on and then put them back in and had to print the alignment again page.  Yet the problem persists.
    I checked the Device Manager, and my drivers are up to date.  I also checked all connections.
    Any suggestions are welcome.

    Oh boy.  I don't know what I thought.  It just had to unplugging everything & then reconnect them, turn off & on.  This took care of it - seems so simple now.

    I guess it was my new laptop which has the printer all confused.  Win7, my find of CL.

    Insofar as the Lexmark support, I have not yet that day.  In any case, it comes to X 2690 model I had for centuries, so I guess that support would be of any help.  I mean, the guarantee missed a long time ago.
    Thank you for taking the time to answer.
  • HP 5530: Black-and-white printing with no color cartridge

    Two questions please.

    (1) this printer print black and white if the color cartridge is empty or not placed on printer at all.

    (2) I have been using HP 61 XL.  Is HP 61 the same quality as HP XL 61

    Thank you.

    Hey @Kathiebronx,

    I see that you have questions about the desire 5530 e - all - in - one printer. I can answer those for you.

    (1) the 5530 envy has a system of two cartridges so it will print with a black cartridge in the printer.

    (2) 61 and 61XL cartridges are both HP cartridges. The printer must be able to print with the same quality that you were using a regular cartridge or a cartridge XL.

    I hope this helps to answer your questions and I hope you have a great week!

    If this resolve that your problem then please let others know by clicking on accept as Solution on my post.

    If you appreciate my help so please inform other users of the forum by clicking on the icon below my post thumbs up.

  • Photosmart 7520: How to erase the memory of my 7520 HP printer all in one?

    How to erase the memory of my 7520 HP printer all in one?

    I try to delete all personal data before recycling.  I also want to remove the password of wireless network that seems to be in memory?

    From the front panel access home, installation, tools, Reset Factory Defaults.  Also make sure that camera cards are removed from the slots on the front panel.

  • HOW CAN I REPLACE EXPIRED INK CARTRIDGE IN THE PRINTER ALL IN ONE HP OFFICEJET PRO L7780?

    HOW CAN I REPLACE EXPIRED INK CARTRIDGE IN THE PRINTER ALL IN ONE HP OFFICEJET PRO L7780?

    I DO NOT PRINT A LOT AND I HAVE TWO PRINTERS. THE EXPIRATION DATE ON THE CARTRIDGE, THE PRINTER DOSE NOT LET ME PRINT. I KNOW THAT THERE IS WAY TO OVERRIDE THIS PROBLEM, BECAUSE ON MY PREVIOUS PRINTER THEY REPLACES THE KEY.

    The error message itself will remain but will continue to print. This message will remain until the cartridge is replaced. Substitution is the printer printing always regardless of the error message on the display screen.

  • Can not find the driver of scan to PRINTER ALL-IN-ONE KODAK ESP 5210

    Can not find the driver of scan to PRINTER ALL-IN-ONE KODAK ESP 5210. Device Manager says last driver is installed.

    Moved from feedback

    Original title: scan driver

    Hello Timmy,

    Please take a look at the following link for the driver\firmware for your printer.

    KODAK ESP 5210 All-in-One Printer Firmware - WINDOWS operating systems

    If this is not enough, you may have contact with Kodak support for the same. Thank you.

Maybe you are looking for

  • Inspector on the tools of firefox development is empty

    I have trouble with the Developer Tools tab of the Inspector. At times, the Panel is completely empty. the Panel with the rules, calculated, fonts,... is very good and the path is also active, but the main table with the html structure is empty. I ha

  • Apple Watch gives a warning sound or vibration when it is out of reach with your iPhone?

    Apple Watch gives it its warning or vibrates when it is out of reach with your iPhone? If so, how to set up? If this is not the case, why they have this important function, so we do not lose our phones?

  • Satellite A505 breaks down

    This laptop has begun recently to close (as it would if I pressed the power button) for no apparent reason.I suspect that it is because it is overheating, but there were a couple times when he did it in a few minutes of starting with nothing else run

  • Y510 unable to get data from the camera.

    Hello I have a Y510 with Windows Vista 32 bit, 3 GB RAM, only 5 weeks. I get this message when I try to use Veriface, "unable to get data from the camera. The camera may have been disconnected or busy. I reinstalled Vista of the State in which the la

  • Impossible to find more older .vi CAN - 2.0 in labview 2009

    Hello I am using a 1 card PCMCIA-CAN/2 series (old enough) in Labview 2009. I installed the latest NI-CAN driver that supports this old card (NI-CAN 2.0, I think), but I don't see the can.llb s vi in the functions palette.  The CAN - 2.0 documentatio